Braun Series A5 manuale d’uso

Vista DOT — Public Use Lift DOT — Public Use Lift “DOT — Public Use Lift” verifies that this platform lift meets the “public use lift” requirements of FMVSS No. 403. This lift may be installed on all vehicles appropriate for the size and weight of the lift, but must be installed on buses, school buses, and multi- purpose passenger veh[...]

NVL917IB e5*72/245*95/54*0110*00 1-800-THE LIFT™ BRAUNLIFT .COM™ The Braun Corporation DOT Public Use Lift MODEL# Max. Lifting Capacity - 800 lbs. PATE NT PENDING- 5,261,779-6,065,924-6,238,169-6,46 4,447-6,599,079-6,692,217-6,739,824 MFG DA TE 55 14CG PUMP CODE CYLINDER A5-00025 SERIAL NUMBER 09/20/06 W e at The Braun Corporation wish to expr [...]

Page 1 Contents T roubleshooting and Maintenance Lift T erminology ............................................................. 2 Switch and Sensor Locations ..................................... 3 Certi fi cation Checklist Diagnostic Procedures ......... 4 Platform Fold Pressure Adjustment ............................ 5 Platform Angle Adjustment[...]

Page 2 Lift T erminology UP D OWN 3 2 8 1 9 FOLD UN F O L D 3 2 8 2 0 ® Hand-Held Pendant Control T op Parallel Arms (2) Adjustable Quiet-Ride Stow Blocks (2) Main Cylinders (2) V ertical Arm Covers (4) Opposite Pump Side V ertical Arm Handrails (2) Outer Barrier (Automatic Outboard Roll Stop) Bottom Parallel Arms (2) Upper Fold Arm (2) Pump Side [...]

Page 3 * Outer Barrier Raised Magnetic Sensor 30433A60 * Ground Detect Magnet 31664 * Ground Detect Magnetic Sensor 30433A60 * Outer Barrier Raised Magnet 31664 Threshold Strip Switch 31221A (Qty . 2) * Bridging Microswitch 975-0443RNA (Rear Pump) 975-0443FNA (Front Pump) * IB Occupancy Microswitch Assy . 31643A * Rotary Position Sensor 31 194A * S[...]

Page 4 Certification Checklist Diagnostic Pr ocedur es The following operations and conditions must be functionally veri fi ed in order for the lift to be FMVSS 403/404 compliant. If an operation does not function as described or a condition is not met, follow the refer- enced procedures to correct the problem or contact a Braun Corporation Produ[...]

Page 5 1. Position the platform at the fl oor level loading position. 2. Loosen the hex nut on the adjustment screw (do not remove hex nut). 3. T urn the adjustment screw counter clockwise until the platform does not fold when the Fold button is pressed. 4. T urn the adjustment screw clockwise in 1/4 turn increments and press the Fold button until[...]

Page 6 Platform Angle Adjustment Wedges Angle A equals Angle B . ✓ B Figur e C A Approximately 1” Clearance Figur e D Millennium “NL” Series Century “NCL” Series Vista “NVL” Series Inboard Outboard Inboard Outboard Wedges T oe must angle down slightly . Barrier must unfold fully . Adjusting the platform angle based on the relationsh[...]

Page 7 Platform Angle Adjustment Screws Adjustment Screw Allen Head A B Platform Angle Adjustment Adjustment Allen screws are provided on each side of the lift platform for adjusting the platform angle. Adjust platform angle as speci fi ed on previous page. Platform Stop Blocks Must make full contact .G a p not permitted . Both stop blocks must ma[...]

Page 8 Platform Floor Level Adjustment Diagnostics: Diagnostic codes have been established in event the lift platform fl oor position does not set (the lift does not sound three “beeps” - see Step 5 above). The control board located inside the pump hous- 91 – The platform position is out of a prede- termined acceptable range 92 – The Bridg[...]

Page 9 H G Platform Stop Block Inboard V ertical Edge of V ertical Arm Bridging Microswitch Adjustment Screw Bridging Micr oswitch Adjustment Bridging Microswitch: The bridging microswitch is located at the bottom of the right (front) vertical arm. See Photos A and B. An adjust- ment screw is built into the platform stop block. The bridging microsw[...]

Page 10 T o better understand the Braun LCD T rouble shooting display you must fi rst understand the numbers that appear on the screen. There are Flashing Codes, Solid Error Codes, and Solid Normal Operational Codes. Flashing Codes #65-89: About 10 seconds after an operation has stopped there are a set of scrolling fl ashing numbers that indicate[...]

Page 1 1 57 – Outer barrier is not up and latched and ground detect switch did not deactivate (Century and Vista only) 58 – Outer barrier is not up and latched and the plat- form is 3” above the ground 59 – Outer barrier is not up after pausing platform travel 60 – V erify the IB occupied switch is functioning cor- rectly when lift is bel[...]

Page 12 U P D O W N 3 2 8 19 F OL D UNFO L D 3 2 82 0 ® Speci fi ed (recommended) A vailable Braun Lubricant T ype Lubricant Amount Part No. LO - Light Oil LG - Light Grease Light Grease Lubriplate 14 oz. (Multipurpose) Can Light Penetrating Oil LPS2, General Purpose 1 1 oz. (30 weight or equivalent) Penetrating Oil Aerosol Can Stainless Stick Do[...]

Page 13 Maintenance and Lubrication Schedule Maintenance and lubrication procedures must be performed as speci fi ed by an authorized service technician. Failure to do so may result in serious bodily injury and/or property damage. Proper maintenance is necessary to ensure safe, troublefree operation. Inspecting the lift for any wear , damage or ot[...]

Page 14 1500 Cycles 750 Cycles Maintenance and Lubrication Schedule continued Perform all procedures listed in previous sections also Resecure, replace damaged parts or otherwise correct as needed. Note: Apply Light Grease to Lift-T ite ™ latch tower pivot point if replacing latch. Correct or replace damaged parts. Remove foreign objects, replace[...]

Page 15 1500 Cycles continued Resecure or replace if needed. Realign towers and vertical arms. Lubri- cate or correct as needed. Resecure or replace if needed. Replace damaged parts. Apply Light Oil to inner roll stop lock pivot points. Replace damaged parts and resecure as needed. Resecure, replace or correct as needed. Note: Apply Loctite ® to t[...]

Page 16 Maintenance and Lubrication Schedule Apply Door-Ease or replace if needed. See Lubri- cation Diagram. Resecure or replace if needed. Resecure, repair or replace if needed. Check to see that the lift is securely anchored to the vehicle and there are no loose bolts, broken welds, or stress fractures. Replace decals if worn, missing or illegib[...]

Page 17 Lift Electrical Schematic NVL917-05-025.ai BK(6) BK(4) GN(20) GN(20) GN BK GN BK BK RD RD RD OR GN RD RD RD BK GN OR YL(26) RD(26) GN(26) BU(16) GN(20) GN(20) GN(20) PK(20) WH(20) WH(20) GN(20) GN(20) GN(20) GN(20) GN(14) BK(18) UP/FOLD SOLENOID RD (2) PUMP RD(14) CIRCUIT SENTRY (CIRCUIT BREAKER) IN-LINE FUSE PLA TFORM LIGHTS (OPTION) INTER[...]

Page 18 Unfold for: Lift Electrical Schematic Lift Wiring Diagram Platform Lights (Option) Circuit Sentry ( Circuit Breaker) Bat. Aux. Lift Power Cable 205-0712-37 Pump Module Power Feed 26082A-4 Connects to Vehicle Battery (+) Positive Post Lead Wire 13362A GN(20) RD(14) ) 0 2 ( K B or Note polarity of diode. It must be oriented as shown. Detail a[...]

Page 19 Orifice Pump Side Cylinder BACKUP PUMP 2500 PSI Down Va lv e 1900 PSI PUMP Opposite Pump Cylinder M Orifice 800 PSI Secondary Va lv e Folding Relief V alve Lifting Relief V alve Fixed Displacement Pump V ented Reservoir Backup Pump Single Acting Cylinder Check V alve Manual Shutoff V alve 2 W ay 2 Position Solenoid V alve Pressure Compensat[...]

Page 20 Hydraulics Parts List Item Qty . Description Part # 1 1 Pump Assembly (M-268-01 12) 120G / 12V / Dual Relief 30915-12V 2 1 Lead Wire Assembly , #6 Guage 29049 3 1 Clamp, Hose (M258) 29663 4 1 Diode Assembly , Up Solenoid 73906A 5 1 Solenoid, 4-Post - Prestolite 28308 6 1 Motor , Pump - 12 V olt - Low RPM 29690 7 1 V alve Assembly , “Dual [...]

Page 21 27 Opposite Pump Cylinder Manual Backup Pump 24 25 21 12 15 27 23 22 30 19 1 16 6 13 29 28 Hydraulic Pump Motor Pump Side Cylinder 10 7 17 20 18 28 26 26 14 2 3 5 4 Hydraulics Diagram[...]

Page 22 Pump Module Parts List * Apply red #271 Thread Locker Loctite ® to the four hex bolts (items 26 and 27) if a blue nylon patch is not present on the bolts when retro fi tting an M268 pump assembly . Loctite ® is available from The Braun Corporation under part number 1 1522-1. t Indicates items available for replacement part purposes only [...]

Page 23 Pump Module Diagram Note: Rear pump module shown, front pump module mirror image. 44 37 43 42 41 40 39 4 7 3 38 38 26 27 25 28 29 27 1 14 12 23 15 2 21 30 31 33 34 36 35 22 16 19 20 9 10 18 5 13 8 6 11 b UP DOW N 3 2 8 1 9 FO L D UNFO LD 3 2 8 2 0 ® 11 c UNF OLD FOLD DOWN UP 3 2 35 3 11 a UP D O WN 3 2 8 1 9 FOLD UNFOLD 3 2 8 2 0 ® 24 Pum[...]

Page 24 Repair Parts List Part Numbers of Items Identical on All Lift Models 14 14 W asher, .516" I.D. x 1" O.D. x .0269", Auto BK 15328 15 4 Washer, Finger , Disc Spring 27276 16 8 Snap-Ring 1/2" 13273 17 4 Snap-Ring 5/16" 24570 18 4 O-Ring, 5/16" I.D. x 1/16" O.D. 26614 19 2 Screw, Socket Head, 3/8-16 x 1/2"[...]

Page 25 Exploded View 150 53 114 111 109 104 113 53 53 53 50 116 53 123 49 188 22 180 53 109 111 41 14 16 153 77 139 51 139 91 76 105 149 149 105 79 113 53 53 50 116 15 14 126 91 41 76 33 79 101 8 162 32 32 32 172 122 32 151 69 16 153 85 77 102 15 115 115 115 85 126 79 33 7 101 149 107 25 155 89 102 69 149 107 112 104 113 112 36 36 52 52 52 10 52 5[...]

Page 26 Unfold for: Series A5 NVL917IB Lift Exploded View NOTES This page intentionally left blank.[...]

Over 300 Braun Dealers W orldwide "Pr oviding Access to the W orld" ® "Pr oviding Access to the W orld" International Corporate Hdqrs: P .O. Box 310 Winamac, IN 46996 USA 1-800-THE LIFT ® (574) 946-6153 F AX: (574) 946-4670 ®[...]

Public Use Wheelchair Lifts Patent #5,261,779 Patent #6,065,924 Patent #6,238,169 Patent #5,261,779 Patent #6,065,924 Patent #6,238,169 Patent #6,464,447 Patent #6,599,079 Patent #6,692,217 Patent #6,464,447 Patent #6,599,079 Patent #6,692,217 Patent #6,739,824 Patent #6,837,670 Patents Pending Patent #6,739,824 Patent #6,837,670 Patents Pending Al[...]