Planar PT2245PW manual

PT2245PW T ouch Screen Monitor USER’S GUIDE www .planar .com[...]

The information contained in this document is subject to change without notice. This document contains proprietary information that is protected by copyright. All rights are reserved. No part of this document may be reproduced,translated to another l a n g u a g e or stored in a retrieval system, or transmitted by any means, electronic, mechanical,[...]

T able of Contents Usage Notice Precautions ................................................................................................................. 1 Introduction About PT2245PW Series ............................................................................................. 2 T ouch Screen for PT2245PW ................................[...]

Usage Notice ! W arning - T o prevent the risk of re or shock hazards, do not expose this product to rain or moisture. ! W arning - Please do not open or disassemble the product as this may cause electric shock. Precautions Follow all warnings, precautions and maintenance as recommended in this user ’s manual to maximize the life of your unit.[...]

Introduction About PT2245PW Series The PT2245PW Series is a 21.5" at panel screen with an active matrix, thin-lm transistor (TFT) edge-lit LED LCD. This unit is to be used as commercial and light industrial equipment only . Features include: • Direct Analog signal input • Direct Digital signal input • Active matrix TFT LCD technolo[...]

3 Package Overview Cable Cover Screw LCD Display Power Cord VGA Signal Cable USB Cable ( A to B) DVI-D Cable DC Power Supply Landing Strip User ’s Guide xxxxxxxxx / xxxxxxxxx xxxxxxxxx USER’S GUIDE www.planartouch.com[...]

Installation Product Overview • Front V iew • Bottom V iew (Without Stand) 4 VGA USB DC IN DVI RJ -Type[...]

VESA Mount for Y our Monitor This monitor conforms to the VESA Flat Panel Mounting Physical Mounting Interface standard which denes a physical mounting interface for at panel monitors, and corresponding with the standards of at panel monitor mounting devices, such as wall and table arms. The VESA mounting interface is located on the back o[...]

Start Y our Installation Please follow these instructions so that you can hook up the cables to associated connectors. 1. Lay the display at on an even surface. 2. Move the stand into position as seen in the step 1 diagram. 3. Remove the cable cover as seen in the step 2 diagram. 4. Connect the cables to the appropriate connectors as seen in the[...]

7 Connecting the Display (Figure 8.1) T o setup this display , please refer to the following gure and procedures. 1. Be sure all equipment is turned off. 2. Connect the DC plug to the power connector on the monitor and the other end into an electrical outlet (8.1). 3. Connect the D-SUB or DVI cable from the display’s D-SUB or DVI input connect[...]

8 (Figure 8.1) (Optional)[...]

9 User Controls Side Panel Controls OSD Key Menu off status Menu on status Menu appear Menu disappear / return to main item Brightness Main item select up / Adjust up Contrast Main item select down / Adjust down Select sub-item function Power On / Off Icon Key Name Menu Up Down Select Power[...]

10 How to Use the OSD Menus Icon Key Name Menu Up Down Select Power 1. Press the “Menu” button to pop up the “on-screen menu” and press “Up” or “Down” button to select among the ve functions in the main menu. 2. Choose the adjustment items by pressing the “Select” button. 3. Adjust the value of the adjustment items by pressin[...]

11 On-Screen Display Menus Main OSD Menu: ITEM CONTENT Contrast The monitor luminance level control. Brightness The monitor backlight level control. Auto Adjust Fine-tune the image to full screen automatically . Left/Right Moving screen image horizontal position to left or right. Up/Down Moving screen image vertical position to up or down. Horizont[...]

12 Appendix T roubleshooting If you are experiencing trouble with the display , refer to the following. If the problem persists, please contact your local dealer or our service center . Problem: No image appears on screen. ► Check that all the I/O and power connectors are correctly and well connected as described in the “Installation” section[...]

W arning Signal If you see warning messages on your screen, this means that the display cannot receive a clean signal from the computer graphics card. Below are the three kinds of W arning Signal. Please check the cable connections or contact your local dealer or our service center for more information. No Signal This message means that the display[...]

Product Dimensions ► Side View ► Front View ► Top View 517.4 mm 313.3 mm 351.7 mm 249.6 mm 219.0 mm 212.0 mm 46.0 mm 14[...]

Rotate 15 ► Side View ► Front View ► Top View 313.3 mm 517.4 mm 553.7 mm 212.0 mm 46.0 mm 219.0 mm 249.6 mm[...]

Compatibility Modes Mode Resolution H-Frequency(khz) V -Frequency(hz) IBM VGA 720X400 31.47 70 IBM VGA 640X480 31.47 60 Apple MacII 640X480 35.00 66 VESA VGA 640X480 37.86 72 VESA VGA 640X480 37.50 75 VESA SVGA 800X600 35.16 56 VESA SVGA 800X600 37.88 60 VESA SVGA 800X600 48.08 72 VESA SVGA 800X600 46.88 75 Apple Mac 832X624 49.72 75 VESA XGA 1024X[...]

T ouch Screen Driver Installation The is available with USB connection. The touch driver is available at www .planar .com/sup- port for these operating systems: Windows® 7/8, VIST A, XP , 2000, CE, XP Embedded, Linux kernel 2.6.x (32 bit & 64 bit) , Apple® Mac OS. (Windows 7/8 Multi touch without driver) Please Note: 1. The PT2245PW is Micros[...]

18 PT2245PW Calibration Instruction: Calibrating the touch screen in Windows 7/8: 1. T ap the Start button, Control Panel and then Hardware and Sound. 2. Under T ablet PC Settings, tap Calibrate the screen for pen or touch input. 3. On the Display tab, under Display options, tap Calibrate and then Y es to allow the program to make changes. 4. Follo[...]

19[...]

PT2245PW Install Instruction: If you are using a PC running, Windows® 7/8, VIST A, XP , 2000, follow the instructions below: 1. Power on the PC. 2. Make sure that the USB cable is connected to the computer . 3. Visit www .planar .com/support. 4. Follow the step-by-step instructions as shown on the pop-up windows. If you are using a PC running driv[...]

T echnical Support Cables and Accessories T o nd cables and accessories for your Planar monitor , touch screen or other Planar products visit our online store at www .PlanarOnline.com. T echnical Support Visit Planar at http://www .planar .com/support for operations manuals, touchscreen drivers, warranty information and access to Planar ’s T e[...]

Planar Systems, Inc. Customer Service 24x7 Online T echnical Support: http://www .planar .com/ support 1 195 NW Compton Drive Beaverton, OR 97006-1992 T el: 1-866-PLANAR1 (866-752-6271) or +1 503-748-5799 outside the United States. Hours: 24 hours a day , 7 days a week © 2013 Planar Systems, Inc. 10/13 Planar is a registered trademark of Planar Sy[...]