Smeg STA6245 manuel d'utilisation

INSTRUCTION MANUAL GUIDE FOR USING THE DISHWA SH ER AND THE WASHING PROGRAMS[...]

Contents 1 1. Safety and operati ng instructions ___________________________ 2 2. Installation an d hook-up ___________________________________ 5 3. Description of t he controls _________________________________ 9 4. Operating inst ructions ___________________________________ 15 5. Cleaning and maintenance _______________________________ 27 6. Trou[...]

Safety instructions 2 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLI ANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULL Y READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL. INSTALLATION MUST BE PERFORMED B Y A QUALIFIED TECHNICIAN, IN COMPLIANCE WITH THE REGU[...]

Safety instructions 3 OBSOLETE APPLIANCES MUST BE RENDERED UNUSABLE. CUT OFF THE MAINS POWER CORD AFTER UNPLUGGI NG IT FROM THE WALL OUTLET, AND MAKE SAFE ANY COMPONENTS WHICH MIGHT BE DANGEROUS FOR CHILDREN (LOCKS, DOORS, ETC.). THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT ( W[...]

Safety instructions 4 LEANING OR SITTING ON THE DISHWASHER DOOR WHEN OPEN MA Y CAUSE THE APPLIANCE TO OVERTURN, PUTING PEOPLE AT RISK. NEVER LEAVE THE DISHWASHER DOOR OPEN; PEOPLE MIGHT TRIP OVER IT. DO NOT DRINK THE WATER RESIDUES WHICH MAY BE PRESENT INSIDE THE DISHES OR DISHWASHER AT THE END OF THE WASHING PROGRAM AND BEFORE THE DRYING CYCLE. KN[...]

Installation instructions 5 2. Inst allation and hook-up Remove the polystyrene bask et retainers. Position the appliance in the desired place of installation. The back or sides of the dish washer may be placed up a gainst walls or other furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent [...]

Installation instructions 6 CONNECTING TO THE WATER SUPPLY Connect the intake hose to a cold water supply with ¾” gas thread, inserting the filter A supplied w ith the dishwasher. Take care to screw the h ose firmly into place with your h ands and then complete b y tightening about ¼ of a turn with pliers . In dishwasher s equipped with the A C[...]

Installation instructions 7 2.2 Electrical connection and precaution s CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON THE INNER EDGE OF THE DOOR. THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET OUTLET MUST BE OF THE SAME TYPE AND MEET THE REGULATIONS IN FORCE. THE PL[...]

Installation instructions 8 FOR GREAT BRITAIN ONLY: THIS APPLIANCE MUST BE E ARTHED. Fuse replacemen t If the mains lead of this appl iance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use a n A.S .T .A. ap proved fuse to BS 1362 type and proceed as follo w s: 1. Remove the fuse cover A and fuse B . 2. Fit repla[...]

User instructions 9 3. Description of the controls 3.1 Upper panel All the dishwasher controls are gr ou ped on the upper panel. Switch-on, programming, switch-off etc. procedur es are onl y possible when the door is open. 1 ON/OFF BUTTON Pressing this button energises the appl iance. 2 SELECTED PROGRAM INDICATOR LIGHTS Illumination of this light d[...]

User instructions 10 8 DELAYED START BUTTON (on some models only) Pressing this button in sequence delays th e start of the program by 3, 6 or 9 hours. 9 DELAYED START LIGHTS (on some models only) Illuminate to show that start delayed by 3, 6 or 9 hours has been set. SETTING THE WASHING PROGRAM A ND SWITCHING ON To select the most suitable program [...]

User instructions 11 DURATION CONSUMPTION PROGRAMME, NUMBER & SYMBOL LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS MINUTES (2) WATER LITRES (1) POWER KWh (2) 1 SOAK Pans and dishes awaiting completi on of the load Cold prewash 15' 6 0,03 2 LIGHT Delicate dish es with light dirt Wash at 45°C Cold rinse Rinse at 70°C Dry 80' 12 1,00 3 EC[...]

User instructions 12 3.2 Washing programs Before starting a washing pro g ram make sure that: • The water supply tap is open. • The correct amount of detergent has been added to the dispenser . • The baskets have been correctly lo ad ed. • The spray arms are abl e to rotate freely and without obstruction. • The dishwasher door is secur el[...]

User instructions 13 CANCELLING THE CURRENT PROGRAM • To cancel the currentl y sele cted program, open the door and hol d down the PROGRAM SELECTION (3) button for a few seconds until the indicator lights for programs 4 and 5 illuminate simultaneously (the word "end" is displ ayed on the window). • Close the door. • After approximat[...]

User instructions 14 If the door has to be opened while washing is in progress, the progr am will be interrupted. The relativ e light will keep flashing and a bee per will signal that the cycle has not been completed. You must wait about 1 minute before closing the door to rest art the program. When the door i s closed the program will continue fro[...]

User instructions 15 4. Operating instructions Once the dishwasher h as been correctly installed, prepare for us e as follows: • Adjust the water softening system; • Add the regenerating salt; • Add the rinse aid and deter ge nt. 4.1 Using the water softening system The amount of scale contain ed in the water (water hardness inde x) can cause[...]

User instructions 16 • Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system. • When necessary, refill the r ege nerating salt container before starting the washing program . In this way, the exce ss saline solution will be immediately remove d by the water; the prolonged presence of s[...]

User instructions 17 WATER HARDNESS TABLE WATER HARDNESS German Degrees (°dH) French D egrees (° dF) SETTING 0 - 4 0 - 7 Setting N. 1 NO SALT 5 - 15 8 - 25 Setting N. 1 16 - 23 26 - 40 Setting N. 2 24 - 31 41 - 60 Setting N. 3 32 - 47 61 - 80 Setting N. 4 48 - 58 81 - 100 Setting N. 5 Contact your local w ater board for informati on on the hardne[...]

User instructions 18 ADDING THE RINSE AID The rinse aid he lps the dishes dry faster and prevents the formation of scale deposits and staining; it is automatic all y added to the water during the final rinse c ycle, from the container situated on the inner side of the door. To add rinse aid: • Open the door. • Rotate the container cap anticlock[...]

User instructions 19 ADDING THE DETERGENT To open the detergent dispenser cap, l ightly press the button P . Add the detergent and clos e the cap carefully. During the washing cycle, the disp enser will be opened automatically. • When a program with ho t prewash is sele cted (see p rogram table), extra detergent must be placed in the cavity G/H ([...]

User instructions 20 • "3/1" Products If you wish to use detergents which already contain salt and rinse aid, check whether your dis hwasher is fitted with the " 3/1 option button " on the " Controls description " page and then ref er to the section which explains how to use this funct ion. If the button is not provi[...]

User instructions 21 WARNING! • Make sure that the dishes are secu rely in place so that they cannot tip over or obstruct the rotati on of the spray arms during the washing cycle. • Do not place very small obj ects in the baskets as these could fall and obstruct the spray arms or the wash pump. • Containers such as cups, bowls, glasses and po[...]

User instructions 22 4.4 Using the baskets The dishwasher has a capacit y of 12 place-settings , including serving dishes. LOWER BASKET The lower basket receives the full force o f the lower spray arm, and should therefore be use d for the “t oughest” items with a heavier degree of soiling. All types and combinatio ns of loads are permitted, pr[...]

User instructions 23 CUTLERY BASKET The cutlery should be arrang ed in an orderly manner inside the basket, with the handles pointin g downwards. Take care during loadi ng to avoid injury from the knife blades. T he basket is suitabl e for al l t ypes of cutler y, except those l ong enough to interfere w ith the upper s pray arm. Ladles, wooden spo[...]

User instructions 24 UPPER BASKET It is recommended to load the upper bask et with small- or medium-sized items such as glass es, small plates, tea or coffee cups, shall ow bowls and light objec ts made from heat resistant plastic. If the upper basket is used in the lowermost pos ition , it can als o be loa ded with ser ving dishes, provided they a[...]

User instructions 25 ADJUSTING THE UPPER BA SKET The height of the top b asket can be adjusted to al low large dishes or pans to be placed in the bottom basket. The adjustment procedure m ay be type A , B or C , depending on the dishwasher model purchased. Version A : pull-out with adjustment in two positions on the right hand side. • Pull out th[...]

User instructions 26 Version C: with adjustment in three positions on both sides. The sides of the basket must always be set at the sam e height . This adjustment is only available on some “ maxi ” model dishwashers (at least 860 mm tall). • Raise the basket by pulling on the top e dge (1) , to the first or second catch depending on th e hei [...]

User instructions 27 5. Cleaning and maintenance Before carrying out any work, a lways unplug the appliance from the electrical supply or switch off the all-pole disconnection dev ice. 5.1 General warnings and recommendations Avoid the use of acidic or abrasi ve detergents. Clean the outer surfaces and door-linin g of the dishwasher regularly using[...]

User instructions 28 CLEANING THE FILTER UNIT • It is advisable to p eriodically inspect the centre filter C and, if necessary, to clean it. To remove the filter, grip th e tabs, turn them anticlockwise and lift upwards; • push the centre filter D from the underside to remove it from the micro-filter: • separate the two parts which make up th[...]

User instructions 29 BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE: • Check that there are no deposits of sludge or rust inside t he water pipe: if there are, allow the water to run from the water s upp ly tap for a few minutes. • Plug the power cord back into the socket. • Reconnect the water intake h o se and open the tap again. TRO[...]

User instructions 30 If the dishes fail to dry or remain dull, check that: • there is rinse aid inside the special c ontainer; • the rinse aid dispenser setting is correct; • the detergent used is of good quality and has not lost its effectiveness (for example, throu gh incorre ct storage, with the box left open). If the dishes show signs of [...]

User instructions 31 6. T roubleshooting The dishwasher is capable of signall ing a number of faults through the simultaneous illumination of several i ndicator lights, with the following meanings: FAULT DESCRIPTION E1 Acquastop failure The anti-flooding system has been activated (for the relevant models only). The system is tripped in case of wate[...]

User instructions 32 FAULT DESCRIPTION E7 Turbine flow-regulator malfunction (for the relevant models only) The appliance i s not able to "measure" the a mount of water loaded accurately. Interrupt the program and switch off the dish washer. Switch the dishwasher back on, program it again and start the washing cycle. If the probl em persi[...]

User instructions 33 TECHNICA L DA TA Width 597 ÷ 599 mm Depth measured flush with the outer edge of the control panel 550 mm H ei g h t (depending on models) from 820 mm to 870 mm from 860 mm to 910 mm Capacity 12 Standard place settings Water supply pressure min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar) Electrical characteristics See rating[...]

3/4” 3/4” 1/2” SW 32 MIN 40cm Cu ø10 N O TA: N.B.: REMARQUE: ANMERKUNG: Solamente alcuni modelli sono dotati di uno dei dispositivi sotto illustrati. Only some models are equipped with one of the two devices illustrated be low . seul quelques modèles sont munis de l’un de deux dispositifs illustrés ci-dessus. Nur einige Modelle verfügen[...]