Sanyo KHS1251 manual

INSTRUCTION MANUAL Split System Air Conditioner COOL/DRY/HEAT Model KHS0951 KHS1251 KHS1852 Save These Instructions! Pub. OI-85264180351004 © SANYO 2002 Printed on Recycled Paper[...]

Features This air conditioner is equipped with cooling, heating and drying functions. Details on these functions are provided below; refer to these descriptions when using the air conditioner . • Microprocessor Controlled Operation The interior compartment of the remote control unit contains several features to facilitate automatic operation, eas[...]

Contents Page Features .................................................................................................................. 2 Product Information .............................................................................................. 3 Alert Symbols ...............................................................................[...]

Installation Location • We recommend that this air conditioner be installed properly by qualified installation technicians in accordance with the Installation Instructions provided with the unit. • Before installation, check that the voltage of the electric supply in your home or office is the same as the voltage shown on the nameplate. • Do [...]

Names of Parts NOTE This illustration is based on the external appearance of a standard model. Consequently, the shape may differ from that of the air conditioner which you have selected. This air conditioner consists of an indoor unit and an outdoor unit. Y ou can control the air conditioner with the remote control unit. Air Intakes Air from the r[...]

Unit Display and Operation Selector Remote control receiver This section picks up infrared signals from the remote control unit (transmitter). Operation selector ON position This position is for operating the air conditioner with the wireless remote control unit. Set the selector normally in this position. OFF position Switch the selector to the OF[...]

24-hour clock with ON/OFF 24-hour OFF T imer ................. 1-hour OFF T imer ................... Remote Control Unit (Display) (1) Operation mode AUTO ....................................... HEA T ........................................ MILD DRY................................ COOL ....................................... (2) Fan speed AUTO ...[...]

8 OI-3 51 - 0 8 E G Remot e Contr ol Unit Sensor T ransmit ter Display NIGHT SETBA CK button 1 HR. TIMER butt on MODE select or butt on FLAP but ton ADDRESS switch (Cov er closed) ON/OFF operation but t on T emperatur e setting but tons F AN SPEED selector but ton TIMER SELECT but ton TIMER AND PRESENT TIME set ting butt ons PROGRAM but ton A CL bu[...]

9 OI-351-9E G Remote Contr ol Unit (continued) Progr am butt on For details, see “Setting the Timer” . Press this but ton to select the mode you want to program. TIMER SELECT but ton No display : The timer does not operate. : The air conditioner stops at the set time. : The air conditioner starts at the set time. : The air conditioner stops and[...]

Using the Remote Control Unit How to Install Batteries NOTE • The batteries last about six months, depending on how much you use the remote control unit. Replace the batteries when the remote control unit ' s display fails to indicate, or when the remote control cannot be used to change the air conditioner ’ s settings. • Use two fresh l[...]

11 OI-351-1 1EG Using the Remote Contr ol Unit (continued) Mounting the Remote Contr ol Unit When at tac hing to wall 1 ) Confirm the indoor unit beeps when the ON/OFF but ton is pressed at the w all location where the remote control unit is to be attac hed, then at tac h the holder to the w all. 2) When taking out the remote control unit, pull it [...]

Operation with the Remote Control Unit 1. Automatic Operation NOTE Check that the circuit breaker on the power panel is turned on and that the operation selector of the indoor unit is in the ON position. Once the mode is selected and the unit is preset by following the steps below , you can have the air conditioner automatically bring the room to t[...]

Operation with the Remote Control Unit (continued) Press TEMP . to change the temperature setting. • Although the fan speed is set automatically , you can change the fan speed by pressing the F AN SPEED selector button. T o stop the air conditioner , press the ON/OFF operation button again. Press the upper TEMP. button to raise the temperature se[...]

Operation with the Remote Control Unit (continued) 2. Manual Operation NOTE Check that the circuit breaker on the power panel is turned on and that the operation selector of the indoor unit is in the ON position. If the automatic operation settings of the unit do not meet your needs, press the setting buttons as described below and change the setti[...]

Operation with the Remote Control Unit (continued) NOTE • This appliance has a built-in 3-minute time delay circuit to ensure reliable operation. When the operation button is pressed, the compressor will start running within three minutes. In the event of power failure, the unit will stop. When the power is restored, the unit will restart automat[...]

Operation with the Remote Control Unit (continued) 4. Night Setback Mode The Night Setback Mode is used for saving energy . Press the NIGHT SETBACK button while the air conditioner is operating. The mark appears in the display . T o cancel the night setback function, press the NIGHT SETBACK button again. 16 OI-351-16EG oi202000[...]

Operation with the Remote Control Unit (continued) 17 OI-351-17EG oi202000 A. In Cooling and DRY Mode: ( and ) When the night setback mode is selected, the air conditioner automatically raises the temperature setting 2 ° F when 30 minutes have passed after the selection was made, and then another 2 ° F after another 30 minutes have passed, regard[...]

Special Remarks ` `DR Y'' ( ) Operation How it works? • Once the room temperature reaches the level that was set, the unit repeats the cycle of turning on and off automatically . • During DRY operation, the fan speed is automatically set to LOW or VERY LOW ; the fan speed then switches back and forth between LOW (for 20 seconds) and V[...]

19 OI-351-1 9EG S et ting the T imer 1 . Ho w to set the pr esent time (Example) T o set to 9:1 0 pm. Operation Indication 1 . Press the P rogram but ton ( ) three times. 2. • Press the HH but ton until PM 9 is displayed. • Press the MM but ton until 1 0 is displayed. The time indication alone blinks. The display will automatically stop blinkin[...]

20 OI-351-20E G Set ting the Timer (continued) 3 . Ho w to set the ON time (Example) T o start operation at 7:1 0 am. Operation Indication 1 . Press the P rogram but ton ( ) twice. 2. • Press the HH but ton until AM 7 is displayed. • Press the MM but ton until 1 0 is displayed. 3. Press the ON/OFF but ton to star t the air conditioner . 4. Pres[...]

21 OI- 351 -21 E G S et ting the 1 -Hour OFF T imer 1 . 1 -Hour OFF Timer This function causes the unit to oper ate f or one hour and then st op, r egardless of whether the unit is on or off when this but t on is pr essed. The indicator in the display indicates that this function is operating. Setting pr ocedur e: Reg ardless of whether the unit is[...]

22 OI- 351 -22 E G Adjusting the Airflow Direction 1 . Hor iz ontal The horizontal airflow can be adjusted by mo ving the vertical vanes with your hands to the lef t or right. CA UTION When the humidity is high, the ver tical v anes should be in the fr ont position dur ing the cooling or dehumidifying oper ation. If the v ertical v anes ar e positi[...]

23 OI- 351 -23 E G Operation without the R emote Control Unit If you have lost the remote control unit or it has trouble, follow the steps below . 1. When the air conditioner is not running If you want to turn on the air conditioner , switc h the operation selector to the OFF position, and then to the ON position. NO TE The set temperature and fan [...]

24 OI- 351 -24 E G 1. With the ˝FRON T˝ mark facing you, slide the anti-mold filter up into the unit and then lower the handle into the groove on the unit. 2. After installing the anti-mold filter , press the locations marked by the arrows ( ) and close the air intake grille. Car e and Cleaning (continued) Anti-mold filter The anti-mold filter be[...]

25 OI- 351 -25 E G Car e and Cleaning (continued) Air cleaning filter (not pr ovided) The air cleaning filter removes dust and dir t from the air , and reduces odor s and smoke from tobacco. NO TE KHS0951/KHS1251 The air cleaning filter is not provided with the air conditioner and must be purc hased separately . The first time that you buy the air [...]

26 OI- 351 -26 E G Car e and Cleaning (continued) Removing and r emounting the air intak e gr ille • With the air intake grille open all the way , grip both arms with your hands and pull toward you to remove. T o remount, hold the air intak e grille roughly horizontal and push it in until the arm shaf ts fit into the indentations in the main unit[...]

27 OI- 351 -27 E G T roubleshooting If your air conditioner does not work properly , fir st c hec k the following points before requesting service. If it still does not work properly , contact your dealer or service center . T rouble P ossible Cause Remedy Air conditioner does not run at all. 1 . Power failure. 2. Leak age circuit breaker tripped. [...]

oi330000 oi202000 SANYO FISHER COMPANY A DIVISION OF SANYO NORTH AMERICA CORPORATION 21605 Plummer Street Chatsworth, CA 91311 U.S.A. In Canada SANYO Canada Inc. 300 Applewood Crescent, Concord Ontario, L4K 5C7, Canada[...]