NEC LCD1970NXP manuale d’uso

MultiSync LCD1970VX MultiSync LCD1970NX MultiSync LCD1970NXp User’ s Manual[...]

Index W arning, Caution ............................................................................................................... .......... English-1 Declaration ................................................................................................................................... English-1 Canadian Depar tment of Communications [...]

English English-1 W ARNING CA UTION CA UTION: T O REDUCE THE RISK OF ELECTRIC SHOCK, MAKE SURE POWER CORD IS UNPLUGGED FROM W ALL SOCKET . T O FULL Y DISENGA GE THE POWER T O THE UNIT , PLEASE DISCONNECT THE PO WER CORD FROM THE A C OUTLET .DO NO T REMO VE CO VER (OR BA CK). NO USER SER VICEABLE P ARTS INSIDE. REFER SER VICING T O QUALIFIED SER VIC[...]

English-2 Canadian Depar tment of Communications Compliance Statement DOC: This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations . C-UL: Bears the C-UL Mark and is in compliance with Canadian Safety Regulations according to CAN/CSA C22.2 No. 60950-1. FCC Information 1 . Use the attached spe[...]

English English-3 Contents Y our new NEC MultiSync LCD monitor box* should contain the f ollowing: • MultiSync LCD monitor with tilt/swiv el/height adjust stand • P ower Cord • Cable co ver • Video Signal Cable (15-pin mini D-SUB male to 15-pin mini D-SUB male) • User ’ s Manual • CD ROM (includes complete User ’ s Manual in PDF f o[...]

English-4 Quic k Star t T o attach the MultiSync LCD monitor to your system, f ollow these instructions: 1. T ur n off the power to your computer . 2. For the PC or MA C with D VI digital output: Connect the D VI signal cable (not included) to the connector of the displa y card in your system ( Figure A.1 ). Tighten all scre ws. For the PC with Ana[...]

English English-5 Inser t T op First Then Bottom 7. Place the D VI cab le into the specific hooks indicated in Figure C.3 . 8. Make sure all cab les are resting flat against the stand ( Figure C.3 ). Figure D .1 Figure D .2 D VI Cable Flat Figure C.3 9. Hold the all cables firmly and place the cable co ver onto the stand ( Figure D.1 ). T o remov e[...]

English-6 Figure S.1 Figure RL.1 Raise and Lower Monitor Screen The monitor may be r aised or lowered. T o raise or lower screen, place hands on each side of the monitor and lift or lower to the desired height ( Figure RL.1 ). NO TE: Handle with care when raising or lowering the monitor screen. Tilt and Swivel Grasp both sides of the monitor screen[...]

English English-7 Figure S.3 Figure S.4 5. Lift up the stand to unlatch the upper hooks and remov e the stand ( Figure S.3 ). 6. Remov e the 2 screws on the top of the monitor ( Figure S.4 ). The monitor is now ready for mounting in an alternate manner . 7. Connect the cables to the bac k of the monitor . 8. Rev erse this process to re-attach stand[...]

English-8 Contr ols OSM (On-Screen Manager) control b uttons on the fr ont of the monitor function as follo ws: T o access OSM menu, press any of the control b uttons (MENU/EXIT , Left, Right, Down, Up). T o change signal input, press the SELECT button. T o change D V MODE, press the RESET button. NO TE: OSM must be closed in order to change signal[...]

English English-9 Colour Contr ol System Colour Control System: Six colour presets select the desired colour setting (sRGB and NA TIVE colour presets are standard and cannot be changed). R,G,B: Increases or decreases Red, Green or Blue colour depending upon which is selected. The change in colour will appear on screen and the direction (increase or[...]

English-10 Recommended use Safety Precautions and Maintenance FOR OPTIMUM PERFORMANCE, PLEASE NOTE THE FOLLO WING WHEN SETTING UP AND USING THE MUL TISYNC LCD COLOUR MONIT OR: • DO NO T OPEN THE MONITOR. There are no user serviceable par ts inside and opening or removing cov ers may e xpose you to dangerous shoc k hazards or other risks. Ref er a[...]

English English-11 CORRECT PLACEMENT AND ADJUSTMENT OF THE MONITOR CAN REDUCE EYE, SHOULDER AND NECK F A TIGUE. CHECK THE FOLLO WING WHEN Y OU POSITION THE MONIT OR: • F or optimum performance, allow 20 min utes for w ar m-up. • Adjust the monitor height so that the top of the screen is at or slightly below ey e le vel. Y our eyes should look s[...]

English-12 Specifications f or LCD1970VX Monitor Specifications MultiSync LCD1970VX Monitor Notes LCD Module Diagonal: 48.2 cm/19.0 inches Active matrix; thin film transistor (TFT) Viewab le Image Size: 48.2 cm/19.0 inches liquid crystal display (LCD); 0.294 mm dot Native Resolution (Pix el Count): 1280 x 1024 pitch; 250 cd/m 2 white luminance; 550[...]

English English-13 Specifications f or LCD1970NX Monitor Specifications MultiSync LCD1970NX Monitor Notes LCD Module Diagonal: 48.2 cm/19.0 inches Active matrix; thin film transistor (TFT) View able Image Size: 48.2 cm/19.0 inches liquid crystal display (LCD); 0.294 mm dot Native Resolution (Pix el Count): 1280 x 1024 pitch; 250 cd/m 2 * 3 white lu[...]

English-14 Specifications f or LCD1970NXp Monitor Specifications MultiSync LCD1970NXp Monitor Notes LCD Module Diagonal: 48.2 cm/19.0 inches Active matrix; thin film transistor (TFT) Viewab le Image Size: 48.2 cm/19.0 inches liquid crystal display (LCD); 0.294 mm dot Native Resolution (Pix el Count): 1280 x 1024 pitch; 250 cd/m 2 white luminance; 8[...]

English English-15 Features Thin-frame design creates more desktop space for y ou to work and play , while the flat screen ’ s crisp, bright images and cr ystal- clear text deliv er a comf or table viewing e xperience. No T ouch Auto Adjust automatically adjusts y our optimal image settings upon initial power-on. Colour Control System allows y ou[...]

English-16 T r oub leshooting No picture • The signal cab le should be completely connected to the display card/computer . • The display card should be completely seated in its slot. • Check the V acation Switch should be in the ON position. • F ront P ower Switch and computer po wer s witch should be in the ON position. • Check to mak e [...]

English English-17 TCO’03 Congratulations! The displa y you ha ve just purchased carries the TCO ’ 03 Displa ys label. This means that your displa y is designed, manuf actured and tested according to some of the strictest quality and environmental requirements in the world. This makes f or a high perf or mance product, designed with the user in[...]

English-18 NEC DISPLA Y SOLUTIONS is strongly committed to environmental protection and sees recycling as one of the compan y ’ s top prior ities in tr ying to minimize the burden placed on the en vironment. W e are engaged in dev eloping environmentally- friendly products, and alwa ys strive to help define and comply with the latest independent [...]