Electrolux E36WV100FS manuale d’uso

5995465563 E36WV1 00FS U se & Car e Guide In stallation In struction s V ent Hood[...]

2 Finding Information READ AND SA VE THESE INSTRUCTIONS Read all instructions before installing the hood. For your safety , please read and observe all safety instructions. This guide will help you anticipate all installation connections. QUESTIONS? For toll-free telephone support in the U.S. and Canada: 1-877- 4ELECTROLUX (1-877-435-3287) For onli[...]

3 Finding Information T ABLE OF CONTENTS Finding Information .............................................. 2 Please Read And Save This Guide ................... 2 Make A Record For Quick Reference ................ 2 Questions ........................................................... 3 T able Of Contents ..........................................[...]

4 Safety IMPORT ANT SAFETY INSTRUCTIONS Safety Precautions Do not attempt to install or operate your unit until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a W arning or Caution based on the risk type. Definitions This is the safety alert symbol. It is used to alert you to potential per[...]

5 WARNING • Read all instructions before using this appliance. • Install or locate this appliance only in accordance with these installation instructions. • Do not operate this appliance if it has a damaged electrical conduit or wires, if it is not working properly or if it has been damaged or dropped. • T o reduce the risk of fire, electr[...]

6 Safety WARNING • Do not use an extension cord. If the power supply cord is too short, have a qualified electrician install an outlet near the appliance. • This appliance should be serviced only by qualified service personnel. Contact the nearest Electrolux authorized servicer at (877) 435-3287, or at www .electroluxusa.com for examination, [...]

7 Safety CA UTION • T o reduce risk of fire and to properly exhaust air , be sure to duct air outside. Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or garages. • T ake care when using cleaning agents or detergents. • A void using food products that produce flames under the Range Hood. • For ge[...]

8 Getting Started OPERA TING YOUR HOOD The hood is operated using the slide controls under the front edge of the hood. The light switch turns the halogen lights on and off. PILOT LAMP BLO WER ON/OFF SWITCH BLO WER SPEED CONTROL Figure 1 WARNING The HEA T SENTR Y thermostat can start the blower even if the hood is turned OFF . When this occurs, it i[...]

9 Operation HALOGEN BULBS This range hood requires two halogen bulbs (T ype MR16, 12V olt, 20 Watt Max). 1 Loosen the ring nut by turning it counterclockwise. 2 Remove the bulb by pulling downward (DO NOT ROT A TE). 3 Replace with T ype MR16, 12V olt, 20 W att Max halogen bulb. 4 Reinstall the ring nut. T urn clockwise to secure. WARNING Always swi[...]

10 Operation FUSE REPLACEMENT FUSE FUSE BO X ELECTRICAL BO X SUPPORT TRIM ELECTRICAL BO X SUPPORT SCREWS Figure 4 Figure 3 IF LIGHTS F AIL T O OPERA TE, DISCONNECT POWER A T THE SERVICE ENTRANCE. CHECK THE FUSE AND REPLACE IF NECESSAR Y . 1 Remove grease filters. 2 Remove (2) trim screws. 3 Remove trim by pulling it forward. 4 Remove the electrica[...]

1 1 Care and Cleaning CLEANING THE FIL TERS AND HOOD Hood Cleaning Stainless steel is one of the easiest materials to keep clean. Occasional care will help preserve its fine appearance. Cleaning tips: 1 Hot water with soap or detergent is all that is usually needed. 2 Follow all cleaning by rinsing with clear water . Wipe dry with a clean, soft cl[...]

12 Installation INST ALLA TION PLANNING A qualified installer must complete the installation of this built-in appliance. Proper installation is your responsibility . Carefully check the location where the hood is to be installed. The hood should be placed for convenient access. Make certain that electrical power can be provided in the selected loc[...]

13 Installation VERIFY P ACKAGE CONTENTS Unpack hood and check contents. Y ou should receive: 1 - Hood 1 - Decorative Flue Assembly 1 - Flue Mounting Bracket 1 - Set of Filters 1 - Parts Bag : 2 - Mounting Brackets 10 - Mounting Screws (4.8 x 38mm Pan Head) 4 - Mounting Screws (3.9 x 9.5mm Pan Head) 4 - Mounting Screws (3.9 X 9.5mm Pan Head - Black[...]

14 Installation INST ALLING THE DUCTS 1 Decide where the ductwork will run between the hood and the outside. 2 A straight, short duct run will allow the hood to perform most efficiently . 3 Lo ng duc t runs , elb ows , and tra nsi ti ons w ill r edu ce th e per for man ce o f the hoo d. Use as few of them as possible. Larger ducting may be require[...]

15 Installation INST ALLING THE HOOD MOUNTING BRACKET 1 Construct wood wall framing that is flush with interior surface of wall studs. Make sure: a the framing is centered over installation location. b the height of the framing will allow the mounting bracket to be secured to the framing within the dimensions shown. 2 After wall surfa ce is fini [...]

16 Installation INST ALLING THE HOOD 1 Raise the hood into its mounting location. 2 Align the rectangular opening on the back of the hood with the wall-mounting bracket. Gently lower the hood until it securely engages the bracket. 3 Make minor changes to the hoods horizontal and vertical position by adjusting screws on the wall mounting brackets. 4[...]

17 PO WER CONNECTION A T HOOD CONNECT: WHITE-TO-WHITE BLACK-T O-BLACK GREEN-TO-GR OUND 120 VOL T 60 HZ LINE-IN 8” ROUND DUCT Figure 12 Figure 13 Installation INST ALLING THE ELECTRICAL 1 Run 120 V AC electrical power cable to the hoods wiring box. 2 Remove the cover from the wiring box and remove one knockout. 3 Feed 6” of cable through the kno[...]

18 INST ALLING THE FIL TER(S) 1 T o remove the grease filters, grip the latch and pull it down. This will disengage the filters from the hood. T ilt the filters downward and remove. 2 T o install the grease filters, align rear filter tabs with slots in the hood. Pull latch tab down, push filter up into position and release the tab. Make sure [...]

19 Installation VERIFYING OPERA TION • Install the filters. • V erify that the hood control knobs are in the OFF position. • T urn on the main power supply . • Slide light switch to the ON position. Lights should illuminate. • Slide blower switch to the ON position. Then slide the speed control switch to check operation of the variable s[...]

20 T roubleshooting IF SER VICE IS REQUIRED First, review the recommended checks listed in the T roubleshooting Guide . Then, be certain that the appliance has been installed properly and is being operated correctly . Familiarize yourself with the warranty terms and conditions listed in the W arranty section. If the above checks have been completed[...]

21 T roubleshooting TROUBLESHOOTING GUIDE IMPORT ANT Unnecessary service calls may be expensive, frustrating and time consuming. Before you call for service, please review the potential problems, possible causes and remedies shown in the table below . Problem T roubleshooting - What to check when problems occur Remedy Possible Cause Nothing works. [...]

22 Saving Energy ENERGY SA VING TIPS 1 Do not operate the blower at a speed that is higher than necessary to remove the cooking exhaust. Running at excessive speeds removes more air from the inside of the house that must be replaced by outside air . This may be especially costly when the housing air conditioning or heating system is in operation. 2[...]

23[...]

24 14 W a r r a n t y I n f o r m a t i o n HOO D WA RR A N TY Your hoo d is pro tected by this w arr anty WARRAN TY PERIOD THROU GH OUR AUTHORI ZED SERVIC ERS, WE WIL L: THE CON SUMER WILL BE RESPONS IBLE FOR: FULL ON E-YEAR WARRAN TY One y ear from original p urchase date . Pay all costs for repairing or rep l acing any parts of th is product whi[...]