Kingston Technology KNS1600 manuale d’uso

K INGSTON T ECHNO LOGY F AST E THE R X 10/100B AS E -TX 19” R AC K -M OU NTABLE F AST E THERNE T S WITCH U SER’S G UIDE M ODEL : KNS1600/R[...]

KNS1600/R User’s Guide - Rev. A00 Kingston Technology Company Kingston Technology’s Fast EtheRx 16-Port 10/100BASE-TX 19” Rack-Mountable Fast Ethernet Switch User’s Guide Part No. 4460169-001.A00 Kingston Technology Company 17600 Newhope Fountain Valley, CA 92708 (714) 435-2600 http:// www.kingston.com[...]

Kingston Technology Company Fast EtheRx K NS1600/R - Rev. A00 Important Safety Instructions 1. Read all these instructions. 2. Save these instructions for later use. 3. Follow all warnings and instruction s marked on the product. 4. Do not use this product near water. 5. This product should be operate d from the type of power source indicated o n t[...]

i KNS1600/R User’s Guide - Rev. A00 Kingston Technology Company Table Of Contents Introduction ........................................................................... 1 Special Features ....................................................... 2 Package Contents..................................................... 2 Compliance Standards .......[...]

ii Kingston Technology Company KNS1600/R User’s Guide - Rev. A00 Rear Panel ................................................................ 7 Power Switch ............................................... 7 AC Power Connector ................................... 7 Fuse ............................................................. 7 Fan Units ......[...]

Introduction 1 KNS1600/R User’s Guide - Rev. A00 Kingston Technology Company Introduction Intended Audience: This manual assumes that the user has a general work ing knowledge of networking princip les and architecture and is familiar with network systems in general. Congratulations on the purchase of your new Kingston Fast EtheRx 10/100BASE-TX 1[...]

2 Special Features Kingston Technology Company KNS1600/R User’s Guide - Rev. A00 Special Features • Provides automatic switching function between 10Mbps and 100Mbps • Auto-Negotiation for 10/100Mbps selection • Auto-Negotiation for half-duplex and full-duplex mode operation • Uses Store and Forward switching approach to minimize r e- tran[...]

Design Features 3 KNS1600/R User’s Guide - Rev. A00 Kingston Technology Company Compliance Standards The Fast EtheRx Switch complies with the 10/100Mbps fun ctions as defined by IEEE802.3u 1 00BASE-TX, IEEE80 2.3i 10BASE-T, a nd IEEE802.3 CSMA/CD Ethernet standards. Design Features Switching Function The Fast EtheRx Switch is basically designed t[...]

4 Front Panel Kingston Technology Company KNS1600/R User’s Guide - Rev. A00 Hardware Installation Before you begin installing network cables, please take a few moments to familiarize yourself with Fast EtheRx Switch . The functions on th e front and rear panels are illustr ated in the following sections. Fig. 1-KNS1600/R Front Panel Front Panel P[...]

Front Panel 5 KNS1600/R User’s Guide - Rev. A00 Kingston Technology Company 3. Make sure the cable is wired properly and connected on both ends. 4. Make sure the correct cabl e type has been selected . 5. If steps 1 through 4 are correct, please check the cable, as it may be defective or wired incorrectl y. Replace th e cable and try again. Pleas[...]

6 Front Panel Kingston Technology Company KNS1600/R User’s Guide - Rev. A00 The following diagrams show the relationship between cable type and which UTP port connector to use. To verify the pin wir ing of your UTP cable, see “Appendix A Pin Assignments.” Using a Straight-Through Cable Use the port labeled when connecting to a network card or[...]

Rear Panel 7 KNS1600/R User’s Guide - Rev. A00 Kingston Technology Company Rear Panel Figure 2 – KNS1600/R Rear Panel Power Sw itch The AC Power switch turns the un it kj or kbb . If the PWR LED do es not light up when the unit is turned on, please check the following: 1. Try a different AC power outlet. 2. Check the external fuse located in th[...]

8 Appendices Kingston Technology Company KNS1600/R User’s Guide - Rev. A00 Appendices[...]

Appendix A Pin Assignments 9 KNS1600/R User’s Guide - Rev. A00 Kingston Technology Company Appendix A Pin Assignments UTP Port Pin Assignments The UTP ports use RJ-45 Unshielded Twisted Pair (UTP) cabling. Connector pin numbers and pin wiring assignments ar e listed below in Figure A-1 an d Table A-1, respectivel y. Twisted-Pair cables can be wir[...]

10 Appendix B Cabling Guidelines Kingston Technology Company KNS1600/R User’s Guide - Rev. A00 Appendix B Cabling Guidelines UTP Cable Type When installing network cables, the following table shows appropriate cabling guidelines for 100BASE-TX Fast Ethern et architecture. Cabling Component s: 100BASE-TX Trunk and Patch Cable Typ e: 4-Pair 100 Ω[...]

Appendix B Cabling Guidelines 11 KNS1600/R User’s Guide - Rev. A00 Kingston Technology Company UTP Cable Wiring Standards There are two governmental agencies: the Electronic Industry Association (EIA) and the Telecommunications Industr y Association (TIA), which set the standard for all cable wiring requirements for commercial buildings. With the[...]

12 Appendix B Cabling Guidelines Kingston Technology Company KNS1600/R User’s Guide - Rev. A00 UTP Cable Rating Codes UTP cables meet differen t UL-NEC requirements based mostly on cable-jacke t quality. Below is an explanation of the rating codes for each cable type . UL – The National Electrical Code (NEC), published by the National Fire Prot[...]

Appendix C Specifications 13 KNS1600/R User’s Guide - Rev. A00 Kingston Technology Comp any Appendix C Specifications Fast EtheRx Model KNS1600R Compliance: IEEE 802.3u 100BASE-TX Standar d IEEE802.3i 1 0BASE-T Standard IEEE802.3 CSMA /CD Ethernet S ta ndard Media Interface: Sixteen (16) auto -negotiating 10/100 Mbps UTP ports Uplink Port: Port 1[...]

14 Appendix C Specifications Kingston Technology Company KNS1600/R User’s Guide - Rev. A00 Physical: Dimension (H xWxD): 1.69” x 17.3 2” x 7.88” (43.30m m x 443.40m m x 201.70m m) Weight: 6.3 lbs. (2. 9 kg) Certification EMI Standards: FCC Class A, CE CISPR A, C-Tick EMC Standards: EN55022, IEC801-2, IEC801-3, IEC801-4 Low Voltage Di rectiv[...]

Appendix D Frequently Asked Questions 15 KNS1600/R User’s Guide - Rev. A00 Kingston Technology Compa ny Appendix D Frequently Asked Questions What is a switch and what does it do? Switching hubs are low-latenc y devices that allow you to maximize the bandwidth of a network using concurrent access with in the unit. Switches allow you to segment LA[...]

16 Appendix D Frequently Asked Questions Kingston Technology Company KNS1600/R User’s Guide - Rev. A00 Category 5 Compliance vs. Categ ory 5 Performance? Using CAT 5 cabling in your network installation does not necessarily achieve full Category 5 performance. To achieve any category-rated performance, make sure all cabling components, including [...]

Appendix E Mounting Templates 17 KNS1600/R User’s Guide - Rev. A00 Kingston Technology Comp any Appendix E Mounting Templates The Fast EtheRx Switch can be stationed on a flat surface using the four rubber feet provided, or mounted in a standard 19” r ack by using the mounting brackets and 4 thumb screws provided with th e unit. Rubber Feet for[...]

18 Appendix F Product Warranties and Notices Kingston Technology Company KNS1600/R User’s Guide - Rev. A00 Appendix F Product Warranties and Notices Limited Warranty Statement KINGSTON TECHNOLOGY COMPANY (" Kingston") warrants that this product is free from defects in material and workmanship. Subject to the conditions and lim itations [...]

Appendix F Product Warranties and Notices 19 KNS1600/R User’s Guide - Rev. A00 Kingston Technology Comp any Warranty Claim Requirements To obtain warranty service, return the defective product, freight prepaid and insured, to your local authorized Kingston dealer or distributor, or to the Kingston factory service center located at 17600 Newhope S[...]

20 Appendix F Product Warranties and Notices Kingston Technology Company KNS1600/R User’s Guide - Rev. A00 F.C.C. Certification This device has been tested and found to comply with limits for Class A digital device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful in[...]