Audiovox XR9000 manuale d’uso

128-7863 1 of 20 Page 1 Model XR9000 Owner ’s Manual IMPORT ANT ! In order to provide you with the highest level of security to your vehicle, this system is equipped with selectable manual override circuitry . It is possible that you will need to override you security system if the transmitter becomes lost, or inoperative due to battery failure. [...]

128-7863 2 of 20 Page 2  Additional Engine Immobilizer Output, (Optional Relay Required)  T rue Last Door Arming (Hardwire Only)  Defective Zone By-Pass  Defective Zone Chirp Confirmation (Unit Chirps T o Report Zone Cleared)  6 T one Mini Siren  Car Horn Output For Additional Alarm Response (Improved T iming T o Minimize RF Inter[...]

128-7863 3 of 20 Page 3 simply press button 1, (lock), two times within a one second time period. The system will now respond to that transmitter each time a button is pressed. NOTE: This system is custom configurable and can be set up to operate with a number of options controlled from any transmitter button or button com- bination. For reference,[...]

128-7863 4 of 20 Page 4  Doors Lock - Optional NOTE: If the optional Headlamp illumination feature has been added, and has been selected for operation when arming, as an added convenience, the sys- tem will turn on the headlights when the system is armed. The LCD Remote has the following response: ARMING THE SYSTEM - P ASSIVE (AUT OMA TIC) (Must[...]

128-7863 5 of 20 Page 5 transmitter button is activated, the drivers door only will unlock, pressing the unlock button a second time will cause all doors to unlock. NOTE: If your transmitter has been configured with single button Lock/Unlock, t o activate the all door unlock feature operate the Lock/Unlock button a second time within 3 seconds of t[...]

128-7863 6 of 20 Page 6 WARNING SIGNALS section of this manual to identify which zone was triggered.  Doors Unlock - Optional  2 S tep Doors Unlock - Optional NOTE: If the optional Headlamp illumination feature has been added and has been selected for operation when disarming, as an added convenience, the system will turn on the headlights wh[...]

128-7863 7 of 20 Page 7 1. Open the vehicle door . The alarm will sound. 2. Turn the ignition key to the on position. 3. Within 5 seconds, press and release the PBLED override switch. The alarm system will stop sounding and enter the (bypassed) mode. Y ou can now start and operate the vehicle normally . T ypically this override mode is used only if[...]

128-7863 8 of 20 Page 8 (As per the example, press and release 2 times to set the units digit to 2). 8. Turn the ignition switch to the off position. Immediately observe the LED flash pattern. Y ou will note the LED flashing five times, pause, and then flash two times, pause. This pattern will be repeated three times indicating the new code (52) ha[...]

128-7863 9 of 20 Page 9 again for 3 seconds. If the button is not pressed, the alarm will automatically stop after 30 seconds. Also if any transmitter button other than the Lock or Unlock button is pressed and released, the Panic mode will be turned off immediately. The normal function of this transmitter button will be suspended during the Panic s[...]

128-7863 10 of 20 Page 10 programmed, simply press the lock button of your keychain transmitter anytime during the remote start cycle. The shock sensor will be shunted for the entire run cycle and will resume normal operation after the remote start unit shuts off. Check with your installation center to determine if this feature has been pro- gramme[...]

128-7863 11 of 20 Page 11 2. Depress the brake pedal. 3. Open the hood. 4. Place the system in the Remote S tart Override mode. 5. Race the engine to above 4000 RPM. OPERA TING ON AUT OMA TIC ST ART UP TIMER MODE Y our system has the ability to automatically start the vehicle every 2 or 4 hours over a 48 hour period. This feature is especially usef[...]

128-7863 12 of 20 Page 12 NOTE: The feature that has been added to channel 3 will always be activated using the same transmitter button that remotely starts the vehicle. There is no way to move the channel 3 function to a different transmitter button. ADDITIONAL REMOTE FUNCTION (CHANNEL 4) This system has an additional feature that can be connected[...]

128-7863 13 of 20 Page 13 1) Place the gear selector in park. 2) Set the parking, (hand), brake. 3) Be certain your foot is off the brake pedal. 4) Press the program/Push-Button switch 2 times within 5 seconds. The parking lights will flash two times indicating the mode was successfully en- tered. If your parking lights flashed four times, this ind[...]

128-7863 14 of 20 Page 14 When the Panic Mode has been activated and the system is armed the vehicle's lights will flash, the siren and lock icon will be displayed on the LCD screen and the siren will beep. If the system is disarmed and the Panic Mode is activated, the lights will flash unlock icon will be displayed and the siren will beep on [...]

128-7863 15 of 20 Page 15 the door is closed or the zone clears, the transmitter will chirp 1 time, and the display will clear . When the vehicle is armed, and the hood or trunk, is opened or ajar , the transmitter will chirp 3 times, the lights will flash, and the display will indicate a hood or trunk trigger as shown on the previous page. When th[...]

128-7863 16 of 20 Page 16 ADDITIONAL REMOTE FEA TURES: The two way remote control unit allows you to access status information from the vehicle, check temperature, light the display , toggle the transmitter from beep tones to vibrate mode, initiate daily start timer , and temperature start. Selection of these and other features are shown below: NOT[...]

128-7863 17 of 20 Page 17 activated at the vehicle, you can toggle the feature on simultaneously pressing the Lock + Option buttons of the transmitter . The 24 hour icon will appear and the transmitter will emit a tone confirming the feature is active. Note: the unit will start once and run for the prescribed time. If you require more frequent star[...]

128-7863 18 of 20 Page 18 Battery Indicator: Y our transmitter has a battery indicator that is shown in the upper right corner of the screen as shown left. This icon indicates a new battery shown with 3 bars. As the battery deteriorates, the bars will disap- pear . 1 bar indicates the battery should be replaced. Replace battery with a fresh 1.5V AA[...]

128-7863 19 of 20 Page 19[...]

128-7863 20 of 20 Page 20 XR9000 SYSTEM FUNCTIONS A T A GLANCE DASH LED INDICA TORS RAPID FLASHING = P ASSIVE ARMING/ACTIVE REARMING SLOW FLASHING = ARMED OF F = DISARMED ON SOLID = V ALET MODE 3 FLASH...P AUSE = INT RUSI ON ZON E 3 2 FLASH...P AUSE = INT RUSI ON ZON E 2 1 FLASH...P AUSE = INT RUSI ON ZON E 1 SIREN CHIRP INDICA TORS 1 CHIRP * = A R[...]