Cisco Systems 6509-NEB manuale d’uso

Corporate Headquarters: Copyright © 20 04–20 06 Cisco Systems, Inc. All rights reserved. Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA Catalyst 6509-NEB Switch and Cisco OSR-7609 Router Upgrade Note Product N umber: WS-6509-NEB-UPGR D= This publication d escribes ho w to upgr ade your Catalyst 65 09-NEB switch or Ci sco[...]

2 Catalyst 6509-NEB Switch and Cisc o OSR-7609 Ro uter Upgrade Note 78-16162-02 Contents Contents This publication co nsists of the following sections: • Safety Overvie w , page 2 • Parts List, page 3 • Required T ools, page 3 • Installation Guidelines, page 4 • Shutting Do wn the System, page 4 • Replacing the Panel Safety Cover , page[...]

3 Catalyst 6509-NEB Switch and Cisco OSR-7609 Router Upgrade Note 78-16162-02 Parts List War ni ng This unit might have more than one power supply connection. All connections must be removed to de-energize the unit. Statement 1028 War ni ng Only trained and qualified personn el should be allowed to install, replac e, or servic e this equipment. Sta[...]

4 Catalyst 6509-NEB Switch and Cisc o OSR-7609 Ro uter Upgrade Note 78-16162-02 Installation Guidelines Installation Guidelines Follo w these guidelines wh en upgrading the ch assis: • If your switch or rou ter is using an A C-input po wer supply , you are required to install t h e WS-CA C-3000W po wer supply . The 3000 W A C-input pro vides a po[...]

5 Catalyst 6509-NEB Switch and Cisco OSR-7609 Router Upgrade Note 78-16162-02 Replacing the Panel Safety Cover War ni ng This unit might have more than one power supply connection. All connections must be removed to de-energize the unit. Statement 1028 Step 2 Depending on ho w your system is pow e red, perform one of the tw o sets of substeps belo [...]

6 Catalyst 6509-NEB Switch and Cisc o OSR-7609 Ro uter Upgrade Note 78-16162-02 Replacing the Pa ne l Safety Cover Figur e 1 Removin g the P anel Saf ety Cover Step 3 On the ne w panel safety cov er , grasp the panel handl e and press th e panel into place, startin g at the bottom of the chassis and wo rking up. Be careful not to damage th e EMI ga[...]

7 Catalyst 6509-NEB Switch and Cisco OSR-7609 Router Upgrade Note 78-16162-02 Replacing the Fan Tra y Figure 2 Insta ll ing the P anel Safety Cov er Replacing the Fan Tray This section descri bes ho w to remove and instal l the fan tray for the Catalyst 6509-NEB switch and Cisco OSR-7609 Router . A flat-blade or number 2 Ph illips-head scre wdriv e[...]

8 Catalyst 6509-NEB Switch and Cisc o OSR-7609 Ro uter Upgrade Note 78-16162-02 Replacing the Fa n Tray Removing the Fan Tray War ni ng When removing the fan tray , keep your hands and fingers away from the spinning fan blades. Let the fan blades completely stop before you remove the fan tray . Statement 258 T o remove the e xisting fan tray , foll[...]

9 Catalyst 6509-NEB Switch and Cisco OSR-7609 Router Upgrade Note 78-16162-02 Replacing the Fan Tra y Installing the High Speed Fan Tray T o install the high speed fa n tray , follow these steps: Step 1 Hold the fan tr ay with the f ans facing do wn and the F AN F AIL LED on the right. (See Figure 4 .) Figure 4 Insta lling the High Speed Fan T ra y[...]

10 Catalyst 6509-NEB Switch and Cisc o OSR-7609 Ro uter Upgrade Note 78-16162-02 Replacing the Po we r Supply Replacing the Power Supply Note DC-input systems —See the “Connecting Site Power to the Fan T r ay for DC-Input Systems” section on page 15 to connect site po wer to the high speed fan tray . This section descri bes ho w to remove and[...]

11 Catalyst 6509-NEB Switch and Cisco OSR-7609 Router Upgrade Note 78-16162-02 Replacing the Power Sup ply Figur e 6 Removing an A C-Input Po wer Supply FAN STA TUS 105074 SUPERVISOR2 WS-X6K-SUP2-2GE STATUS SYSTEM CONSOLE PWR MGMT RESET CONSOLE CONSOLE PORT MODE PCMCIA EJECT PORT 1 PORT 2 Switch Load 100% 1% LINK LINK SUPERVISOR2 WS-X6K-SUP2-2GE ST[...]

12 Catalyst 6509-NEB Switch and Cisc o OSR-7609 Ro uter Upgrade Note 78-16162-02 Replacing the Po we r Supply Installing the 3000 W AC-Input Power Supply Caution Use both hands to install and remo v e po wer supplies . Each Catalyst 6500 series A C-input po wer sup ply weighs between 22 pounds (9.9 kg) and 28 pounds (12.6 kg). T o install the 3000 [...]

13 Catalyst 6509-NEB Switch and Cisco OSR-7609 Router Upgrade Note 78-16162-02 Connecting Power to the Fan Tra y Figure 8 Insta lling the 30 00 W Po wer Supply Step 4 T igh ten the p ower supply captive installation screw . (See Figure 7 .) Step 5 If you ha ve a redundant po wer supply , install it now follo wing the step s in this section. Step 6 [...]

14 Catalyst 6509-NEB Switch and Cisc o OSR-7609 Ro uter Upgrade Note 78-16162-02 Connecting Pow e r to the Fan Tray Installing the Fan Tray Power Cable for AC-Input Systems Note The fan tray ships with power wires secured at each terminal block. Use these wires to co nnect the fan tray to the 3000 W A C-input po wer supply using the supplied cables[...]

15 Catalyst 6509-NEB Switch and Cisco OSR-7609 Router Upgrade Note 78-16162-02 Connecting Power to the Fan Tra y Connecting Site Power to the Fan Tray for DC-Input Systems Note T o provide redundanc y , you may cho ose to connect eac h f an terminal block to a separate po wer source. Note Each input of the f an tray is rated 10 A @ -40 t o -60 VDC.[...]

16 Catalyst 6509-NEB Switch and Cisc o OSR-7609 Ro uter Upgrade Note 78-16162-02 Connecting Pow e r to the Fan Tray Figure 12 Removing the T erminal Bloc k Cover Step 3 W ith a flat blade scre wdriv er , disconnect the input wires from the t erminal block. (See Figure 13 .) Figure 13 Input Wire Connecti ons on the T er minal Block Step 4 Connect th[...]

17 Catalyst 6509-NEB Switch and Cisco OSR-7609 Router Upgrade Note 78-16162-02 Replacing the Supervisor Engine Figur e 14 DC-Input Wire Connecti ons on the T erminal Block War ni ng When installing or replacing th e unit, the ground conn ection must alway s be made first and disconnected last. Statement 1046 Step 5 After ensuring that all wire conn[...]

18 Catalyst 6509-NEB Switch and Cisc o OSR-7609 Ro uter Upgrade Note 78-16162-02 Replacing the Su pervisor Engine Step 3 Loosen the two capt iv e in stallati on screws on the supervis or engine. Step 4 Place your thumbs on t he ejector lev ers located at the top and botto m of the supervisor engine, and simultaneously rot a te the lev ers outward t[...]

19 Catalyst 6509-NEB Switch and Cisco OSR-7609 Router Upgrade Note 78-16162-02 Replacing the Supervisor Engine Step 8 Using the t h umb and fo refinger of each ha nd, g ras p th e two ejector levers and e x ert a sl ight pressure to the left, deflecting the mo dule approximately 0.040 inches (1 mm) to create a smal l gap between the supervisor eng [...]

20 Catalyst 6509-NEB Switch and Cisc o OSR-7609 Ro uter Upgrade Note 78-16162-02 Replacing the Su pervisor Engine Figur e 16 Clear ing the EMI Gask et in the Chassis INPUT OK FAN OK OUTPUT FAIL OUTPUT 42V 42V OK I I N S T A L L R U N O 110-120V - 15A 200-240V - 15A 60/50HZ m m / + 24 PORT 100FX WS-X6224 105093 INPUT OK FAN OK OUTPUT FAIL OUTPUT 42V[...]

21 Catalyst 6509-NEB Switch and Cisco OSR-7609 Router Upgrade Note 78-16162-02 Powering Up the Syste m Figur e 1 7 Eject or Lever Closur e in the Chassis Powering Up the System This section descri bes ho w to power up the system. • A C-Input Systems, page 21 • DC-Input Systems, page 22 AC-Input Systems T o power up yo ur AC-in put system, follo[...]

22 Catalyst 6509-NEB Switch and Cisc o OSR-7609 Ro uter Upgrade Note 78-16162-02 Verifying Installation DC-Input Systems T o power up yo ur DC-input system, follow these steps: Step 1 Remov e the tape from t he circuit breaker swi tch handle, and restor e po wer by mo ving the circui t breaker switch handle to the On (|) po sition. Step 2 T urn the[...]

23 Catalyst 6509-NEB Switch and Cisco OSR-7609 Router Upgrade Note 78-16162-02 Related Documentation Related Documentation For additi onal information on Catalyst 6500 se ries switches and command-line interface (CLI) commands, refer to the follo wing publications: • Re gulatory Compliance and Safety Information f o r the Catalyst 6500 Series Swi[...]

24 Catalyst 6509-NEB Switch and Cisc o OSR-7609 Ro uter Upgrade Note 78-16162-02 Documentation Feedba ck Ordering Documentation Registered Cisco.com users may order Cisco documentation at the Product Document ation Store in the Cisco Marketplace at this URL: http://www .cisco.com/go/marketp lace/ Nonregistered Cis co.com users c an order tec hnical[...]

25 Catalyst 6509-NEB Switch and Cisco OSR-7609 Router Upgrade Note 78-16162-02 Obtaining Technical Assistance Reporting Security Problems in Cisco Products Cisco is committed to deli vering secure products. W e te st our products internally before we release them, and we stri ve to correct all vulnerabilit ies quickly . If you think th at you hav e[...]

26 Catalyst 6509-NEB Switch and Cisc o OSR-7609 Ro uter Upgrade Note 78-16162-02 Obtaining Technica l Assistance Cisco Technical Support & Documentation Website The Cisco T echnical Support & Documentation website pro vides online documents and tools f or troubleshooting and resolv ing technical issues with Cisco products and t e chnologies[...]

27 Catalyst 6509-NEB Switch and Cisco OSR-7609 Router Upgrade Note 78-16162-02 Obtaining Additional Public ations and Information Definitions of Service Request Severity T o ensure that all se rvice requests are report ed in a standard format, Cisco has established sev erity definitions. Se verity 1 (S1)—An e xisting network is do wn, or there is[...]

28 Catalyst 6509-NEB Switch and Cisc o OSR-7609 Ro uter Upgrade Note 78-16162-02 Obtaining Additional Publ ications and Information or vie w the digital edition at this URL: http://cisco iq.texterity .com/ciscoiq/sample/ • Internet Pr ot ocol Journal is a quarterly journal publ ished by Cisco Systems for engin e ering professionals in vol ved in [...]