Smeg Gas Cooktop CIR60XS manuale d’uso

Index 1. INSTRUCTIONS FOR SAFE AND PROPER USE ________________ 4 2. POSITIONING OF HOB ____________________________________ 6 3. GAS CONNE CTION ______________________________________ 11 4. ELECTRICAL CO NNECTION ______________________________ 12 5. GAS CONNE CTION ______________________________________ 13 6. ADAPTATION TO DIFFERENT TYPES OF GAS __[...]

Introduction 1. INSTR UCTIONS FOR SAFE AND PR OPER USE THIS MANUAL IS AN INTE GRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT I N ITS ENTIRETY AND I N AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKING HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTI ONS THEREIN BEFORE USING THE COOKING H OB. ALSO KEEP THE SERIES OF NOZZLES[...]

Introduction THE IDENTIFICATION PLATE, WITH TECHNIC AL DATA, SERIAL NUMBE R AND MARKING IS CLEARLY VISIBLE UNDER THE CASING. THE PLATE ON THE CASING MUST N OT BE REMOVED. BEFORE CONNECTING THE DEVICE, MAKE SURE THAT IT H AS BEEN REGULATED FOR THE TYPE OF GAS THAT WILL FEED IT, CHECKING THE LABEL UNDER THE CASING. DO NOT PUT PANS WITH OUT PERFECTLY [...]

Instructions for the installer 6 2. POSITIONING OF HOB It is the law that all gas applia nces are installed by authorised persons . Clearance around th e appliance must com ply with the requireme nts of AS5601. The following operati on requires bui lding and/or carpe ntry work so must be carried out by a competent tradesman. In stallation can be ca[...]

Instructions for the installer 7 In case of installation on a hollo w compartment with doors, a separating panel has to be placed under the hob. Keep a minimum distance of 10 mm between the bottom of the unit and the panel surface. The pa nel has to be easily removable to allow access in the event of technical service. Overall dimensions: location [...]

Instructions for the installer 8 2.2 Clearance above and around domestic appliances Extract from AS5601 REQUIREMENTS 1 Overhead clearances – (Mea surement A ) Range hoods and exhaust fans sha ll be installe d in accordanc e with the manufacturer’s instructio ns. However, in no case shall the clearance betwee n the highest part of the hob of the[...]

Instructions for the installer 9 be protected in accordance wit h Clause 5.12 .1.2 to a height C of not less than 150 mm above the hob for the full dime nsion (width or depth) of the cooking surfac e area. Where the cook ing applianc e is fitted with a ‘splashback’, protection of the rear wall is not requir ed. 3 Additional requireme nts for Fr[...]

Instructions for the installer 10 2.3 Room ventilation Caution – This hob may only be insta lled and op erated in rooms permanently v entilated in a ccordance wit h current regulations. For proper operation of a gas applia nce it is es sential for the air nec essary for combustion of the gas to be able to flow naturally into the r oom. Air must f[...]

Instructions for the installer 11 3. GAS CONNECTION This appliance is s uitable for inst allation wit h Natural Gas or ULPG (propane). Refer to page 12 for the relevant burner press ure and appr opriate injector sizes. W hen the app liance is to be connected to Natural Gas then t he pressure regulator suppl ied must be fitted to th e gas inlet. A t[...]

Instructions for the installer 12 4. ELECTRICAL CONNECTION Make sure that the voltage a nd capacity of th e power line conform to the data shown on the plate l ocated under the casin g. Do not remove this plate for any reason. The plug on the end of the supply cable a nd the wall socket must be the same type and conform to the curr ent electrical s[...]

Instructions for the installer 13 5. GAS CONNECTION Connection to the gas ma ins may be made with a rigid copper pipe or with a flexible pipe and conforming to the prov isions defined by standar d regulations in force. To facilitate connection, fitting A o n the rear of the applianc e may be adjusted latera lly. For this purpose, loosen hexagon nut[...]

Instructions for the installer 14 5.1 Connection to LPG Use a pressur e regulator an d make the con nection to the tank according to the provisions of standar ds regulatio ns in force. Make sure that feed pressure conforms to the l evels shown in the table in pa ragraph “ 6.2 Regulation for LPG ”. 5.2 Ventilation of rooms The hob may be install[...]

Instructions for the installer 15 6. AD APT A TION T O DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the appliance from the electrical socket. The hob has been inspected for NG natural gas at a pressure of 1.0 kPa. For functioning with other types of gas t he nozzles m ust be repl aced and the primary air adj ust[...]

Instructions for the installer 16 6.2 Regulation for LPG Loosen screw A and push support B all the w ay. Use a do uble hea d wrench to remove n ozzle C and ass emble the suitabl e one, following the instructions indicated in the referenc e charts, with r espect to the type of gas to use. The scr ewing torque of the nozzle sh ould nev er exceed 3 Nm[...]

Instructions for the installer 17 6.3 Regulation for natural gas The hob has been adj usted for natural gas at a pressure of 1.0kPa. To allow the unit to work ba ck with this type of gas, after it has been adjusted for L PG, perform the s ame operations described in paragrap h “ 6.2 Regulation for LPG ”, bu t refer to the followi ng table for t[...]

Instructions for the installer 18 7.3 Arrangement of burn ers on hob BURNERS 1 Auxiliary 2 Semi-rapid 3 Rapid 4 Rapid 5 WOK 7.4 Lubrification of gas taps After a while, the gas tap may become hard to turn o r lock. If this happens, it has to be cleaned i nside and re-greased. This must be done by a qua lified technician.[...]

Instructions for the user 19 8. USING THE HOB Before turning on the burners, make sure that the burner rin gs, caps and grids have been fitted correctly. In the ultrarapid burner, notch A must be aligned with pin B . Grid C provided is intended for use with wok s (Chinese pans). Adapter D comes only with open grids models and is int ended for use w[...]

Instructions for the user 20 8.2 Practical advice for u sing the burners For better burner performance and minimum ga s consumption, flat bottomed, even reci pients must be used, with covers and proporti onal in siz e to the burners (se e paragra ph “ 8.3 Diameter of containers ”). To avoid overc ooking or dam age to the surface top w hile cook[...]

Instructions for the user 21 8.4.2 Using the electric elements The electric elements are idea l for ultrarapid cooking. The settings shown in the table are merely in dicative. POSITION HEAT INTENSITY POSSIBLE COOKING - 0 Off To melt butter, chocolate, etc. 1 Weak To heat small amounts of liquid. 2 Soft To heat larger amounts of liquid. To defrost f[...]

Instructions for the user 22 9. CLEANING AND MAINTENANCE Before any intervention, disconnect the power supply of the device. 9.1 Cleaning Clean the cooking top regul arly every time you use it, obv iously after it has cooled. NEVER USE A STEAM JET TO CLEAN THE APPLIANCE. 9.1.1 Regular daily cleaning of the hob In order to clean and preserv e the su[...]

Instructions for the user 23 9.2.1 Ignition plugs and safety devices For good functioning of the lighting ig nition plugs a nd the sa fety devices, keep them very clean. Check frequently and clea n with a damp cloth whe n necessary. 9.2.2 The cover Clean the glass or steel cover, w here mo unted, with warm water. Neve r use abrasive sponges or d et[...]

Instructions for the user 24 10. PR OBLEMS AND CA USES Each of the followi ng cases is caused by a n abnormal op eration of th e appliance and should be dealt with by a authoris ed persons: pleas e contact your local de aler or Service Ce nter in case you detect a ny of these malfunctioning. PROBLEM CAUSE WHAT TO DO The flame is very long with brig[...]

[...]

914772609/ B[...]