Chamberlain ATS211R manuel d'utilisation

TM H I G H L O W N O R M A L H I G H L O W N O R M A L UP FORCE DOWN FORCE The Chamberlain Group, Inc. 845 Larch Avenue, Elmhurst, Illinois 60126 MODEL A TS 21 1R COMMERCIAL DOOR OPENER For Residential and Light Duty Commercial Use Install on Sectional Doors Only OWNER'S MANUAL ■ Please read this manual and the enclosed safety materials care[...]

Start by reviewing these important safety alert symbols 2 CONTENTS PAGE A review of safety alert symbols ..............................2 You'll need tools ......................................................3 Illustration of door installation .................................4 Opener carton inventory .........................................[...]

3 An unbalanced garage door might not reverse when required and someone under the door could be seriously injured or killed. If your garage door binds, sticks or is out of balance, call for professional garage door service. Garage doors, door springs, cables, pulleys, brackets and their hardware, are under extreme tension and can cause serious inju[...]

4 Safety Reversing Sensor Horizontal and vertical reinforcement is needed for lightweight garage doors (fiberglass, steel, aluminum, door with glass panels, etc.). See page 19 for details. Support bracket & fastening hardware is required. See page 12. — — — — — — — — Door Center Header Wall Safety Reversing Sensor Floor must be [...]

5 Straight Door Arm Door Bracket Plate Door Bracket Safety Labels and Literature "C" Wrap (2) 2 -Conductor Bell Wire White & White/Red Curved Door Arm Rail Styrofoam Chain Pulley Bracket Trolley Chain Safety Reversing Sensor Mounting Bracket With Slot (2) Safety Reversing Sensor Mounting Bracket With Square Holes (2) Mounting Hardware[...]

Chain Spreader Sprocket Chain USE ONLY THIS TYPE AND SIZE SCREW Washered Screw 5/16"-18x1/2" Opener 6 • Guide the chain over chain spreader and opener sprocket. If necessary, loosen the outer nut on the trolley to obtain more chain slack. Insert the second washered screw. CAUTION! Use only the screw previously removed from opener. • T[...]

• Spin the inner nut and lock washer down t he threaded shaft, away from t he t rolley . • T o tighten the chain, t ur n outer nut in t he direction shown. As you turn the nut, keep the chain from twisting. • When the chain is approximat ely 1/2" above the base of the rail at its midpoin t, re-tight en the inner nut to secure the ad just[...]

• Open your door to the highest point of travel as shown. Draw an intersecting horizontal line on the header wall 2" above the high point. This height will provide travel clearance for the top edge of the door. Header Wall Ceiling Track Highest Point of Travel Door 2" 8 Proceed to Step 2, page 9. Vertical Guideline Finished Ceiling Vert[...]

Lag Screws 5/16"-9x1-5/8" Highest Point of Travel (of Garage Door) Vertical Center Line Header Wall Garage Door UP CEILING MOUNT ONLY Wall Mounting Holes Optional Wall Mounting Holes The nail hole is for positioning only. You must use lag screws to mount the header bracket. UP CEILING MOUNT ONLY Door Spring Header Bracket 2x4 Structural S[...]

Header Bracket Chain Pulley Bracket Temporary Support Header Wall Garage Door Clevis Pin 5/16"x2-3/4 " Ring Fastener Header Bracket Chain Pulley Bracket Rail Rail • Position the opener on the garage floor below the header bracket. Use packing material as a protective base. If the door spring is in the way you'll need help. Have som[...]

Installation Step 4 Position the Opener To prevent damage to steel, aluminum, fiberglass or glass panel doors, do not rest the opener on the door without using a 2x4. 11 CAUTION Trolley Trolley Release Arm • If the top panel hits the trolley when you raise the door, pull down on the trolley release arm to disconnect the inner and outer sections. [...]

Installation Step 5 Hang the Opener Two representative installations are shown. Yours may be different. Hanging brackets should be angled, Figure 1, to provide rigid support. On finished ceilings, Figure 2, attach a sturdy metal bracket to structural supports in ceiling before installing the opener. The bracket and fastening hardware are not suppli[...]

Installation Step 6 Install the Door Control 13 Children operating or playing with a garage door opener can injure themselves or others. The garage door could close and cause serious injury or death. Install the Door Control (or any additional push buttons) out of the reach of children and away from all moving parts of the door and door hardware, b[...]

Opener 75 Watt Max. Light Bulb Install the Light • Install a 75 watt maximum light bulb in the socket. The light will t ur n ON and remain lit for approximately 4-1/2 minut es when power is connected. Then t he light will tur n OFF . • If the bulb bur ns out premat urely due to vibration, replace with a "Garage Door Opener" bulb. Inst[...]

To reduce the risk of electric shock, your garage door opener has a grounding type plug with a third grounding pin. This plug will only fit into a grounding type outlet. If the plug doesn't fit into the outlet you have, contact a qualified electrician to install the proper outlet. Installation Step 9 Electrical Requirements Ground Tab Green Gr[...]

Without a properly working safety reversing sensor , persons (particularly children) could be injured or killed by a closing garage door . Read and follow all instructions. T o protect small children, install the safety reversing sensor so that the beam will be no higher than 4-6" above the garage floor . Disconnect power to the garage door op[...]

1/4x1-1/2" Lag Screw #10-32x3/8" Screw 1/4"-20 Lock Nut #10x32 Lock Nut Staples 1/4"-20x1/2" Carriage Bolts Installation Step 10 Install the Safety Reversing Sensor (Receiving and Sending Eyes) Inside Garage Wall "C" Shaped Wrap Mounting Bracket with Square Holes 1/4-20x1/2" Carriage Bolts 1/4 " Lock Nut[...]

Invisible Light Beam Protection Area Sensor Sensor Connect Wire to Opener Terminals Bell Wire Bell Wire Finished Ceiling Sensor Connections Wall Control Connections (dotted line) OPENER TERMINAL SCREWS 1 2 3 18 1/4-20 x 1-1/2" Hex Bolt "C" Wrap Sensor with Wire Wing Nut Indicator Light 1/4-20x1-1/2" Hex Bolt Wing Nut Hardware Sh[...]

Installation Step 1 1 Fasten Door Bracket & Plate To prevent damage to steel, aluminum, fiberglass or glass panel doors, always reinforce the inside of the door both vertically and horizontally with an angle iron. INST ALLA TION STEP 11 Fasten the Door Bracket A horizontal reinforcement brace should be long enough to be secured to two or three [...]

Installation Step 12 Connect Door Arm to Trolley Make sure garage door is fully closed. Pull the manual release handle to disconnect the outer trolley from the inner trolley. Slide the outer trolley back (away from the door) about 2” as shown in Figures 1, 2 and 3. Figure 2: • Bring arm sections together. Find two pairs of holes that line up an[...]

Adjustment Step 1 Adjust the UP and DOWN Limits Do not make any limit adjustments until the Safety Reversing Sensors are completely installed. 21 Limit adjustment settings regulate the points at which the door will stop when moving up or down. The door will stop in the up direction if anything interferes with door travel. The door will reverse in t[...]

Ad justment Step 2 Adjust the Force T oo much force on the door will interfere with the proper operation of t he safety reverse system. The door might not reverse properly when required and could seriously injure or kill someone under it. Do not increase the force beyond what is required to close the door . Do not use the force ad justments to comp[...]

Adjustment Step 4 T est the Safety Reverse System Test: • Place a 2x4 laid flat on the floor, centered under the garage door. • Operate the door in the down direction. The door must reverse on striking the obstruction. Adjustment: If the door stops on the obstruction, it is not traveling far enough in the down direction. • Increase the DOWN l[...]

Limit and Force Adjustment Control Weather conditions may cause some minor changes in door operation requiring some re-adjustments, particularly during the first year of operation. Pages 21 and 22 refer to the limit and force adjustments. Only a screwdriver is required. Follow the instructions carefully. Repeat the safety reverse test (page 23) aft[...]

The lockout feature prevents the trolley from reconnecting auto- matically. Pull the manual release handle down and back (toward the opener). The door can then be raised and lowered manually as often as necessary. To disengage the lockout feature, pull the manual release handle straight down. The trolley will reconnect on the next UP or DOWN operat[...]

Children operating or playing with a garage door opener can injure themselves or others. The garage door could close and cause serious injury or death. Do not allow children to operate the Door Control or remote control transmitter(s). A moving garage door could injure or kill someone under it. Activate the opener only when you can see the door cle[...]

SECURITY ✚ Multi-Function Door Control - Model 58LM (OPTIONAL) 27 Children operating or playing with a garage door opener can injure themselves or others. The garage door could close and cause serious injury or death. Install the door control (or any additional push buttons) out of the reach of children and away from all moving parts of the door [...]

SECURITY ✚ Multi-Function Door Control - Model 68LM (OPTIONAL) 28 The Door Control Push Bar: Press to open or close the door. Press again to reverse the door during the closing cycle or to stop the door while it's opening. Light Feature: Press the Light button. If the opener light is off, it will turn on. If the opener light is on, (even in [...]

SECURITY ✚ Keyless Entry - Model 67LM (OPTIONAL) 29 Features For use with any SECURITY ✚ compatible garage door opener receiver. Personalized Code: Up to 10,000 possible combinations. Code can be easily changed if desired. Operation: 12 Volt power supply. Opener activates when 4-digit code and Enter button is pressed. If wrong numbers are accid[...]

1. Does the opener have electric power? Plug a lamp into the outlet. If it doesn't light, check the fuse box or the circuit breaker. (Some outlets are controlled by a wall switch.) 2. Have you disabled all door locks? Review installation instruction warnings on page 7. 3. Is there a build-up of ice or snow under the door? The door may be froze[...]

The chain droops or sags: It is normal for the chain to droop slightly in the closed door position. Use the manual release rope and handle to disconnect the trolley. If the chain returns to the normal height when the trolley is disengaged and the door reverses on a 2x4 laid flat, no adjustments are needed. (See page 7.) 31 Having a Problem? (contin[...]

6 UP CEILING MOUNT ONLY 10 1 NOTICE 3 5 4 9 8 11 12 2 7 2 1 3 4 RAIL GREASE NO. 83A4 5 Repair Parts Rail Assembly Parts Installation Parts 32 KEY PART NO. NO. DESCRIPTION 1 1A995 Master link kit 2 41A2780 Chain pulley bracket 3 41A3489 Complete trolley assembly 4 CD1008 8 Foot Rail Assembly CD1010 10 Foot Rail Assembly CD1012 12 Foot Rail Assembly [...]

Repair Parts Opener Assembly Parts 9 7 12 13 14 15 18 4 8 11 17 10 16 3 5 6 18 15 DN UP Brown Wire (Down) Contact LIMIT SWITCH ASSY. Grey Wire Yellow Wire (Up) Contact Center Limit Contact Drive Gear 1 2 KEY PART NO. NO. DESCRIPTION 1 41C5069 Rail support bracket assembly kit 2 144B18 Pulley (Chain) 3 41C4470 Gear and sprocket assy. Complete with: [...]

LIGHT LOCK LIGHT LOCK Accessories A vailable for your Opener Other Products For Y our Opener 108D36 Model 59 Model 976LM Model 1702 Outside Keylock: Opens the garage door automatically from outside when remote control is not handy. Outside Quick Release: Required for a garage with NO access door. 10 foot Complete Rail and Chain Assembly: To allow a[...]

Index Access Door/Outside Quick Release Accessory ..........................................................................................4, 34 Chain Tension ..............................................................................................................................................4, 7, 31 Electrical Safety Warnings ............[...]

LIFTMASTER GARAGE DOOR OPENER ONE-YEAR LIMITED WARRANTY Chamberlain/LiftMaster warrants to the first retail purchaser of this product that it will be free from any defect in materials and/or workmanship for a period of twelve full months from the date of purchase. The product must be used in complete accordance with Lift-Master's instructions [...]