Bosch Appliances BC2600RA manuale d’uso

SAR8854 Rev. 07/08 Installation Manual Bosch Eco26 + External Model BC2600RA Service Department: 1300 30 70 37 www.bosch.com.au To be installed and serviced only by an authorised person This appliance is not suitable for use as a pool heater The "authorised installing person" is responsible for: appliance. 2. Ensure unit performs to the s[...]

2 Installation Instructions Potential dangers from accidents during installation and use are divided into the following three categories. Closely observe these warnings, they are critical to your safety. Prohibited Disconnect Power Earth Be sure to do Requests to Installers • In order to use the water heater safely, read this installation manual [...]

3 Installation Instructions 1. Included Accessories The following accessories are included with the unit. Check for any missing items before starting installation. Q ’ ty Shape Part Tapping Screw 1 each Part Shape Q ’ ty 5 Owner's Guide, Installation Manual (this document) 2. Optional Accessories The accessories listed below are not includ[...]

4 Installation Instructions 3. Before Installation Do Not Use Equipment for Purposes Other Than Those Specified • Do not use for other than increasing the temperature of the water supply, as unexpected accidents may occur as a result. Check Water Supply Quality • If the water supply is hard, acidic or otherwise impure, treat the water with appr[...]

5 Installation Instructions 4. Choosing Installation Site * Locate the appliance in an area where water leakage from the unit or connections will not result in damage to the area adjacent to the appliance or to the lower floors of the structure. When such locations cannot be avoided, it is recommended that a suitable drain pan, adequately drained, [...]

6 Installation Instructions 5. Installation Clearances Before installing, check for the following: The location of the flue terminal must comply with the clearances shown on this page. If you are unsure about clearances not indicated here, in general refer to AS5601, or your local authority. In Western Australia refer to the WA Office of Energy rul[...]

7 Installation Instructions CLEARANCES FOR FLUE TERMINAL (front of heater) The location of the flue terminal must comply with the clearances shown on this page. If you are unsure about clearances not indicated here, in general refer to AS5601, or your local authority. In Western Australia refer to the WA Office of Energy rules and regulations. Use [...]

8 Installation Instructions Illustration 6. Installation Check 4. Drill holes for the remaining four screws. 5. Hang the unit again by the first screw, and then insert and tighten the remaining four screws. 6. Take waterproofing measures so that water does not enter the building from screws mounting the device. • Make sure the unit is installed s[...]

9 Installation Instructions Gas Connection 1) Fit a union to the water heater gas inlet for easy connec- tion and removal. The thread diameter is 20 mm. THIS DOES NOT INDICATE THE SIZE OF THE GAS SUPPLY. 2) Fit an AGA / NZGA approved isolating gas cock in the supply line adjacent to the water heater gas connection. 3) Ensure that the supply pipe an[...]

10 Installation Instructions 8. W ater Piping This appliance is suitable for potable water applications. Do not use this appliance if any part has been underwater. Immediately call a qualified service technician to inspect the appliance and replace any part of the control system and gas control which has been under water. Piping and components conn[...]

11 Installation Instructions Supply water piping • Do not use PVC, iron, or any piping which has been treated with chromates, boiler seal or other chemicals. • Pipe sizing from the cold water supply should be sized according to local BY LAWS for water supply. • If sludge or foreign matter is present in the water supply it is recommended that [...]

12 Installation Instructions PLEASE FOLLOW LOCAL CODES ABOUT CONDENSATE PIPING. • This water heater is a high efficiency, fully condensing appliance which produces condensate during operation. Therefore, it is necessary to install condensate piping. The water heater incorporates a col- lection, neutralization, and removal system which must be pro[...]

13 Installation Instructions Do not connect electrical power to the unit until all electrical wiring has been completed. Consult a qualified electrician for the electrical work. 10. Electrical Wiring This appliance must be electrically earthed in accordance with Electrical Authority Regulations. Caution: Label all wires prior to disconnection when [...]

14 Installation Instructions The remote controller will indicate when the neutralizer unit is in need of replacement by displaying an error code. Therefore, the remote controller should always be installed with this water heater in order to prevent an unexpected disruption of hot water service. The bathroom and sub controllers have a maximum temper[...]

15 Installation Instructions Remote controller cord • Use remote controller cord for any extensions. • Install according to the National Electrical Code and all applicable local codes. Connecting Remote Controller Cord to Unit • Tie the redundant cord outside the water heater. Do not put the extra length inside the water heater. • The remot[...]

16 Installation Instructions (1) Open a hot water fixture and confirm that the Burner On lamp comes on, and that hot water is being produced. (If necessary, repeat until the air in the gas piping is bled out). * White smoke may be noticed from the exhaust vent during cold weather. However, this is not a malfunction of the unit. * If an “ 11 ” e[...]

17 Installation Instructions Lighting Instructions This water heater does not have a pilot. It is equipped with an ignition device that automatically lights the burner. Do not try to light the burner by hand. 1. Read the safety information in the installation manual or on the right side of the water heater. 2. Turn off all electrical power to the u[...]

18 Installation Instructions 13. Dimensions 338 (VIEW FROM TOP) 279 243 136 100 60 HOT WATER OUTLET (R3/4) 177 48 58 141 179 GAS INLET (R3/4) DRAIN OUTLET (R1/2) COLD WATER INLET (R3/4) WIRING THROUGHWAYS 2-6.5 x 13 OBLONG HOLE 4- 13 4- 13 120 135 60 42 42 2- 6.5 120 85 50 10 10 622 13 567 600 566 31 10 10 20 28 267 334 350 260 3-6.5 x 16.5 OBLONG [...]