Tyco 3000 manual

T ouchmonitor User Guide 1939L 19¨ LCD Rear-mount Touchmonitor 3000 Series Revision A[...]

User Guide 19 " LCD REAR-MOUNT TOUCHMONITOR 1939L Fa mily 3000 Serie s Revision A P/N E851250[...]

Copyright © 2006 T yco Electronics Corporation. All Rights Reserved. No part of this publication may be reproduced, tra nsmitted, tra nscribed, stored in a retrieval system, or tra nslated into a ny la nguage or computer la nguage, in a ny f orm or by a ny mea ns, including, but not li mited to, electronic, magnetic, optical, che mical, ma nual, o[...]

T able of Contents Chapter 1 Regulatory Information 33 Introduction 7 Warranty 37 Product Description ................................................... 7 Precautions ................................................................ 7 Index 39 About the Product ...................................................... 8 Chapter 2 Installation and Setu[...]

C H A P T E R 1 I NTRODUCTION Product De scription Y our new touchmonitor combines the reli a ble performa nce of touch technology with the latest a dva nces in (LCD) display de sign. This combination of f eatures create s a natural flow of informa- tion between a user a nd your touchmonitor . This LCD monitor incorporates a 19” color a ctive mat[...]

About the Product Y our LCD rear -mount touchmonitor is a 19” SXGA TFT color display with the f ollowing f eatures: • The internal microprocessor digitally controls auto-sca nning for horizontal sca n frequencies between 31.5 KHz a nd 80 KHz, a nd vertical sca n frequencies between 56.3 Hz a nd 75.0 Hz. In ea ch frequency mode, the microprocess[...]

C H A P T E R 2 I NST ALLA TION AND S ETUP This cha pter discusses how to install your LCD touchmonitor a nd how to install the driver software. U n pa cking Y our T ouchmonitor Check that the following 9 ite ms are present a nd in good condition: LCD monitor V ideo ca ble USB ca ble Serial ca ble Europea n power ca ble Power ca ble US/Ca na da T o[...]

T ouch Interf a ce Connection Note: Before connecting the cables to your touchmonitor and PC, be sure that the computer and touchmonitor are turned off. 1. Connect one end of the power a da pter to the monitor a nd the other end to the connector of the power cord. 2. Connect one end of either the touchscr een seri al (RS232) ca bl e or the touchscr[...]

Product Overview Main Unit Re ar View 2-1 1[...]

In stalling the Driver Software Elo T ouchSystems provide s driver software that allows your touchmonitor to work with your computer . Drivers are located on the enclosed CD-ROM f or the f ollowing operating syste ms: • W indows XP • W indows 2000 • W indows Me • W indows 98 • W indows 95 • W indows NT 4.0 The latest versions of drivers[...]

In stalling the Serial T ouch Driver In stalling the Serial T ouch Driver f or Windows XP , Windows 2000, Me, 95/98 a nd NT 4.0 NOTE: For Windows 2000 and NT 4.0 you must have administrator access rights to install the driver. 1 Insert the Elo CD-ROM in your computer's CD-ROM drive. 2 If the AutoStart feature for your CD-ROM drive is a ctive, [...]

In stalling the Serial T ouch Driver for MS-DOS a nd Windows 3.1 Y ou must have a DOS mouse driver (MOUSE.COM) installed f or your mouse if you wish to continue using your mouse along with your touchmonitor in DOS. T o install W indows 3.x a nd MS-DOS from W indows 95/98, f ollow the directions below: 1 Insert the CD-ROM in your computer’s CD-ROM[...]

In stalling the USB T ouch Driver Installing the USB Touch Driver for Windows XP, Windows 2000, Me, 95/98 and NT 4.0 1 Insert the Elo CD-ROM in your computer’s CD-ROM drive. If W indows 98, W indows Me or W indows 2000 starts the Add New Hardware W izard. 2 Choose Next . Select “Search f or the best driver f or your device (Recommended)” a nd[...]

2-16 User Guide[...]

C H A P T E R 3 O PERA TION About T ouchmonitor Adjustments Y our touchmonitor will not likely require a djustment. V ari ations in video output a nd a pplication may require a djustments to your touchmonitor to optimize the quality of the display . For best perf orma nce, your touchmonitor should be operating in native resolution, that is 1280 x 1[...]

Re ar Pa nel Controls Control Function 1 Menu/Exit Display/exits the On Screen Display (OSD) menus. 2 1. Enter contra st of the OSD. 2. Increa se value of the a djustment item. 3. Select item counter-clockwise. 3 1. Enter brightness a djustment. 2. Decrea se value of the a djustment item. 3. Select item clockwise. 4 Select Selects the a djustment i[...]

Controls a nd Adjustment On Screen Display (OSD) Menu Function s T o Display a nd Select the OSD Functions: 1 Press the Menu key to a ctivate the OSD menu. 2 Use or to move through the menu. Press the Select key , the para meter will be highlighted when selected. 3 T o quit the OSD screen at a ny time during the operation, press the Menu key . If n[...]

On Screen Display (OSD) Control Options Control Descri ption Contra st Increases or decrea ses contra st. Brightness Increa ses or decrea se s brightness. V -Position Moves the screen up or down. H-Position Moves the screen left or right. Recall Defaults Returns the monitor to its default settings. RG B Press or to select 9300, 6500, 5500, 7500 a n[...]

Pre set Modes T o reduce the need for a djustment for dif ferent modes, the monitor ha s default setting modes that are most commonly used a s given in the ta ble below . If a ny of these display modes are detected, the monitor automatically a djusts the picture size a nd centering. When no mode is matched, the user ca n store their pref erred mode[...]

Power M a n agement Syste m The monitor is equi pped with the power ma nagement function which automatically reduces the power consumption when not in use. Power Mode Consumption O n <50W Sleep <4W Off <2W W e recommend switching the monitor off when it is not in use f or a long ti me. NOTE: The monitor automatically goes through the Power[...]

C H A P T E R 4 T ROUBLESHOOTING If you are experiencing trouble with your touchmonitor , refer to the f ollowing ta ble. If the proble m persists, plea se conta ct your local dealer or our service center . Solution s to Common Proble ms Problem Suggestion(s) The monitor does not respond Check that the monitor’s Power Switch is on. after you turn[...]

4-24 User Guide[...]

A P P E N D I X A N A TIVE R ESOLUTION The native resolution of a monitor is the resolution level at which the LCD pa nel is designed to perform best. For the LCD touchmonitor, the native resolution is 1280 x 1024 for the 17 inch size. In almost all ca ses, screen i mages look be st when viewed at the ir native resolution. Y ou ca n lower the resol[...]

As a n exa mple, a SXGA resolution LCD pa nel ha s 1280 pixels horizontally by 1024 pixels vertically . Input video is also represented by the sa me terms. SXGA input video has a f ormat of 1280 pixels horizontally by 1024 pixels vertically. When the input pixels contained in the video input format match the native resolution of the pa nel, there i[...]

A P P E N D I X B T OUCHMONITOR S AFETY This ma nual contains information that is i mporta nt for the proper setup a nd maintena nce of your touchmonitor . Bef ore setting up a nd powering on your new touchmonitor , rea d through this ma nual, especi ally Cha pter 2 (Installation), a nd Cha pter 3 (Operation). 1 T o reduce the risk of electric shoc[...]

Care a nd Ha ndling of Y our T ouchmonitor The f ollowing tips will help kee p your touchmonitor functioning at the opti mal level. • T o avoid risk of electric shock, do not disasse mble the brick supply or display unit ca binet. The unit is not user servicea ble. Re me mber to unplug the display unit from the power outlet bef ore clea ning. •[...]

A P P E N D I X C T ECHNICAL S PECIFICA TIONS C-29[...]

T ouchmonitor Specification s Model 1939L LCD Display 19” TFT Active Matrix Pa nel Display Size 376(H) x 301(V) mm Pixel Pitch 0.294(H) x 0.294(V) mm Display Mode V GA 640 x 350 (70Hz) V GA 720 x 400 (70Hz) V GA 640 x 480 (60 / 72/ 75Hz) SV GA 800 x 600 (56 / 60 / 72/ 75Hz) XGA 1024 x 768 (60 / 70 / 75Hz) SXGA 1280 x 1024 (60 / 70 / 75Hz) Max. Re[...]

C-31 19” LCD T ouchmonitor (ET1939L-XCW A-X-G) Dimensions[...]

C-32 User Guide[...]

R EGULA TO R Y I NFORMA TION I. Electrical Safety Information: A) Compli a nce is required with respect to the voltage, frequency , a nd current requirements indicated on the ma nufacturer’s la bel. Connection to a different power source tha n those specified here in will likely result in i mproper operation, da mage to the equi pment or pose a f[...]

This Information T echnology Equi pment (ITE) is required to have a CE Mark on the ma nufacturer’s la bel which mea ns that the equi pment ha s been tested to the f ollowing Directives a nd Sta ndards: This equi pment has been tested to the require ments f or the CE M ark a s required by EMC Directive 89/336/EEC indicated in Europea n Sta ndard E[...]

35 TYPE APPROVED MPR II[...]

36 User Guide[...]

W ARRANTY Except a s otherwise stated herein or in a n order a cknowledgment delivered to Buyer , Seller warra nts to Buyer that the Product shall be free of defects in materi als a nd workma nship. The warra nty f or the touchmonitors a nd components of the product is regional; plea se conta ct your regional of fice. Seller makes no warra nty rega[...]

THESE REMEDIES SHALL BE THE BUYER’S EXCLUSIVE REMEDIES FOR BREACH OF W ARRANTY . EXCEPT FOR THE EXPRESS W ARRANTY SET FOR TH ABOVE, SELLER G RANTS NO OTHER W ARRANTIES, EXPRESS OR IMPLIED BY ST A TUTE OR OTHER WISE, REGAR D- ING THE PRODUCTS, THEIR FIT NESS FOR ANY PURPOSE, THEIR QUALITY , THEIR MERCHANT ABILITY , THEIR NONINFRINGEMENT , OR OTHER[...]

Numerics 19" LCD Touchmonitor (ET1939L-XCWA-X-G) Dimensions, 32 A About the Product, 8 About Touchmonitor Adjustments, 17 B Brightness, 30 C Care and Handling of Your Touchmonitor, 28 Certifications, 30 Cleaning Your Touchmonitor, 28 Contrast Ratio, 30 Controls and Adjustment, 19 D Dimensions (HxWxD), 30 Display Color, 30 Display Mode, 30 Disp[...]

S Signal Connector, 30 Solutions to Common Problems, 23 Storage Conditions, 30 SVGA, 25 SXGA, 25 T Technical Specifications, 29 Touch Interface Connection, 11 Touch not working, 23 Touch Panel (optional), 30 Touchmonitor Safety, 27 Touchmonitor Specifications, 30 Troubleshooting, 23 U Unpacking Your Touchmonitor, 9 UXGA, 25 V VGA, 25 Viewing Angle,[...]

[...]

Check out Elo’s Web site! www.elotouch.com Get the latest... • Product information • Specifications • News on upcoming events • Press releases • Software drivers Getting in T ouch with Elo To find out more about Elo’s extensive range of touch solutions, visit our Web site at www.elotouch.com or simply call the office nearest you: USA [...]