Belling CH77TC manuel d'utilisation

Part No 083316700 Date 15/07/2013 Belling 77cm Hob T ouch UK Users Guide & Installation Handbook[...]

CONTENTS & INTRODUCTION CONTENTS • SAFET Y • USING THE PRODUCT • CLEANING • INST ALL A TION INSTRUCTIONS • TECHNICAL DA T A • CUSTOMER CARE INTRODUCTION Thank you for buying this British- built appliance from us. This guide book is designed to help you through each step of owning your new appliance, from installati[...]

SAFETY 5.162 BEFORE USING THE PRODUCT Make sure that you ha ve removed all packaging and wrapping. Some of the items inside this appliance may have additional wrapping. GENERAL WARNING! - The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating elements. Children less than 8 years of age shall be [...]

SAFETY 5.162 during use, as this will seriously affect the safet y and performance, particularly in relation to surface temper atures becoming hot and gas oper ated parts not workingefciently .The coolingfan(ift ted)is designed to run on after the control knob has been switched off . WARNING! - Do not spr ay aerosols i[...]

SAFETY 5.162 electrical switch. Contact your local gas supplier immediately . ELECTRIC INDUCTION HOB WARNING:- Unattended cooking on a hob can be dangerous andmayresultinr e. NEVER try to extinguish arewithwater ,but switch off the appliance andthencoverame e.g. with a lid or a damp cloth. Danger?[...]

SAFETY 5.162 fail-saf e. The pacemaker must be designed in compliance with the appropriate regulations. Caution: This appliance is for cooking purposes only . It must not be used for other purposes, f or example room heating. Caution: The use of a gas cooking appliance results in the production of heat, moisture and products of combustion in the ro[...]

SAFETY 5.162 the hob when you’re not around - take them of f the cook zone if you have to lea ve the kitchen even if you think it will only be for a moment, while you answer the door or phone. If you use a griddle plate ensure it is completely cool before at tempting to lift it from the hob as residual heat may cause burns, Alwa ys use oven glove[...]

SAFETY 5.162 This hob is not intended to be opertated by means of a external timer or seperate remote control system. Fire Safety Advice Mostkitchenresoccurwhenpeopleare distracted or leav e things unattended, so remember: If you’re called awa y from the cooker - by the phone or someone at the door , either take pans off t[...]

USING THE HOB - ELECTRIC (CERAMIC) T ouch at one point to “jump” to a specic setting or slide your nger along the select or ON/OFF KEY KEYLOCK 5 4 1 2 POWER LEVEL/COOK ZONE DISPLA Y 3 COOK Z ONE KEYS (1 - 4) POWER LEVEL ADJUST SLIDER (+ / -) 6 DUAL C OOK ZONE KEY 7 TIMER KEY 8 TIMER ADJUST KEYS 9 PA USE KEY 10 DUAL Z ONE OPERA TION KE Y T[...]

Whenpowerisrstswitchedonthehob will always start up with the K ey Lock activated. Key Lock A Red Led indicates when the k ey lock is active, to deactivate/activ ate, touch the K ey Lock key for 1 second. The key lock is deactiv ated when the Red LED switches off . If any of the cook zones are ON, the k ey lock function lo[...]

USING THE HOB - ELECTRIC (CERAMIC) To operate the dual cook zone • Select the appropriate cook zone and set the power level as per the single zone • Whilsttheheaterdisplayisstillash - ing press the central dual z one key , a red LED will illuminate next to the cook zone to indicate it has been activated. • The po[...]

USING THE HOB - ELECTRIC (CERAMIC) Timer (All Cook Zones) All 5 cooking zones can be operated under the timer independently and at the same time for up to 99 minutes. When the set time expires the timer will beep and the cook zone will switch off automatically . To Set The Timer To A Cook Zone 1, Set the desired power level to the cook zone. 2, Whi[...]

ERROR CODES Radiant Heater errors Event that generates the error (Visualization Priority Order) Description Heater Display (fore 0.5 sec./ back 0.5 sec) Effect in the appliance Normal status recovery Microcontroller fault Microcontroller Internal Erro r ‘F0’ App. off ------- Communication fault Communication Error ‘F5’ Heaters Off When the [...]

CLEANING ELECTRIC HOB Ceramic glass hobs • It is recommended that you clean and wash the hob surface bef ore usingforthersttime.Applyathin coat of ceramic hob cleaner to the hob to help maintain and protect it. • The ceramic hob top can be cleaned using a clean, damp cloth or kitchen paper . Do not use a used di[...]

INSTALLATION between hob base and appliance must be maintained. Installation above an oven Refer to the manuf acturer’s instructions for clearances abo ve the oven. W e recommend a 25mm gap between the bottom of the hob and appliance. Installation above a unit with a drawer or door The base of the appliance must be pro- tected from damage e.g. dr[...]

INSTALLATION Clearances and dimension – require- ments No shelf or overhang of combustible material should be closer than 650mm above the hob. There must be a minimum clearance of 50mm between the edges of the hob and any side walls; this clear ance must be maintained up to 420mm above the worktop. There must be a minimum clearance of 50mm betwee[...]

INSTALLATION Fitting into worktop Cut a hole in the work surface to the required size. The worktop must be of heat-resistant material or co vered with heat-resistant material. Protecting the cut-out; The types of chipboard used for work surfaces swell relatively quickly in contact with humidity . Apply a suitable sealant to the cut edge to protect [...]

INSTALLATION Installation Bracket Advice Secure the hob to the worktop by means of the brackets pr ovided, taking the thick - ness of the worktop into account. INST ALLA TION POSITIONS INST ALLA TION POSITIONS UNDERSIDE OF HOB Depending on your appliance it will be supplied with one of the following installation packs; Installation pack 1 4 x “U?[...]

INSTALLATION CONNECT TO THE ELECTRICITY SUPPLY WARNING: This appliance must be earthed. Only connect to the electrical mains terminal with the power switched off . The electrical mains terminal is live. Follow the terminal block connection schematic Loose and inappropriate connections can make the terminal overheat. Ensurethecableclampi[...]

TECHNICAL DATA SUPPLY: 220 -240V ~ 50Hz 5.04kW - 8.2kW Refertothedatabadgeontheundersideofy ourhobforspecicpowerratingofyourmodel[...]

CUSTOMER CARE 15.030 CUSTOMER CARE WEB SHOP Having purchased a superior cooker , hob or hood from us, you’ll naturally want to keep it looking great. And who better to help you care for it than the manuf ac- turer? W e offer an extensive r ange of accesso- ries, components and cleaning products which, will instantly give your cooker a good as new[...]

Please keep this handbook for f uture reference, or for an yone else who may use the appliance.[...]

Please keep this handbook for f uture reference, or for an yone else who may use the appliance.[...]

17 .010 CUSTOMER CARE T o contact Belling about your appliance, please call Warranty Registration 0844 481 0182 to register your appliance Customer Care Helpline 0844 815 3746 incaseofdifcultywithintheUK Alternatively general, spar es and service information is available f rom our website at www.belling.co.uk Please ensure that[...]