Sanyo XHS3632 manual

INSTRUCTION MANUAL Split System Heat Pump W all-mounted type Ceiling-mounted type Recessed type KHS2432 THS2432 XHS2432 KHS3632 THS3632 XHS3632 THS4232 XHS4232 Save This Instruction Manual Pub . OI-8546418921200 2 ©SANY O 2003[...]

Features These air conditioners are equipped with a cooling function. Details on this function are provided below; refer to these descriptions when using the air conditioner . • Microprocessor Controlled Operation The interior compartment of the remote control unit contains several features to facilitate automatic operation, and is logically disp[...]

Contents Page Features .................................................................................................................. 2 Product Information .............................................................................................. 3 W arning Symbols ............................................................................[...]

Installation Location • We recommend that this air conditioner be installed properly by qualified installation technicians in accordance with the Installation Instructions provided with the unit. • Before installation, check that the voltage of the electric supply in your home or office is the same as the voltage shown on the nameplate. • Do [...]

Names of Parts Each air conditioner shown below consists of an indoor unit and an outdoor unit. Y ou can control the air conditioner with the remote control unit. NOTE This illustration is based on the external view of a standard model. Consequently , the shape may differ from that of the air conditioner which you have selected. Air intake The retu[...]

Unit Display and Operation Selector 1. TEST RUN 2. PCB CHK(ON) 3. RCU MAIN (OFF) 4. (OFF) ADDRESS OPERA TION lamp TIMER lamp Remote control receiver Recessed type Ceiling-mounted type Air filter Recessed type Air intake grille Operation selector Ceiling-mounted type Air intake grille Finger -hold Operation selector 1. TEST RUN 2. PCB CHK(ON) 3. RCU[...]

Unit Display and Operation Selector (continued) REMOTE CONTROL receiver This section picks up infrared signals from the remote control unit (transmitter). Operation selector ON position This position is for operating the air conditioner with the wireless remote control unit. The selector should normally be set in this position. OFF position Switch [...]

Remote Control Unit (Display) (1) Operation mode AUTO ....................................... COOLING................................. HEA TING ................................. F AN .......................................... (2) Fan speed Automatic operation .............. HIGH ........................................ MEDIUM ......................[...]

9 OI-212-09E G Remote Contr ol Unit Sensor T r ansmitter Display NIGHT SETBACK but ton 1 HR. TIMER but t on MODE selector but ton FLAP butt on ADDRESS switch (Cov er closed) ON/OFF operation but ton T emper ature set ting butt ons F AN SPEED selector but ton TIMER SELECT butt on TIMER AND PRESENT TIME setting but tons PROGRAM but ton ACL but ton SE[...]

10 OI-212-1 0EG Remot e Contr ol Unit (continued) Pr ogram but ton For details, see “Set ting the Timer” . Press this but ton to select the mode you w ant to program. TIMER SELECT but ton No display : The timer does not operate. : The air conditioner stops at the set time. : The air conditioner starts at the set time. : The air conditioner stop[...]

11 OI-212-1 1EG Using the R emote Control Unit How t o Install Batt er ies 1. Slide the cover in the direction indicated by the ar row and remove it. 2. Install two AAA alkaline batteries. Make sure the batteries point in the direction marked in the bat tery compartment. 3. Use a thin object suc h as the tip of a pen to press the A CL button. NO TE[...]

12 OI-212-12E G Using the Remot e Contr ol Unit (continued) Mounting the Remote Contr ol Unit When at taching t o wall 1) Confirm the indoor unit beeps when the ON/OFF but ton is pressed at the wall location where the remote control unit is to be at tac hed, then attac h the holder to the w all. 2) When taking out the remote control unit, pull it f[...]

Operation with the Remote Control Unit 1. Automatic Operation NOTE Check that the circuit breaker on the power panel is turned on and that the operation selector of the indoor unit is in the ON position. When Automatic operation mode is selected and the unit is set using the steps below , the air conditioner operates automatically and brings the ro[...]

Operation with the Remote Control Unit (continued) 2. Manual Operation NOTE Check that the circuit breaker on the power panel is turned on and that the operation selector of the indoor unit is in the ON position. If the automatic operation settings of the unit are not satisfactory , press the setting buttons below to change the settings as desired.[...]

Operation with the Remote Control Unit (continued) NOTE • Choose the best position in the room for the remote control unit, which also acts as the sensor for room comfort and transmits the operating instructions. Once you’ve found this best position, always keep the remote control unit there. • This appliance has a built-in 3-minute time dela[...]

Operation with the Remote Control Unit (continued) 4. Fan Only If you want to circulate air without any temperature control, follow these steps: STEP 1: Press the MODE selector button to switch to the fan mode. ( ) STEP 2: Press the ON/OFF button. STEP 3: Press the F AN SPEED selector button to select the fan speed of your choice ( , ,o r ). 5. Nig[...]

Operation with the Remote Control Unit (continued) A. Cooling Mode: ( ) B. Heating Mode: ( ) When the night setback mode is selected, the air conditioner automatically raises the temperature setting 2 °F when 30 minutes have passed after the selection was made, and then another 2 °F after another 30 minutes have passed, regardless of the indoor t[...]

18 OI-212-18E G 2 . Ho w to set the OFF time (Example) T o stop the air conditioner at 1 1:30 pm. 1 . Press the P rogram but ton ( ) once. 2. • Press the HH but ton until PM 1 1 is displayed. • Press the MM but ton until 30 is displayed. 3. Press the ON/OFF but ton to star t the air conditioner . 4. Press the TIMER SELECT button to set OFF time[...]

19 OI-212-1 9E G Set ting the Timer (continued) 3 . Ho w to set the ON time (Example) T o start operation at 7:1 0 am. Operation Indication 1 . Press the P rogram but ton ( ) twice. 2. • Press the HH but ton until AM 7 is displayed. • Press the MM but ton until 1 0 is displayed. 3. Press the ON/OFF but ton to star t the air conditioner . 4. Pre[...]

20 OI-212-20E G Using the 1 -Hour OFF T imer 1 . 1 -Hour OFF Timer This function causes the unit t o operat e for one hour and then st op, r eg ardless of whether the unit is on or of f when this butt on is pr essed. The indicator in the display indicates that this function is operating. Set ting procedur e: Reg ardless of whether the unit is opera[...]

Adjusting the Airflow Direction A. Horizontal (Wall-mounted type only) The horizontal airflow can be adjusted by moving the vertical vane to the left or right. B. V ertical Confirm that the remote control unit has been turned on. Press the FLAP button to start the flap moving up and down ( ). If you want to stop the flap movement and to direct the [...]

Care and Cleaning 1. For safety , be sure to turn the air conditioner off and also to disconnect the power before cleaning. 2. Do not pour water or spray detergent on the indoor unit to clean it. This will damage the internal components and may cause an electric shock or fire. Air Intake and outlet side (Indoor Unit) Clean the air intake and outlet[...]

Care and Cleaning (continued) How to remove the filter Ceiling-mounted type: 1. Remove the bolt screws on the latch using a screwdriver . (After cleaning, be sure to reattach the two bolt screws.) 2. T ake hold of the two latches on the air intake grille and press them to the rear , and the grille will open downward. 3. T ake hold of the finger -ho[...]

T roubleshooting If your air conditioner does not work properly , first check the following points before requesting service. If it still does not work properly , contact your dealer or service center . T rouble Possible Cause Remedy Air conditioner does not run at all. 1. Power failure. 1. Restore power . 2. Leakage breaker tripped. 2. Contact ser[...]

SANYO FISHER COMP ANY A DIVISION OF SANYO NORTH AMERICA CORPORA TION 21605 Plummer Street Chatsworth, CA 91311 U.S.A. In Canada SANYO Canada Inc. oi212001 300 Applewood Crescent, Concord, Ontar io, L4K 5C7 , Canada[...]