Middleby Marshall PS536GS manual

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28

Ir a la página of

Buen manual de instrucciones

Las leyes obligan al vendedor a entregarle al comprador, junto con el producto, el manual de instrucciones Middleby Marshall PS536GS. La falta del manual o facilitar información incorrecta al consumidor constituyen una base de reclamación por no estar de acuerdo el producto con el contrato. Según la ley, está permitido adjuntar un manual de otra forma que no sea en papel, lo cual últimamente es bastante común y los fabricantes nos facilitan un manual gráfico, su versión electrónica Middleby Marshall PS536GS o vídeos de instrucciones para usuarios. La condición es que tenga una forma legible y entendible.

¿Qué es un manual de instrucciones?

El nombre proviene de la palabra latina “instructio”, es decir, ordenar. Por lo tanto, en un manual Middleby Marshall PS536GS se puede encontrar la descripción de las etapas de actuación. El propósito de un manual es enseñar, facilitar el encendido o el uso de un dispositivo o la realización de acciones concretas. Un manual de instrucciones también es una fuente de información acerca de un objeto o un servicio, es una pista.

Desafortunadamente pocos usuarios destinan su tiempo a leer manuales Middleby Marshall PS536GS, sin embargo, un buen manual nos permite, no solo conocer una cantidad de funcionalidades adicionales del dispositivo comprado, sino también evitar la mayoría de fallos.

Entonces, ¿qué debe contener el manual de instrucciones perfecto?

Sobre todo, un manual de instrucciones Middleby Marshall PS536GS debe contener:
- información acerca de las especificaciones técnicas del dispositivo Middleby Marshall PS536GS
- nombre de fabricante y año de fabricación del dispositivo Middleby Marshall PS536GS
- condiciones de uso, configuración y mantenimiento del dispositivo Middleby Marshall PS536GS
- marcas de seguridad y certificados que confirmen su concordancia con determinadas normativas

¿Por qué no leemos los manuales de instrucciones?

Normalmente es por la falta de tiempo y seguridad acerca de las funcionalidades determinadas de los dispositivos comprados. Desafortunadamente la conexión y el encendido de Middleby Marshall PS536GS no es suficiente. El manual de instrucciones siempre contiene una serie de indicaciones acerca de determinadas funcionalidades, normas de seguridad, consejos de mantenimiento (incluso qué productos usar), fallos eventuales de Middleby Marshall PS536GS y maneras de solucionar los problemas que puedan ocurrir durante su uso. Al final, en un manual se pueden encontrar los detalles de servicio técnico Middleby Marshall en caso de que las soluciones propuestas no hayan funcionado. Actualmente gozan de éxito manuales de instrucciones en forma de animaciones interesantes o vídeo manuales que llegan al usuario mucho mejor que en forma de un folleto. Este tipo de manual ayuda a que el usuario vea el vídeo entero sin saltarse las especificaciones y las descripciones técnicas complicadas de Middleby Marshall PS536GS, como se suele hacer teniendo una versión en papel.

¿Por qué vale la pena leer los manuales de instrucciones?

Sobre todo es en ellos donde encontraremos las respuestas acerca de la construcción, las posibilidades del dispositivo Middleby Marshall PS536GS, el uso de determinados accesorios y una serie de informaciones que permiten aprovechar completamente sus funciones y comodidades.

Tras una compra exitosa de un equipo o un dispositivo, vale la pena dedicar un momento para familiarizarse con cada parte del manual Middleby Marshall PS536GS. Actualmente se preparan y traducen con dedicación, para que no solo sean comprensibles para los usuarios, sino que también cumplan su función básica de información y ayuda.

Índice de manuales de instrucciones

  • Página 1

    PS536GS Gas Domestic, S td. Export & CE ENGLISH /French/S p anish P/N 50236 November 18, 2008 Rev.E Price $30.00 Middleby Cooking Systems Group • 1400 Toastmaster Drive • Elgin, IL 60120 • (847)741-3300 • FAX (847)741-4406 © 2003 Middleby Marshall, Inc. is a registered trademark of Middleby Marshall, Inc. All rights reserved. PS536GS G[...]

  • Página 2

    2 ENGLISH Middleby Cooking Systems Group • 1400 Toastmaster Drive • Elgin, IL 60120 • USA • (847)741-3300 • FAX (847)741-4406 Ret ain This Manual For Future Reference NOTICE: This Owner's Operating and Installation Manual should be given to the user. The operator of the oven should be familiar with the functions and operation of the [...]

  • Página 3

    3 ENGLISH SECTION 1 - DESCRIPTION ................................................... 4 I . OVEN USES ............................................................. 4 I I. OVEN COMPONENTS ............................................. 4 A . Window ............................................................. 4 B . Conveyor End Stop ..................[...]

  • Página 4

    4 ENGLISH III. OVEN SPECIFICATIONS Table 1-1: Dimensions Overall Height: single oven with 17-1/2" (446mm) legs 43-1/2" (1105mm) double oven with standard 17-1/2" (446mm) legs 63" (1600mm) double oven with optional 20-1/2" (521mm) legs 66" (1676mm) double oven with optional 25-1/2" (648mm) legs 71" (1803mm) tr[...]

  • Página 5

    5 ENGLISH SECTION 1 - DESCRIPTION Table 1-3: Electrical specifications for gas ovens (per oven cavity) Main Blower Control Current Voltage Circuit Voltage Phase Freq. Draw Poles Wires 208/240V 120V conv. speed control 1 Ph 50/60 Hz 6A * 2 Pole 3 Wire (2 hot, 1 gnd) & drive motor; all others as per line (208/240V) * The current draw shown above [...]

  • Página 6

    6 ENGLISH SECTION 2 - INST ALLA TION WARNING Keep the appliance area free and clear of combustibles. WARNING Do not obstruct the flow of combustion and ventilation air to and from your oven. There must be no obstructions around or underneath the oven. Constructional changes to the area where the oven is installed shall not affect the air supply to [...]

  • Página 7

    7 ENGLISH SECTION 2 - INSTALLATION Figure 2-1 - Installation Kit 1 2 3 4a, 4b, 4c, 4d 5 6 9 11 10 8 12 14 15 13 16 7 I. INSTALLATION KIT - see Figure 2-1 Qty. Qty. Qty. Inc. with Inc. with Single Double Triple d om e s t ic C E Item Oven Oven Oven Part No. ovens? ovens? Description 1 1 1 1 48605 Yes Yes Top panel 2 4 4 4 3A80A8801 Yes Yes Screw, pa[...]

  • Página 8

    8 ENGLISH B . Recommendations NOTE THAT THE HOOD DIMENSIONS SHOWN IN FIGURE 2- 2 ARE RECOMMENDATIONS ONLY. LOCAL, NATIONAL AND INTERNATIONAL CODES MUST BE FOLLOWED WHEN INSTALLING THE VENTILATION SYSTEM. ANY APPLICABLE CODES SUPERSEDE THE RECOMMENDATIONS SHOWN IN THIS MANUAL. The rate of air flow exhausted through the ventilation system may vary de[...]

  • Página 9

    9 ENGLISH SECTION 2 - INSTALLATION III. ASSEMBLY A . Top Panel and Base Pad Assembly 1. Install the four leg extensions onto the base pad using the 3/8"-16x1" screws, 3/8" flat washers, and 3/8" lockwashers supplied in the Base Pad Kit. See Figure 2-3. Check that the finished sides of each leg extension face OUTWARDS. For domest[...]

  • Página 10

    10 ENGLISH B . Stacking For single ovens, skip ahead to Part C, Restraint Cable Installation. IMPORTANT Middleby Marshall STRONGLY RECOMMENDS that PS536GS oven cavities be stacked using the following: • PS500 Series Stacking Lift Kit, P/N 30580 • PS536 Stacking Hardware Kit, P/N 46494 Contact your Middleby Marshall Authorized Service Agent for [...]

  • Página 11

    11 ENGLISH SECTION 2 - INSTALLATION Figure 2-9 - Conveyor installation Folded frame D . Conveyor Installation 1. Unfold the conveyor as shown in Figure 2-9. Then, begin to slide the conveyor into the end of the oven. The conveyor can only be installed from the end of the oven with the drive motor. 2. Continue moving the conveyor into the oven until[...]

  • Página 12

    12 ENGLISH Hang chain cover on screws in control compartment wall Place inside edge of tray on retainer bracket Swing outside edge of tray up and into place Press conveyor end stop down over edge of conveyor frame SECTION 2 - INSTALLATION Figure 2-13 - Final assembly Figure 2-12 - Conveyor and master link orientation Direction of travel CORRECT mas[...]

  • Página 13

    13 ENGLISH SECTION 2 - INSTALLATION IV. ELECTRICAL SUPPLY WARNING Authorized supplier personnel normally accomplish the connections for the ventilation system, electric supply, and gas supply, as arranged by the customer. Following these connections, the factory-authorized installer can perform the initial startup of the oven. NOTE: The electric su[...]

  • Página 14

    14 ENGLISH SECTION 2 - INSTALLATION V. GAS SUPPLY CAUTION DURING PRESSURE TESTING NOTE THE FOLLOWING: 1. The oven and its individual shutoff valve must be discon- nected from the gas supply piping system during any pressure testing of that system at test pressure in excess of 1/2 psi (3.45 kPa). 2. The oven must be isolated from the gas supply pipi[...]

  • Página 15

    15 ENGLISH SECTION 2 - INSTALLATION Gas Va l ve Main• Pressure• Ta p Gas Burner Assembl y Main• Orifices Figure 2-16. Gas Burner Assembly Gas Burner Manifold Pressure Tap Adjustment Screw (5 mm) for minimum pressure setting Adjustment Screw (8 mm) for maximum pressure setting Figure 2-17. Burner Assembly Figure 2-18. Gas Valve 5. Disconnect e[...]

  • Página 16

    16 ENGLISH SECTION 2 - INSTALLATION NOTES[...]

  • Página 17

    17 ENGLISH SECTION 3 - OPERA TION A B C D E "BLOWER" Switch: Turns the blowers and cooling fans on and off. The HEAT Switch has no effect unless the BLOWER Switch is in the “ON” position. A. "HEAT" Switch: Allows the burner to activate. Activation is determined by the settings on the Digital Temperature Controller. "CON[...]

  • Página 18

    18 ENGLISH SECTION 3 - OPERATION CAUTION In case of power failure, turn all switches to the “OFF” ("O") position, open the oven window, and remove the product. After the power has been restored, perform the normal startup procedure. IF THE OVEN WAS SWITCHED OFF FOR LESS THAN 5 MINUTES, WAIT FOR AT LEAST FIVE MINUTES BEFORE RESTARTING [...]

  • Página 19

    19 ENGLISH Display Shows the Set Point or the Actual T em- perature in degrees Fahrenheit (F) or Celsius (C). "SP LOCK" Light Lights when the set point is locked out from changes. This setting can only be changed by service personnel. OVERTEMP Light Lights when the oven temperature is greater than 650°F (343°C). Refer to Quick Reference[...]

  • Página 20

    20 ENGLISH I. MAINTENANCE - DAILY A . Check that the oven is cool and the power is disconnected, as described in the warning at the beginning of this Section. B . Clean ALL of the cooling fan grills and vent openings with a stiff nylon brush. Refer to Figure 4-1 for the locations of the grills and vents. C. Clean the outside of the oven with a soft[...]

  • Página 21

    21 ENGLISH III. MAINTENANCE - EVERY 3 MONTHS A . Check that the oven is cool and the power is disconnected, as described in the warning at the beginning of this Section. B . Open the machinery compartment access panel. Vacuum the inside of the compartment using a shop vacuum. C. Tighten all electrical control terminal screws. D . Split Belt Disasse[...]

  • Página 22

    22 ENGLISH SECTION 4 - MAINTENANCE 2. Remove the master links from each conveyor belt. Then, roll the belts up along the length of the conveyor to remove them from the frame. 3. Remove the two conveyor adjustment screws from the idler end of the conveyor frame, as shown in Figure 4- 4. 4. Remove the idler shaft assembly from the conveyor. 5. Pull a[...]

  • Página 23

    23 ENGLISH IV. MAINTENANCE - EVERY 6 MONTHS A . Check that the oven is cool and the power is disconnected, as described in the warning at the beginning of this Section. B . Check for excessive wear on the conveyor drive motor brushes. The brushes should be replaced if they have worn to less than 1/4" (6mm) in length. Be sure to replace the bru[...]

  • Página 24

    I. KEY SPARE PARTS KIT ITEM QTY. P/N DESCRIPTION 1 1 47321 DIGITAL TEMPERATURE CONTROLLER 2 1 51067 C O N V EY OR DR I VE MO TO R W /P IC KU P AS SY . 3 2 30153 DRIVE MOTOR BRUSHES 4 1 60542 KIT, CONVEYOR SPEED CONTROLER 5 1 33984 KIT, THERMOCOUPLE 6 ″ 6 1 50517 BELT, BLOWER 7 1 44687 MOTOR, BLOWER, 208/230V, 1/2HP 8 1 33983 HIGH LIMIT CONTROL MO[...]

  • Página 25

    SECTION 6 - ELECTRICAL WIRING DIAGRAMS SECTION 6 - ELECTRICAL WIRING DIAGRAMS IMPORT ANT An electrical wiring diagram for the oven is also located inside the machinery compartment. Fig. 6-1 - Wiring diagram, PS536GS Gas Oven 208/240V, 50/60 Hz, 1 Ph 60968 Rev. D[...]

  • Página 26

    NOTES[...]

  • Página 27

    NOTES[...]

  • Página 28

    Middleby Cooking Systems Group • 1400 Toastmaster Drive • Elgin, IL 60120 • USA • (847)741-3300 • FAX (847)741-4406 24-Hour Service Hotline: 1-(800)-238-8444 www .middleby .com Middleby is proud to support the Commercial Food Equipment Service Association (CFESA). We recognize and applaud CFESA's ongoing efforts to improve the qualit[...]