Miele KM 520 manuel d'utilisation

Operating and Installation instructions Ceramic cooktops KM 520 To avoid the risk of accidents or damage to the appliance it is essential to read these instructions before it is installed or used for the first time. M.-Nr. 06 464 860 en - AU, NZ[...]

Description of the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Warning and Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Caring for the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Before using for [...]

KM 520 abcd Single circle zones e Residual heat indicators Control knob for cooking zone f Rear left g Rear right h Front right i Front left Description of the appliance 3[...]

Cooking zones Cooking zones KM 520 C in cm Rating in watts (230 V) y 14.5 1200 w 21.0 2300 x 14.5 1200 z 18.0 1800 Total: 6500 Description of the appliance 4[...]

This appliance complies with all relevant local and national safety requirements. Improper use of the appliance can, however, present a risk of both personal injury and material damage. To avoid the risk of accidents and damage to the appliance, please read these instructions carefully before installation and before using it for the first time. The[...]

Safety with children ~ Children should be supervised to ensure that they do not play with the appliance. ~ Older children may use the appliance only when its operation has been clearly explained to them and they are able to use it safely, recognising the dangers of misuse. They must be aware of the potential dangers caused by incorrect operation. ~[...]

Technical safety ~ Before installation, check the appliance for visible signs of damage. Do not install and use a damaged appliance. A damaged appliance is dangerous. ~ The electrical safety of this appliance can only be guaranteed when continuity is complete between it and an effective earthing system which complies with local and national safety [...]

~ If the connection cable is damaged, it must be replaced by a suitably qualified electrician with a specialist connection cable of type H 05 VV-F (pvc insulated), available from the Miele Spare Parts Department. ~ Do not connect the appliance to the mains electricity supply by a multi-socket unit or an extension lead. These do not guarantee the re[...]

~ For added protection, it is advisable to use heat-resistant pot holders or gloves when using the appliance. Do not let them get damp or wet, as this causes heat to transfer through the material more quickly with the risk of scalding or burning yourself. ~ Do not flambé under a rangehood. The flames could set the rangehood on fire. ~ Do not use t[...]

~ Do not allow either solid or liquid sugar, or pieces of plastic or aluminium foil to get onto the cooking zones when they are hot. If this should occur, switch off the appliance, and carefully scrape off all the sugar, plastic or aluminium residues from the cooktop whilst they are still hot, using a shielded scaper blade. Take care not to burn yo[...]

Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal and can normally be recycled. Ensure that any plastic wrappings, bags, etc. are disposed of safely and kept out of the reach of babies and young children. Danger of suffocation. Rather than just thro[...]

Please stick the extra data plate for the appliance supplied with this documentation in the space provided in the "After sales service" section of this booklet. Cleaning for the first time Remove any protective wrapping and stickers. Before using for the first time, clean the appliance with a damp cloth only and then wipe dry. Do not use [...]

Switching on and off Do not leave the appliance unattended whilst it is being used. Controls on cooking zones without extended areas can be turned through 360°. These cooking zones are switched on by turning the appropriate control clockwise or anti-clockwise to the required setting, and switched off by turning the control clockwise or anti-clockw[...]

Settings Cooking process Setting Melting butter, chocolate etc. Dissolving gelatine Preparing yoghurt 1-2 Thickening sauces containing egg yolk and butter Warming small quantities of food/liquid Keeping warm food which sticks easily Cooking rice 1-3 Warming liquid and semi-solid foods Thickening sauces, e.g. hollandaise Making porridge Preparing om[...]

Switching on an extended area Depending on model, the outer circle of a double circle zone or the extended cooking zone can be switched on to provide an extended cooking area when cooking with larger pans. Proceed as follows: ^ Turn the cooking zone control clockwise past "12" as far as it will go. ^ Then turn the control anti-clockwise b[...]

Pans – Pans made from any material can be used on a ceramic cooktop. However, Miele recommends to refrain from using cookware with an exposed copper or aluminium base as they may leave permanent visual marks on the ceramic surface. – The best pans are those with a thick base which is very slightly concave when cold. When heated, the base flatte[...]

Tips on saving energy – Use a pan lid whenever possible to minimise heat loss. Uncovered Covered – Select a smaller pan when cooking small quantities. A small pan on a small cooking zone uses less energy than a large, partially filled pan on a large cooking zone. – Use as little water as possible to cook with, and reduce the power setting onc[...]

Overheating protection Each cooking zone is equipped with overheating protection. An internal temperature limiter switches off the heating elements in the cooking zone before the ceramic surface overheats. Once the ceramic has cooled down to a safe level the heating will automatically switch back on again. Overheating can be caused by: – switchin[...]

For Miele branded cleaning and conditioning products see "Optional accessories". Do not use a steam cleaner to clean this appliance. The steam could reach electrical components and cause a short circuit. Only use proprietary cleaning products which are suitable for cleaning ceramic cooktops. Never use cleaners containing sand, soda, alkal[...]

Spots caused by limescale deposits, water and aluminium residues (which have a metalic appearance) can be removed using the ceramic cooktop cleaner. Should any sugar, plastic or aluminium foil spill or fall on to a hot cooking zone, first switch off the appliance. Then carefully scrape off all the sugar, plastic or aluminium residues from the cookt[...]

Repairs to electrical appliances must only be carried out by a suitably qualified and competent person in accordance with local and national safety regulations. Repairs and other work by unqualified persons could be dangerous. The manufacturer cannot be held liable for unauthorised work. Ensure that current is not supplied to the appliance until af[...]

Miele branded cleaning and conditioning products are available for your appliance. These can be ordered via the internet at www.miele-shop.com (depending on country) or from your Miele Spare Parts Department (see back cover). Ceramic and stainless steel cooktop cleaner 250 ml Removes heavy soiling, limescale deposits and aluminium residues Optional[...]

Safety instructions for installation Fit the wall units and rangehood before fitting the cooktop to avoid damaging the appliance. ~ The veneer or laminate coatings of worktops (or adjacent kitchen units) must be treated with 100 °C heat-resistant adhesive which will not dissolve or distort. Any backmoulds must be of heat-resistant material. ~ This[...]

Safety clearances Safety clearance above the cooktop A minimum safety clearance must be maintained between the appliance and the rangehood above it. See the rangehood manufacturer's operating and installation instructions for details. If the manufacturer's instructions are not available for the rangehood, a minimum safety clearance of at [...]

Before installing the appliance check that the location provides the required clearances from combustible material and if necessary provide protection to adjacent surfaces as required by regulations. The minimum side clearance from a cooktop to a combustible surface* shall be a 300 mm horizontal distance from the periphery of any electric burner. T[...]

Building-in dimensions KM 520 a Spring clamps b Building-in depth c Building-in depth for mains connection box d Front Installation 26[...]

Preparing the worktop ^ Make the worktop cut-out following the dimensions applicable. Remember to maintain a minimum safety distance from the back wall , as well as from any tall unit or side wall to the right or left of the cooktop. See "Safety clearances". ^ Seal the cut surfaces with a suitable heat-resistant sealant to avoid swelling [...]

Fixing the spring clamps Wooden Worktops ^ Position the spring clamps (supplied) a in the positions shown (see "Building-in dimensions") so that they are flush with the top edge of the cut-out, and secure with the 3.5 x 25 mm screws supplied. Granite and marble worktops ^ Position the spring clamps a , and secure using double-sided tape f[...]

Installing the cooktop ^ Feed the cooktop connection cable down through the cut-out. ^ Lightly position the cooktop on the spring clamps a . ^ Using both hands, press down evenly on the sides of the cooktop until it clicks into position. When doing this make sure that the seal under the cooktop sits flush with the worktop on all sides. This is impo[...]

Sealant Do not use any sealant unless expressly instructed to do so. The sealing strip under the edge of the top part of the cooktop provides a sufficient seal for the worktop. Do not use sealant between the frame of the top part of the cooktop and the worktop. This could cause difficulties if the cooktop ever needs to be taken out for servicing an[...]

Electrical connection All electrical work should be carried out by a suitably qualified and competent person, in strict accordance with national and local safety regulations. Installation, repairs and other work by unqualified persons could be dangerous. The manufacturer cannot be held liable for unauthorised work. Ensure power is not supplied to t[...]

Connection diagram Warning This appliance must only be connected to a 230 V or 240 V supply using the connection cable supplied in the accessory pack. Connection must be made in accordance with the connection diagram. The earth lead must be connected. Installation 32[...]

The address of the nearest Miele Customer Contact Centre is given on the back page. The voltage and rated load are given on the data plate. Please quote these data, together with the model description and serial number when contacting the Miele Customer Contact Centre. Space in which to adhere the extra data plate supplied with the appliance. Ensur[...]

34[...]

35[...]

Alteration rights reserved / 5008 M.-Nr. 06 464 860 / 03[...]