Panasonic CY-RC50KN manual

Rear-View Camera Model CY-RC50KN CY-RC50KW Operating Instructions O Please read these instructions carefully before using this product and keep this manual for future reference. POWER CAMERA IN VIDEO OUT English[...]

R Read the operating instructions for the unit and all other components of your car navigation system carefully before using the system. They contain instructions about how to use the system in a safe and effective manner. Panasonic assumes no responsibility for any problems resulting from failure to observe the instructions given in this manual. T[...]

Observe the following cautions when using this unit. R Do not use this system for any purpose other than mounting on a road vehicle. Non-vehicular use (such as use outdoors or on a pleasure boat) could cause smoking generation, ignition, electric shock, injury and breakdown. R Do not use an automatic car–washing machine to wash the vehicle. Expos[...]

Carefully read the instruction manuals for the connected devices (Car Monitor etc.). Before reversing, always check behind you by eye. O This product uses mirrored display (which mimics the orientation of the rear-view and side mirrors), and is for checking the view behind the vehicle. O It is intended to augment the driver’s fi eld of vision be[...]

Memor andum[...]

Output image ........................................... Wide-angle mirror image (for checking the rear view) Video format ..................................................................................................... NTSC composite Power supply ...................................................................................... DC 12 V, n[...]

Observe the following warnings when installing. R Use on a DC 12 V  grounded vehicle. This system can only be used on a DC 12 V  grounded vehicle. It cannot be used in DC 24 V and other battery system (large trucks, diesel vehicles for use in cold regions, etc.). Use on such vehicles would cause fi re and breakdown. R Disconnect the battery [...]

Information on Disposal for Users of Waste Electrical & Electronic Equipment (private households) This symbol on the products and/or accompanying documents means that used electrical and electronic products should not be mixed with general household waste. For proper treatment, recovery and recycling, please take these products to designated co[...]

If you suspect something wrong Check and take steps as described below. If the described suggestions do not solve the problem, it is recommended to take the unit to your nearest authorized Panasonic Service Centre. The product should be serviced only by qualifi ed personnel. Please refer checking and repair to professionals. Panasonic shall not be[...]

Pesticide Alcohol Thinner Benzine Wax Caution on cleaning O Do not wipe with volatile chemicals, such as alcohol, benzine, thinners and gasoline. These can cause deformation, deterioration and breakage. O Do not wipe with cleaners that contain abrasive particles, as they leave scratches. O If the lens is dirty, wipe it gently with a soft, moist clo[...]

Consult your dealer if any item is missing. O Figures in ( ) are quantities. Rear view camera control unit (1) Power cord (2) RCA cord (1) Q Accessories Operating instructions (this manual) (1) PAN EUROPEAN GUARANTEE (Warranty Card) 5 m (1) Camera bracket (1) Cord rail Rear view camera (with Rubber water seal) 4 m cord Bolts with washer (1) Hexagon[...]

O Route the camera cord so that it does not allow rainwater etc. to penetrate. O Allow enough slack in the cord so that it is not pulled when the door is opened and closed. Rear view camera Rear view camera control unit Cord clamp Harness cover Tie band Tie to the harness cover. Car monitor etc. Cord rail (peel off backing paper) Cut to the appropr[...]

Note: O Open and close the back door or boot lid slowly to check that the camera cord is not pinched or abraded by the door/lid. Moisture or water can enter through the damaged area of the cord and penetrate to the interior of the camera, causing breakdowns. O Route the camera cord as far as possible from the antenna cord. (It could cause noise in [...]

Note: O The camera cannot be affi xed to painted or glass surfaces which have been treated with fl uoroplastics (treatments which shed water droplets, mud etc.), or to re-painted surfaces. Make connections and placement tentatively at fi rst, to check positions. Repeated affi xing weakens the adhesive. O The screw holes to use, and the possible[...]

Wipe away all oil and dirt etc. from the mounting surface. Note: Do not mount the control unit in the following locations, which could cause breakdowns. O Places exposed to water O Places which could be stepped on O Dusty places O Close to heater ducts or heat-emitting objects O Places exposed to direct sunlight O Under the carpet, or any other pos[...]

When connected to a Panasonic Car Monitor etc., the image from the camera is automatically displayed in the screen when the shift lever is moved to reverse (R). O For some combinations of vehicle type and device, additional cords (option) may be required, or connection may not be possible. Consult your dealer or service centre. O For connection wit[...]

o rding to the installation instructions for the connected devices. P R N D 2 L 1A ＋ − CAMERA-IN Reverse lead (Violet/white stripe) In-Dash Monitor (CQ-VD7005N/W: option) Reverse extension cord (Violet/white stripe) Reverse lamp Clip connector Connection to a Car Monitor (example) Clip connector Transmission Reverse lead (Violet/white stripe) G[...]

P R N D 2 L 1 A REVERSE GND ＋ − Car Monitor How to disconnect locked cords Power cord Rear view camera cord How to attach a clip connector  Insert the cord into the clip connector. Vehicle-side wiring cord Reverse lead of this unit  Press the element into place.  Close the cover. Reverse lead (Violet/white stripe) Ground lead (Black) C[...]

 Adjust the camera angle so that the fender or the rear edge of the vehicle appears at the bottom of the monitor.  Attach the camera bracket to a glass or painted surface on the vehicle body. Side view  Mount the camera body onto the camera bracket. Bolt with washer Hexagon wrench Rear view camera Side with logo uppermost The screw holes t[...]

Memor andum[...]