Smeg DI607C manuel d'utilisation

INSTRUCTION MANUAL DISHWASHER DI 607 BIO smeg Extra 3/1 Extra[...]

Contents 3 1. Safety and o p e r ating i nstructi o ns _________________________ _ 4 2. Installat i on a nd hook- u p _________________________________ _ 7 3. Descript i on of the contr o ls _______________________________ _ 11 4. Operati n g ins t r uctions __________________________________ _ 20 5. Cle a n i ng a nd m a int e nan c e ____________[...]

Safety instructions 4 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULL Y READ ALL THE INSTRU CTIONS CONTAINED IN THIS MANUAL. INSTALLATI ON MUST BE PERFORMED BY A QUALIFIED TECHNICIAN, IN COMPLIANCE WITH THE RE G[...]

Safety instructions 5 THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT ( WEEE ). BY ENSURING THIS PRODUCT IS DISPOSED OF CORREC TLY, YOU WILL HELP PREVENT POTENTIAL NEGATIVE CONSEQUENCES FOR THE ENVIRONMENT AND HUMAN HEALTH, WHICH COULD OTHERWISE B E CAUSED BY INAPPROPRIATE WASTE H[...]

Safety instructions 6 DO NOT DRINK THE WATER RESIDUES WHICH MAY BE PRESENT INSIDE THE DISHES OR DISHWASHER AT THE END OF THE WASHI NG PROGRAM AND BEFORE THE DRYING CYCLE. KNIVES AND OTHER SHARP-POINTED KITCHEN UTENSILS MUST BE PLACED IN THE CUTLERY BASKET WITH THEIR TIPS FACING DOWNWARD. AQU AS TO P MO DE LS THE AQUASTOP DEVICE PREVENTS FLOODING IN[...]

Installation instructions 7 2. Inst allation and hook-up Remove the polystyrene basket retainers. Position the appliance in the desired place of installatio n. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source, fit the spec ial insulating panel to prevent o[...]

Installation instructions 8 2.1 Water supply connection Preventing the risk of clogging or damage: if the w ater pipe is new or has not been used for a long time, before connecti ng to the water supply check that the water is clear and free of impurities, to prevent damage to the appliance. The dishwasher must always be connected to the water syste[...]

Installation instructions 9 IF THE APPLIA NCE IS PROVIDED WITH A PLUGLESS SUPPLY CORD: IT IS NECESSARY TO INSTALL IN THE FIXED WIRING AN ALL-POLE DISCONNECTION DEVICE HAVING A GAP BETWEEN CONTA CTS OF AT LEAST 3.5MM . AFTER INSTALLATION THE DI SCONNECTION DEVICE HAS TO BE EASY TO REACH. THE CONNECTION TO THE MAINS MUS T BE CARRIED OUT B Y A QUALIFI[...]

Installation instructions 10 FOR UK ONLY: THIS APPLIANCE MUST BE E ARTHED. Fuse replacemen t If the mains lead of this applianc e is fitted with a BS 1363 A 13amp fused plug, to change a fuse in this type of plug use a n A.S . T. A. approved fuse to BS 136 2 type and proceed as follo ws: 1. Remove the fuse cover A and fuse B . 2. Fit replacement 13[...]

User instructions 11 3. Description of the controls 3.1 Upper panel All the dishwasher c ontrols are group ed on the up per panel. S witch-on, programming, switch-off etc. procedures are onl y possible when the door is open. 1 ON/OFF BUTTON Pressing this button energises the appliance. 2 SELECTED PROGRAM INDICATOR LIGHTS Illumination of this light [...]

User instructions 12 8 "3/1" OPTION BUTTON Press this button to activate the option for use of 3/1 products. 9 "3/1" OPTION LIGHT Illuminates to indicate that the function is activated. 10 PROGRAM DELAY BUTTON Press this button to delay the start of the program by up to 9 hours. 11 INFORMATION DISPLAY SETTING THE WASHING PROGRAM[...]

User instructions 13 After using the table to identify the most appr opriate washing program: x press the ON/OFF button (1) and wait for the PROGR AM INDICATOR LIGHT (2) to illuminate; x keep pressing the PROGRAM SELECTION button (3) until the indicator light corresponding to the desired program illumi nates; x close the door; after about 2" t[...]

User instructions 14 Only run the soak program with half loads. The 3/1 option (8) can be selected in all programs except the soak program. To execute programs 6,7,8,9,10 users must first press the extra programs button (6). (*) Reference program as per EN 50242 standard. (**) 20 grams in the detergent d i sp e nser + 5 grams in the tank. (–) Not[...]

User instructions 15 The washing cycle will not take place if the dishwasher door is left open or not properly closed. TABLE FOR CERTIFICATION BODIES Reference sta ndard EN 50242 Reference program BIO Load 7 place-sett ings Type of detergent B Amount of detergent 21 g Rinse aid setting 5/6 3.2 Washing programs Before starting a washing program make[...]

User instructions 16 CHANGING THE PROGRAM To change the progr am in progress, simply open the door and select a new program. When the door is closed the dishwasher will automaticall y select the new program. EXTRA PROGRAMS Button (6) gives access to fi ve extra programs in addition to the ones which can be selected directly using the program select[...]

User instructions 17 DELAYING THE PROGRAM (available in all programs except the soak program) The PROGRAM DELAY button (10) can be pressed to delay the start of the program by up to 9 hours . This means that the dish washer can be operated at the time of day of your choic e. Press the button several times in succession and the displa y will show th[...]

User instructions 18 ADJUSTING THE WATER SOFTENING SYSTEM N.B.: for the setting belo w to be possible, a washing program other than the soak program must be set. Press the PROGRAM DELA Y button (10) and keep it pressed until th e preset value appears follo wed by a full stop (normally 3. ). Release the button then press it agai n in succession to d[...]

User instructions 19 If the door has to be opened while w ashing is in pr ogress, the progr am will be interrupted. The relativ e light will keep flashi ng and a beeper wil l signal that the cycle has not been compl eted. When the door is closed the program will c ontinue from where it was interrupted. This o peration should only be carried out if [...]

User instructions 20 4. Operating instructions Once the dishwasher has b een correctly installed, pr epare for use as follows: x Adjust the water softening system; x Add the regen erating salt; x Add the rins e aid and detergent. 4.1 Using the water softening system The amount of scale contai ned in the water (w ater hardness in dex) can cau se whi[...]

User instructions 21 x Do not use table salt as it contains insoluble substanc es which, over time, may damage the water softening system. x When necessary, refill the r egenerating salt container before starting the washing program . In this way, the excess sal ine solution will be immediately removed by the water; the prolonged presence of salt w[...]

User instructions 22 ADDING THE RINSE AID The rinse aid helps the d ishes dry faster and prevents the formation of scale deposits and staini ng; it is automaticall y added to the water during the final rinse cycle, from the container situated on the inner side of the door. To add rinse aid: x Open the door. x Open the door S . x Add the rinse aid u[...]

User instructions 23 ADDING THE DETERGENT After adding the detergent, to close th e lid slide it in the dir ection shown by the arrow as far as it will go then press gently to lock. During washing, the dispenser will be opened automatically. x Use only det ergents specially formulated for dis hwashers. For optimal washing results it is important to[...]

User instructions 24 x "3/1" Products If you wish to use detergents which already contain salt and rinse aid, check whether your dishwasher is fitted with the " 3 /1 opti on button " on the " Controls description " page and t hen refer to the section which explains how to use this funct ion. If the button is not provid[...]

User instructions 25 WARNING! x Make sure that the dishes are securely in pla ce so that they cannot tip over or obstruct the rotation of the spray arms duri ng the washing cycle. x Do not place very small obj ects in the baskets as these coul d fall and obstruct the spray arms or the wash pump. x Containers such as cups, bowls, glasses and pots sh[...]

User instructions 26 4.4 Using the baskets The dishwasher has a capacity of 7 place-settings , includi ng serving dishes. CAUTION: do not place items in positions where they prevent t he detergent dispenser hatch from opening properly.      GI     [...]

User instructions 27 The basket is fi tted with plate racks which can be stowed horizontal if required. CUTLERY BASKET Cutlery must be placed with the tips facing do wnward .      GI     [...]

User instructions 28 5. Cleaning and maintenance Before carrying out any work, always disconnect the appliance from the electrical power supply. 5.1 General warnings and recommendations Avoid the use of acidic or abrasive detergents. Clean the outer surfaces and door-lining of the dishwasher regularly using a soft cloth moistened with water or with[...]

User instructions 29 To remove the top spray arm, take off the retainer ring-nut. Wash it i n a jet of water and fit it into place correctly, checking that there are no impediments of any kind prev enting it from turning freely. CLEANING THE FILTER UNIT x The central filter C should be insp ected regularly and cl eaned if necessary. x T o remove it[...]

User instructions 30 GENERAL WARNINGS AND RECOMME NDATIONS FOR CO RRECT MAINTENANCE: x The filters shou ld be cleaned under running wate r using a stiff brush. x When removing the filter , take care that there are no food residues on it. If any residues fall into the washing pit they might block hydraulic components, or foul the spray arm nozzles. [...]

User instructions 31 If the dishes do not co me out clean, check that: x the correct amount of detergent has been ad ded; x there is regenerating salt inside the special container; x the dishes are being load ed correctly; x the selected program is suitable for the dish types and thei r degree of soiling; x all the filters are clean and position ed[...]

User instructions 32 6. T roubleshooting The dishwasher is capable of signalling a n umber of faults through the simultaneous illumination of several indicator lights, with the following meanings: FAU LT DESCRIPT ION E3 Water heating malfunction The water is not heated or the heating parameters are not correct. Repeat the washing program; if the pr[...]

User instructions 33 If an alarm occurs the appliance interrupts the program in progress and signals a fault. x Alarms E3 , E4 and E9 interrupt the current program immediately. x The E5 , E6 alarms interrupts the running program once the cause is resolved, it will bring bach the ex ecution of the program. x The alarm E7 is visualized at the end of [...]

[...]

898 898 896 896 894 894 0 5 10 10 15 15 20 20 25 25 30 30 35 35 40 40 45 45 50 50 55 55 MAX MAX MIN MIN SX SX DX DX SX SX DX DX 55 55 50 50 898 898 896 896 894 894 0 5 10 10 15 15 20 20 25 25 30 30 35 35 40 40 45 45[...]