La Crosse Technology WS-7034TWC-IT manuale d’uso

WS-7034U-IT Wireless 915 MHz Temperature Station Instruction Manual[...]

2 TABLE OF CONTENTS Topic Page Quick Setup 3-5 Inventory of Contents 6 Detailed Setup Guide Battery Installation 7 Setting the Time 7-8 Selecting Units of Measurement 9 Features Minimum and Maximum Temperatures 9-10 Resetting Minimum and Maximum Temperatures 10 Adding additional remote temperature sensors (optional) 11-12 Mounting 12-13 Troubleshoo[...]

3 QUICK SETUP Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. 1. Have the indoor temperature st ation and remote tem perature sensor 3 to 5 feet apart. 2. Batteries should be out of bot h units for 10 minutes. 3. Place the batteries into the remote temperature sensor first then into the indoor temperature st ation. (All [...]

4 display will show both the indoor temperature and an outdoor temperature. If the indoor temperat ure station does not display both t emperatures afte r the 10 minutes please ret ry the set up as stated above. After both i ndoor and outdoor temperat ures are displayed for 10 minutes you can place your rem ote temperature sensor outdoors and set yo[...]

5 NOTE: Fog and mist will not harm your remote tem perature sensor but direct rain must be avoi ded. To complete the set up of your i ndoor temperature station after the 10 m inutes have passed please follow the steps on pages 8-9. INVENTORY OF CONTENTS 1. The indoor temperature station (Figure 1) 2. The remote temperature sensor (TX29U) and mounti[...]

6 ADDITIONAL EQUIPMENT (not included) 1. 1 Philips screwdriver. 2. 2 Fresh AAA Alkaline batteries. 3. 2 Fresh AA Alkaline batteries DETAILED SETUP GUIDE Battery Installation 1. Install 2 AA batteries in the remote temperature sensor. Make sure they do not spring free, or start-up Figure 1[...]

7 Battery Cover problems may occur. 2. Install 2 AAA batteries in the indoor temperature station. Do not press any buttons for at least ten minutes. Setting the Time 1. Press and hold the “ SET” button for 5 second, “12h” will appear in the TIME LCD. 2. Press and release the “ MIN/MAX” button to select either 12h time (am/pm) or 24h tim[...]

8 5. Press and release the “SET” button to move to the minute setting 6. Press and release the “ MIN/MAX” button to set the minutes. 7. Press and release the “ SET” button to activate the clock. Note: When in 12h mode, there is only a “PM” display, which appears under “TIME.” If there is no display here it is AM. Make sure you s[...]

9 FEATURES Minimum and Maximum Temperatures 1. Press and release the “ MIN/MAX” button, “MIN” appears next to the indoor and remote temperatures. 2. The recorded minimum temperature is displayed. The time of the minimum outdoor temperature will also flash. 3. Press the “MIN/MAX” button, “MAX” appears next to the indoor and remote te[...]

10 Resetting Min and Max Tempe ratures To reset both the minimum and maximum temperatures—press and hold the “RESET/+” button for 4 seconds. Adding Additional Remote Temperature Sensors (optional) The WS-7034U-IT is able to receive signals from 3 different remote temperature sensors. Following are some brief instructions for the basic set-up [...]

11 first into all the remote temperature sensors. Second insta ll batteries into the indoor temperature station and do not press any buttons for ten minutes. Transmission problems will arise if this is not done correctly. To view the temperature of a different remote temperature sensor unit, press and release the “SET/CH” button. A shift from o[...]

12 Remote Temperature Sensor 1. Remove the mounting bracket from the remote temperature sensor. 2. Mount the bracket in the desired location with either screws or adhesive tape. 3. Reattach the remote temperature sensor into mounting bracket. Indoor Temperature Station The indoor temperature station comes with the table stand already mounted. If yo[...]

13 temperature station over the screw and pull down to secure. TROUBLESHOOTING NOTE: For problems not solved, please contact La Crosse Technology via e-mail or phone, or visit our website, www.lacrossetechnology.com Problem: The LCD is faint Solution: Replace batteries Problem: No outdoor temperature is displayed. Solution: 1. Remove all batteries,[...]

14 so the straight-line signal is not passing through more than two or three walls. Problem: Temperatures do not match if units are placed next to each other. Solution: Each temperature sensor is manufactured to be accurate to within 1 degree plus or minus and under normal conditions, so two sensors could be as much as 2 degrees different. However,[...]

15 is difficult to compensate for the above factors and obtain an accurate comparison. MAINTENANCE AND CARE INSTRUCTIONS • Extreme temperatures, vibration, and shock should be avoided to prevent damage to the units. • Clean display s and units with a soft, damp cloth. Do not use solvents or scouring agents; they may mark the displays and casing[...]

16 Measuring Temperatures Indoor Temperature Station 14.1 ° F to 139.82 ° F with 0.2 ° F resolution. (-9.9 ° C to 59.9 ° C with 0.1 ° C resolution). Remote Temperature Sensor -39.8 ° F to 139.8 ° F with 0.2 ° F resolution. (-39.8 ° C to 59.9 ° C with 0.1 ° C resolution). Temp accuracy +/- 1 ° F (+/- .5 ° C). Transmitting range Maximum[...]

17 Dimensions: (L x W x H) Indoor Temperature Station 2.36 x .88 x 5.90 in. (excluding table stand) (60 x 22.5 x 150 mm). Remote Temperature Sensor 2.32 x 0.86 x 2.55 in. (59 x 22 x 65 mm). Battery life Up to 24 months. WARRANTY INFORMATION La Crosse Technology, Ltd pr ovides a 1-year limited warranty on this product against manufacturing defects i[...]

18 of sale must be presented upon request as pr oof of purchase to La Crosse Technology, L td or La Crosse Technology, Ltd’s authorized ser vice center. La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the[...]

19 Your La Crosse Technology, L td warranty covers all defects in material and workm anship with the following specified exceptions: (1) damage caused by accident, unreasonable use or neglect (including the lack of reasonable and necessary maintenance); (2) damage occurri ng during shipment (claim s must be presented to the carrier); (3) damage to,[...]

20 SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS PRODUCT. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. THIS PRODUCT IS NOT A TOY. KEEP OUT OF CHILDREN’S REACH. This warranty gives you specific legal rights. You may also have other r ights specific to your State. Some States do no allow the [...]

21 sales@lacrossetechnology.com (information on other products) web: www.lacrosse te chnology.com FCC DISCLAIMER This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harm ful interference. (2) This device must accept any interference received, including interference [...]

22 duplicated or processed using electronic, mechanical or chem ical procedures without written permission of the publisher. This handbook may contain m istakes and printing errors. The inform ation in this handbook is regularly checked and corrections made in the next issue. We accept no liability for technical mistakes or printing er rors, or the[...]