DeLonghi DEGH60 manuale d’uso

INST ALLA TION and SER VICE INSTRUCTIONS USE and CARE INSTRUCTIONS distributed by DèLonghi Pty Ltd BUIL T -IN GAS HOBS DEGH60 DEGH60ST DEGH60WT[...]

2 Dear Customer , Thank you for having pur chased and given your pr efer ence to our pr oduct. The safety pr ecautions and r ecommendations r eported below ar e for your own safety and that of others. They will also pr ovide a means by which to make full use of the featur es offer ed by your appliance. Please keep this booklet in a safe place. It m[...]

3 IMPORT ANT PRECAUTIONS AND RECOMMENDA TIONS FOR USE OF ELECTRICAL APPLIANCES Use of any electrical appliance implies the necessity to follow a series of fundamental rules. In particular: ■ Never touch the appliance with wet hands or feet; ■ do not operate the appliance bar efooted; ■ do not allow childr en or other incapable people to use t[...]

4 470 35 min 500 550 100 580 min Figur e 1 DIMENSIONS (T able 2): (Note: Also r efer to Figure 1) General Dimensions Width 580 mm Depth 500 mm Depth Below Mounting Surface 30 mm Cut-out Dimensions Width 550 mm Depth 470 mm INST ALLA TION CAUTION: ■ This appliance must be installed in accor dance with these installation instructions, local gas fit[...]

5 750 mm 35 mm min 100 mm min 500 mm 450 mm Figur e 2 CLEARANCES: Installation clearances and pr otection of combustible surfaces shall comply with the curr ent local regulations e.g. AG 601 (AS 5601) - Gas Installations code. This cooktop has been designed and constructed in accor dance with the following codes and specifications: AGA101 (AS 4551)[...]

6 The installation shall comply with the dimensions in Figur es 1 and 2, bearing in mind that: ■ A minimum clearance of 20 mm has to be kept between the bottom of the cooking hob and the top of an appliance or a shelf. T o ensur e this clearance mount the spacers, supplied with the appliance, as shown in the figur e below . ■ A partition betwee[...]

7 INST ALLA TION (Refer to Figur e 4): 1. Spr ead out the gasket “C” over the workbench at the edge of the cut out tak- ing car e to overlap the gasket at the corners. 2. Slot in the cooking hob into the cut out of the workbench and locate it cor- r ectly . 3. Adjust the clamps “A” and tighten the scr ews “B” until the hob is firmly sec[...]

8 GAS SUPPL Y : ■ This appliance is suitable for use with Natural Gas or ULPG. (Check the “gas type” sticker attached to the appliance). ■ For Natural Gas the gas supply must be r egulated to obtain a pressur e of 1 kPa with the two semi-rapid (SR) burners operating. ■ For ULPG models connect the gas supply dir ectly to the appliance test[...]

9 T ABLE FOR THE CHOICE OF THE INJECTORS Natural gas ULPG T est Point Pressur e [kPa] 1.0 2.75 BURNER Auxiliary (A) 0.85 3.6 0.53 3.6 Medium-speed burner (SR) 1.12 6.3 0.70 6.3 T riple-ring burner (TR) 1.55 11.9 0.94 11.9 Gas Consumption [MJ/h] Injector Orifice Dia. [mm] Gas Consumption [MJ/h] Injector Orifice Dia. [mm] 5. Check the minimum burner [...]

10 CONVERSION PROCEDURE (to convert to Natural gas or to ULPG) REPLACING THE INJECTORS The conversion pr ocedure must be carried out only by an authorised person. This appliance is suitable for use with Natural gas or ULPG (check the “gas type” stick- er attached to the appliance). The nominal gas consumption and injector size details ar e prov[...]

11 MINIMUM BURNER SETTING ADJUSTMENT Check whether the flame spr eads to all burner ports when the burner is lit with the gas tap set to the minimum position. If some ports do not light, incr ease the minimum gas rate setting. Check whether the burner r emains lit even when the gas tap is turned quickly from the maximum to the minimum position. If [...]

12 ELECTRICAL REQUIREMENTS: W ARNING: ■ THIS APPLIANCE MUST BE EARTHED. CAUTION: ■ Ensur e that the power outlet is properly earthed befor e connecting the appliance. ■ Disconnect power befor e servicing the appliance. The appliance is pr ovided with a standard 240V AC thr ee pin plug and power cable (3 x 0.75 mm 2 ). The wir es in the power [...]

13 USE and CARE CAUTION: ■ This appliance must be used only for the task it has explicitly been designed for , that is for domestic cooking of foodstuffs. Any other form of usage is to be con- sider ed as inappropriate and ther efor e dangerous. Do not use this appliance as a space heater . ■ Do NOT place combustible materials or pr oducts on t[...]

14 ■ The electric ignition is incorporated in the knobs ■ This appliance is class 3 2 8 7 6 5 3 4 1 CONTROL P ANEL 5 . T riple-ring burner contr ol knob (1) 6 . Left semi-rapid burner contr ol knob (2) 7 . Right semi-rapid burner contr ol knob (3) 8 . Auxiliary burner control knob (4) Figur e 11a 2 8 7 6 5 3 4 1 Figur e 11b GAS HOB GAS BURNERS [...]

15 LIGHTING GAS BURNERS ■ Check that the electricity is switched on to allow spark ignition. ■ Make sur e that all controls ar e turned to zer o. ■ The gas flow to the burner is contr olled by the knobs on the safety taps. ■ Y ou contr ol the flow by turning the knob indicator to line up with the following symbols: – Symbol : tap closed ([...]

16 Lighting the burners WITH ELECTRIC IGNITION (without safety cut-off valve) mod. DEGH60WT - DEGH60ST T o light one of the burners, pr ess and turn the corresponding knob to the maximum flow position (lar ge flame) and keep the knob pressed down until the gas is lit. T urn the gas tap to the position r equired. Whenever lighting any of the burners[...]

17 COOKING HINTS FOR GAS HOBS Burners Pan diameter Auxiliary * 12 - 14 cm Semi-rapid 16 - 20 cm T riple ring 24 - 28 cm W ok max 36 cm The burner must be chosen accor ding to the diameter of the pans and energy r equired. For optimum efficiency use a wok or pan no smaller than 230mm diameter . Saucepans with handles which ar e excessively heavy , i[...]

18 mod. DEGH60WT - DEGH60ST Figur e 15a CORRECT USE OF TRIPLE-RING BURNER ■ The flat-bottomed pans ar e to be placed directly onto the pan-support. ■ T o use the WOK, you must place the wok stand in the CORRECT position as shown in fig. 15a - 15b. IMPORT ANT : The special grille for wok pans (figs. 15a, 15b) MUST BE PLACED ONL Y over the pan- r[...]

19 Cleaning and Maintenance GENERAL TIPS ■ Befor e cleaning the hob switch it off and wait for it to cool down. ■ Clean with a cloth, hot water and soap or liquid deter gent. ■ Do not use pr oducts which are abrasive, corr osive or chlorine based. ■ Do not use steel pads. ■ Do not leave acid or alkaline substances (vinegar , salt, lemon j[...]

20 Figur e 16 Figur e 17 CORRECT POSITIONING OF THE BURNERS ■ It is very important to check that spreader F and cap C of the burner (see Figur es 16 and 17) are perfectly in place because if they move out of place serious pr oblems could arise. ■ Make sur e that electrode S (Fig. 16) is kept clean so that the sparks always strike . ■ Model DE[...]

21 CORRECT POSITIONING OF THE TRIPLE-RING BURNER ■ The triple ring burner must be corr ectly positioned (see fig. 20); the burner rib must be located in position as shown by the arr ow (see fig. 18). ■ The burner corr ectly positioned must not rotate (fig. 19). ■ Then position the cap A and the ring B (fig. 19). Figur e 18 Figur e 20 Figur e [...]

22 SERVICE AND MAINTENANCE If the ignition spark fails to ignite or does not light the gas, check the following items befor e calling our Customer Service Centre to obtain the near est Authorised Delonghi Service Agent: ■ Burner is r eassembled and located correctly . ■ Spark electr ode and white ceramic are clean and dry . ■ 240 V AC power s[...]

23 Descriptions and illustrations in this booklet are given as simply indicative. The manufactur er reserves the right, considering the characteristics of the models described here, at any time and without notice, to make eventual necessary modifications for their construction or for commercial needs.[...]

cod. 1103186 ß2[...]