JVC UX-G5 manuel d'utilisation

UX-G5 —Consists of CA-UXG5 and SP-UXG5 LVT1349-003A [UJ] English MICRO COMPONENT SYSTEM INSTRUCTIONS Cover[UJ].fm Page 1 Thursday, June 9, 2005 11:15 AM[...]

G-1 Warnings, Cautions and Others CAUTION— (standby/on) button! Disconnect the mains plug to shut the power off completely (all lamps and indications go off). The button in any position does not disconnect the mains line. • When the unit is on standby, the STANDBY lamp lights in red. • When the unit is turned on, the STANDBY lamp goes off. Th[...]

1 Contents Introduction ..................................................... 2 Precautions...................................................................... 2 How to Read This Manual .............................................. 2 Getting Started ................................................ 3 Step 1: Unpack................................[...]

2 Introduction Precautions Installation • Install in a place which is level, dry and neither too hot nor too cold—between 5°C and 35°C. • Install the System in a location with adequate ventilation to prevent internal heat buildup inside the System. • Leave sufficient distance between the System and the TV. • Keep the speakers away from [...]

3 Getting Started Step 1 : Unpack After unpacking, check to be sure that you have all the following items. The number in parentheses indicates the quantity of each piece supplied. • FM antenna (1) • AM loop antenna (1) • Remote control (1) • Batteries (2) • AC plug adapter (1) If any item is missing, consult your dealer immediately. Step [...]

4 Step 3 : Hook Up If you need more detailed information, see page 6. AM EXT GND AM EXT GND AM LOOP ANTENNA Illustrations of the input/output terminals below are typical examples. When you connect other components, refer also to their manuals since the terminal names actually printed on the rear may vary. Turn the power off to all components before[...]

5 ANTENNA AM EXT GND AM LOOP 220V–240V AC VOLT AGE SELECTOR 110V–127V FM antenna (supplied) Extend it so that you can obtain the best reception. AM loop antenna (supplied) Turn it until the best reception is obtained. Non-stripe Black stripe UX-G5[UJ].book Page 5 Friday, June 10, 2005 1:07 PM[...]

6 To assemble and connect the AM loop antenna To assemble the AM loop antenna To connect the AM loop antenna Make sure to connect the wire correctly: The white end to AM EXT, the black end to GND. • If the AM loop antenna wire or speaker cords are covered with vinyl, remove the vinyl to expose the tip of the antenna by twisting the vinyl. • Mak[...]

7 Before Operating the System The indications on the display teach you a lot of things while you are operating the System. Before operating the System, be familiar with when and how the indicator illuminates on the display. 1 Disc tray indicators • 1–5: Disc tray number •: Tray indicator – Lights when the disc is detected. – Blinking whil[...]

8 Daily Operations —Playback 1 Turn on the power. The STANDBY lamp on the main unit turns off. • Without pressing STANDBY/ON , the System turns on by pressing one of the source selecting buttons in the next step. 2 Select the source. Playback automatically starts if the selected source is ready to start. • If you press AUX, start playback sou[...]

9 Listening to the Radio To select the AM tuner interval spacing Some countries space AM stations 9 kHz spacing, and other countries use 10 kHz spacing. You can change the AM tuner intervals while the System is on stand by. 1 • Current interval setting appears on the display. 2 Select the interval spacing while current setting appears on the disp[...]

10 To tune in to a preset station 1 Select a band (FM or AM). 2 Select a preset number for the station you store. Playing Back a Disc This System can play back the following discs—regular CD and CD-R/CD-RW (recorded either in the audio CD or MP3 format). • Caution for DualDisc playback The Non-DVD side of a “DualDisc” does not comply with t[...]

11 For MP3 playback According to the MP3 playback mode, 4 / 1 , ¡ / ¢ or numeric buttons work for the group selection or the track selection. Examples: When the MP3 play back mode is “GROUP.” You can change the MP3 playback mode by pressing FM MODE/MP3. • Each time you press the button, the MP3 playback mode changes as follows: TRACK: • O[...]

12 Playing Back a Tape To insert a tape You can play back type I tapes. To change the tape running direction To reverse the tape automatically Playing Back Other Equipment To connect other equipment By using a stereo mini plug cord (not supplied), you can connect equipment with analog audio output jacks such as an MD player, or a TV, etc. If the au[...]

13 Daily Operations —Sound & Other Adjustments Adjusting the Volume You can adjust the volume level from level 0 (VOL-MIN) to level 31 (VOL-MAX). To drop the volume in a moment Adjusting the Sound To emphasize the sound—SOUND TURBO This function emphasizes the sound. To reinforce the bass sound —AHB PRO You can reinforce the bass sound to[...]

14 Changing the Display Brightness —DIMMER You can dim the display window. Setting the Clock Without setting the built-in clock, you cannot use the Daily Timer (see page 20). • To exit from the clock setting, press CLOCK/TIMER as required. • To go back to the previous step, press CANCEL. 1 Activate the clock setting mode. • If you have alre[...]

15 Advanced Disc Operations Programming the Playing Order— Program Play You can arrange the playing order of the tracks (up to 32) before you start playback. • You cannot enjoy MP3 discs for program play. • You can repeat all the programmed tracks by pressing REPEAT. 1 Before starting playback, press PROGRAM. 2 Select a disc by pressing CD 1 [...]

16 To check the programmed contents While the PRGM indicator is shown on the display and before playback... To modify the program While the PRGM indicator is shown on the display and before playback... To exit from Program Play While the PRGM indicator is shown on the display... Pressing 7 also cancels Program Play. • While in Program Play (PRGM [...]

17 Playing Repeatedly—Repeat Play You can repeat playback. For CD: For MP3 (Track mode): For MP3 (Group mode): Prohibiting Disc Ejection—Child Lock You can lock the disc trays so that no one can eject the loaded discs. • This is possible while the System is on standby. While the disc trays are closed... • Only CD 1 0 can work for this funct[...]

18 Advanced Tape Operations Recording on a Tape You can use type I tapes for recording. • To play a tape, see page 12. 1 Insert a recordable cassette. 2 Check the tape running direction and Reverse mode settings on the display. To change the direction To change the Reverse mode if necessary Remote control Main unit CD 6 TAPE 23 7 AUX FM/AM REV.MO[...]

19 3 Select and start playing the source—“FM,” “AM,” “CD,” or “AUX IN.” • When recording a disc, you can also use “Synchronized Disc Recording” (see below). 4 Start recording. Synchronized Disc Recording You can start and stop both disc play and tape recording at the same time. To record the entire disc 1 Load a disc and ins[...]

20 Timer Operations Setting the Timer Using Daily Timer, you can wake up with music, etc. On the other hand, with Recording Timer, you can make a tape of a radio broadcast automatically. • You can store three Daily Timer settings and one Recording Timer setting; however, you can activate only one of the four settings above at the same time. • T[...]

21 1 Select one of the timer setting modes you want to set— Daily 1 Timer, Daily 2 Timer, Daily 3 Timer, or Recording Timer. 2 Make the timer setting as you want. For Daily Timers: 1 Set the hour then the minute for on-time. 2 Select the playback source—“TUNER FM,” “TUNER AM,” “CD,” “TAPE,” or “AUX IN.” 3 For “TUNER FM” [...]

22 Additional Information Learning More about This System Daily Operations—Playback (see pages 8 to 12) Listening to the Radio: • If you store a new station into an occupied preset number, the previously stored station in that number will be erased. • When you unplug the AC power cord or if a power failure occurs, the preset stations will be [...]

23 Timer Operations (see pages 20 and 21) • When you unplug the AC power cord or if a power failure occurs, the timer will be canceled. You need to set the clock first, then the timer again. • Without stopping the recording, you cannot change the source after Recording Timer starts recording. • You cannot use the SLEEP timer while activating [...]

24 Troubleshooting If you are having a problem with your System, check this list for a possible solution before calling for service. General: Adjustments or settings are suddenly canceled before you finish. ] There is a time limit. Repeat the procedure again. Operations are disabled. ] The built-in microprocessor may malfunction due to external ele[...]

25 Maintenance To get the best performance of the System, keep your discs, and mechanism clean. Handling discs • When removing the disc from its case, hold it at the edge while pressing the center hole lightly. • Do not touch the shiny surface of the disc, or bend the disc. • Put the disc back in its case after use to prevent warping. • Be [...]

26 Parts Index Refer to the pages to see how to use the buttons and controls. SET CANCEL FM MODE/ MP3 REV . MODE SLEEP A.ST ANDBY AHB PRO BASS/ TREBLE SOUND TURBO CLOCK /TIMER F ADE MUTING DISPLA Y PRESET UP VOLUME 1 4 7 10 2 5 8 3 6 9 10 RM-SUXG5U REMOTE CONTROL PRESET DOWN DIMMER ST ANDBY/ON CD 1 CD 2 CD 3 REPEA T CD 4 CD 5 PROGRAM RANDOM ST ANDB[...]

0605AIMMDWBET EN © 2005 Victor Company of Japan, Limited UX-G5 MICRO COMPONENT SYSTEM CAUTION for mains (AC) line BEFORE PLUGGING IN, do check that your mains (AC) line voltage corresponds with the position of the voltage selector switch provided on the outside of this equipment and, if different, reset the voltage selector switch, to prevent from[...]