Brinkmann Gas Kettle Grill manuel d'utilisation

IGNITER LOW OFF HIGH F O R O U T D O O R U S E O N L Y • R e a d a n d f o l l o w a l l w a r n i n g s a n d i n s t r u c t i o n s i n • T u r n b u r n e r k n o b t o H I G H a n d p r e s s i g n i t e r • I f b u r n e r d o e s n o t i g n i t e i m m e d i a t e l y , t u r n b u r n e r k n o b t o O F F , w a i t 5 m i n u t e s t[...]

WE W ANT YOU T O ASSEMBLE AND USE YOUR GRILL AS SAFEL Y AS POSSIBLE. THE PURPOSE OF THIS SAFETY ALERT SYMBOL IS TO A TTRACT YOUR A TTENTION TO POSSIBLE HAZARDS AS YOU ASSEMBLE AND USE YOUR GRILL. WHEN YOU SEE THE SAFETY ALERT SYMBOL P A Y CLOSE A TTENTION TO THE INFORMA TION WHICH FOLLOWS! READ ALL SAFETY W ARNINGS AND INSTRUCTIONS CAREFULL Y BEFOR[...]

2 W ARNING • Never use natural gas in a unit designed for liquid propane gas. • Never use charcoal briquets or lighter fluid in a gas grill. • Leak test all connections before first use, even if grill was purchased fully assembled and after each tank refill. • Never check for leaks using a match or open flame. CAUTION! Strong odors, colds, [...]

CYLINDER SPECIFICA TIONS: When purchasing or exchanging a cylinder for your gas grill, it must be constructed and marked in accordance with the specifications for LP gas cylinders of the U.S. Department of T ransportation (DOT) or the National Standard of Canada, CAN/CSA-B339 as applicable with a listed over-filling prevention device (OPD). 3 W ARN[...]

4 The cylinder must also be equipped with: • A shut-off valve terminating in a T ype 1 gas cylinder valve outlet. • A T ype 1 valve that prevents gas flow until a positive seal is obtained. • An arrangement for vapor withdrawal. • A collar to protect the cylinder shut off valve. • A safety relief device having direct communication with th[...]

W ARNING FILLING THE LP GAS CYLINDER: • Allow only qualified LP gas dealers to properly fill or repair your LP gas cylinder . • New tanks should be purged prior to filling; inform LP gas dealer if you are using a new tank. • DO NOT allow the cylinder to be filled beyond 80% capacity . Over-filled tanks can create a dangerous condition. Over-f[...]

6 W ARNING • Never use your grill without leak testing all gas connections and hoses. See the section on "Leak T esting" in this manual for proper procedures. The pressure regulator and hose assembly supplied with your gas grill is designed to work with an LP gas supply cylinder . • DO NOT attempt to connect it to any other fuel suppl[...]

LEAK TESTING: T o prevent fire or explosion hazard: • DO NOT smoke or permit ignition sources in the area while conducting a leak test. • Perform test OUTDOORS only in a well ventilated area. • Never perform a leak test with a match or open flame. • Never perform a leak test while the grill is in use. WHEN TO PERFORM A LEAK TEST : • After[...]

W ARNING 8 6. Check each place listed (A -J) for growing bubbles which indicates a leak. 7. T urn OFF gas supply at cylinder valve. 8. T urn on control knob to release gas pressure in hose. 9. T urn control knobs to “ off ” position. 10. T ighten any leaking connections. 1 1. Repeat soapy water test until no leaks are detected. DO NOT use the g[...]

Read, understand and follow all warnings and instructions contained in this manual. DO NOT skip any of the warnings and instructions contained in the preceding sections of this manual. LIGHTING INSTRUCTIONS: Follow the instructions exactly . 1. OPEN THE GRILL LID before attempting to light the burner so that fumes do not accumulate inside the grill[...]

TURNING OFF THE GRILL: 1. T urn OFF the LP tank valve. 2. T urn burner control knob to the OFF position. NOTE: T urn off LP cylinder first to prevent gas from being left in the system under pressure. CAUTION! • The LP tank valve should always be in the off, or closed, position when the grill is not in use. 10 T o turn off the LP tank valve, turn [...]

CONTROLLING FLARE-UPS: • Flare-ups are a part of cooking meats on a gas grill. This adds to the unique flavor of cooking on a gas grill. Excessive flare-ups can over-cook your food and cause a dangerous situation for you or your grill. Excessive flare-ups result from the build-up of grease in the bottom of your grill. If this should occur , DO NO[...]

TRANSPORTING AND STORAGE: • Never move a grill when it is hot or when objects are on the cooking surfaces. • Make sure that cylinder valve is shut off. After moving the grill check that all gas connections are free of leaks. Check the venturi tubes to ensure they are properly connected to the valves and the orifices are inside the venturi tube.[...]

BURNER AND VENTURI • Although your burner is constructed of cast iron, it will rust as a result of the extreme heat and acids from cooking foods. Regularly inspect the burner for cracks, abnormal holes, and other signs of corro- sion damage. If found, replace the burner . • V enturi tube can become blocked by spiders and other insects building [...]

TROUBLE SHOOTING: Problem: Possible Causes: • Burner will not light 1. Check LP cylinder fuel level. 2. Bad electrode spark. Check to see if the grill will match light. Electrode or collector may need adjustment. 3. V enturi may not be properly seated. 4. V enturi may be obstructed. 5. The cylinder valve may be closed. 6. Regulator is not properl[...]

• T o protect your grill from excessive rust, the unit must be kept clean and covered at all times when not in use. A grill cover may be ordered directly from Brinkmann by calling 1-800-468-5252 or 1-800-527-0717 . • W ash cooking grill and heat shield with hot, soapy water , rinse well and dry . Lightly coat cooking grill with vegetable oil or[...]

P ARTS LIST : 1 Kettle Grill Body 1 Dome lid 1 Heat shield 1 Bottom shelf/T ank support 1 Handle (with bolts and washers) 1 2 3 4 5 ASSEMBL Y INSTRUCTIONS READ ALL SAFETY W ARNINGS & ASSEMBL Y INSTRUCTIONS CAREFULL Y BEFORE ASSEMBLING OR OPERA TING YOUR GRILL. WE RECOMMEND TWO PEOPLE WORK TOGETHER WHEN ASSEMBLING THIS UNIT . The following tools[...]

17 P ARTS BAG CONT AINS: 2 Hood Nuts 2 Flat washers 3 #8 X 3/8" Sheet metal screws 2 Hood bolts 3 Wing bolts P AR TS BAG CONTENTS Make sure you have all items listed under P ARTS LIST and P ARTS BAG CONTENTS before you begin the installation process. Y our Parts Bag will include: 3 - #8 X 3/8" Sheet metal screws 2 - Hood bolts 2 - Hood nu[...]

Choose a good, cleared assembly area and get a friend to help you put your grill together . Lay cardboard down to protect grill finish and assembly area. Step 1 Place kettle grill body upside down as illustrated. Step 2 Slide all 3 legs with casters into leg supports. Align holes in lower leg with holes in leg supports. Do not tighten with #8 X 3/8[...]

Step 3 Align bottom shelf/tank support with holes in the legs. Step 4 Insert wing bolts through holes in legs into bottom shelf/tank support. NOTE: When securing wing bolts, twist legs for proper alignment with bottom shelf/tank support. Step 5 Secure legs into leg sockets using three #8 X 3/8 ” sheet metal screws. 19[...]

20 Step 6 With the help of a friend, carefully turn the the grill to its upright position. T ry to minimize stress placed on the legs. NOTE: Lock casters to prevent grill from moving during final assembly . Step 7 Place dome lid on grill body and align hinges. Step 8 Fasten hinges together using hood bolts, washers and hood nuts as illustrated. IGN[...]

21 Step 9 Place heat shield into lower grill body just above burner . Step 10 Place cooking grill directly above heat shield. Heat shield[...]

Step 1 1 Add control knob to valve by aligning the notched stem of the valve with the cut out on the knob. Step 12 Secure handle to lid using screws and washers provided with handle. Step 13 Place grease cup in cut out of ash guard/grease cup holder as illustrated. Check grease cup periodically when grilling to avoid spills. 22 I G N I T E R LOW OF[...]

23 I G N I T E R LOW OFF HIGH F O R O U T D O O R U S E O N L Y • R e a d a n d f o l l o w a l l w a r n i n g s a n d i n s t r u c t i o n s i n • T u r n b u r n e r k n o b t o H I G H a n d p r e s s i g n i t e r • I f b u r n e r d o e s n o t i g n i t e i m m e d i a t e l y , t u r n b u r n e r k n o b t o O F F , w a i t 5 m i n [...]

PROFESSIONAL SHISH-KABOB SKEWERS These heavy-duty , 18" shish-kabob skewers are extra-long for fabulous restaurant style kabobs. Made of rust resistant stainless steel to last for years. SET OF 12 812-2904-0 ACCESSORIES 24 RIB RACK Chrome-plated rack can greatly increase the cooking capacity of your grill. Holds ribs, chicken halves, potatoes [...]

ACCESSORIES LOOK FOR THESE AND OTHER BRINKMANN ACCESSORIES A T YOUR LOCAL RET AILER WHERE SMOKERS ARE SOLD, OR ORDER DIRECT BY CALLING 1-800-468-5252. THE UL TIMA TE 5-PIECE BBQ TOOL SET Yo u ’ ll be the envy of your fellow outdoor chefs with this ultimate BBQ tool set. It ’ s sleek ergonomic design combined with durable, heavy- gauge stainless[...]

[...]

Owner ’ s Manual for Models 810-3310-0 10/01, 2/02 140-3310-0 For one-year from date of purchase, The Brinkmann Corporation warrants the Brinkmann Gas Kettle Grill against defects due to workmanship or materials to the original purchaser . The Brinkmann Corporation ’ s obligations under this warranty are limited to the following guidelines: •[...]