Jensen SD1411 manuale d’uso

SD1411 Owner's Manual / TUNE SD1411 MP3/WMA RECEIVER SCAN MONO EQ AUX IN MENU (7) AM/FM/CD/MP3/WMA Receiver[...]

SD1411 2 PREPAR ATION Getting Started Congratulations on your purchase of the Phase Linear SD141 1 Mobile AM/FM/CD/MP3/WMA Receiver . It’s a good idea to read all of the instructions before beginning the installation. We recommend having your Phase Linear SD141 1 inst alled by a reputable installation shop. Contents Installation Instructions ....[...]

SD1411 3 INSTALLATION INSTRUCTIONS This unit is designed for installation in cars, trucks and vans with an existing radio opening. In many cases, a special installation kit will be required to mount the radio to the dashboard. These kits are availabl e at electronics supply stores and car stereo specialty shops. Always check the kit application bef[...]

SD1411 4 9. Attach one end of the perforated support strap (supplied) to the screw stud on the rear of the chassis using the hex nut provided. Fasten the other end of the perforated strap to a secure part of the dashboard, either above or below the radio, using the screw and hex nut provided. Bend the strap, as necessary , to position it. CAUTION: [...]

SD1411 5 Remove Radio T o remove the radio after installation, remove the trim ring by lifting in the center and pulling it off from either side. Insert the removal keys straight back until they lock, and then pull the radio out. If removal keys are inserted at an angle, they will not lock properly to release the unit. Removal Key[...]

SD1411 6 WIRING 1. Power Antenna (dark blue wire) - Connect to power antenna or amplifier . If not use d, tape bare end of wire. 2. Accessory/Ignition (red wire) - Connect to existing radio wire or radio fuse. 3. Ground (black wire) - Connect to ground terminal or clean, unpainted part of chassis. 4. Memory/Battery (yellow wire) - Connect to batter[...]

SD1411 7 OPERATING INSTRUCTIONS Power Press the power button (1) or any ot her button on the face of the receiver to turn the unit on when the ignition switch is on. Press the power button again to turn the receiver of f. If the radio was left on when the ignition was last turned off, the receiver will turn on automatically when the ignition switch[...]

SD1411 8 Balance Press the AUDIO CONTROL button (4) four times until “BAL” appears in the display . Within five seconds, turn the AUDIO CONTROL (3) clockwise (or counter clockwise) to adjust Balance between the right and left speakers from “BAL 10R” (full right) to “BAL 10L” (fu ll left). “BAL L=R” represents an equal balance level [...]

SD1411 9 Display (D) When the unit is off, the LCD displays the time of day . When the unit is on, the LCD automatically shows the tuner or CD display , depending on which mode of operation is currently activated. Display Clock During tuner or CD operation, press D (9) to display the time of day . After five seconds, the display reverts to tuner or[...]

SD1411 10 T UNER OPERATION AM/FM Band Selector (BAND) Press BAND (5) during radio play to switch between three FM bands and one AM band. “F1”, “F2”, “F3” or “AM” will appea r in the display to indicate the band currently selected. Tuning Automatic Tuning Press the Up T uning (14) button to tune upward in frequency and the Down Tunin[...]

SD1411 11 Repeat for the remaining five presets on the current band and for all presets on the other three bands. Automatically Store / Pr eset Scan (AS/PS) Automatically Store Select six strong stations and store them in the current band using the Automa tic S tore feature. T o enable this feature, press and hold AS/PS (17) for more than two secon[...]

SD1411 12 CD PLAY ER OPERATION Insert CD With the label surface facing up, gently insert the disc into the CD slot (21) until the soft- loading mechanism engages and pulls th e disc in. Disc play begins, “CDP PLA Y” will appear in the display , and the CD icon will become animated. The center of the disc icon (7) illuminates and becomes animate[...]

SD1411 13 Disc Repeat (RPT) Press RPT (25) during disc play to cont inuously repeat the selected track. “S--RPT” will appear in the display . Press RPT again to stop repeating. “S--RPT” will disappear from the display , and regular play will resume. The repeat function will also be canceled when activating the scan or shuffle functions. Dis[...]

SD1411 14 MP3/WMA OPERATION MP3 and WMA (Windows Media Audio) music files are digital audio fi les that are compressed to allow more files on a single CD. This unit can play MP3/WMA directly from files contained on a CD-R/RW using the buttons on the receiver (or optional remote) as described below. Many types of software are available for convertin[...]

SD1411 15 Entering ID3 Tag This unit supports ID3 tag versions 1.0 and 1.1. For the character codes, refer to the table below . Entering File and Folder Names Names using the code list characters are the only file names and folder names that can be entered and displayed. Other characters will not display correctly . The unit recognizes and plays on[...]

SD1411 16 beginning with play s equence numbers such as "01" to "99". For example, a medium with the following folder/file hierarchy is s ubject to Folder Search, File Search or Folder Select as shown below. Pause Press the 1/>/|| button (23) to suspend disc play . Press the play/pause button again to resume play . Track Sele[...]

SD1411 17 Y ou can also turn the rotary to access and file numbers sequentially . Af ter locating the desired file, press the BAND/ENTER button (5) or AUDIO CONTROL button (4) to begin playback. Directory/File Search 1. Press the AS/PS button (17) twice to enter Directory or File Name Search mode. The LCD will display a blinking asterisk. 2. Use th[...]

SD1411 18 USING A USB DEVICE OR SD CARD Loading a USB Device USB devices can be played through the USB connector on the front panel. T o access files on a USB device, insert the USB device as indicated below: After inserting an USB device containing MP3 or WMA files, “USB PLA Y” appears on the display and the unit will automatically scan the ca[...]

SD1411 19 REMOTE CONTROL The remote control will allow you to control the basic functions of the SD141 1. The remote control sensor is located on the left side of the front panel to the rig ht of the MONO button (18). S VOL VOL D U BND SCN MOD LOC AMS PEQ MO MUT DISP 12 3 4 5 6 PA U SCN RPT SHUF DN UP LOUD TR. DN TR. UP AMS = AS/PS PEQ = EQ MOD = M[...]

SD1411 20 CARE AND MAINTENANCE CD Player The following guidelines will help you extend the life of your CD player: 1. When cleaning the vehicle interior , do not get water or cleaning fluids on the unit. 2. The CD player will not operate properly in extreme hot/cold or under damp conditions. In case of such conditions, wait until the vehicle interi[...]

SD1411 21 T ROUBLESHOOTING Problem Cause Corrective Action Does not operate (display does not light) No power to yellow wire; no power to red wire Check connec tion with test light; chec k vehicle fuse with test light. Inline fuse blown Replace fuse. No power to unit Inline fuse blown Check/replace fuse. Not all speakers operate Incorrect splices o[...]

SD1411 22 SPECIFICATIONS CEA Power Ratings Power output: 13 watts RMS X 4 channels into 4-ohms @ < 1% THD+N Signal to noise ratio: 70dBA below refere nce. (Reference: 1 watt, 4-ohms) Frequency response: 20Hz to 20kHz (-3d B), Auxiliary input used as source reference Reference supply voltage: 14.4VDC CD Player Signal-to-noise ratio: >90dBA Fre[...]

Limited Warranty DO NOT RETURN THIS PRODUCT TO THE STORE CD or Multimedia Radios/Headunits Audiovox Electronics Corporation (“the Company”) is committed to quality and customer service, and are pleased to offer you this Warranty. Please read it thoroughly and contact the Company at 1-800- 323-4815 with any questions. Who is covered? The Company[...]

Audiovox Electronics Corporation 150 Marcus Boulevard Hauppauge, NY 1 1788 1-800-323-4815 www .audiovox.com ©200 7 Audiovox v . 0 903 07[...]