Memorex MCD4300BT manuale d’uso

MODEL: MCD4300BT BEFORE OPERA TING THIS PRODUCT , PLEASE READ THESE INSTRUCTIONS COMPLETEL Y . AZURE BLUET OOTH CAP ABLE MUL TI-HANDSET SYSTEM OPERA TING INSTRUCTIONS MCD4300BT.2002.O/M.QXD 4/19/02 9:57 AM Page 37[...]

1 CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN DANGEROUS VOLTAGE Uninsulated Dangerous Voltage, that may be of sufficient magnitude to constitute a risk of electric shock to persons is present[...]

2 IMPORT ANT SAFETY PRECAUTIONS (CONTINUED) 8. Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock. 9. Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short out parts that could result in fire or electric shock. Never spill or spray[...]

8. Do not store this product, or the battery provided with or identified for use with this product, in a high-temperature area. Batteries that are stored in a freezer or refrigerator for the purpose of extending shelf life should be stabilized at room temperature prior to use after cold storage. 9. Disconnect telephone lines before installing batte[...]

Important Safety Instructions ..........1 Contents .............................................4 Location of Controls .........................5 Installation Instructions ....................6 Installation of the Rechargeable Battery ..................................................7 Charging the Rechargeable Battery ....7 Wall Mounting the Unit [...]

5 LOCA TION OF CONTROLS FRONT HANDSET: 1. Headset Jack (top of handset) 2. Handset LED Indicator 3. CLEAR Button 4. CID JOG Control 5. TALK Button 6. Key buttons (0-9,*,#) 7. TRANS (Transfer) Button 8. FLASH Button 9. Handset Antenna 10. Display 11. SEL (Select) Button 12. MENU Button 13. REDIAL Button 14. PAGE Button 16 17 19 20 18 15 BASE BASE: 1[...]

1. Carefully unpack and remove your unit from the box. 2. Make sure all the items have been included: 3. Make sure the Rechargeable Battery is installed or install the Rechargeable Battery as described on the next page. PLEASE REFER TO THE FOLLOWING DIAGRAM FOR STEPS 4 THROUGH 7: 4. Slide the T/P switch to TONE or PULSE to match the service provide[...]

7 INST ALLA TION INSTRUCTIONS (CONTINUED) Remove the battery cover located on the rear of the handset by sliding it downward. 1 If replacing an old battery pack, unplug the battery connector and remove it by carefully using a small flat head screw- driver to pry it out from the battery compartment. 2 Plug the new battery into the rechargeable batte[...]

8 INST ALLA TION INSTRUCTIONS (CONTINUED) W all Mounting the Unit 1. Use an existing wall mount, like ones found in a kitchen or drill one as follows: Drill two holes with a vertical distance between the two marked positions of 83mm as shown in Figure 1. Drive a screw into each of the holes. Tighten them to the end of the screw lines, only leaving [...]

9 SET -UP INSTRUCTIONS (CONTINUED) SETTING THE TIME It may be necessary to set the internal clock time of the phone to display the time in the Caller ID display when incoming calls are received. If you subscribe to Caller ID, the time is automatically set when the first call is received. If the time is not automatically set, follow the steps below:[...]

10 SET -UP INSTRUCTIONS (CONTINUED) SETTING THE AREA CODES To conveniently call back a number from the caller ID, it is necessary to store your local area code when your telephone is installed, as follows: Press the MENU button ❶ ; the Menu will appear in the display. Using the CID JOG control ❷ , scroll down to select “2. SET UP” and press[...]

11 SET -UP INSTRUCTIONS (CONTINUED) CHANGING THE HANDSET’S VOLUME Change the handset’s volume as follows: Press the MENU button; the Menu will appear in the display. 12/14 17 10:25 AM 17 1.MEMORY 2.SET UP 3.RINGER 4.VOLUME 1 Using the CID JOG control ❶ , scroll down to select “4. VOLUME” and press the CID JOG control ❶ , or simply press[...]

12 SET -UP INSTRUCTIONS (CONTINUED) CHANGING THE RINGER VOLUME Change the handset’s ringer volume as follows: Press the MENU button; the Menu will appear in the display. 12/14 17 10:25 AM 17 1.MEMORY 2.SET UP 3.RINGER 4.VOLUME 1 Using the CID JOG control ❶ , scroll down to select “4. VOLUME” and press the CID JOG control ❶ , or simply pre[...]

13 SET -UP INSTRUCTIONS (CONTINUED) CHANGING THE RINGER MELODY Change the ringer melody to choose from two tones or three songs as follows: Press the MENU button; the Menu will appear in the display. 12/14 17 10:25 AM 17 1.MEMORY 2.SET UP 3.RINGER 4.VOLUME 1 Using the CID JOG control ❶ , scroll down to select “3. RINGER” and press the CID JOG[...]

14 BASIC OPERA TION PLACING A CALL After the battery has been fully charged, p ress the Key buttons (0-9) ❶ for the phone number you wish to call. NOTE: Press the REDIAL button ❷ to insert a pause. A pause is a two second interval between numbers. 2 1 1 Press the TALK button t o dial the number you entered. You can also press the TALK button fi[...]

15 BASIC OPERA TION (CONTINUED) RECEIVING A CALL The last 30 incoming calls are saved in the Caller ID log. Make sure that the Caller ID service is turned on by your phone company. When you receive a call, the display will show the name of the caller, number, time and date of the call. JOHN SMITH 8001234567 12/14 17 10:25 AM 1 To answer the call, p[...]

16 BASIC OPERA TION (CONTINUED) USING THE BASE P AGE BUTTON USING THE FLASH BUTTON Press the PAGE button on the base to locate all handsets when not in use; all handsets will ring. Press again to end the paging feature. Press any button on the handset to end paging. If none of the handsets pick up in two minutes, the paging will stop. 1 Press the F[...]

17 BASIC OPERA TION (CONTINUED) CHECKING THE CALLER ID LOG Using the CID JOG control, scroll to see the Caller ID log. Scroll up for newer calls, down for older calls. JOHN SMITH 800-123-4567 12/14 17 10:25 AM 1 DELETING NAME(S)/NUMBER(S) FROM THE CALLER ID LOG Using the CID JOG control ❶ , scroll to the desired number to delete. Press the CID JO[...]

18 BASIC OPERA TION (CONTINUED) AUTOMA TICALL Y DIALING A NUMBER IN THE CALLER ID DISPLA Y When the local area code and/or extra codes have been stored as described on page 13, you can automatically call a number from the caller ID log as follows: Using the CID JOG control, scroll to see the Caller ID log. Scroll up for newer calls, down for older [...]

19 BASIC OPERA TION (CONTINUED) ADDING A DIRECTOR Y ENTR Y The directory can store up to 100 name/telephone numbers which you may enter either through the phone as described below or via your computer using a USB cable (not included) and the included CD software (see page 30 for instructions). SA VING CALLER ID INFORMA TION TO THE DIRECT OR Y You c[...]

20 BASIC OPERA TION (CONTINUED) ENTERING A NAME USING THE KEY BUTT ONS When entering names into the directory, you must use the Key buttons (0-9,*,#). To use the buttons to add names, perform the following steps: Follow steps one through five on the previous page to program the telephone number. 1 2 12/14 17 10:25 AM 17 1.MEMORY 2.SET UP 3.RINGER 4[...]

21 BASIC OPERA TION (CONTINUED) DIALING A NUMBER FROM THE DIRECT OR Y To select and dial a number from the directory, follow the steps below: Press the MENU button; the Menu will appear in the display. 12/14 17 10:25 AM 17 1.MEMORY 2.SET UP 3.RINGER 4.VOLUME 1 Using the CID JOG control ❶ , scroll down to select “1. MEMORY” and press the CID J[...]

22 BASIC OPERA TION (CONTINUED) EDITING A DIRECTOR Y ENTR Y To select and edit a name/number from the directory, follow the steps below: Follow steps one through four on the previous page to select a name/ number to edit. Press the CID JOG control to select the entry. 1 2 12/14 17 10:25 AM 17 1.MEMORY 2.SET UP 3.RINGER 4.VOLUME 1 Using the CID JOG [...]

23 ADV ANCED FEA TURES SETTING THE ALARM THE TIME MUST BE SET BEFORE SETTING THE ALARM. (For time setting, refer to page 9.) Press the MENU button; the Menu will appear in the display. 12/14 17 10:25 AM 17 1.MEMORY 2.SET UP 3.RINGER 4.VOLUME 1 Using the CID JOG control ❶ , scroll down to select “2. SET UP” and press the CID JOG control ❶ , [...]

24 ADV ANCED FEA TURES (CONTINUED) TURNING THE ALARM ON/OFF After the alarm has been set, it automatically will turn on at a set time, one time only. If you would like to turn the alarm off or back on, follow the instructions below: Press the MENU button; the Menu will appear in the display. 12/14 17 10:25 AM 17 1.MEMORY 2.SET UP 3.RINGER 4.VOLUME [...]

25 ADV ANCED FEA TURES (CONTINUED) SETTING THE ALARM MELODY Choose one of the alarm melodies as follows: Press the MENU button ❶ ; the Menu will appear in the display.Using the CID JOG control ❷ , scroll down to select “3. RINGER” and press the CID JOG control ❷ , or simply press the “3” button ❸ . 12/14 17 10:25 AM 17 1.MEMORY 2.SE[...]

26 ADV ANCED FEA TURES (CONTINUED) REGISTERING THE HANDSETS (FOR MUL TIPLE HANDSET USAGE) You can purchase additional handsets for use with many of this telephone’s features. Make sure the battery is connected and the base is plugged in and on for at least five seconds before starting the operation. Make sure the extra headset purchased is fully [...]

27 ADV ANCED FEA TURES (CONTINUED) ASSIGNING/CHANGING A HANDSET’S INTERNAL/INTERCOM (EXTENSION) NUMBER The handset that comes with the unit is assigned number 1 at the factory. To assign or change the number of the additional handsets (if purchased), in order to take advantage of the additional features, simply follow the instructions below: Pres[...]

28 ADV ANCED FEA TURES (CONTINUED) MAKING INTERCOM CALLS (P AGING) Intercom calls are calls to the additional handsets (if purchased) and do not tie up the phone line. For example, if used in your home, you can have a conversation with your wife by the pool without going outside. Each additional handset must be registered, see page 26. Follow the i[...]

29 ADV ANCED FEA TURES (CONTINUED) TRANSFERRING A CALL Transfer a call to another handset (this example shows Handset 1 transferring to Handset 2) as follows: When speaking with an outside call, press the TRANS button on the handset; the party on the line will be put on hold; the display will show “TRANSFERRING ENTER EXTENSION”. 1 Using the Key[...]

30 USING THE SOFTW ARE INST ALLING THE SOFTW ARE: Included with your telephone is software that can be used to synchronize your phone directory with Microsoft Outlook. It can also be used to download ringer melodies (MIDI Files). Additionally, there will be other software applications and upgrades available through the Bluetooth page on our website[...]

2. CONFIGURING OUTLOOK XP: a. Outlook XP synchronization will not work with a Microsoft Exchange server. If you do not get your mail via Microsoft Exchange, you can ignore the following steps. However if you do connect to a Microsoft Exchange server you will need to add a POP3 account, by following these steps: 1. Click on “Start” – “Settin[...]

DOWNLOADING RINGER MELODIES (MIDI “INSTRUMENT AL MUSIC FORMA T”): Before uploading MIDI files to your phone, you must first download them from the Bluetooth page on our website, www.memcorpinc.com as follows: 1. Go to the Memorex website at www.memcorpinc.com . 2. From the “Products” tab select the “Communication” drop down menu and the[...]

5. On the right-hand side of your window you will see the following: “MIDI FILES [HANDSET]”, and below that you will see three sets of numbers. For example: 321 421 214 These numbers are the three “MIDI FILES” that are currently on your phone. You can only change these three MIDI files. The Bluetooth phone comes with five MIDI files. Howeve[...]

SYMPTOM SOLUTION No dial tone. • Make sure the telephone line cord is connected properly to the modular wall jack. No power on the • Make sure the battery pack is properly connected handset. inside the handset. • The handset may need recharging, recharge handset. Handset does not • Make sure the charging contacts on both the base and charge[...]

35 CARE AND MAINTENANCE 1. Clean your phone with a damp (never wet) cloth. Solvent or detergent should never be used. 2. Avoid operating your unit under direct sunlight or in hot, humid or dusty places. 3. Keep your unit away from heating appliances. 4. Every few months, or when charging becomes abnormal, clean the contacts of the handset and the b[...]

Memcorp, Inc. Weston, FL Printed in China Visit our website at www.memcorpinc.com MCD4300BT.2002.O/M.QXD 4/19/02 9:57 AM Page 36[...]