GE 3200 manuale d’uso

3 Important Safety Information 10 Installation Instructions Important Electrical Safety Adjustments and Auxiliary Controls 4 Operating Instructions The Controls on Y our Zoneline Care of Product 19 Helpful Information Things That Are Normal 20 If Something Goes Wrong Before Y ou Call For Service GE Service Numbers Warranty GE Appliances Zoneline ®[...]

Welcome to the GE family. We’re proud of our quality products and we believe in dependable service. You’ll see it in this easy-to-use manual and you’ll hear it in the friendly voices of our customer service department. Best of all, you’ll experience these values each time you enjoy the comfort of your Zoneline. That’s important, because y[...]

• This Zoneline must be properly installed in accordance with the Installation Instructions before it is used. See pages 10-12. • Repair or replace immediately all electric service cords that have become frayed or otherwise damaged. • Unplug or disconnect the Zoneline at the fuse box or circuit breaker before making any repairs. NOTE: We stro[...]

4 Operating Instructions The temp control is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the same level of comfort. When you turn the knob to COOLER (blue) the indoor air will become cooler. Turn the knob to WARMER (red) and the indoor air will become warmer. 3200 Series only When the outdoor temp[...]

5 Ener gy T ip K eep the v ent control at CLOSE . The room air will be filtered and circulated. The ventilation control lever is located at the lower left side of the Zoneline unit, behind the room cabinet. When set at CLOSE , only the air inside the room is circulated and filtered. When set at OPEN , some outdoor air will be drawn into the room. T[...]

Operating Instructions Other Zoneline features Additional controls are located behind the room cabinet. T o remove: Pull out at the bottom to release it from the tabs. Then lift up. T o replace: Place the tabs over the top rail. Push inward at the bottom until it snaps into place. T o Remove the Room Cabinet 6 Heat pumps can save money by removing [...]

Switch #6 controls the Freeze Sentinel. When the switch is DOWN , the Freeze Sentinel automatically turns on the resistance heater and fan if the room temperature (sensed at the unit) drops to approximately 40 ° F. It will turn the heater off when the temperature reaches about 45 ° F. The unit leaves the factory with the Freeze Sentinel in the DO[...]

8 Operating Instructions Care & Cleaning Turn the Zoneline off and discon- nect the power supply. To clean, use water and a mild detergent. Do not use bleach or abrasives. Some commercial cleaners may damage the plastic parts. Room Cabinet and Case The coils on the outdoor side of the Zoneline should be checked regularly. If they are clogged wi[...]

T ur n the Zoneline off before cleaning. The most important thing you can do to maintain the Zoneline is to clean the filter at least every 30 days. Clogged filters reduce cool- ing, heating and air flow. Keeping these filters clean will: • Decrease cost of operation. • Save energy. • Prevent clogged heat exchanger coils. • Reduce the risk [...]

Installation Instructions Read carefully If you have any questions, call the GE Answer Center at 800.626.2000. • Use the correct wall case. This chassis is designed to be installed in a GE plastic or insulated metal wall case. This mini- mizes condensation from forming on the room side of the case. If the current wall case is not insulated, you c[...]

Important Electrical Safety—Read Carefully Installer: Leave these instructions with the Zoneline. Owner: Keep these instructions for future use. • Follow the National Electrical Code (NEC) or local codes and ordinances. • For personal safety, this Zoneline must be prop- erly grounded. • Protective devices (fuses or circuit breakers) accepta[...]

Installation Instructions All wiring, including installation of the receptacle, must be in accordance with the NEC and local codes, ordinances and regulations. This unit is equipped with a line cord for appropriate amperage wall receptacle. See below. T T a a n n d d e e m m P P e e r r p p e e n n d d i i c c u u l l a a r r L L a a r r g g e e T [...]

These models must be installed using one of the following methods: A Electrical subbase kits are available to provide a flexible enclosure for direct connection. Branch Circuit and Chassis Proper GE Amperage Rating Subbase Kit 15 RAK204E15 20 RAK204E20 30 RAK204E30 The instructions provided with the selected subbase kit must be carefully followed. [...]

Installation Instructions 6 Use the round knockout at the bottom of the junction box to attach conduit coming from the branch circuit. Remove the knockout, attach the conduit and bring wires into the junction box. Leave 6 ″ of wire free at the end of the conduit to allow connections to be made. 7 If a fuse and fuseholder are to be used, the knock[...]

15 1 The RAB71 or RAB77 wall case must be properly installed per instructions packed with the case. 2 Remove the corrugated stiffener and the outdoor protective panel. Use the slit in the outdoor panel as a handhold and push out. 3 Install the exterior grille from the room side following instructions packed with the grille. Insulated Wall Case This[...]

16 Slide the unit into the wall case and secure with four screws through the unit flange holes. If an insulated wall case is needed, see Install the Wall Case and Exterior Grille section on the previous page. Install the Unit into the W all Case 3 Reinstall the room cabinet by hooking the top over the rail along the unit top, then pushing it in at [...]

Low Voltage Connectors & Auxiliary Controls NOTE: The owner is responsible for checking all switches and ensuring they are set in the desired setting. 17 The Electric Heat Option switch #1 increases the Zoneline air temperature by using electric heat only. The heat pump is not used to produce any heat. Using the Electric Heat Option is much mor[...]

Installation Instructions To operate the Remote Control/Wall Thermostat (Class 2) switch #3, you must use an Optional Interface Module kit. See the Installation Instructions with accessory kit RAK0IM. UP DOWN 1 2 3 4 5 6 Remote Control/W all Thermostat (Class 2) To operate Central Desk Control (CDC), switch #5, you must have an Optional Interface M[...]

19 Helpful Information Things That Are Normal Noise Explanation 3-Minute Dela y You may hear a pinging or popping noise caused by water being picked up and thrown against the condenser on rainy days or when the humidity is high. This design feature helps remove moisture and improve efficiency. You may hear relays click when the controls cycle on an[...]

20 The unit is unplugged • Make sure the Zoneline plug is pushed completely into the outlet. The fuse is blown/circuit • Check the house fuse/circuit breaker breaker is tripped box and replace fuse or reset the breaker. The unit is waiting for the • This is normal. The Zoneline will start compressor ov erload again after it resets. protector [...]

21 Problem Possible Causes What to Do Burning Odor at the Start of Heating Operation Dust is on the surface of • This can cause a “burning” odor at the the heating element beginning of the heating operation. This odor should quickly fade. The Air is Not Always Cool or Hot During Operation The heat pump is not • This is normal. The heat pump[...]

22 Notes[...]

800.626.2000 TDD 800-833-4322 GE Service Numbers We’ll be there! Open 24 hours a day, 7 days a week. GE Answer Center ® 800-GE-CARES (800-432-2737) We provide expert repair service, scheduled at a time that’s convenient for you. Our factory-trained technicians know your air conditioner inside and out— so most repairs can be handled in just o[...]

Printed in China 12-97 CG Pub. No. 49-7359 Zoneline 2200/3200 Series What Is Not Covered FULL ONE- YEAR W ARRANT Y For one year from date of original pur- chase, we will provide, free of charge, parts and service labor on site to repair or replace any part of the Zoneline that fails because of a manufacturing defect. FULL FIVE- YEAR W ARRANT Y For [...]