Quadra-Fire 3100-I manual

R DO NOT DISCARD THIS MANUAL CAUTION • Important operating and maintenance instructions included. • Leave this manual with party responsible for use and operation. HOT SURF ACES! Glass and other surfaces are hot during operation AND cool down. W ARNING Hot glass will cause burns. • Do not touch glass until it is cooled • NEVER allow childre[...]

3100-I ACT WOOD INSERT Page 2 September 1, 2008 R 250-6381D and Welcome to the Quadra-Fire Family ! H earth & Home T echnologies welcomes you to our tradition of excellence! In choosing a Quadra-Fire appliance, you have our assurance of commitment to quality , durability , and performance. This commitment begins with our research of the market,[...]

Page 3 September 1, 2008 3100-I ACT WOOD INSERT R 250-638D SAFETY & OVER VIEW OF APPLIANCE Serial Number /Listing Label Location ------------------ 2 Dimensions ----------------------------------------------------- 4 Minimum Clearances to Combustibles ------------------ 5 Installation Recommendations ---------------------------- 6 Listings &[...]

3100-I ACT WOOD INSERT Page 4 September 1, 2008 R 250-6381D INSERT DIMENSIONS T OP VIEW SIDE VIEW FRONT VIEW A B C L 27-7/16" (697mm) 14-1/8" (359mm) 38-7/8" (987mm) 12-3/16" (310mm) 8-5/8" (219mm) 5-3/8" (137mm) 22-7/16" (570mm) 23-1/8" (587mm) 21-1/2" (546mm) 20-3/8" (518mm) 26-1/4" (667mm) 7[...]

Page 5 September 1, 2008 3100-I ACT WOOD INSERT R 250-638D Hearth Extension A B C D F E Insert SideW all Maximum Mantel Depth - 10" (254mm) Fascia or T rim Mantel Thermal Protection USA & Canada USA CANADA A Sidewall to Stove 16" 16" (406mm) B Mantel Clearances *No Mantel Shield 33" 34" (864mm) with 5" Mantel Defle[...]

3100-I ACT WOOD INSERT Page 6 September 1, 2008 R 250-6381D A VOID FIRE: T o ensure that insulation or any other combustible material does not contact the chimney , a chimney inside the house must have at least 2 inches (51mm) of air space clearance around t he chimney . A chimney outside the house must have at least 1 inch (25mm) clearance to the [...]

Page 7 September 1, 2008 3100-I ACT WOOD INSERT R 250-638D IF INST ALLING THIS MODEL TO A MASONR Y CHIMNEY , AL W A YS BE SURE THE CHIMNEY IS IN GOOD CONDITION AND THA T IT MEETS THE MINIMUM ST ANDARDS OF THE NA TIONAL FIRE PROTECTION ASSOCIA TION (NFP A) ST ANDARD 21 1. A F ACTOR Y BUIL T CHIMNEY MUST BE 6 INCH (152mm) UL 103 HT AND ULC S629. THIS[...]

3100-I ACT WOOD INSERT Page 8 September 1, 2008 R 250-6381D Floor Ceiling Caulk Floor (second Story) Non-Combustible Firestopping Material Minimum 1 inch (25mm) clearance from exterior chimney to sheathing Firestopping 2 inch (51mm ) A chimney must be the required height above the roof or other obstruction for safety and for proper draft oper - ati[...]

Page 9 September 1, 2008 3100-I ACT WOOD INSERT R 250-638D MASONR Y FIREPLACE USING DIRECT -CONNECT METHOD Refer to: Clearances to Combustibles on page 5, Canadian Installation requirements on page 1 1, Hearth Requirements on page 5 and Zero Clearance Adjustable Support Kit on page 14. Figure 9A - Installation Into Masonry Fireplace Direct Connect [...]

3100-I ACT WOOD INSERT Page 10 September 1, 2008 R 250-6381D The following modications of factory built replaces are permissible: 1) removal of damper; 2) removal of smoke shelf or bafe; 3) removal of ember catches; 4) removal of re grate; 5) removal of viewing screen/curtain; and, 6) removal of doors. NOTE: Installation into replace[...]

Page 1 1 September 1, 2008 3100-I ACT WOOD INSERT R 250-638D INST ALLA TION IN CANADA MASONR Y and HEA T -CIRCULA TING (INST ALLA TIONS INTO F ACTORY -BUIL T FIREPLACES ARE PROHIBITED IN CANADA) Whether installed in a masonry or heat-circulating replace, this replace insert must be installed with a continuous chim- ney liner of 6” (152mm) d[...]

3100-I ACT WOOD INSERT Page 12 September 1, 2008 R 250-6381D Vi ew of "L" Bracket installed Kit Includes: ( 2) Side Panels, left & right; (1) Panel T op & Fastener package; (2) Side T rim, left & right; (1) T rim T op & Fastener package. T ools Needed: Powered Phillips head screw driver . 1. Install the 2 side panels on th[...]

Page 13 September 1, 2008 3100-I ACT WOOD INSERT R 250-638D Included in Kit: (2) Fan mounts & fan assemblies; (1) Speed Control, Power Cord/wire assembly; (1 set) Fan Connector wires, must be high temperature wire; and (1) Strain relief. T ools Needed: Large Phillips screwdriver , pliers F AN (BLOWER) INST ALLA TION INSTRUCTIONS Part No. 831-1 [...]

3100-I ACT WOOD INSERT Page 14 September 1, 2008 R 250-6381D ZERO CLEARANCE ADJUST ABLE TRIM SUPPORT , 2” to 10” Part No. 841-0990, size 9” x 45” and Part No. ADJSPT -12, size 12” x 50” Included in Kit: ( 1) T rim T op, (1) T rim Front, (2) T rim Sides, Double-Sided T ape (already installed) T ools Needed: Phillips Head Screwdriver , Sh[...]

Page 15 September 1, 2008 3100-I ACT WOOD INSERT R 250-638D WOOD SELECTION AND STORAGE Burn only dry seasoned wood. Dry , well-seasoned wood will not only minimize the chance of creosote formation but will give you the most efcient heat output. Even dry wood contains at least 15% moisture by weight and should be burned hot enough to keep the chi[...]

3100-I ACT WOOD INSERT Page 16 September 1, 2008 R 250-6381D BURN RA TES ST ARTING FIRE : Open both controls (push in) completely . After a wood load has been burning on high for 5 to 15 minutes or longer for very large pieces, close the Start-Up Air Control (right side) by pulling it out. HIGH: Leave the Primary Air Control fully open (immediately[...]

Page 17 September 1, 2008 3100-I ACT WOOD INSERT R 250-638D AIR qUALITY AND YOUR qUADRA-FIRE INSERT In recent years there has been an increasing concern about the quality of our air . Much of the blame for poor air quality has been placed on the burning of wood for home heating. In order to improve this situation we at Quadra-Fire have developed cl[...]

3100-I ACT WOOD INSERT Page 18 September 1, 2008 R 250-6381D MAINTENANCE CARE AND CLEANING OF PLA TED SURF ACES IMPORT ANT : Y ou must clean all the ngerprints and oils from the plated surfaces before ring the insert for the rst time. Use warm soapy water and a soft rag, glass cleaner and a paper towel, or vinegar and a paper towel to remo[...]

Page 19 September 1, 2008 3100-I ACT WOOD INSERT R 250-638D BAFFLE REMOV AL & INST ALLA TION NOTE : The bafe in the 3100-I ACT Insert is 2700° Fiber Board. Removing hardware exposed to combustion processes can be frustrating. If your reason for removing the bafe is simply to clean the chimney , you have alternatives which will save time [...]

3100-I ACT WOOD INSERT Page 20 September 1, 2008 R 250-6381D EXPLODED VIEW 1 9 10 11 2 4 3 8 6 7 5 Item Description Item Description 1 T rim Ring, Louver 7 Screen, Left/Right (interchange - able) 2 Manifold T ubes, Back (3) 8 Speed Control 3 Manifold T ube, Front (1) 9 Bafe, Fiberboard 4 Spring Handle, 1/4” (2) 10 Blanket, Ceramic 5 Blower Ass[...]

Page 21 September 1, 2008 3100-I ACT WOOD INSERT R 250-638D Item # Part Description Alphabetical Order SKU 9 Bafe, Fiberboard 831-1800 10 Blanket, Ceramic, 1 inch thick 832-3401 Blower Assembly , with Wire Harness 831-1 101 Blower Cord with Speed Control & Wire Harness 832-1400 5 Blower Assembly 831-1 101 Blower Replacement (1) 832-3190 1 1 [...]

3100-I ACT WOOD INSERT Page 22 September 1, 2008 R 250-6381D 1 T rim Ring for Louver, Gold 430-2691 1 T rim Ring for Louver, Nickel 430-5430 Upgrade Kit to Nickel, Door UK-DRNL 14 W asher, Spacing SAE 3/8 for Door Handle 220-0010 Item # Part Description Alphabetical Order SKU ACCESSORIES 15 16 17 18 19 20 21 22 12 13 14 Item Description Part No. 12[...]

Page 23 September 1, 2008 3100-I ACT WOOD INSERT R 250-638D Date of Service Performed By Description of Service Service And Maintenance Log[...]

3100-I ACT WOOD INSERT Page 24 September 1, 2008 R 250-6381D Date of Service Performed By Description of Service Service And Maintenance Log (Cont’d)[...]

Page 25 September 1, 2008 3100-I ACT WOOD INSERT R 250-638D Homeowner ’ s Notes[...]

3100-I ACT WOOD INSERT Page 26 September 1, 2008 R 250-6381D W arranty Policy Hearth & Home T echnologies LIMITED W ARRANTY Hearth & Home T echnologies (“HHT”) and its respective brands extends the following warranty for HHT gas, wood, pellet and electric appliances purchased from an authorized HHT dealer and installed in the United Sta[...]

Page 27 September 1, 2008 3100-I ACT WOOD INSERT R 250-638D  HHT’s obligation under this warranty does not extend to damages resulting from: (1) installation, operation or main- tenance of the appliance not in accordance with the installation instructions; operating instructions and the listing agent identication label furnished with the[...]

Page 28 September 1, 2008 250-6381D R • Do NOT discard this manual. • Important operating and maintenance instructions included. • Read, understand and follow these instruci- tons for safe installation and operation. • Leave this manual with party responsible for use and operation. CAUTION This product may be covered by one or more of the f[...]