Cobra Electronics 29NW ST manuale d’uso

Ho w to Us e Y ou r Co b r a 29 NW ST Contents Features .................................................................................................. 1 The CB St ory .........................................................................................A1 FCC Regulations FCC Warnings Included Accessories Controls & Indicators ...........[...]

Installation Installation Location 3 2 Mounting and Connection Mounting and Connection H old the radio with the mounting bracket in the exact desired lo cation. If there is no in ter- ference , remov e the bracket and use it as a template to mark the lo ca tion for the moun t- ing screws. Location Plan location of transceiver and microphone bracket[...]

Installation Installation 5 4 Note Connecting to an accessory fuse prevents the unit from being lef t on accidentall y , and also per - mits operating the unit without running the engine. Note In positive ground vehicles the red wire goes to the chassis and the black wire is connec ted to the ignition switch. Note Before installing the CB radio , v[...]

Ignition Noise Interference Antennas U se of a mobile receiver at low signal le vels is normally limited by the presence of electrical noise. The primary sour ce of noise in automobiles is from the alterna tor and ignition system. T ypically , when signal le vel is adequate, the back - ground noise does not present a serious problem. Also, when ex [...]

T he CB/PA button should be in the CB position. Operation 9 Operation T urning On Setting Channel Selector 8 T urning On Make sure the p ow er cor d , antenna and micr o- phone are connec ted to their proper connec tors before starting. Setting Channel Selec tor 2 1 R o t a t e the On / Of f V olu me knob c l oc kw i s e to a normal listening le ve[...]

While holding mic button adjust the SWR CAL knob so the meter needle swings to the CAL ▼ mark on the meter (lo cated on the right). Operation Operation Calibrate For SWR (Standing W ave Ratio) 11 10 continued Note Calibration must be made in an open area (ne ver in a garage). Vehicle doors must be closed . No one should be standing near the anten[...]

Rotat e the On/Off V olume knob clockwise the green RT/TX LED will be illumina ted . Repeat the same steps t w o through five on Channel 1 and 40. This will check SWR for all channels . T he S/RF-SWR-CAL switch must be in the S/RF position to read the meter. 6 W hile still holding down the mic button,set the S/RF SWR CAL switch to the SWR position,[...]

Operation Operation 15 14 Activating SoundTracker ™ Push and release the ST button. R ed LED is illuminated when SoundTracker™ is turned on. 1 The SoundT rack e r TM System While previous systems only “blanket out” or limit noise in higher sound frequencies , the revolution- ary new SoundT racker TM System actually reduces noise while leavi[...]

When switched to ANL the Automatic Noise Limiter is activa ted . This helps reduce noise crea ted by the vehicle ’ s electronics. When switched to NB/ANL position the RF N oise Blanker is also activ ated, providing increased noise filtr ation. When switched to OFF position all noise filtration will be turned off . Operation Operation 17 16 NB-ANL[...]

F ull clockwise rotation closes the ga te allowing only very strong signals to en ter . F ull counterclockwise rotation opens the “ ga te ” allowing all signals in. T o achie v e the Desired Squelch Setting (DSS), turn the Squelch control counterclockwise until you hear noise. Now turn the control clockwise just until the noise stops . This is [...]

Setting Dynamike This controls the microphone sensitivit y (outgoing audio le vel). T o T ransmit 21 T o Transmit T ransmit 20 Setting Dynamike Caution! Be sure the antenna is proper ly connected to the radio befor e transmitting. Prolonged trans- mitting without an antenna,or a poorl y matched antenna, could cause damage to the transmitter. Be sur[...]

Operation Operation RF Meter 23 22 External Speaker RF Meter This meter swings proportiona tely to the RF output (outgoing signal) while transmitting . External Sp eaker The ext ernal speaker jack is used for remote receiver monitoring . T he S/RF-SWR-CAL switch must be in the S/RF position. 1 Note The ex ternal speaker should have 8-ohm impedance [...]

Operation Operation P A (Public Address) 25 24 P A (Public Address) Connect an e xternal PA speaker to the PA jack on the rear panel. Set CB/PA switch to PA position. P ush and hold microphone button and speak in a normal voic e. Y our voice will now transmit on the PA speaker . Adjust P A speaker volume with the Dynamike control. Note Speaker shou[...]

T emporary Mobile Set-Up 27 Base Station Operation (From 120V AC House Curr ent) T emporary Mobile Set-Up T emporary Mobile Oper ation F or temporary mobile oper ation you may want t o purchase an optional cigarette ligh t er adapter from your COBRA dealer . This adapter and a mag - netic mount ant enna allow you to quickly “install” your trans[...]

How Y our CB Can Serve Y ou How Y our CB Can Serve Y ou 29 28 The FCC gives these examples of permitted and prohibited messages for channel 9. These are only guidelines and not all-inclusive: P ermitted Example Message Y es “Tornado sight ed six miles north of town.” No “Post number 10. No tornado sigh ted.” Y es “ Out of gas on I-95 at m[...]

How Y our CB Can Serve Y ou How Y our CB Can Serve Y ou 31 30 Code Meaning 10-29 Time is up for contact 10-30 Does not conform to FCC rules 10-33 Emergency traffic 10-34 T rouble at this station 10-35 Confidential information 10-36 Correct time is 10-37 Wr ecker needed a t 10-38 A mbulance needed 10-39 Message delivered 10-41 Turn to channel 10-42 [...]

29 NW ST Specifications Frequency Ranges 33 32 GENERAL CHANNELS. . . . . . . . . . . . . . . . . . . . . . . CB - 40 CH FREQUENCY RANGE. . . . . . . . . . . . . . . CB - 26.965 TO 27.405 MHZ FREQUENCY T OLERANCE. . . . . . . . . . 0.005 % FREQUENCY CONTROL . . . . . . . . . . . . PLL (PHASE LOCK LOOP) SYNTHESIZER OPERA TING TEMPERA TURE R ANGE. . .[...]

Limited Two Y ear W arranty 35 34 COBRA ELECTRONICS CORPORA TION warrants that its COBRA CB Radios, and the component parts thereof , will be free of defects in wor kmanship and ma terials for perio d of two (2) years from the da te of first consumer purchase . This warranty may be enfor c ed by the first consumer purchaser , provided that the pr o[...]

37 36 Y ou Can Find These Fine Accessories At Y our Local Cobra CB Dealer If you wish, you can order directly from Cobra. Order by phone Call 1.773.889.3087 (Pr ess 1 from the main menu) 8 a.m.-8 p.m. M-F CST . Order by mail or fax Please fill out order form on ne xt page, and mail/fax directly to Cobra. Optional Accessories Dynamic E xternal Speak[...]

39 38 Notes Notes Notes Notes 29 NW ST manual3.3 6/15/99 12:50 PM Page 38[...]

40 Notes Notes 29 NW ST manual3.3 6/15/99 12:50 PM Page 40[...]

2 9 N W S T Cobra Electronics Corporation 6500 W est Cortland Street Chicago, IL60707 Cobra Electronics Corp.© 1999 Printed in China Part No. 480-191-P-001 CB Radio “Ing eniou s Pr o d u c ts for E a sier C o m m u n i c a t i o n .” O pe r ati ng I n s tr u c tions for your C o b r a 29 NW ST Fo r t e c h n i c al ass is ta nc e, pl e ase ca [...]

The Citizens Band lies bet w een the shor tw a ve broadcast and 10-meter Ama teur radio bands , and was established by law in 1949. The Class D two-w ay communica tions service was opened in 1959.(CB also includes a Class A citizens band and Class C remote control frequencies.) FCC Regulations FCC regulations permit only “transmissions ” (one p[...]

T hank you for purchasing the Cobra 29 NW ST CB Radio. Properly used, this Cobra pr oduct will giv e y ou many years of reliable servic e. SoundT r acke r TM “C uts noise coming in...strengthens signals going out.” This P atent pending technolog y dramatically improv es transmission and reception of CB signals. The revolutionary SoundTracker TM[...]