Char-Broil 10101480 manuale d’uso

FOR OUTDOOR USE ONL Y If you have questions or need assistance during assembly , please call . T o insure your satisfaction and for follow-up service, register your appliance online at www .charbroil.com/register 1-800-241-7548 CA UTION: Read and follow all safety statements, assembly instructions, and use and care directions before attempting to a[...]

D ANGER Safety Symbols The symbols and boxes shown below explain what each heading means. Read and follow all of the messages found throughout the manual. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury . WARNING W ARNING: Indicates an potentially hazardous situation which, if not av[...]

3 WARNING CALIFORNIA PROPOSITION 65 1. Combustible by-products produced when using this product contains chemicals known to the State of California to cause cancer , birth defects, or other reproductive harm. 2. This product contains chemicals, including lead and lead compounds, known to the State of California to cause cancer , birth defects or ot[...]

4 Food Safety Food safety is a very important part of enjoying the outdoor cooking experience. T o keep food safe from harmful bacteria, follow these four basic steps: Clean: W ash hands, utensils, and surfaces with hot soapy water before and after handling raw meat and poultry . Separate: Separate raw meats and poultry from ready-to-eat foods to a[...]

• NEVER store a spare LP cylinder under or near the appliance or in an enclosed area. • Never fill a cylinder beyond 80% full. • An over filled or improperly stored cylinder is a hazard due to possible gas release from the safety relief valve. This could cause an intense fire with risk of property damage, serious injury or death. • If you s[...]

WARNING If “growing” bubbles appear do not use or move the LP cylinder . Contact an LP gas supplier or your fire department! Connecting Regulator to the LP Cylinder 1. LP cylinder must be properly secured onto . (Refer to assembly section.) 2. T urn all control knobs to the OFF position. 3. T urn LP cylinder OFF by turning hand-wheel clockwise [...]

6. T urn the coupling nut clockwise and tighten to a full stop. The regulator will seal on the back-check feature in the LP cylinder valve, resulting in some resistance. An additional one-half to three-quarters turn is required to complete the connection. Tighten by hand only – do not use tools. NOTE: If you cannot complete the connection, discon[...]

24” 3 ft. 3 ft. WARNING CA UTION • Putting out grease fires by closing the lid is not possible. This a ppliance is well ventilated for safety reasons. • Do not use water on a grease fire. Personal injury may result. If a grease fire develops, turn knobs and LP cylinder off. • Do not leave appliance unattended while burning off food residue.[...]

CA UTION If ignition does NOT occur in 5 seconds, turn the control knob OFF , wait 5 minutes and repeat the lighting procedure. If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidently ignite with risk of injury . T urn control knob and LP cylinder OFF when not in use. WARNING Ignitor Light[...]

Cleaning the Burner Assembly (Continued) 7. Clean inner burner as recommended below , shown E . We suggest three ways to clean the burner tube. Use the one easiest for you. (A) Bend a stiff wire (a light weight coat hanger works well) into a small hook. Run hook through burner tube several times. (B) Use a narrow bottle brush with a flexible handle[...]

This warranty only applies to units purchased from an authorized retailer . Manufacturer warrants to the original consumer-pur chaser only that this product shall be free from defects in workmanship and materials after correct assembly and under normal and reasonable home use for the periods indicated below beginning on the date of purchase*. The m[...]

P ARTS DIAGRAM NOTE: Some grill parts shown in the assembly steps may differ slightly in appearance from those on your particular model. However , the method of assembly remains the same. Q R K O F P M E D G I A B H J J C K N L S 12 T U V W X Key Qty Description O 4 Leg Assemblies P 1 Grease T ray Q 2 Grease T ray Rails R 1 V alve/Hose/Regulator S [...]

ASSEMBL Y 2 1 Qty: 12 #10-24x1/2" Screw Leg Assembly with Rating Label • Remove top cover , cooking basket and cooking pot. • T urn appliance upside down. • Attach legs to body using three #10-24 x 1/2" screws and three #10-24 Keps nuts for each leg. Insert screw through appliance body from outside, then through matching hole in leg[...]

3 Qty: 3 #10x3/8" Self-T ap Screw Make sure valve is centered with burner tube Burner T ube V alve end V alve and Burner Centered B A Electrode Spade end of ignitor wire D View is shown with unit upside-down Assemble the control panel to the appliance: Install 1 each #10x3/8” self-tap screw into the bottom hole of the Heat Shield shown below[...]

5 • Slide grease tray onto grease tray rails. • Insert Foil T ray Liner into Grease T ray as shown. Grease tray rails Grease T ray 15 Foil T ray Liner 4 • T urn appliance upright on its legs. Push on control knob and ignitor knob (A). • If not already assembled, slide handle springs onto side handles (B). • Attach side handles to applianc[...]

6 Cooking Pot Cooking Basket T op Cover 16 • Place cooking pot and cooking basket into appliance body and place the top cover as shown. • When cooking hang top cover on handle as shown. Once seasoning is complete, the appliance is now ready for use. The cooking chamber will continue to darken with use. This will inhibit rusting along with impro[...]

NOTES 17[...]

EMERGENCIES: If a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department. Emergencies Problem Gas leaking from cracked/cut/burned hose. Gas leaking from LP cylinder . Gas leaking from LP cylinder valve. Gas leaking between LP cylinder and regulator connection. Fire coming through control panel. Grease fire or cont[...]

T roubleshooting ( continued ) Possible Cause • Rotary knob rotates without clicking. • Sparking between ignitor and electrode. • See “GAS ISSUES:” on previous page. • Match will not reach. • Improper method of match-lighting. • Out of gas. • Excess flow valve on regulator tripped. • V apor lock at coupling nut/LP cylinder conne[...]

REGTEMP REV02 W arranty Registration Department P .O. Box 1240 Columbus, GA 31902-1240[...]