GE DCD330G manuale d’uso

Dryers Part No. 175D1807P295 Pub. No. 49-90028 10/99 JR 131892900 DCB330E DCB330G DCD330E DCD330G Models: Owner’ s Manual & Installation Instructions Commercial www .geappliances.com GE Answer Center ® 800.626.2000[...]

Congratulations! Y ou Are Now Part of Our Family . Welcome to our family. We’re proud of our quality products and we are committed to providing dependable service. You’ll see it in this easy-to-use Owner’s Manual and you’ll hear it in the friendly voices of our customer service department. Best of all, you’ll experience these values each [...]

IMPORT ANT SAFETY INFORMA TION. READ ALL INSTRUCTIONS BEFORE USING. ■ Properly ground dryer to conform with all governing codes and ordinances. Follow details in the Installation Instructions section. ■ Install or store where it will not be exposed to temperatures below freezing or exposed to the weather. ■ Connect to a properly rated, protec[...]

4 IMPORT ANT SAFETY INSTRUCTIONS. READ ALL INSTRUCTIONS BEFORE USING. W ARNING! YOUR LAUNDRY AREA ■ Keep the area underneath and around your appliances free of combustible materials, such as lint, paper, rags, chemicals, gasoline and other flammable vapors and liquids. ■ Keep the floor around your appliances clean and dry to reduce the possibil[...]

WHEN NOT USING YOUR DRYER ■ Grasp the plug firmly when disconnecting this appliance to avoid damage to the cord while pulling. Place the cord away from traffic areas so it will not be stepped on, tripped over or subjected to damage. ■ Do not attempt to repair or replace any part of this appliance or attempt any servicing unless specifically rec[...]

6 Care and cleaning. The Exterior: Wipe or dust any spills or washing compounds with a damp cloth. Dryer control panel and finishes may be damaged by some laundry pretreatment soil and stain remover products. Apply these products away from the dryer. The fabric may then be washed and dried normally. Damage to your dryer caused by these products is [...]

T ools and Materials Required for Dryer Installation 7 Using the four shipping carton corner posts (two on each side), carefully lay the dryer on its left side and remove foam shipping pad. CAUTION: To prevent damage, do not use the control panel as a means to pick up or move the dryer. Return the dryer to an upright position. Adjust the leveling l[...]

Electrical requirements. Read these instructions completely and carefully . Electrical Connection Information for Gas Dryers WARNING— To reduce the risk of fire, electric shock, or personal injury: • DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE. • DO NOT , UNDER ANY CIRCUMST ANCES, CUT OR REMOVE THE THIRD GROUNDING PRON[...]

9 If all rigid metal duct cannot be used, then flexible all-metal venting can be used, but it will reduce the maximum recommended duct length. In special installations when it is impossible to make a connection with the above recommendations, then UL-listed clothes dryer transition duct may be used as transition venting between the dryer and wall c[...]

Replace brass connecting pipe that is not plastic- coated. Stainless steel or plastic-coated brass MUST be used. WARNING: Never reuse old flexible connectors. The use of old flexible connectors can cause gas leaks and personal injury. Always use NEW flexible connectors when installing a gas appliance. Installation MUST conform with local codes, or [...]

Installation in Recess or Closet This dryer MUST be exhausted outdoors. No other fuel burning appliance shall be installed in the same closet as the GAS DRYER. Your dryer needs the space around it for proper ventilation. DO NOT INST ALL YOUR DRYER IN A CLOSET WITH A SOLID DOOR. A minimum of 120 square inches (774.2 square cm) of opening, equally di[...]

Installing the dryer (cont.). Rough-In Dimensions Dryer MUST be exhausted outside (outdoors, not beneath the mobile home) using metal ducting that will not support combustion. Metal ducting must be 4 ″ (10.16 cm) in diameter with no obstructions. Rigid metal duct is preferred. If dryer is exhausted through the floor and area beneath the mobile ho[...]

13 Electrical Installation for Electric Dryers WARNING: The following are specific requirements for proper and safe electrical installation of your dryer. Failure to follow these instructions can create electrical shock and/or a fire hazard. WARNING: This appliance MUST be properly grounded. Electrical shock can result if the dryer is not properly [...]

Installing the dryer (cont.). Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner. Install a UL-approved strain relief into the power cord entry hole of the mounting bracket. Use a strain relief which attaches to the mounting bracket with a nut. Finger-tight[...]

15 Replacement Parts If replacement parts are needed for your dryer, contact the source where you purchased your dryer. CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing. WARNING: Destroy the carton and plastic bags after the par[...]

Installing the dryer (cont.). Reversing the Dryer Door Swing Open the dryer door. Remove the 4 hinge hole plugs or screws from the left side of door opening. Place nearby for future installation. NOTE: Y ou may need a plastic knife to help pull out the plugs. Be careful not to scratch the paint. Remove the four screws that secure the door hinges to[...]

17 Countdown Display (DCD models only) The countdown display shows the remaining operating time as well as the current drying cycle. The display board is configured for a 45-minute dry time at the factory to correspond with the 45-minute timer cam pre-installed in the coin box. If the timer cam is modified for another operating duration, the dipswi[...]

Notes 18 Customer Service Care and Cleaning Safety Instructions Installation Instructions[...]

19 Customer Service Care and Cleaning Safety Instructions Installation Instructions[...]

20 GE Commercial Dryer W arranty Parts and service are available from your General Electric Commercial Laundry distributor . For The Period Of: GE Will Replace: Three Y ears Any part of the dryer which fails due to a defect in materials or workmanship, except the drop From the date of the coin meter, coin slide mechanism, coin vault and locks, whic[...]