SoundCraft Spirit Folio 4 manuel d'utilisation

[...]

Thank you for buying a SPI RIT FOL IO 4 mixer, brought t o y ou with p ride by t he S PIRI T team of P eter, Graham, Malcolm, M artin, P eter, B rian, George, Colin, T ony, Jam es, M ukesh, Andy , Candy and Simon. W e hope you have as much fun as we did! Owni ng a SPIRIT console brings you the expertise and suppor t of one of the industr y’s lead[...]

[...]

e[...]

[...]

e[...]

[...]

e[...]

[...]

e This group of switches selects a choice of sources for the STEREO LISTEN switch (see below). Any combination may be selected as required. A built-in 1kHz OSCILLA T OR provides a test tone for system tests or aligning T ape Machines. Press the switch to turn ON the oscillator and feed a 1kHz tone to the MIX and GROUP outputs at a fixed level. DON?[...]

Normally the Monitor and Phones outputs receive either the Mix signal or the 2 T rack Return signal, depending on the position of the MIX/2TK switch. STEREO LISTEN provides a further choice of sources from Aux Sends 5-8, Groups 1-4 or Stereo Returns PFL. The switches are non-interlocking to allow several sources to be monitored simultaneously . The[...]

You will probably use your SP IRI T FOLIO 4 with a wide r ange of different types of sound source, and these will be at varying signal levels. It is i m port ant to set the GAIN of the inputs corr ectly to give the best perfor mance. Set up the individual mono input channels as follows: • • Plug in the chosen source (usually the MI C i nput for[...]

While the connec tions to the FOLIO 4 for PA wor k are quite s traightf orward, recording is rather more dem anding because the m ixer is not only required to mix down input s i gnals but a l so t o provide a monitor mix for art ists to hear previously recorded tracks when overdubbing new parts. A typical 4-track set- up is as fo llows : • • Co[...]

Balan ced Input 2. Hot(+v e) 3. Cold( -ve) 1. Screen MONO INPUT CHANNEL Unbala nced Input 1. Screen 2. Hot(+ ve) Link 3 to 1 Hot (+ve) Cold (-ve) Gnd/Screen Signal Gnd/Screen Gnd/Screen Tip Ring Sleeve Unbalanced Balanced Ba l anced M i c I nput - XLR 3-Pole Jac k Unbal anced M i c Input - XL R MIC INPUT The mic i nput socket at the rear of the mix[...]

INSERT The pre-EQ Inser t is a break point in the channel signal path. I t allows the signal to be taken out of the mixer, through an external piece of equipment and then back into the m ixer to continue thr ough to the f inal output. The Insert is a 3-pole ‘A’ gauge jack socket, wh ich is normally bypassed. When a jack is insert ed, th e signa[...]

These contr ol s route the input channel signal to any one or more of eight Auxiliary busses. These combine th e sends from each channel, mixing them to separate outputs on the rear of the mixer. Since they are independent of the main outputs t hey can provide additional sources for foldback, effects processors or ex t ra loudspeaker ‘fil ls’. [...]

STEREO INPUT CHANNE LS 13-2 0 STEREO INPUT L & R These i nputs accept 3-pole ‘A’ gauge (TRS) jacks. Use t hese inputs for sources such as keybo a rds, d rum mac hines, sy nths, tape machi nes or as re turn s from processi n g un it s. The inputs are BALANCED for l ow noise and immunit y from i nterf erence, but you can use UNBALANCED source[...]

This send can be pre- fade and used in the same way as Aux Sends 1 & 2 for Foldback or as a Monitor feed, but for Effect s it is more appropriate for the Aux Send to fade up and down with the fader (PO S T-FADE). A M aster Section AUX3 PRE switch allows you to sw i tch all channel Aux 3 sends f rom pre- to post-fade acros s the whole mixer as r[...]

Just like the P FL switches on the channels, you can monitor the AUX 1-4 outputs by pressing the latching AFL switch. This rout es the AUX out put signal to the MO NITOR or P HONES, rep lacing any existing signal (norm ally the Monitor receives e i ther MI X or the Tape Ret urn, depending on the position of the MIX switch - see bel ow). The RIGHT P[...]

The three colour PPM Bargraph Meters normally fol low the Monitor selection to show the level of the S t ereo MIX outputs or 2-T rack Tape Ret urns, giving y ou a constant warning of exc essive peaks in the signal which might cause overloading. Alternatively they may be switc hed t o monitor a choice of Group or Auxiliary output s, the Stereo Retur[...]

STEREO PUBLIC ADDRESS In this basic PA Set-up, v arious sources are connec ted to the inputs, microphones to Mic inputs and keyboards etc. to L ine inputs. Note that som e gu itars will not produce suff icient level for a direct connect ion, and will requi re a Direct In j ection (DI ) box connected via the microphone input . The output is taken fr[...]

PUBLIC ADDRESS - STEREO + SIDE F I L L OR CENTRE F E ED In this second example an additional side fill or cent re speaker cluster is driven from Aux 7 & 8, Aux 4 or Aux 3 switched to Post -fade, with individual rotary fader contro l. Aux 7 & 8 woul d be ideal, since a Group can also feed these Aux sends if required. The individual channel A[...]

STEREO RECORDING The console m ay be used for 2-T rack or basic m ul titrac k recording, l ive or in the stud i o. T he set up is s i mi lar to the previous ex amples, but w i th the Mix L/ R Output feeding a 2-Track Tape M achine. T he tape out puts are brought back to the console for monitoring via t he 2-Track Tape Returns. Aux 1, 2 or 3 (global[...]

4-Track Reco rd ing The console m ay also be used for 4- T r ack recording. T he set up i s sim i lar to the previous examp l e, but with a 4-track recor der fed from the Group Outputs and brought back for monitoring via 4 line inputs. In this case a compressor /limiter is shown applied to one o f the mic channels via the insert. 23[...]

AFL (After Fade Liste n) a function t hat allows the ope rator to mo nitor the post -fa de signa l in a cha nnel indep endent ly of the main mix. Balance the rela tive levels of the left and r ight c hann els of a stereo s ignal. Balanced a method of aud io conne ction which ‘balanc es’ the signal bet wee n two wires and a scre en which ca rrie[...]

(Measured 20Hz - 20kHz RMS) Ω (inc. No ise @ 1kHz) (@ 1kHz, typical) Ω 25[...]

1 19.37 (4.70") 777.00 (30.59") 470.00 (18.50") 124.00 (4.88") 17.00 (0.67") 410.00 (16.14") Ω Ω Ω 26[...]

3 1 2 MONO INPUT CHANNEL STEREO INPUT CHANNEL STEREO RETURNS ▲ ▲ ➚ ➚ ➚ ➚ MASTER SECTION SY STE M BLOCK DIAGRAM 27[...]