Fisher & Paykel DD60 manuel d'utilisation

NZ A U DishDra w er® User guide DD60 models[...]

[...]

1 Contents Safety and warnings 3 Controls (models with no L CD) 6 Controls (models with L CD) 8 Operation 10 W ash progr amme chart 11 Caring for y our dinnerware 12 Dishwasher standar ds test 13 Rack ing featur es and accessories 14 Loading suggestions 16 Detergent dispenser 18 Dishwasher det ergent and tablets 19 Rinse aid dispenser 20 Option adj[...]

2[...]

3 Safety and warnings Y our DishDraw er® has been carefully designed to operat e safely during normal dishwashing procedures . Please keep the following instructions in mind when you are using your DishDrawer®. Impor tant safet y instruc tions W ARNING! - When using your dishwasher , follow basic precautions , including the following: Read all in[...]

4 Safety and warnings Impor tant safet y instruc tions Installation This DishDrawer® must be installed and located in accordance with the Installation instructions before it is used. If you did not receive Installation instruction sheets with your DishDrawer®, you can order them by calling your Authorised Service Agent or from the Fisher & Pa[...]

5 Safety and warnings Impor tant safet y instruc tions Impor tant! Under no circumstances should you open the dr awer whilst the DishDraw er® is in operation. Operational Always press the button to pause and w ait until you hear the three additional beeps before opening the drawer . The DishDrawer® m ust be used with the motor assembly , filter p[...]

6 Contr ols (models with no LCD ) If you have a double DishDraw er®, each drawer has its own controls and can run independently of the other . P ower butt on The button turns the DishDrawer® on or off . Opening the drawer will automatically turn the DishDra wer® on for 30 seconds. T o end a wash programme in mid cycle, pr ess the button. Any wat[...]

7 Contr ols (models with no LCD ) Keylock The Keylock featur e disables all the buttons on the DishDrawer®. T o activate, press and hold the / button until you hear one beep (3 seconds). The light above the / button is lit when Keylock is activated. T o cancel the Keylock f eature, pr ess and hold the / button until the light above the / button di[...]

8 If you have a double DishDraw er®, each drawer has its own control panel and can run independently of the other . P ower butt on The button turns the DishDrawer® on or off . Opening the drawer will automatically turn the DishDrawer® on f or 30 seconds. T o end a wash programme in mid cycle, pr ess the button. Any water in the DishDraw er® wil[...]

9 Keylock The Keylock featur e disables all the buttons on the control panel . T o activate, press and hold the button until you hear one beep (3 seconds). The symbol appears in the electronic display when the Keylock feature is activated . Childlock The Childlock featur e locks the drawer and disables all the buttons on the contr ol panel. T o act[...]

10 1 Load dishes Remove all food scraps and load the dishes. 2 Add detergent 3 Check rinse aid 4 Press the button 5 Select a wash programme The length of the wash programme will appear on the electronic display (models with L CD only). 6 Select (optional) 7 Check Ensure there is nothing obstructing the spray arm. The drain filter must be level with[...]

11 W ash progr amme char t Standard wash progr amme - when to use Heavy Heavily soiled pots, pans and dishes. Normal Dishes with normal soils for optimum wash and dry performance. Also the only recommended programme if you are using dishwasher tablets. F ast Lightly soiled dishes. Delicate Lightly soiled and heat sensitive crockery . Rinse Prevents[...]

12 Caring f or your dinnerware The combination of high temperatur es and dishwasher detergent ma y cause damage to some items if they are washed in the DishDraw er®. Remember, if in an y doubt about any aspect concerning items washed in the DishDraw er®, follow the instructions from the manufacturer of the items, or wash the item b y hand. Cutler[...]

13 Dishw asher standards test The DishDrawer®s ar e tested to AS/NZS 2007 standards for both wash and dry per formance. The following ar e loading pattern diagrams , detergent quantities and rinse aid quantities used for the DishDraw er®. W ash programme Normal Eco (At the end of the prog ramme, open the DishDrawer 50 mm to improv e the dry per f[...]

14 Rack ing featur es and acc essories Stemware notches The six notches on the left- hand side help support long-stemmed glassware. F olding tines The front half is ideal f or large, deep bowls . F old the tine sections down towards each other if you need the spac e for pots or other large items. F old down the right-hand section only and lean cups[...]

15 Rack ing featur es and acc essories 12 3 Glass supports These clip on the rack wires to giv e your tall glasses extra stability. Adjustable racks Y ou can adjust these independently of each other to any height: 1 F old up to unlock the rack. 2 Adjust the height to suit by sliding up or do wn. 3 F old down to lock in position. F old the racks awa[...]

16 Loading suggestions When loading your DishDr awer®, make sure that you place items so that water c oming from the rotating spra y arm below can reach all areas (wash per formance will be reduc ed if it can ’t) nothing blocks the water from getting to items on the adjustable racks . T ypical breakfast load T ypical dinner par ty load T ypical [...]

17 Loading suggestions How NO T to load your DishDraw er® Overcrow ded and wash water will not reach some of the dinnerware. Cups, glasses and bo wls must have their openings facing down. The plates are nesting t ogether and wash water may not get through. Ensure cutlery are not nesting or stuck together . They need to be evenly spread out. Ensure[...]

18 Detergent dispenser a Pre-wash compartment, 10g capacity b Main wash compartment, 30g capacity c Detergent dispenser latch d Rinse aid indicator light e R inse aid plug Impor tant! Only use powdered detergent recommended for domestic automatic dish washers in the detergent dispenser . Dishwasher detergents are strongly alk aline and can be dange[...]

19 Dishw asher detergent and tablets Detergent quantities The detergent quantities r ecommended below are f or individual drawers. W ash programmes pre-wash (g)* main wash (g)* Heavy 5 15 Normal 15 Delicate F ast 5 5 * 5g equates to appro ximately 1 teaspoon, 15g equates to approximately 1 tablespoon. Dishwasher tablets Impor tant! If you are using[...]

20 Rinse aid dispenser W e highly recommend the r egular use of liquid rinse aid to give the best drying results. Rinse aid gives a streak-fr ee, spark ling clean look to glass and chinaware . I n addition, it prevents metal from tarnishing. The rinse aid dispenser is on the inside of the draw er , located underneath the detergent dispenser . The r[...]

21 Option adjustments The following options can be adjust ed to suit your pr eferences: Rinse aid setting Reduce the Rinse aid setting if there is excess f oam af ter a wash programme or if you ar e using dishwasher tablets with built-in rinse aid. Increase the Rinse aid setting if dishes are wet or streaky after a wash programme . W ater softener [...]

22 Option adjustments How to make option adjustments (Integr ated and Pr efinished - no L CD) F ollow the steps below Rinse aid setting Auto po wer option End of wash programme beeps option Closed draw er option * First Enter Option adjustment mode: 1 Press the butt on to turn power on. Open DishDraw er®. 2 Press and hold the and / buttons for 5 s[...]

23 Option adjustments How to make option adjustments (models with L CD) F ollow the steps below Rinse aid setting Auto po wer option End of wash programme beeps option Closed draw er option Clean dish * First Enter Option adjustment mode: 1 Press the button to turn power on. Open the DishDrawer®. 2 Press and hold the and buttons f or 5 seconds unt[...]

24 Car e and cleaning Impor tant! Disconnect the DishDrawer® from the po wer supply before any cleaning or maintenanc e. Cleaning the sur faces Impor tant! W e do not recommend the use of the following cleaning a ids on your DishDrawer® as they may damage the surfaces: Plastic or stainless steel scouring pads Abrasive , solvent, household cleaner[...]

25 Cleaning the drain filter , spray arm and filter plate W e recommend that the drain filter is cleaned whenever there is evidence of f ood par ticles. The spray arm and filter plate ma y need cleaning about once a month in normal use or more often should the need arise. If a dishwasher cleaner/descaler is used, you must run a wash programme with [...]

26 Cleaning the spray arm and filter pla te Ensure the DishDrawer® is c ool before you start cleaning and follow the instructions for removing the drain filter and spra y arm. 1 Unplug the DishDrawer® or turn it off at the power supply . 2 Unclip the glass supports from the rack wires and fold all the adjustable racks awa y , so that they are upr[...]

27 T roubleshooting Problem Possible cause What to do Unclean dishes W ash programme unsuitable for the load. Refer to the ‘Wash programme chart’ for a suitable wash programme, or the soils w ere too heavily baked on and dishes may need soaking. Spray arm unable to rotat e. Ensure no items are obstructing the spray arm path. DishDrawer® ov erl[...]

28 T roubleshooting Problem Possible C ause What to do Continuous beeping A fault has occurred. Refer to the ‘F ault codes’ section. Intermittent beeping DishDrawer® is in pause mode. Close the DishDraw er® and press the button. DishDraw er® will not start Po wer supply is not connected. Connect the power supply . The drawer is not closed pr[...]

29 How to rec ognise a fault code When a fault has occurred, the DishDra wer® will continuously beep every second. The fault code will be display ed on the electronic display for models with L CD and on the wash programme selector for models with no L CD . Each fault code is shown in the follo wing chart. How to att end to a fault code 1 Press the[...]

30 F ault codes F ault codes Possible causes What to do F1 Flood switch has been activated. T urn the water and power supply to the DishDrawer® off and call y our Authorised Ser vice Centre or C ustomer Care. F2 Motor problem. Call your A uthorised Ser vice Centre or Customer Car e. F3 T emperature sensor failed. Ensure water coming in thr ough th[...]

31 F ault codes Possible causes What to do U1 Fill fault. 1 Turn the DishDra wer® water supply on. 2 Ensure the spray arm is placed on the impeller and can rotate about the centre. If the DishDraw er® is full of water , it will need to be emptied manually . 3 Call your A uthorised Ser vice Centre or Customer Car e. U4 F ault in the other drawer p[...]

32 W arranty and ser vice Before y ou call for ser vice or assistance ... Check the things you can do yourself . Refer to the installation instructions and your user guide and check that: 1 your product is correctly installed 2 you are familiar with its normal operation. If after check ing these points you still need assistance, please r efer to th[...]

[...]

Copyright © F isher & Paykel 2009. All rights reserved. The product specifications in this booklet apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at an y time. Y ou should therefore check with your Dealer to ensure this booklet correc[...]