Graham Field 765000 manuale d’uso

765000 AL TERNA TING PRESSURE MA TTRESS SYSTEM WITH ACTIVE SENSOR TECHNOL OGY USER MANUAL Impor tant: Do not operate the Mattress System without rst reading and understanding this manual! Save this manual for future use. Info: The most current version of this manual can be found online at www.grahameld.com. 765000-INS-LAB-RevC11[...]

2 765000-INS-LAB-RevC11 CONTENTS INTRODUCTION..................................................................................... 3 INTENDEDUSEOFTHISDEVICE ........................................................ 3 CONTRAINDICA TION ...................................................................... 3 IMPORT ANTSAFETY[...]

765000-INS-LAB-RevC11 3 INTRODUCTION Use this manual for set-up and operation of the Lumex ® AltaDyne ® Sensor Plus 765000 Alternating Pr essur e Mattr ess System with Active Sensor T echnology . Read all instructions befor e using the mattr ess system. Save this manual for futur e r efer ence. INTENDED USE OF THIS DEVICE The intended use of t[...]

4 765000-INS-LAB-RevC11 IMPORT ANT SAFETY PRECA UTIONS The safety statements pr esented in this chapter r efer to the basic safety information that should be obser ved by those using this Mattr ess System. Ther e ar e additional safety statements in other chapters or sections, which may be the same as or similar to the following, or specic to[...]

765000-INS-LAB-RevC11 5 WARNING T o reduce the risk of bur ns, electrocution, r e, or per sonal injur y:  W ARNING:Donotleavethisproductunattendedwhen pluggedin.  W ARNING: Alwaysuseclosesupervisionwhenthis productisused b y, on,ornearchildrenorthosewho req[...]

6 765000-INS-LAB-RevC11  W ARNING:Patiententrapmentwithbedsiderails maycauseinjuryordeath.Thebedframeandits components,includingthemattress,bedsiderails, headandfootboard,bedding,andanyaccessories addedtothebed,canallaffectthe?[...]

765000-INS-LAB-RevC11 7 EQUIPMENT SYMBOLS Manufacturer “BF”symbol: Indicates that this product is in accordance with the degree of protection against electric shock for type BF equipment Functional earth (for UL only) Attention! Read the instructions! Disposal of Electrical & Electronic Equipment (WEEE): Do not treat this product as hous[...]

8 765000-INS-LAB-RevC11 PRODUCT DESCRIPTION PUMP AND MA TTRESS SY STEM pumpandmattresssystem CPRvalves quickconnectors (mattress-pump connectors) mattress footend symbol pump PUMP: FRONT quickconnector front panel PUMP: REAR mainpower switch powercord receptacle fuse hanger filter[...]

765000-INS-LAB-RevC11 9 PUMP: FRONT P ANEL Fr ont panel of pump is shown below . Descriptions of buttons and indicators follow . T uningbutton; indicatorsatleftofbutton Powerfailureindicator Alarmmutebutton Serviceindicator Power(ON/OFF)button; indicatoratrightofbutton Panellockbutton; indica[...]

10 765000-INS-LAB-RevC11 Tuning button: The tuning button ne-tunes the mattr ess system's auto-adjusted pr essur e. Thr ee tuning settings ar e available: 0 System auto-adjusted pr essur e - One level softer than auto-adjusted pr essur e + One level rmer than auto-adjusted pr essur e Info: The tuning function is only available in alte[...]

765000-INS-LAB-RevC11 11 Maxfir m button: The pump will automatically enter maxrm mode ever y time the power is turned on. Maxrm mode ensur es the pump is able to r each its maximum operating pr essur e. Maxrm mode will last for 20 minutes, and then the system will automatically enter auto-adjust mode. T o disable maxrm mode, pr ess[...]

12 765000-INS-LAB-RevC11 Low pr essur e indicator: The low pressur e indicator (yellow LED) illuminates, and the alarm sounds, when an abnormally low pr essur e level occurs. If the low pr essur e indicator persistently illuminates inappr opriately: 1. Check to ensur e all connections ar e pr operly and secur ely connected per installation instr[...]

765000-INS-LAB-RevC11 13 INST ALLA TION UNP ACKING 1. Car efully r emove all components fr om the carton. 2. Inspect all components. 3. If damage is evident to the contents, please notify the carrier and your Graham-Field equipment pr ovider . PUMP AND MA TTRESS SETUP 1. Place the mattr ess on top of the bed frame; ensur e that the foot end symb[...]

14 765000-INS-LAB-RevC11  W ARNING:Locateallcordssothattheywillnotbe steppedon,trippedover ,orotherwisesubjectedto damageorstress.  W ARNING: Donotuseahouseholdextensioncordifthe electricalcorddoesnotreachthepoweroutlet.Useo[...]

765000-INS-LAB-RevC11 15 OPERA TION GETTING ST AR TED 1. T urn the main power switch to the ON position. 2. Pr ess the fr ont panel power button. The power indicator will illuminate. Info: The mattress system will automatically enter maxfirm mode for the quickest inflation at set-up; when inflated, it will then automatically enter auto- adjus[...]

16 765000-INS-LAB-RevC11 TRANSPORT CAP In case of power failur e or transport: Disconnect the quick connector and cap the mattr ess with the transport cap to slow deation. Info: This system is equipped with cell-on-cell technology to provide added support and prevent bottoming out in the event of a power failure. Lower cells will hold air for[...]

765000-INS-LAB-RevC11 17 MAINTENANCE CLEANING  W ARNING: To reducetheriskofincreasedbacterial growth,infection,illness,orinjuryfromcontamination, thoroughlycleananddrythemattresssystembefore useandasnecessaryduringuseasfollows: Pump : W ipe the pump with[...]

18 765000-INS-LAB-RevC11 Fuse replacement tool needed: small screwdriver 1. If you suspect a blown fuse, disconnect the plug fr om the wall outlet immediately . 2. Use a small scr ewdriver to r emove the cover of the fuse holder (fuse locations ar e shown in pictur e at right). 3. Insert a new fuse of the correct rating (T1A/250V , VDE appr oved[...]

765000-INS-LAB-RevC11 19 SPECIFICA TIONS Pump Specication Power Supply (Info: see rating label on product) AC 120V 60 Hz 0.17A (for 120V system) Fuse Rating T1A, 250V Cycle time Fixed / 10 minutes Dimensions (L x W x H) 1 1.4" x 7.9" x 4.6" (29.1 x 20 x 11.7 cm) Weight 5 lb (2.2 kg) Environment T emperature Operation: 50°F to [...]

20 765000-INS-LAB-RevC11 LIMITED WARRANTY GF Health Pr oducts, Inc. warrants the Lumex ® AltaDyne ® Sensor Plus 765000 Alternating Pr essur e Mattr ess System with Active Sensor T echnology for a period of twelve months for defects in workmanship and materials. If a pr oduct is deemed to be under warranty , GF Health Pr oducts, Inc. shall pr o[...]

765000-INS-LAB-RevC11 21 APPENDIX A: EMC INFORMA TION Guidance and Manufacturer’s De claration- Electromagnetic Emissions: This device is intended for use in the electromagnetic environment specified below . The user of this device should make sure i t is used in such an environmen t. Emissions T est Compliance Electromagnetic Environment-Gui [...]

22 765000-INS-LAB-RevC11 Guidance and Manufact urer ’ s Declaration- Electromagn etic Immunity: This device is intended for use in the electromagnetic environment spec ified bel ow . T he user of t his device should ma ke sure it is us ed in such an environment. Immunity T est IEC60601 test level Compliance Electromagnetic Environment-Guidance[...]

765000-INS-LAB-RevC11 23 a The ISM (indu str ial, sc ient ific and medical) bands between 150 kHz and 80 MHz are 6,765 MHz to 6,795 MHz;13,553 MHz to 13,567 MHz; 26,957 MHz to 27,283 MHz; and 40,66 M Hz to 40,70 MHz. b The compliance levels in the ISM frequenc y bands between 150 kHz and 80 MHz and in the frequency ran ge 80 MHz to 2,5 GHz are i[...]

USA Corporate Headquar ters: GF Health Products, Inc. 2935 Nor theast Parkway Atlanta, Georgia 30360 telephone: 770-368-4700 fax: 770-368-2386 www .grahamfield.com © 2011 GF Health Products, Inc.[...]