Polycom KWS8000 manuale d’uso

Polycom ® KIRK ® Wireless Ser ver 8000 Installation Guide[...]

ii Copyright © Polycom, Inc. All Rights Reserved Catalog No. 14184630_Hd.1 Version 1 Proprietary and Confidential The information contained herein is the sole intellec tual property of Polycom, Inc. No distribution, reproduction or unauthorized use of these materials is permit ted withou t the expressed written consent of Polycom, Inc. Information[...]

Contents 1 Contents KWS8000 Installation Installing the KWS8000 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–1 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–1 General Installation Information . . . . . . . . . . . . . . . . . . . . . . . . [...]

1–1 1 KWS8000 Installation This guide des cribes how you install th e KWS8000. Installing the KWS8000 The KWS 8000 can be installed in a rack, on a flat surface or on a wall using the KWS8000 Wall Hanger. Before you start the installation, place the KSW 8000 on a stable flat surface in the selected location, and inspect the package for any damage[...]

Polycom KIRK Wireless Ser v er 8000 Installation Guide 1–2 General Installation Information The maximum number of KWS 8000 units that can be linked together depends on the mounting method and the maxi mum length of the link cable: • Rack mount: 8 units • Flat surface mount: 2 units • Wall mount: 1 unit General Mounting Safety Precautions ?[...]

KWS8000 Installation 1–3 Rack mounting Safety Precautions. • Ensure that the leveling jacks on the bottom of the rack are fully extended to the floor with the full weig ht of the rack resting on them. • In a single rack installation, sta biliz ers should be attached to the rack. • In multiple rack installations, the rack s should be coupled[...]

Polycom KIRK Wireless Ser v er 8000 Installation Guide 1–4 Figure 1- 1 Rack Installation Installing the KWS 8000 on a Flat Sur face Before you start instal lation take notic e of the following safety precautions. Flat Surface Mounting Safety Precautions • Ensure the surface can support the weight of the unit. • Never install the KWS8000 on th[...]

KWS8000 Installation 1–5 2 Before placing the unit, carefully turn it upside down and mount the four rubber pads supplied in the package. On e must be placed at e a ch corner of the bottom plate. 3 Place it on a clean, fl at, horizontal surface. Installing the KWS8000 on a W all Before you start instal lation take notic e of the following safety [...]

Polycom KIRK Wireless Ser v er 8000 Installation Guide 1–6 2 Mount the wall ha nger securely us ing four screws. Us e rawlplugs, expansion bolts or other appropriate fastening methods in relation to the wall material. 3 Remove drilling dust, unpac k the KW S8000, fi t it into the wall hanger, and then fasten the two front screws. Figure 1-3 Fitti[...]

KWS8000 Installation 1–7 • The interface cables must be removed before any interface card is removed or replaced. • When unplugging power, unplug AC mains power first before unplugging the power connector from the KWS8000. • The AC adapters must never be hanging by their own weight in the AC mains connector or the output connector. T o Conn[...]

Polycom KIRK Wireless Ser v er 8000 Installation Guide 1–8 The unit configuration determines which plugs to use. Connect the plugs according to the following table. 1 Plug a suitable power cord into the AC power adapter. 2 Insert the AC power adapter output connector firmly into the socket on the KWS8000 so that the retention clip snaps to the pl[...]

KWS8000 Installation 1–9 Figure 1-5 S toring room for two AC power adapte rs If more than two AC power adapters ar e used, these must be kept on a flat surface (same requirements as for the KW S8000 unit). In a rack installation the power adapters can be kept on a tray installed for the purpose provided that the ambient temperature is below 32ºC[...]

Polycom KIRK Wireless Ser v er 8000 Installation Guide 1–10 Figure 1-6 Installing Interface cards 2 Plug the interface cables into the card as de scribed in “Connecting Interface Cables” on page 1-11. T o Install CPU Cards 1 Ensure that the KWS8000 is powered off completely. 2 With two hands, gently slide the card into the unit. Give the card[...]

KWS8000 Installation 1–11 Figure 1-7 Installing CPU card 3 Plug the interface cables into the card as de scribed in “Connecting Interface Cables” on page 1-11. 4 Connect the power and reboot the unit. Connecting Interface Cables The front interface of the KWS8000 is provided with connectors for the different interfaces provided. Please see th[...]

Polycom KIRK Wireless Ser v er 8000 Installation Guide 1–12 Figure 1-8 Harnessing cables to the back and out[...]

KWS8000 Installation 1–13 Figure 1-9 Harnessing cables to the side and out. Regardless of which way is used for harnessing, you must guide the cables through the opening in the plastic front . This ensure s safe retention of the cable.[...]

2–1 2 Replacing Components The KWS8000 is designed to minimize down-time. Several components can be replaced while the system is up. Component Replacement The following components are hot-swappable: • Interface cards • AC adapters The following require a power down of the system: • Backplane • CPU card Before replacing any components, tak[...]

Polycom KIRK Wireless Ser v er 8000 Installation Guide 2–2 Component Replacement Precautions • Cards contain static sens itive circuitry and may be destroyed or damaged by electrostatic discharge (ESD.) • All maintenance tasks must be perf ormed by qualified, authorized personnel only. • Use only original replacement parts. • Make sure yo[...]

Replacing Components 2–3 7 Plug the interface cables into the card. 8 Connect power and reboot the unit. Replacing the Backplane The backplane cannot be repl aced on-site. The chassis wi ll have to be returned for repair or be replaced with a new one. If a new chassis is to be installed, you can move the cards from the faulty chassis to the new o[...]

3–1 3 Regulator y Notices This section contains important sa fety regulations for the KWS8000. International Regulator y and Product Infor mation United States Federal Communication Commission (FCC) Part 15: Class A St atement . This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of[...]

Polycom KIRK Wireless Ser v er 8000 Installation Guide 3–2 Polycom Inc. or our designated agent. This stipulation is required by the FCC and applies during and after the warranty perio d. United St ates Safety Con struct ion Details : o All connections are indoor only . o No direct connections to public networks. o Unit is intended for RESTRICTED[...]

Regulator y Notices 3–3 be collected separately . Canadian Department of Communications This Class [A] digital apparatus complies with Canadian ICES-003. Notice: The Industry Canada label iden tifies certified equipment. This certification means that the equipment meets telecommunication network protective, operational and safety requirements as [...]

Polycom KIRK Wireless Ser v er 8000 Installation Guide 3–4 Impor tant Safety Instr uctions and Product Information Before using your te lephone equipmen t, you should always follow basic safety instruction to reduce the risk of fire, electrical shock and injury to persons, and damage to property. 1 Read and understand all instructions 2 Follow al[...]

Regulator y Notices 3–5 Warning 1 Avoid using telephone durin g an electr ical storm. There may be a risk of electrical shock from lightning 2 Do not use the telephone to report a gas leak in the vicinity of the leak 3 Do not place the unit near microwave ovens, radio equipm ent, or non-ground connected televisions. Thes e appliances may cause el[...]

Polycom KIRK Wireless Ser v er 8000 Installation Guide 3–6 IC Note: Operation is subject to the followin g two conditions: (1) This device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. The term “IC:” before the certification /reg istration[...]

Regulator y Notices 3–7 EXCLUSIONS . Polycom will not be liable under t his limited warranty i f its testing and examination disclose that th e alleged defect or ma lfunction in the product does not exist or results from: • Failure to f ollow Polycom's instal lation, operation, or maintenance instructions. • Unauthorized product mo dific[...]

Polycom KIRK Wireless Ser v er 8000 Installation Guide 3–8 OUT OF OR IN CONNECTION WI TH THE SALE, INSTALLATION, MAINTENANCE, USE, PE RFORMA NCE, FAIL URE, OR INTERRUPTION OF ITS PRODUCTS, EVEN IF POLYCOM OR ITS AUTHORIZED RESELLER HAS BEEN ADVISED OF THE POSSIB ILITY OF SUCH DAMAGES, AND LIMITS ITS LIABILITY TO REPAIR, REPLACEMENT, OR REFUND OF [...]

Regulator y Notices 3–9 “PRODUCT”). You may use the SOFTWARE PRODUCT only in connection with the use of the PRODUCT. You are not permitted to lease, rent, di stribute or sublicense the SOFTWARE PRODUCT or to use the SOFTWARE PRODUCT in a time-sharing arrangem ent or in any other unauthorized manner. Further, no license is granted to you in th[...]

Polycom KIRK Wireless Ser v er 8000 Installation Guide 3–10 and related rights in the content accessed t hrough the SOFTWARE PRODUC T is the property of such content owner an d may be protected by applicable law. This Agreement gives you no rights in such content. 2.7 Confidentiality. The SOFTWARE PRODUCT contains valuable proprietary infor matio[...]

Regulator y Notices 3–11 6.1 Limited Warran ty . POLYCOM warrants that (a) the SOFTWARE PRODUCT will perform substant ially in accordance wi th the accompanying documentation for a period of ninety (90) days from the date of receipt by you, and (b) any SUPPORT SERVICES provided by POLYCOM shall be substantially as described in appl icable written[...]

Polycom KIRK Wireless Ser v er 8000 Installation Guide 3–12 OR THE PROVISION OF OR FAILUR E TO PROVIDE SUPPORT SERVICES, EVEN IF POLYCOM HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. IN ANY CASE, POLYCOM' S ENTIRE LIABILITY SHALL BE LIMITED TO THE GREATER OF THE AMOUNT ACTUALLY P AID BY YOU FOR THE SOFTWARE PRODUCT OR U.S. $5.00. PROV[...]

. 3–13 10.4 U.S. Government Restricted Rights. The SOFTWARE PRODUCT and documentation are provided with RESTRICTED RIGHTS. The SOFTWARE PRODUCT programs and documentation are deemed to be "commercial computer software" and "commercial computer software documentation", respectively, pursuant to DFAR Se ction 227.7202 and FAR 12[...]

KWS 8000 Installation and Configuration Guide 11 T ables Table 1-1 Physical dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–1 Table 1-2 Power supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–1 Table 1-3 Power consumption . . . . . . . . . . . . . [...]

Figures 11 Figures Figure 1-1 Rack Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–4 Figure 1-2 Wall hanger positioni ng . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1–5 Figure 1-3 Fitting the kWS8000 into the wall hanger . . . . . . . . . . . . . . . . . . . . [...]

Index Index – 1 Index A AC power adapters 1–9 E Environment 1–1 F Flat surface installation 1–4 I Interface cable connection 1–11 Interface card installation 1–9 P Physical dimensions 1–1 Power cables, connecting 1–6 Power consumption 1–1 Power supply 1–1 R Rack installa tion 1–3 S Safety Cables 1–6 Flat surface installation[...]

A–1 A RJ45 Wiring The following table shows the assignment s of wire pairs to plug and socket pins of the RJ45 cable. Ta b l e A -1 RJ45 cable wiring Pin Pair Wiri ng Connector 1 Connector 2 Connector 3 Connector 4 1 2 t i p 1591 3 2 2 r i n g 1591 3 3 3 t i p 261 0 1 4 4 1 r i n g 0481 2 5 1 t i p 0481 2 6 3 r i n g 261 0 1 4 7 4 t i p 271 1 1 5[...]

[...]

14184630, Hd.1. Rasmussens Bogtrykkeri, Ringkøbing[...]