Baumatic BWD1200SS manuale d’uso

BWD1200SS Washer dryer[...]

USER MANUAL FOR YOUR BAUMATIC BWD1200SS Washer dryer NOTE : This User Instruction Manual contains imp ortant information, including safety & installation p oints, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available fo r future reference; for you or any pers on not familiar w[...]

3 Contents Environmental note 4 Important safety information 5 – 6 Specifications 7 Description of the appliance 8 C o n t r o l p a n e l 9 P r o g r a m o p t i o n s 9 Wash program indicator neons 10 Wash program control kn ob 10 D r y i n g t i m e r c o n t r o l k n o b 1 0 D e t e r g e n t d r a w e r 1 1 Preparing the wash cycle 12 Prepa[...]

ENVIRONMENTAL NOTE Note : Before discarding an old appliance, switch off and disconnect it from the power supp ly. Cut off and render any plug useless. Cut the cable off directly behind th e appliance to prevent misuse. This should be undertake n by a competent person. Disable the door lock to make sure that children cannot get stuck inside the app[...]

IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the info rmation contained in this booklet, please contact the Baumatic Technical Department. General Safety o Repairs to your applia[...]

6 o Before the first use of the a ppliance, we advise that a 90 °C cotton wash is completed. No garments should be placed inside the machine; however a small amount of detergent must be used. During Use o It is recommended that the a ppliance is unplugged and the water supply is turned off after the machine is used. o This appliance is only design[...]

7 Specifications 9 19 wash programs 9 6kg wash load/kg drying load 9 1200 rpm maximum spin speed 9 LED indicating programs, function and wash cycle progress. 9 170 Minute drying time knob 9 Eco carbon tub 9 Maxi porthole 9 Automatic consumption reduction 9 Anti foam system 9 Overflow protection 9 Safety door lock 9 Electronic balance load control 9[...]

Description of the appliance A - Glass porthole door B - Filter C - Adjustable feet D - Top cover E - Drum F - Control panel 8[...]

Control panel A - Start button B - Pre wash button C - Additional rinse button D - Drying timer control knob E - Wash program indicator neons F - Wash program control knob G - On/Off button Wash program control knob This control knob allows you to select the wash program of your choice. Start button Once a wash program has been se lected, this butt[...]

Wash program indicator neons o During the wash cycle, the relevant wash program indicator neon will light, to advise what stage of the wash program the machine has reached. Wash program control knob o Turn this dial to select the wash or drying program that you require. Drying timer control knob o Turn this dial to select the drying time that you r[...]

Detergent drawer 1) Pre wash section This compartment should have deterg ent placed in it, if you are going to select a wash program that has a pre wash as part of it. 2) Main wash section This compartment should have detergen t placed in it (you should also put a water softening agent in this section, if you use one). The detergent will be added t[...]

Preparing the wash cycle Preparing your garments for washing o Your washing should be sorted out, according to the fabric type and the wash care symbol that is printed on the garment’s wash care label. (see separate section on wash care symbols). o Your washing should also be sorted out according to the degree of soiling. o Check all pockets on a[...]

A selection of wash care symbols o The wash care symbols should be used to help you to select the most suitable wash program. They will also help you to sort your laundry into different loads, depending on the fabric type and the highest temperature which the garment can be washed at. o If the wash care label does not appear in the above table, the[...]

Detergents and conditioners The amount of detergent that you n eed to use in your appliance, will depend on o The degree of soiling. Lightly soiled garments in general require less detergent. o The size of the wash load. A smaller wash load will require a reduction in the amount of detergent. o The hardness of your tap water. T he harder your water[...]

Wash program table (*) Program for wash and energy consumption assessment, in accordance with standard EN60456 (press intensive wash button). 15[...]

16 electing a wash program S 9 Load your laundry and put detergent in the relevant Close the porthole door firmly. 9 Switch on the appliance using the On/Off button, the Start 9 Select the most appropriate wash program for the garments that 9 Select any program options that you require, by pressing the Any program option that you select , will affe[...]

17 electing a separate drying program MPORTANT: Do not exceed th e maximum loads listed in the he timings in this table are approxim ate and refer to a wash load that 9 Load your laundry and then clos e the porthole door firmly. Turn the drying time control knob clockwise, to select a suitable 9 Turn the wash program contro l knob clockwise to the [...]

18 electing an automatic wash and dry program 9 Load your laundry and then clos e the porthole door firmly. Turn the drying time control knob clockwise, to select a suitable 9 Select the most appropriate wash program for the garments that 9 Select any program options that you require, by pressing the Any program option that you select , will affect[...]

19 ancelling or pausing a wash program To stop a wash program once a wash cycle is in progress, you n. o The appliance will go onto PAUSE status and the wash program At this stage you can either rese lect a different wash program by o IMPORTANT: You should only select a new wash program if the o Alternatively you can turn the wa sh program control [...]

Maintenance and cleaning In daily use 9 Once a wash cycle has comple ted, you should pull out the detergent drawer slightly , so it can dry out. 9 Leave the porthole door ajar for a short while after a wash cycle has completed. This should help to prevent stagnant smells and to protect the door seal. 9 Close the water tap. 9 We suggest that you dis[...]

o Use warm water and a brush to thoroughly clean the three compartments of the detergent drawer. o Clean the area that the detergen t drawer slides into with a brush. o Replace the detergent drawer by placing it back into the slot. Then push the drawer fu lly back into position. The washer dryer drum The drum of your washer dryer is constructed fro[...]

Poor wash results My garments are looking gr ey and there are limescale deposits present in the drum of my washer dryer. o There is not enough detergent being added. o The incorrect detergent is being used. o Stains are not being pre-treated. o The correct wash program or wash temperature was not selected. I have followed the advice given above, bu[...]

Cleaning the drain pump filter IMPORTANT: Switch off your washer dryer and disconnect the plug from your mains supply. You should clean out the filter approximately every twenty washes. If the drain pump filter is not cleaned regularly, then your appliance may find it difficult to pump out wate r efficiently. o Open the flap that covers the filter.[...]

o Remove the filter and rinse out the filter under the tap. Remove any debris from the filter. o Remove any debris that is in th e area of the appliance that you removed the drain pump filter from. o Screw the filter clockwise back into position, making sure that it is fully tightened. You should keep turning until you cannot turn it any further. o[...]

25 Removing stains Garments that are covered in stains , grease or are heavily soiled may need to be pre-washed or soaked before being placed inside of the washing machine. o Soaking helps to remove protein- type stains, like blood, milk or grass. o Pre-washing helps to loosen soil before the main wash. Stain removal rules o Use warm water for soak[...]

26 Stain removal guide STAIN TO REMOVE Blood Rinse immediately in COLD water. If the stain remains, soak in cold water with an enzyme pre- wash. Chewing gum Use ice in a plastic bag to harden the gum. Scrape off what you can and the n sponge with white spirit. Chocolate/ Cocoa Sponge with COLD water an d th en soak in an enzyme pre- wash. If stains[...]

Installation IMPORTANT: THIS INSTALLATION MUST BE COMPLETED BY A SUITAB LY QUALIFIED PERSON. BAUMATIC ONLY SANCTION THE INSTALLATION GIVEN IN THIS INSTRUCTION MANUAL. YOU SHOULD KEEP THE TRANSIT PACKAGING, I N CASE YOU NEED TO TRANSPORT THE MACHINE IN THE FUTURE. Unpacking the machine and re moving the transit bolts 9 Remove any of the external pac[...]

9 There are four plastic covers that should be placed in the holes where the transit bolts were removed from. IMPORTANT: The transit bolts MUST be removed before your washing machine is used for the first time. Positioning and leve ling the appliance 9 Place the washing machine on a solid and level floor surface. 9 DO NOT PLACE THE WASHING MACHINE [...]

9 Once leveled correctly, you should tighten the lock nut back up on each of the washing machine feet using a spanner. IMPORTANT: When the washing machine is positioned in the location where it will be used. Make sure that all four feet are resting firmly on the floor, by pressing down on ea ch corner and checking that the appliance stands still. C[...]

9 IMPORTANT: There should be a filter si tting inside the end of the inlet hose that connects to your mains water supply. The inlet hose may leak if this filter is missing . This filter is supplied with the appliance, you should contact Baum atic to obtain one, if it is missing. 9 Tighten the inlet hose to your ma ins supply fully, but do not over [...]

Power supply 9 IMPORTANT: The electrical socket must still be accessible once the appliance is installed. 9 Consult the rating plate, located on the back of the appliance BEFORE making the electrical connections. Ensure that the voltage reaching the plug, is the same as that on the rating plate. 9 DO NOT REMOVE THE RATING PLATE AS THE INFORMATION O[...]

Before first use ma intenance wash o When your washer dryer has b een correctly installed, we recommend that you perform a maintenance wash cycle. o This will check that all aspects of the installation are correct; it will also remove any deposits that may have been left on the drum by the manufacturing process. o Select the Cotton 90°C wash progr[...]

33 Troubleshooting chart Problem Checkpoint o The washer will not operate at all. o Is there a power failure? o Is the power cord correctly connected to the electrical outlet? o Did you turn on the power? o Did you press the On/Off button? o Is there the correct amount of laundry in the washer? o Water is not entering the drum. o Did you connect th[...]

IMPORTANT: If your appliance appears not to be operating correctly, then yo u should disconnect it from your mains supply and then contact the Baumatic Service Department on telephone number (0118) 933 6911. DO NOT ATTEMPT TO REPAIR THE APPLIANCE YOURSELF. Please note that if an engineer is asked to attend whilst the product is under guarantee and [...]

35 General troubleshooting Water under the washer dryer o Tighten the drain pump filter. o Check the drain and inlet hose and make sure that they are both fully tightened. Washer dryer vibrates during the spin cycle o Check that the transport locking devices have been removed (see installation instructions). o Make sure that the washing machine is [...]

36 United Kingdom Baumatic Ltd., Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX United Kingdom Sales Telephone (0118) 933 6900 Sales Fax (0118) 931 0035 Service Telephone (0118) 933 6911 Service Fax (0118) 986 9124 Spares Telephone (01235) 4372 44 Technical Advice Telephone (0118) 933 6933 E-mail: sales@baumatic.co.u k technical@baum[...]

37[...]

38[...]

39[...]

40 40[...]