Troy-Bilt 436 manuale d’uso

IMPOR T ANT : Read saf ety rules and instr uctions carefully bef ore operating equipment. 21” Rear & Side Dischar ge Mulching La wn Mower Model 436 PRINTED IN U.S .A. Warning: This unit is equipped with an internal co mbustion engine and should not be used on or near any unimpro ved forest- covered, brush-covered or gras s-covered land unless[...]

2 TABLE OF CONTENTS FINDING MODEL NUMBER This Operator’s Manual is an import ant part of your new lawn mower. It will help you asse mble, prepare and maintain the unit fo r best performance. Please read and understand what it says. Before you star t assembling your new equipment , p lease locate the model plate on th e equipment and copy th e inf[...]

3 SECTION 1: IMPORTANT SAFE OPERATION PRACTICES General Oper ation 1. Read this operator’s man ual carefully in its entirety before atte mpting to assemble this machine. Read, understand, and follow all instructions on the machine and in the manua l(s) before operation. Be completely familiar with th e controls an d the proper use of this machine[...]

4 8. Never operate th e mower in wet grass. Always be sure of your footing. A slip and fall can cause serious personal injury. If yo u feel you are losing your footing, release the blade con trol handle immediately and th e blade will stop rotating within three seconds. 9. Mow in daylight or good artificial ligh t. Walk, never run. Stop the blade w[...]

5 7. Extinguish all cigarettes, ciga rs, pipes and other sources of ignition . 8. Never fuel machine indoors because flamma ble vapors will accumula te in the area. 9. Never remove gas ca p or add fuel while the engine is hot or running. Allow engine to co ol at least two minutes befo re refueling. 10. Never over fill fuel tank. Fill tank to no mor[...]

6 SECTION 2: SLOPE GAUGE 15° SIGHT AND HOLD THIS LEVEL WITH A VERTICAL TREE A POWER POLE A CORNER OF A BUILDING OR A FENCE POST F O L D ON D O T T E D L I N E , R E P R E S E N T I N G A 1 5 ° S L OP E USE THIS PAGE AS A GUIDE TO DETERMINE SLOPES WHERE YOU MAY NOT O PERATE SAFELY. Do not mow on inclines wit h a slope in excess of 15 degree s (a r[...]

7 SECTION 3: ASSEMBLING YOUR LAWN MOWER Removing Unit From Carton • Remove sta ples, break glue on top flaps or cut tape at carton end and peel t op flap to open carton. • Remove loose parts if included with unit. • Cut corner s and lay carton down flat. Remove packing material. • Roll or slide unit ou t of carton. Check carton thoroughly f[...]

8 Figure 4 • Fasten the cable to the lo wer handle with the two cable ties fou nd on the lower handle. Pull the cable ties tight an d trim off the e xcess. See Figure 5 . Figure 5 Attaching Starter Rope • The rope guide is at tached to the right side of upper handle. Loosen the wing nut which secu res the rope guide. See Figure 6. • With the [...]

9 Removing Grass Catcher • Lift the rear discharge door on the mower, and lif t the grass c atcher up. • Release the rear di scharge door. Converting to Side-Dischar ge • Your mower has been shippe d as a mulcher. To convert it to a side-dischar ge mower, lift the mulching plug. Slide the two hooks on the side- discharge deflector under the h[...]

10 Cutting Height Adjustment Lever This lever, located at each wheel, lets you adju st cutting height of the grass. Reme mber to put all four levers at the same height to avoid une ven cut. Throttle Control The engine is equipped wit h a constant speed throttle for maximum engine and cu tting performance. Recoil Starter The recoil star ter is attac[...]

11 Operating Y our Lawn Mower • Once the engine has star ted, squeeze the blade control handle agai nst the upper handle to run the lawn mower. • Do not operate the mower without the mulching cover, the grass catcher b ag, or the disc harge chute prope rly installed. • Be sure that the lawn is cle ar of stones, st icks, wire, or other objects[...]

12 SECTION 6: MAINTAINING YOUR LAWN MOWER Cleaning the Lawn Mower • Clean underside of th e mower deck after each use to prevent any build- up of grass. If this debris accumulates, it will cause rust and corrosion. NOTE: We do not recomme nd the use of pressure washers or garden ho se to clean your un it. These may cause damag e to bearings or th[...]

13 SECTION 7: SERVICING YOUR LAWN MOWER Blade Care Periodically inspect t he blade adapter a nd pulley for cracks, especially if you strike a foreign object. Replace when neces sary. • Disconnect spark pl ug wire from spark plug. • Turn mower on its side making sur e that the air filter and the carburet or are up. • Remove the bolt and bla de[...]

14 Replacing Rear Flap • To remove rear flap , cut off the flat end of the wire rod which secures it to the deck. See Figure 15 . • Attach the new f lap and new rod to deck, bending the ends of the new rod over to secure to deck. Figure 15 SECTION 8: MAKING ADJUSTMENTS Adjusting Handle Height Your mower is shipped with t he handle in the higher[...]

15 SECTION 9: OFF-SEASON STORAGE Prepare your lawn mowe r for storage at the end of the season or if the unit will not be used for 30 days or more. Store th e mower in a clean, dry area . Gasoline • Do not store gasoline from one season to another. Gasoline, stored more t han one month, may affect engine perfor mance. • Replace your gasoline ca[...]

16 SECTION 11: PARTS LIST FOR MODEL 436 1 6 10 3 2 11 4 5 4 19 34 32 31 29 39 45 24 22 21 20 25 41 43 43 12 29 28 26 27 43 43 48 42 18 35 37 44 47 33 14 13 36 38 25 46 16 23 7 8 9 12 15 53 52 51 17 25 54 49 30 25 31 40 25[...]

17 Ref. No. Part No. Description 1. 747-1161A Control Handle 2. 710-1205 Rope Guide 3. 720-0279 Handle Knob 1/4-20 Thd. 4. 710-1174 Curved Hd. Bolt 5/16-18 x 2" 5. 720-0284 Hand Knob 6. 749-1092A Upper Handle 7. 749-0928A Lower Handle 8. 726-0240 Cable Tie 9. 747-04080 Grass Catcher Frame 10. 746-1130 Control Cable 11. 664-04011 Grass Bag 12. [...]

18 NOTES[...]

19 NOTES[...]

MANUF A CTURER’S LIMITED W ARRANTY FOR: The limited warranty set forth be low is given by Troy-Bilt LLC with respect to new merchandise purchased and used in the United States, its possessions an d territories. “Troy-Bilt” warrants this produc t against defects in material and workmanship for a pe riod of two (2) years commencing on the date [...]