Dukane P42 manuel d'utilisation

Color Plasma Displa y Model P42 Read the instructions inside carefully . Keep this user man ual for future reference. Serial No. ______________________ The serial number is located on the rear of the monitor . USER'S MANU AL P42 with optional stand.[...]

[...]

ENGLISH I SAFETY GUIDELINES This monitor is designed to be safe to use. However, due to high voltage of about 400 V, fire or serious injury may occur unless you use this monitor in the proper way. Please follow the instructions shown below in order to avoid injury. Keep the safety guideline Do not use the monitor if it fails If you find something u[...]

ENGLISH II SAFETY GUIDELINES(continued) • Do not apply shock to the monitor. • Do not use monitor if glass is broken or damaged. If there is no picture appearance, broken glass , smoking or something smells after applying shock to the monitor, turn off the monitor and disconnect the power plug from the mains immediately. Then, call the service [...]

ENGLISH III • Do not touch the power plug with wet hands. You may receive an electric shock. • Do not obstruct a ventilation hole. If you obstruct a ventilation hole during the operation of the monitor or just after switching off the power, it may cause a fire or electric shock due to heating up the monitor. • Do not put the monitor screen si[...]

ENGLISH IV SAFETY GUIDELINES(continued) • Do not coil or wind the power cord. This may cause excessive heat resulting in a fire. • Caution for 200 - 240V operation only This equipment relies on the protective devices in the building installation for short - circuit and over - current protection. Refer to the following table for the suitable num[...]

ENGLISH V PRECAUTIONS • Installation environment Do not obstruct a ventilation hole. Do not put the monitor on carpet or blanket, or near a curtain which has a possibility of obstructing a ventilation hole of the monitor. Do not put the monitor in the following places. • Hot places such as near heater, place exposed to the direct rays of the su[...]

ENGLISH VI SAFETY GUIDELINES(continued) • Prevention of an obstacle to Radio receivers This monitor has been designed pursuant to the FCC class B Rules (see page VII ). This is to prevent a problem to Radio receivers. - Keep the monitor away from Radio. - Adjust Radio antennas in order for the monitor not to receive interference. - The antenna ca[...]

ENGLISH VII • FCC (Federal Communications Commission) STATEMENT WARNING WARNING : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipme[...]

00u14121U 01.9.19 11:58 AM ページ XXXVI[...]

ENGLISH 1 CONTENTS Notes about This Manual • The information in this manual is subject to change without notice. • While meticulous care has been taken in the preparation of this manual, you are requested to notify your dealer or us should you have any comments, views or questions about our product. • Fully understand the prerequisites to usi[...]

ENGLISH 2 FEA TURES ■ This product is complete with the display monitor, plus the accessories shown below. • If any of these accessories is missing, please contact your dealer. User manual (this book) Power cable USER MANUAL BEDIENUNGSANLEITUNG READ THE INSTRUCTIONS INSIDE CAREFULLY. KEEP THIS USER MANUAL FOR FUTURE REFERENCE. For future refere[...]

ENGLISH 3 INST ALLA TION INSTRUCTIONS ■ No stand is provided with this product. When installing the monitor, use the optional Desk-top Stand ( 651-61 or 651-62 ), Wall Mount Unit (horizontal-mount ) The Desk-top Stand has been used for the illustrations in this manual. Installation • Use one of the special mount units to install this product. A[...]

ENGLISH 4 INST ALLA TION INSTRUCTIONS (continued) Front Cabinet (front frame) Main power switch Panel Indicating lamp Remote-control receiver 8 Control panel VOLUME button MENU button INPUT SELECT button SELECT button ■ Adjustment buttons are located on the bottom. ■ The inner side of the cover is provided with indications to distinguish the ad[...]

ENGLISH 5 External device connection terminals Rear AUDIO IN R L/MONO AUDIO IN COMPONENT COMPOSITE S VIDEO 2 VIDEO 1 R P R /C R P B /C B YI N I N OUT L/MONO Video input terminals RGB input terminals AUDIO IN VHBG R RGB 1 RGB 2 D-SUB IN RS232C External speaker terminals 7 7 6 Remote controller SIZE RGB 2 VOLUME+ VOLUME- MUTE MENU RECALL RGB 1 VIDEO [...]

ENGLISH 6 INST ALLA TION INSTRUCTIONS (continued) Connecting to a PC ■ Read SAFETY GUIDELINES ( to ) carefully to ensure maximum safety before proceeding to these steps: 1) Make sure that the display signals produced by your PC meet the specifications of this product. • For the specifications of this product, see Product Specifications ( to ). [...]

ENGLISH 7 Connecting to V ideo Equipment (such as a Laser Disc player, a DVD player, a DSS,or a Video Camera) ■ Read SAFETY GUIDELINES ( to ) carefully to ensure maximum safety before proceeding to these steps: 1) Choose an appropriate site and install the product on a level table where the stand is secure. • Install the monitor to have ready a[...]

ENGLISH 8 INST ALLA TION INSTRUCTIONS (continued) Loading Batteries 1) Open the battery cover. • Slide the battery cover towards the arrow mark while pressing it. 2) Load batteries. • Load two Size AA batteries included observing the correct polarities. 3) Close the battery cover. • Slide back the battery cover towards the arrow mark. Handlin[...]

ENGLISH 9 OPERA TING INSTRUCTIONS • When the indicating lamp blinks in green or the message “POWER SAVE” or “OUT OF FREQUENCY” appears on the screen, there is something unusual about the status of reception. See “Symptoms That Seemingly Appear to be Failures.” Main power swi tc h Main unit Remote controller SUB POWER T urning Power On[...]

■ The input is switched by pressing the RGB1, RGB2, VIDEO1 or VIDEO2 button on the remote control. Pressing the INPUT SELECT button on the monitor main unit switches the input in the order of RGB1 → RGB2 → VIDEO1 → VIDEO2 → RGB1. • When the same signal is input to RGB1 and RGB2, the phase may in some cases shift slightly but this is not[...]

■ Each press on the SIZE button on the remote control switches the display size of the screen (or the display area) in the following order. The selected mode is displayed in the lower part of the screen. • RGB signal input • VIDEO signal input • Depending on the signal type, sometimes it may not be possible to change screen size. Sometimes [...]

■ Press the MENU button to open an MAIN MENU allowing you to complete various adjustments and settings using the SELECT buttons (The , , , and keys of the remote controller or the SELECT or VOLUME button of the main unit.). • Press the SELECT button of the main unit ( or key of the remote controller) to select an item by moving the pink text. ?[...]

ENGLISH 13 PICTURE MENU MAIN MENU PICTURE SOUND DISPLA Y FUNCTION PICTURE MENU CONTRAST : 127 BRIGHTNESS : 0 COLOR : 0 TINT : 0 SHARPNESS : 0 PICTURE MODE : SUPER OPTIONS RETURN PICTURE MENU CONTRAST : 127 BRIGHTNESS : 0 PICTURE MODE : SUPER OPTIONS RETURN VIDEO RGB Selected characters Setup hint CONTRAST Narrows the gap between brightness and dark[...]

ENGLISH 14 OPERA TING INSTRUCTIONS (continued) SOUND MENU MAIN MENU PICTURE SOUND DISPLA Y FUNCTION SOUND MENU VOLUME : 20 BALANCE : 0 TREBLE : 0 BASS : 0 MUTE LEVEL : 0 RETURN Selected characters Setup hint VOLUME Turns down the volume. Turns up the volume. Adjust for the desired sound volume. BALANCE Suppresses right-side sound. Suppresses left-s[...]

ENGLISH 15 Resolution Overall display Partial display Display FULL NORMAL ZOOM 640 X 480 (VGA) X Y 800 X 600 (SVGA) 1024 X 768 (XGA) SXGA X : Y = 5 : 4 Others X : Y = 4 : 3 1280 X 1024 (SXGA) 1600 X 1200 (UXGA) DISPLA Y MENU (RGB) Selected characters Setup hint DISPLAY AREA NORMAL ZOOM FULL Set to FULL to display images across the screen for gainin[...]

ENGLISH 16 OPERA TING INSTRUCTIONS (continued) MANUAL ADJUST MENU (RGB) Selected characters Setup hint H.POSITION Moves the horizontal position to left. Moves the horizontal position to right. Adjust the left-side display position. V.POSITION Moves down the vertical position. Moves up the vertical position. Adjust the vertical display position. CLO[...]

ENGLISH 17 TIPS Using a wide-screen monitor • This monitor has a screen mode selection feature. If an incompatible screen mode is selected to play certain software, such as a TV program, the image would appear different from the original. Take this into consideration when making screen mode choices. • Use of this monitor in its enlarged display[...]

ENGLISH 18 OPERA TING INSTRUCTIONS (continued) FUNCTION MENU MAIN MENU PICTURE SOUND DISPLA Y FUNCTION FUNCTION MENU LANGUAGE : ENG. AUTO FREQ : ON LINE INTP . : OFF 3D COMB : ON COMPONENT VIDEO SYSTEM : AREA1 SCREEN SA VER RETURN ENGLISH FUNCTION MENU LANGUAGE : ENG. AUTO FREQ : ON MODE : PC SCREEN SA VER RETURN ENGLISH VIDEO RGB Selected characte[...]

ENGLISH 19 COMPONENT MENU(VIDEO) Selected characters Setup hint COMPONENT SD1 (480i) Set to Cb/Cr to suit the Y/Cb/Cr signals. Set to Pb/Pr to suit the Y/Pb/Pr signals. The default is Y/Cb/Cr. COMPONENT SD2 (European SDTV) COMPONENT HD1 (480p) COMPONENT HD2 (720p) The default is Y/Pb/Pr. COMPONENT HD3 (1080i) SCREEN SA VER MENU MAIN MENU PICTURE SO[...]

ENGLISH 20 OTHER FEA TURES • The previously recorded items will be lost. • The signal mode can be identified by the horizontal/vertical sync frequency and the sync signal polarity. Different signals with which all the elements are the same or similar will be handled as the same signal. • RGB1 and RGB2 inputs have common elements that can be r[...]

ENGLISH 21 ■ The on-screen display system shown to the right will be displayed when the SELECT button is used to select DISPLAY and moreover DISPLAY INIT is selected from the On-screen Display System . If the key (select YES) of the SELECT button is pressed at this time, the user adjustment values in the table below for the signal currently being[...]

ENGLISH 22 OTHERFEA TURES (continued) Power Save Mode ■ When the RGB input is selected • When this unit is connected to a VESA DPMS computer, the Power Save (Off) mode can be set to be activated automatically when the computer is not being used to reduce power consumption by this unit. RGB sync signal Horizontal Yes No Yes No Vertical Yes Yes N[...]

ENGLISH 23 TROUBLESHOOTING ■ Make the checks suggested below depending on the symptoms observed. If the symptoms remain uncorrected, contact your dealer. Symptoms That Seemingly Appear to be Failures • Customer servicing can be hazardous. W ARNING Symptom Point to check See page • No picture with the power- indicating lamp off. • Check the [...]

ENGLISH 24 TROUBLESHOOTING (continued) Symptom Point to check See page • The temperature of the display panel surface is high. • The plasma display panel is lighting the phosphors by the discharge of internal radiation. In some cases, this may cause the temperature of the panel surface to increase. Please note that this is not a malfunction. - [...]

ENGLISH 25 ■ Depending on the kind of system equipment used, images may not be displayed normally. In this case, make the adjustments suggested below. Actions to Correct Abnormal Displays • The display image may be momentarily disturbed during clock adjustment but this is not a failure. Symptom 1 Text displayed across the screen appears vertica[...]

Symptom 2 Text displayed across the screen appears blurred in its entirety (figure 2). A fine pattern flickers when displayed on the screen (figure 3). Example ABCDEFGHIJ abcdefgABCDEFGabcd ABCDEFGHIJ abcdefgABCDEFGabcd Before adjustment After adjustment ABC ABC ABC Before adjustment After adjustment Adjustment procedure 1) Press MENU button to ope[...]

ENGLISH 27 PRODUCT SPECIFICA TIONS ■ Product specifications and designs are subject to change without notice. Type P 42 Panel Display dimensions Approx. 42 inches (922 mm (H), vertical 522 mm (V), diagonal 1059 mm) Resolution 1024 (H) x 1024 (V) pixels Input signals Input terminals RGB input VIDEO input RGB one-line two input terminals (D-sub 15-[...]

ENGLISH 28 PRODUCT SPECIFICA TIONS (continued) Signal Input Pin Input signal 1 R. video 2 G. video or sync on green 3 B. video 4 No connection 5 No connection 6 R.GND 7 G.GND 8 B.GND 9 No connection 10 GND 11 No connection 12 [SDA] 13 H. sync or H/V composite sync 14 V.sync. [V.CLK] 15 [SCL] ■ RGB terminal (D-sub 15-pin connector) 1 2 3 4 5 6 7 8[...]

ENGLISH 29 ■ The following are recommended for use with this moniter RGB signal input (RGB1 or RGB2 signal input) Recommended Signal List No. Signal mode Horizontal frequency (kHz) Dot clock frequency (MHz) Remarks Signal Name Resolution Vertical frequency (Hz) 1 VGA 640 X 400 70.08 31.47 25.18 2 640 X 480 59.94 31.47 25.18 3 W-VGA 864 X 480 59.9[...]

ENGLISH 30 PRODUCT SPECIFICA TIONS (continued) • The type of video board or connecting cable used may not allow for correct displays adjustment of H.POSITION, V.POSITION, CLOCK and PHASE. • The monitor may fail to display an animation image correctly when a signal having a vertical frequency of 85Hz or higher is input to it. • The monitor dif[...]

LEGAL INFORMA TION TWO-YEAR LIMITED W ARRANTY This Dukane LCD projector is warranted to the original purchaser f or a period of five (2) y ears from the original purchase date - in nor mal use and service - against def ects in mater ial and workmanship . DUKANE CORPORA TION EXPRESSL Y DISCLAIMS ALL O THER W ARRANTIES OF MERCHANT ABILITY AND FITNESS[...]

Dukane Corporation Audio Visual Products Division 2900 Dukane Drive St. Charles, IL 60174-3395 E-mail: avsales@dukane.com Phone: (630) 584-2300 Orders: (800) 676-2485 Information: (800) 676-2486 Fax: (630) 584-5156 Parts & Service: (800) 676-2487 Fax: (630) 584-0984 Audio Visual Products P ar t # 401-592-00[...]