Teka LP7 830 manuale d’uso

Code: 0120504497B Manual de Uso y Mantenimiento Manual de Utilização e Manutenção Use and Maintenance Manual Manual d'Emploi et Entretien Bedienungsanleitung und pilegehinweise LP7 830[...]

1 Index en Safety information Installation How to remove the top of your dishwasher Getting to know your dishwasher How to fill the salt How to fill rinse aid Not suitable for the dishwasher Arranging crockery, glasses, etc. in the dishwasher How to fill the detergent dispenser Programme overview Washing dishes How to keep your dishwasher in shape [...]

2 Safety information At time of delivery Site the dishwasher and connect it up in accordance with the installation instructions. The dishwasher must not be connected to the electricity supply while installation is being carried out. Ensure that the domestic wiring is properly earthed. The mains electricity supply must conform to the details shown o[...]

3 If your family includes children The appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance. Keep detergents out of the reach of children, who must also be kept away from the dishwasher when it is open. If a fault occurs If t[...]

4 Cold water connection Connect the water supply hose to a threaded 3/4 (gas) connector, making sure that it is fastened tightly in place (see fig.A). Some models are fitted with an "Aquastop" water supply hose (see fig.B) in which the small filter is already housed in the threaded end. If the water pipes are new or have not been used for[...]

5 Drain hose connection Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink, making sure to avoid bending or crimping it. If necessary, fit a syphon trap (U-bend) with a connecting piece for the drain hose (fig.C). The free end of the hose must be at a height between 40 and 100 cm and must not be imme[...]

How to remove the top of your dishwasher 6 Freestanding dishwasher can also be used as built-in, according to following processes: 100-150mm 20-30mm en[...]

Built In Dishwasher: fixing on side Built In Dishwasher: fixing on top or 0120200050 7 en[...]

Getting to know your dishwasher Close-up view (control panel) 8 A C BD E F H G K J " 1/2 " Indicator Low Salt Indicator Time-remaining Indicator F G H J K A B C D E ON-OFF Button " 1/2 " Button Delayed Start Button Delayed Start Indicator Low Rinse Aid Indicator Programme Indicator Programme Button Models explanation Model Colou[...]

Salt The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water. How to fill the salt Loading the salt into the container Always use[...]

Adjusting salt consumption The dishwasher is designed to allow for adjusting the amount of salt consumed based on the hardness of the water used. This is intended to optimize and customize the level of salt consumption so that it remains at a minimum. To adjust salt consumption, proceed as follows: Unscrew the cap from the salt container; There is [...]

Rinse aid This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the door . Important Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spotting occurs, the dosage adjuster should be turned to a higher setting. If the dishes have white streaks[...]

Not suitable for the dishwasher What you should not put into the dishwasher Cutlery and tableware manufactured in whole or part from wood.They become faded and unsightly in appearance.Furthermore,the adhesives that are used are not suitable for the temperature that occur inside the dishwasher.Delicate decorative glassware and vases,special antique [...]

Arranging crockery, glasses, etc. in the dishwasher Before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from be- coming clogged, which results in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they are soaked before washed. This will elimin[...]

fig.F Shelf Lean tall glasses and those with long stems against the shelf- not against other items to be washed. Place glasses, cups and small bowls on the additional cup rack. The additional cup rack can be swivelled in or out as required (see fig.F). Knife rack The knife rack clips onto the side of the top basket, giving you the freedom to wash y[...]

Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Programme overview". The detergent dispenser is located on the inside panel of the door. Loading the detergent Notice: To facilitate closing the cov[...]

Programme overview Wash programme Type of crokery e.g. china, pots/ pan s, cutiery, glasses, etc Amount of food remains Description of cycle Condi- tion of food remains 1/2 Load Pre-wash with hot water. Extended wash at 70 ° C. Rinses with cold water. Rinse with hot water. Drying. Prewash use cold water. Extended wash at 55 ° C. Rinse with cold w[...]

Delayed Start Detergent Extended Wash Prewash Rinse Aid Duration in minutes Energy consump- tion in kWh Water consump- tion in litres Laboratory measured valve in accordance with European Standard EN50242 30g 20g 30g 20g 30g 20g 15g 10g 15g 10g 7.5g 5g 7.5g 5g 7.5g 5g * EN50242 test with rinse aid setting 5 112 94 102 90 170 142 92 82 31 29 12 12 1[...]

Washing dishes Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as well as the amount and condition of food remains, with the details contained in the wash cycle table.The corresponding programme sequence, duration and consumption details are shown in the right half of the overvi[...]

Switching the dishwasher ON End of programme Six beeps will indicate that the wash cycle has finished and all the programme indicators light. Switching the dishwasher OFF Several minutes after the programme has ended: Set main switch “A” to OFF. Open the door. Remove dishes, etc. when they have cooled down. Turn on the tap. Set ON-OFF button ?[...]

Delayed start programming You can delay the start of a programme in increments of one hour up to 12 hours. Switch dishwasher ON . Immediately press the Delayed Start button “ D ”, the delayed start indicator “ E ” blinks, the delayed start time indicator “ F ” changes to “ ”. Press the Delayed Start button “ D ” as many times as[...]

Cancelling or modifying a cycle A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled ( see the paragraph entitled, “ Loading the detergent ?[...]

How to keep your dishwasher in shape After Every Wash After every wash, set the main switch “A” to off and leave the door slightly ajar so that moisture and odors are not trapped inside. Remove the plug Before cleaning or performing maintenance, always remove the plug from the socket. Do not run risks. No solvents or Abrasive Cleaning Products [...]

Care and maintenance Dishwasher salt Check the LOW SALT indicator “ G ” .Top up with salt, if required. Regular inspection and maintenance of your appliance helps to prevent problems from occurring.This saves time and aggravation.You should therefore carefully inspect the inside of your dishwasher from time to time. Overall condition of applian[...]

Inspect the nozzles in the spray arms for blocked holes due to remnants of food. If necessary, pull the lower arm “ 11 ” upwards and lift it off. Unscrew the upper spray arm “ 10 ”. Clean both spray arms under running water. Refit the spray arms. Ensure that the lower arm has locked into place and the upper one is screwed tight. Spray arms [...]

Resolving minor problems yourself Experience has shown that you can resolve most problems that rise during normal daily usage yourself, without having to call out a service engineer.Not only does this save costs,but it also means that the appliance is available for use again that much sooner. The following list of common occurrences and their remed[...]

When the programme indicators “ K1,K3,K4” blinks . Have you checked whether: the drain hose is crimped or bent. the drain hose is too high. When the programme indicators “ K1,K2,K6” blinks . Have you checked whether: the drain hose is too low. If you take all these checks and the dishwasher still does not function or your dish- washer have [...]

Water remains inside appliance after programme has ended Blockage or kind in drainage hose. Pump is jammed. Filters are blocked. The programme is still running. Wait for the programme to end . ...during washing Unusual amount of foam is creased Normal washing up liquid has been poured into the rinse-aid container. Appliance stops suddenly while was[...]

Not enough detergent was added to dispenser. Detergent has insuffcient bleaching properties. Use a detergent containing a chemical bleaching agent. Plastic items are discoloured Not enough detergent was added to dispenser compartment. Amount of rinse-aid was set too low. Although water is quite hard, no salt has been put in appliance. Water softene[...]

Technical data 15 standard place settings Width Depth Height Capacity Mains water pressure Power voltage Total absorbed power 60 cm 60 cm 85 cm 0.03-0.6MPa 220-240V~ 50Hz 1950W Maximum current intensity 10A 29 en[...]

General information Measures must be taken to ensure that built-under and built-in units that are subsequently re-sited as free-standing appliances cannot topple over. This can be achieved by bolting the dishwasher to the wall or fitting it under a continuous work surface which is screwed to the adjacent cupboards. For Switzerland only: There are n[...]

31 Information on comparability tests implemented in compliance with EN 50242 Appliance loaded in accordance with standard specifications. Example of loaded dishwasher: See Fig 1 , 2 and 3. Capacity: 15 place settings Comparability programme: Light wash Rinse-aid setting: 5 Detergent: 30+7.5g Height-adjustable top-basket must be inserted in the upp[...]

32 A: Wiring box B: Door switch C: Water level switch D: Drain pump motor E: Dispenser F: 2-way valve G: Softener valve H: Overflow switch I1: Inlet valve I2: Inlet valve (Aquastop) O: Low rinse aid switch P: Temperature sensor Q: Flowmeter R: Turbidity sensor J: Washing pump motor K: Temperature limiter L: Heater M: Relay N: Low salt switch The sy[...]