Zanussi ZU 9100 F manual

FREEZER ZU 9100 F 2222740-41 INSTRUCTION BOOKLET[...]

2 Instructions for the User Important Safety Instructions 3 Description of the Appliance 4 Operation 4 Before use 4 Freezer controls 4 Starting your appliance 5 T emperature control 5 W arning light (red) 5 T emperature acoustic alarm 5 Open door acoustic alarm 5 Freezing fresh food 5 Frozen food storage 5 Internal thermometer 6 Thawing 6 Ice makin[...]

IMPORT ANT SAFETY INSTRUCTIONS These warnings are provided in the interests of your safety . Ensure that you understand them all before installing or using this appliance. Y our safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Departement. Prior to Installation ■ Check the [...]

1 2 3 4 5 6 DESCRIPTION OF THE APPLIANCE 4 OPERA TION Freezer controls Before use Remove all securing tapes. W ash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or deter- gent as the smell may linger . Dry thoroughly . ➀ Freezer calendar ➁ Freezer control ➂ Compartment for froze[...]

Starting your appliance Insert the plug into the wall socket. The appliance can be activated/deactivated by pressing the ON/OFF button.When the pilot light ➂ is illuminated this shows that the appliance is on. T emperature control The temperature within the freezer is controlled by the thermostat ➀ situated at the bottom of the cabi- net . T o [...]

Internal thermometer This indicates the internal temperature of the freez- er . It may indicate a temperature above -18°C when large quantities of food are placed inside for freezing or when the door is left open for a long time. Thawing Frozen food, prior to being used, can be thawed in the fridge or at room temperature depending on the time avai[...]

The freezer compartment will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thick- ness of the frost exceeds 1/4". During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. However , when the ice becomes very thick on the inner [...]

Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELEC- TRICITY supply . W arning This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians. Internal cleaning Clean the inside and accessories with warm water and bicarbonate[...]

9 If after the above checks, there is still a fault, call your local Service Force Centre. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. Please note that proof of purchase is required for any in-guarantee service calls. Symptom S[...]

10 SER VICE AND SP ARE P ARTS In the event of your appliance requiring service, or if you wish to purchase spare parts please contact your local Zanussi Service Force Centre by telephoning: 0870 5 929929 Y our call will be automatically routed to the Service Force Centre covering your post code area. The address of your local Service Force Centre i[...]

11 Standard guarantee conditions We, Zanussi, undertake that if within 24 months of the date of purchase this Zanussi appliance or any part there- of is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour , materials or carriage on condition that: ■ [...]

DIMENSIONS Height 81,5 cm Width 59,6 cm Depth 53,8 cm POWER SUPPL Y VOL T AGE AND FREQUENCY 220-240 V / 50 Hz TOT AL POWER ABSORBED 90 W A VERAGE DAIL Y UNITS ELECTRICITY (*) 0,75 kWh GROSS CAP ACITY 108 l NET CAP ACITY 100 l ST AR RA TING (*) This figure is based on standard test results in accordance with European Standard EN153. Actual con- sump[...]

ELECTRICAL CONNECTION W ARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. If the plug that is fitted to your appliance is not suit- able for your socket outlet, it must be cut off and the appropriate plug fitted. Remove the fuse from the cut off plug. The cut off plug should [...]

14 BUILDING-IN INSTRUCTIONS Before carrying out any work, remove the plug from the power socket. Door Reversal Left door opening: 1. Remove the grid from the appliance pulling it towards you with hands. 2. Remove the left side (A) of the grid cutting it from the rear (see figure). T o reposition the grid on the appliance proceed as fol- lows: Apply[...]

15 T o reverse the opening direction of the door , proceed as shown in the figures: Attention After completion of the door reversing opera- tion, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fit- ting of the[...]

16 Building the appliance in under a worktop The dimensions of the recessed installation area must correspond with those indicated in the figure. Remove covering and adjusting strips. Push the appliance into place. The plug socket neces- sary for connection of the appliance to the electricity supply should be positioned, so that the plug is not pla[...]

17 T o mount the furniture door proceed as shown in the figures:[...]

Screw appliance into place. Refit the covering strip. 18[...]

Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. ■ For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=870 mm and a plinth height dimensi[...]

© Electrolux Household Appliances Limited 2000[...]