Zanussi ZQS 6140 manual

REFRIGERA TOR ZQS 6140 INSTRUCTION BOOKLET 2222 683-27[...]

2 It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transf erred to another owner , or should you mo ve house and leave the appliance, alwa ys ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the ap[...]

3 At the end of the Appliance Life • When disposing of your appliance, use an authorised disposal site. • Remov e the plug and ensure that any locks or catches are remov ed, to prevent y oung children being trapped inside. Disposal of old Appliances The symbol on the product or on its packaging indicates that this product may not be treated as [...]

Operation 4 Fresh food refrigeration T o obtain the best performance, do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour . Do not cover the shelves with any protective material, such as paper , cardboard or plastic, which may obstruct the air circulation through them[...]

The door shelves T o permit storage of food packages of various sizes the half tray can be adjusted in horizontal. T o do this proceed as figure. For more thorough cleaning, the top door shelf and the bottle shelf can be removed by pulling them in the director of the arrows, then refitting them in position. Normal Operating Sounds Y ou may hear fai[...]

6 Defrosting The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located below the appliance, where it evaporates. Important T o avoid defrost water overflowing and dripping onto the food in the fridge, periodically clean the water discharge hole (F) situated under the salad dr[...]

7 When the appliance is not in use When the appliance is not in use for long periods, disconnect from the electricity supply , empty all foods and clean the appliance, leaving the door ajar to prevent unpleasant smells. Something not W orking? Before contacting your local Service Force Centre check the following points. IMPORT ANT : If you call out[...]

8 Service and Sp are Parts In the event of your appliance requiring service, or if you wish to purchase spare part s, please contact your local Service Force Centre by telephoning:- 08705 929929 Y our telephone call will be automatically routed to the Service Force Centre covering your post code area. For the address of your local Service Force Cen[...]

9 Guarantee Conditions Standard guarantee conditions We , Zanussi, under take that if within 12 months of the date of the purchase this Zan ussi appliance or any par t thereof is prov ed to be defective b y reason only of faulty w or kmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour , materials or ca[...]

Positioning The appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located on the inside right of the appliance. The following table shows which ambient temperature is correct for each climate classification. SN +10°C to +32°C ST +18°C t[...]

11 Door reversal T o reverse the opening direction of the door , proceed as shown in the figures: Attention After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitt[...]

12 If you fit your own plug, the colours of the wires in the mains lead of your appliance, may not correspond with the markings identifying the terminals in your plug, proceed as follows: Connect the Green and the Y ellow (earth) wire to the terminal in the plug which is marked with the letter «E» or the earth symbol , or coloured green and yello[...]

13 Building-in instructions Before carrying out any work, remove the plug from the power socket. Grid prep aration Left door opening: Remove the left side (A) of the grid cutting it from the rear (see figure). Right door opening: Remove the right side (B) of the grid cutting it from the rear (see figure). T o position the grid on the appliance proc[...]

14 B 4 1 5. Screw appliance into place and retain the cabinet with screws (I) through the securing brackets into the worktop or adjacent woodwork as necessary . 4. The joint cover (B) is to be assembled after having installed the appliance in the recess. 2. Push the appliance into place. The plug socket necessary for connection of the appliance to [...]

15 7 ab c C click click 8 b = = 9 I c Möbeltür Innenseite a Upper part of kitchen furniture panel I 27,5 cm 27,5 cm 55 cm 10 F 1 2 3 45 ° 11 = = 10 12 1 2[...]

Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. • For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=890 mm and a plinth height dimensi[...]

[...]

[...]

[...]

© Electrolux plc 2008 www .electrolux.com www .zanussi-electrolux.co .uk[...]