Cisco Systems Cisco 7000 manuale d’uso

1 Doc. No . Copyright © 1995 Cisco Systems, Inc. All rights reser ved. Cisco 7000 and Cisco 7507 Rac k-Mount Kit Installation Instructions 78-1058-03 Product Number s: EFT -RMK, A CS-7KRMK and A CS-7KRMK= Customer Order Number: DOC-781058= This document provides instructions for installing Cisco 7000 and Cisco 7507 routers in a 19-inch equipment r[...]

2 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions Rack-Mount Kit Overview Rack-Mount Kit Overvie w This section describes the types of racks for which this rack-mounting kit is intended, and the mounting configurations that are possible with each type. Equipment Rack Descriptions This kit is suitable for mounting the chassis in [...]

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 3 Rack-Mount Kit Overview Rack-Mount Installation Summary Follo wing is a summary of the installation procedures required to rack-mount the chassis. This summary is informational and is not intended to replace the actual procedures required to rack-mount the chassis. Follo wing is a[...]

4 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions Rack-Mount Kit Overview Figure 2 shows the components in this mounting kit. Figure 2 Rack-Mount Kit Components Each of the chassis ears attaches to a side of the chassis with two M4 x 10-mm, Phillips, flat-head scre ws). When the chassis is in the rack, the mounting strips on the[...]

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 5 Rack-Mount Kit Overview In T elco-type installations, you can install the chassis so that the ends of the chassis are approximately centered on two posts. Figure 3 shows a typical center -mount installation. Caution T o maintain a safe center of gra vity in T elco-type installatio[...]

6 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions Rack-Mount Kit Overview Figure 4 shows a typical flush-mount installation. Figure 4 T ypical Flush-Mount Installation—For T elco Racks Bolted to the Floor UPPER POWER LOWER POWER NORMAL Cisco 7000 H2293[...]

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 7 Prerequisites Prerequisites Before you begin this installation, re vie w the safety guidelines in this section to av oid injuring yourself or damaging the equipment. This section also provides descriptions of the tools and parts you need to perform this installation, and guideline[...]

8 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions Prerequisites Saf ety Guidelines Revie w the following guidelines to help ensure your safety and protect the equipment from damage during the installation. W arning Before working on a system that has an on/of f switch, turn OFF the po wer and unplug the po wer cord. (For translat[...]

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 9 Prerequisites • Ensure that your footing is solid and balance the weight of the object between your feet. • Lift the object slowly; ne ver move suddenly or twist your body as you lift. • Keep your back straight and lift with your le gs, not your back. If you must bend do wn [...]

10 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instr uctions Prerequisites Saf ety with Electricity Follo w these basic guidelines when working with an y electrical equipment: • Before beginning an y procedures requiring access to the chassis interior , locate the emergenc y po wer-of f switch for the room in which you are working. • [...]

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 11 Prerequisites When you replace the po wer supplies, remember to engage all of the safety features on each supply . The po wer supplies feature the following three safety interlock features: • A safety interlock on/off switch (see Figure 6) pre vents the po wer supply from being[...]

12 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instr uctions Prerequisites Rack Stability When installing the chassis in any rack that is not secured to the floor or o verhead structure, place the chassis in the lower half of the rack. A fully-configured chassis weighs 145 pounds (65.8 kg), and a shift in the weight distribution (during[...]

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 13 Prerequisites Also, when installing the chassis in T elco-type racks, ensure that the rack is secured to the floor or otherwise stabilized. Center-mount the chassis if possible (and practical for your installation). Doing so places the center of gravity closest to the center of [...]

14 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instr uctions Prerequisites Rack Dimensions and Site La yout For complete site requirements and recommendations, refer to the Cisco 7000 Hardwar e Installation and Maintenance or Cisco 7507 Hardwar e Installation and Maintenance publications. T o help maintain trouble-free operation, consider[...]

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 15 Prerequisites List of P ar ts and T ools This section lists the tools you will need to complete this installation and the parts that are shipped as part of the rack-mount kit. Ensure that you hav e all the tools and parts required so that you can complete the installation without[...]

16 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instr uctions Installation Installation The following sections describe the procedures for mounting the chassis in a 19-inch equipment rack with two or four mounting posts. Before proceeding, re vie w the guidelines and recommendations in the section “Prerequisites” on page 7 to protect y[...]

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 17 Installation After you install both brackets in the rack, you must connect the spanner bar on each bracket to the opposite bracket. The spanner bars are required to pre vent both ends of the brack ets (at the front and rear of the rack) from separating or drifting apart. The cuto[...]

18 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instr uctions Installation Step 4 Slide the bracket up and do wn along the mounting post to align the mounting holes in the bracket with those in the rack post. Step 5 While supporting the bracket with one hand, use the other hand to insert a 10-32 x 5/8-inch, Phillips pan-head screw through [...]

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 19 Installation Figure 11 P ositioning and Fastening a Spanner Bar Caution T o ensure adequate space between the brackets and a proper chassis fit, push the brack ets as far apart as possible before tightening the scre ws that secure them and the spanner bars. Step 5 When both span[...]

20 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instr uctions Installation Attaching the Chassis Ears The ears attach directly to the chassis with four M4 x 10-mm, flat-head screws. Attach the ears to the chassis before you slide the chassis onto the brackets and back into the rack. After you slide the chassis into the rack, insert a 10-3[...]

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 21 Installation Follo w these steps to install the ears on the chassis: Step 1 While referring to Figure 12, position the ears on the chassis as follows: • T o flush-mount the chassis (so that the end of the chassis is approximately flush with the rack posts): Place each ear so [...]

22 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instr uctions Installation Step 6 If a second po wer supply is installed, repeat steps Steps 3 through 5 to remove the second supply . Figure 13 Handling a P ower Suppl y (A C-Input P ower Suppl y Shown) W arning T o a void dropping the po wer supply and injuring yourself, use both hands to r[...]

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 23 Installation Figure 14 Chassis Foot If you hav e not already done so, re view the safety guidelines in the section “Lifting the Chassis Safely” on page 8. Then follow these steps to install the chassis in the rack: Step 1 T wo people ar e r equir ed to perform this step. W it[...]

24 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instr uctions Installation Figure 15 Sliding the Chassis into the Rack Checking Electrical Isolation The inner sides of the mounting brackets and the grommets on the chassis ears are shielded to isolate the chassis from contact with the equipment rack. If your installation requires that the c[...]

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 25 Installation Replacing P ower Supplies and Interf ace Cables Before proceeding, ensure that you hav e suf ficient working space (at least three feet) behind the chassis, and that access to the po wer supply bays is not blocked by an equipment rack po wer strip or cables from oth[...]

26 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instr uctions Installation Restar ting the System T o complete the installation, you will perform a final check of all connections, then restart the system. This procedure is not for new systems; perform this procedure only if you ha v e already connected the network interfaces and performed[...]

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 27 Installation Figure 16 Cisco 7000 P ort Configuration W orksheet Circle one: AIP/CIP/EIP/FIP/ FSIP/HIP/TRIP 0/0 0/1 0/2 0/3 0/4 0/5 0/6 0/7 Slot 3 3/0 3/1 3/2 3/3 3/4 3/5 3/6 3/7 Slot 4 4/0 4/1 4/2 4/3 4/4 4/5 4/6 4/7 Router name Location Prepared by Date H1324a Slot 1 1/0 1/1 1[...]

28 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instr uctions Installation Figure 17 Cisco 7507 P ort Configuration W orksheet Circle one: AIP/CIP/EIP/FEIP/FIP/ FSIP/HIP/TRIP/MIP 0/0 0/1 0/2 0/3 0/4 0/5 0/6 0/7 Slot 3 RSP2 Slot 4 4/0 4/1 4/2 4/3 4/4 4/5 4/6 4/7 Router name Location Prepared by Date H3889 Slot 1 1/0 1/1 1/2 1/3 1/4 1/5 1/6[...]

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 29 Translated Safety Warnings T ranslated Safety W arnings Follo wing are translations of the safety warnings that appear throughout this publication: P ower Disconnection W ar ning W arning Before working on a system that has an on/of f switch, turn OFF the po wer and unplug the po[...]

30 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instr uctions T ranslated Safety W arnings V aroitus Älä kosketa virtalähdettä virtajohdon ollessa k ytkettynä. V irrankatkaisimella v arustetuissa järjestelmissä on virtalähteen sisällä jäljellä verkkojännite, v aikka virrankatkaisin on katkaistu-asennossa virtajohdon ollessa ky[...]

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 31 Translated Safety Warnings Attention A v ant de trav ailler sur un châssis ou à proximité d'une alimentation électrique, débrancher le cordon d'alimentation des unités en courant alternatif ; couper l'alimentation des unités en courant continu au niv eau du [...]

32 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instr uctions T ranslated Safety W arnings ¡Advertencia! Puede ser que este equipo posea más de un cable de alimentación. Para reducir el riesgo de descarga eléctrica, desenchuf ar los dos cables antes de proceder al mantenimiento de la unidad. V arning! Denna enhet kan vara försedd med [...]

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 33 Translated Safety Warnings Adv arsel Det er nødv endig med to personer for å løfte kabinettet. T a tak i kabinettet under den nedre kanten, og løft med begge hender . Unngå personskade ved å holde ryggen rett og løfte med bena, ikke ryggen. Unngå skade på kabinettet og k[...]

34 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instr uctions T ranslated Safety W arnings A vvertenza Prima di svolgere una qualsiasi delle procedure seguenti, v erificare che il circuito CC non sia alimentato. Per verificare che tutta l’alimentazione sia scolle gata (OFF), individuare l’interruttore automatico sul quadro strumenti [...]

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 35 Translated Safety Warnings Chassis W arning—Rack-Mounting and Servicing W arning T o pre vent bodily injury when mounting or servicing this unit in a rack, you must tak e special precautions to ensure that the system remains stable. The follo wing guidelines are provided to ens[...]

36 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instr uctions T ranslated Safety W arnings W arnung Zur V ermeidung von Körperverletzung beim Anbringen oder W arten dieser Einheit in einem Gestell müssen Sie besondere V orkehrungen treffen, um sicherzustellen, daß das System stabil bleibt. Die folgenden Richtlinien sollen zur Gewährlei[...]

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 37 Translated Safety Warnings V arning! För att undvika kroppsskada när du installerar eller utför underhållsarbete på denna enhet på en ställning måste du vidta särskilda försiktighetsåtgärder för att försäkra dig om att systemet står stadigt. Följande riktlinjer g[...]

38 Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instr uctions Cisco Information Online Cisco Inf ormation Online Cisco Information Online (CIO) is Cisco Systems’ primary , real-time support channel. Maintenance customers and partners can self-register on CIO to obtain additional content and services. A v ailable 24 hours a day , 7 days a[...]