TANDBERG Management Server D13939 manuale d’uso

Management Server Quick Setup Guide D13939 Rev 04 This document is not to be reproduced in whole or in part without permission in writing from:[...]

TANDBERG Management Server Q uick Setup Guide ii Trademarks and Copyright All rights reserved. This document conta ins inform ation that is prop rietar y to TANDBERG. No part of this publication may be reproduced, st ored in a re trieval system, or transmitted, in any form, or by any means, electronically, mechani cally, by photocopying, or otherwi[...]

Quick Setup Guide iii Environmental Issues Thank you for buying a product, which contribute s to a reduction in pollution, and thereby helps save the environment. Our products red uce the n eed for travel and transport and thereby re du ce pollution. Our products have either none or few con su mable parts (chemicals, toner, gas, pap er) and low ene[...]

TANDBERG Management Server Q uick Setup Guide iv Operator Safety Summary For your protection, please read these safety instructions completely before op erating the equipment and keep this manual for futu re reference. The information in this summary is inte nded for operators. Carefully observe all wa rni ngs, pr ecautions and instructio ns both o[...]

Quick Setup Guide v  Servicing - Do not attempt to service th e apparatus yourself as opening or remov ing covers may expose you to dangerous vo ltages or other hazards, and will void the warranty. Refer all servicing to qualified servi ce personnel.  Damaged Equipment - Unplug the ap pa ratus from the outlet and refer servicing to qualified [...]

TANDBERG Management Server Q uick Setup Guide vi Contact us If you have any questions, comments or suggestions, please se e the Onlin e Support servi ce at www.tandberg.com It is also possible to send a fa x or mail to the attention of: Product and Sales Support TANDBERG P.O. Box 92 1325 Lysaker Norway Tel: +47 67 125 125 Fax: +47 67 125 234[...]

Quick Setup Guide vii End-User License Information IMPORTANT: THE USER MANUAL CD FOR THIS P RODUCT CONTAINS IMPORTANT TERMS AND CONDITIONS INCLUDING END U SER LICENSE AGREEMENTS. THE LICENSE AGREEMENTS SHOULD BE READ PRIOR TO USE. USE OF THIS PROD UCT CONSTITUTES ACCEPTANCE OF THE TERMS OF THE LICENSES.[...]

TANDBERG Management Server Q uick Setup Guide viii Table of Contents 1 Introduction ................................................................................................................... ...... 9 2 Installa tion................................................................................................................... ...... 10 [...]

Quick Setup Guide Introduction 9 1 Introduction The TANDBERG Management Server is a se rver tha t comes with the TANDBERG Management Suite (TMS) pre-installed. This guide will take you through the initial step s of setting up the TANDBERG M anagement Server before first time use. Please refer to the Getting Started section of the TANDBERG M anageme[...]

TANDBERG Management Server Q uick Setup Guide 10 2 Inst allation Precautions:  Never install communi cati on wiring during a lightnin g storm.  Never install jacks for communication cable s in wet locations unless the jack is specifically designed for wet locations.  Never touch uninstalled co mmuni cation wires or termi nals u nless the c[...]

Quick Setup Guide Introduction 11 2.1 Unpacking To avoid damage to the unit during transportation, t he Manageme nt Server is d elivered in a special shipping box, which should contai n the f ollowing compone nts:  User Manual and other documentation o n CD.  Rack-ears, sc rew s and screwdriv er.  Cables: o Power cable o Ethernet cable [...]

TANDBERG Management Server Q uick Setup Guide 12 2.2 Connecting cables LAN cable Connect a LAN cable from the ‘LAN 1’ connector o n the Managem ent Server to your network. The LAN 2, 3 and 4’ connectors are not used and sh ould be left o pen. Power cable Connect the system power cabl e to an electrical dist ribution socket. Press the power sw[...]

Quick Setup Guide Introduction 13 2.3 IP Address Setting Configuration The Management Server requires the IP Address Se ttings to be configured before it can be used. IP Address Configuration ca n be made using the LCD Panel. Front view of the Management Server wit h the LCD pa nel: LCD Panel buttons and their functions: Up and Do wn arrows Used to[...]

TANDBERG Management Server Q uick Setup Guide 14 5. Move between characters by using the Up an d Do wn arrows. Edit values by pressing Enter a nd using the Up or Down arrow to modify. Press Enter again to confirm the value, or press Return to re store the value to its previous state. 6. When finished editing the address, press Return. You will be a[...]

Quick Setup Guide Introduction 15 3 Product Registration and Up dates You need to register the product if you would like to receive an email from TANDBERG Co nst ant Care Services when Management Server updates to the TANDBERG Manag ement Server become available. You can also check the followin g ftp site for all available downloads: http://ftp.tan[...]

TANDBERG Management Server Q uick Setup Guide 16 4 General Use TANDBERG Management Server The Management Server should al ways be turned o n. The unit itself should not be available to users at any time. If the system does not respond:  Check the LCD panel to determine if the unit is switched on and ‘live’.  Make sure that the Management [...]

Quick Setup Guide Introduction 17 4.1.2 How to shutdown the Management Server 1. Press Enter to display the Main Menu screen. 2. From the Main Menu screen, use the Up or Down a rrow to sel ect Commands . 3. Press Enter to confirm your selection. 4. From the Commands menu, use the Up or Down a rrow to sel ect Shutdown and press Enter. 5. You will be[...]

[...]

Introduction 19 5 Administrator Settings Before the TANDBERG Management S erver can be taken into use , some ba sic settings need to be configured. 5.1 Operating System Settings You can access the Web User Inte rface for Micros oft Windows Server administration to configure operating system settings. 1. Start a web browser and enter the address htt[...]

TANDBERG Management Server Q uick Setup Guide 20 To set the password of the local administrator account, click the Set Administrator Password menu item under the Welcome tab. From the Maintenance tab, you can set the date, time and time-zon e. 5.2 TANDBERG Management Suite Settings You can access the Web User Inte rface fo r the TANDBERG Management[...]

Introduction 21 Set the Default Time Zone to where the majority of the TMS users are situ ated to simplify use r setup. Select the Administrative Tools > Configuration > Net work Settings menu item and scroll down to the TMS Services section to set the scan range TMS uses to se arch for new systems. By default TMS scans the entire network for[...]

TANDBERG Management Server Q uick Setup Guide 22 Select the Administrative Tools > Configuration > Mail Settings menu item to set the SMTP server TMS will use to send emails and the email address th ese will be sent from. 5.3 Added systems The TANDBERG Management Server come s with automatic registration of systems enable d. TMS will therefor[...]