Enviro 50-1386 manuale d’uso

PLEA SE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE SHERWOOD INDUSTRIES IS AN ENVIRONMENT ALL Y RESPONSIBLE COMP ANY . THIS MANUAL IS PRINTED ON RECYCLED P APER. 50-1386 PELLET STOVE Empr ess TECHNICAL MANU AL PLEASE READ THIS ENTIRE MANUAL BEFORE INSTALLATION AND USE OF THIS PELLET BURNING ROOM HEATER. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD R[...]

T able of Contents 2 Introduction......................................................................................................... ...3 Rating Label Location.....................................................................................3 Important Safety Data.................................... ........................................[...]

3 Introduction * This manual is designed for the technician in conjunction with the owner’s manual. * R ATING L ABEL L OCATION : The rating label is located on the hopper top behind the surr ound panel. I MPORTANT S AFETY D ATA : Please read this entire Owner’s Manual before installing or operating this ENVIRO Pellet Stove. Failure to follow th[...]

4 Introduction ELECTRICAL: The use of a surge protected power bar is recommended. The unit must be grounded. The grounded electrical cord should be connected to a standard 120 volts, 60 hertz electrical outlet and also must be accessible. If this power cord should become damaged, a replacement power cord must be purchased from the manufacturer or a[...]

5 Inst alla tion R EMOVING P ELLET S TOVE F ROM P ALLET : Figure 1: Removing Stove From the Pallet. Use a flathead screwdriver or 5 / 16 ” socket to remove the four (4) screws that secure the Empress FPI to the pallet. T wo (2) of the screws ar e shown in Figure 1 and the other two (2) are in the same location but on the opposite side; behind the[...]

Inst alla tion 6 1 2 " ( 3 0 . 5 c m ) M a n t l e 36" (91cm) 3" (7.6cm) 24" (61cm) Fl o o r P r o t e c t i o n ; M i n 6 " ( 1 5 c m ) i n f r o n t o f d o o r Figure 4: Empress FPI Clearance to Combustibles. C LEARANCES TO C OMBUSTIBLES : 42 5 / 8 " (1083mm) 24 1 / 16 " (611mm) 28 9 / 16 " (725mm) 31 3 / [...]

Inst alla tion M ASONRY F IREPLACE I NSTALLATION : If installing the Empress with a skirt the skirt must be installed before the installation. A non-combustible hearth pad must cover combustible flooring underneath, as well as 6” (150 mm) in front of the heater and 6” (150 mm) to the side of the heater . 1. Install the hearth pad. 2. Lock the f[...]

8 Inst alla tion P OSITIVE F LUE C ONNECTION WITHOUT A F ULL R ELINE (USA O NLY ): This unit does not require a f ull reline (in USA only) when installing into a masonry fireplace, however , it is recommended to ensure proper dr afting of the appliance. IMPOR T ANT : Ensure the chimney and firebox are cleaned and free of all debris, including soot [...]

I NSTALLATION OF C AST S KIRT O PTION : Figure 9: Assembling Cast Skirt. Inst alla tion A DJUSTING H OPPER H EIGHT : The back height of this unit can be set to one (1) of three (3) heights; 19 13 / 16 ” (503 mm), 20 13 / 16 ” (529 mm), 21 13 / 16 ” (554 mm). The hopper should be set to the maximum height that can be used in the installation. [...]

1. Install the wall thermostat in a location that is not to close too the unit but will effectively heat the desired area. 2. Install a 12 or 24 V olt Thermostat using an 18 x 2 gauge wire from the unit to the thermostat. Figure 1 1: Mother Board. This control board can be placed into three (3) different modes: Full Auto ON/OFF , High/Low Thermosta[...]

11 Inst alla tion S LIDER /D AMPER S ETTING : This is used to regulate the airflow through the pellet stov e. THE SLIDER / DAMPER MUST BE SET AT TIME OF INSTALLATION. A Qualified Service Technician or Installer must set the Slider Damper . More Air Less Air Figure 15: Slider / damper positions. The slider damper is located behind the cast doors and[...]

T roubleshooting DO NOT: ● Service the stove with wet hands. The stove is an electrical appliance, which may pose a shock hazard if handled improperly. Only qualified technicians should deal with possible internal electrical failures. ● Do not remove from the firebox any screws without penetrating oil lubrication. ● Hold the ON / OFF BUT TON [...]

13 T roubleshooting ü Check the exhaust blower voltage across the blower wires (>=114V on #5 setting and >= 82V on #1 setting). – Replace the Circuit Board if the Voltage reading is less than 82V. with a line voltage >115V AC. ü Check vacuum levels in the exhaust channel by bypassing the vacuum switch, then remove the v acuum hose from[...]

T roubleshooting Auger light flashes but auger motor does not turn at all. ü If the auger gear box does not turn but the motor ’ s armature does try to spin then the auger is jammed. – T ry to break apart jam by poking at the jam through the drop tube. If this fails then empty the hopper and remove the auger co ver **remember to re-seal the co[...]

15 Connect Thermostat Here Red Red Red Red Brown Brown Brown Brown Thermostat Selector Pins White White White 115V White 220V Blue White White Orange Orange Orange Orange Yellow Yellow Grey Grey Grey Grey Purple Purple Blue 115V Black 220V Brown Black Black Black Blue Daughter Board Vacuum Switch Combustion Blower Power Cord Ground Ignitor 120 o F [...]

P ar ts List Reference Number Description Part Number 1 120 °F (49 °C) Ceramic F an T emperature Sensor EC -001 Domestic Power Cor d - 115V EC -042 2 Auger Motor - 115V EF-001 3 High Limit T emp Sensor 200 °F (93 °C) Manual Reset EF-016 Silicone Hose EF-018 4 Ash P an Latch EF-060 P ellet Stove Cleaning Brush EF-156 5 Convection Blower - 115V E[...]

17 P ar ts List Reference Number Description Part Number 15 Exhaust Starter T ube 3” Quick Connect 50-1391 16 Mother Board - 120V 50-1392 17 Daughter Board - 120V 50-1393 18 Slider Damper & Lever 50-1394 19 Exhaust Starter Elbow Quick Connect 50-1395 20 Exhaust Starter Gasket 50-1396 21 Daughter Board Decal 50-1397 22 Ignitor & Intak e T [...]

P ar ts Diagr am - Components 3 Empress - Fireplace Insert Components October 2006 1 9 8 1 1 2 12 14 21 17 16 5 10 18[...]

19 P ar ts Diagr am - P ar ts 6 Empress - Fireplace Insert Parts October 2006 30 32 13 22 4 18 25 23 28 24 26 27 7 31 29 19 15 20[...]

20 W arr anty Sherwood Industries Ltd. is the manufacturer of the Enviro line of heating products. At Sherwood Industries, our commitment to the highest level of quality and customer service is the most important thing we do. Each Enviro stove is built on a tradition of using only the finest materials and is backed by our Exclusive Li fetime Limite[...]

W arr anty Exclusions and Limitations: 1. This Warr anty does not co ver tarnish, discoloration or wear on the plating or paint. 2. This Warr anty ex cludes wear and tear or breakage caused by cleaning, moving or service on log set. 3. A qualified installer must install this stove or fireplace. This Limited W arr anty covers def ects in materials a[...]

22 W arr anty 17 . Damage to plated surfaces caused by fingerprints, scratches, melted items, or other external scores and residues left on the plated surfaces fr om the use of abrasiv e cleaners or polishes is not covered in this warr anty . 18. The Limited W arr anty does not cover tarnish, discolor ation or wear on the plated surfaces. 19. The p[...]

23 NAME OF OWNER: _________________________________________ ADDRESS: _________________________________________ _________________________________________ _________________________________________ PHONE:___________________________________ NAME OF DEALER: _________________________________________ ADDRESS: _________________________________________ ____[...]