Tyco Electronics 1928L manuale d’uso

Touchmonitor User Guide 1928L 19” LCD Desktop Touchmonitor 5000 Series Revision A[...]

User Guide 1928L 19” LCD Desktop Touchmonitor Revision A P/N E1 16103[...]

Copyright © 2006 Tyco Electronics Corporation. All Rights Reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, including, but not limited to, electronic, magnetic, optical, chemical, manual, or otherwise wi[...]

Warnings and Cautions Warning • Danger - Explosion hazard. Do not use in the presence of flammable anesthetics, and other flammable materials. • To prevent fire or shock hazards, do not immerse the unit in water or expose it to rain or moisture. • Do not use the unit with an extension cord receptacle or other outlets unless the prongs of the [...]

CAUTION-Life Support Care must be taken when this touchmonitor is a critical component of a life support system or device. In case of failure of this touchmonitor, appropriate redundant systems should be incorpo- rated into the system or device to prevent injury to the user or patient. The following should be an integral part of the safety design o[...]

Classification With respect to electrical shock, fire in accordance with UL60601-1 and CAN/CSA C22.2 No. 60601-1 This monitor is a CLASS 1 (GROUNDED) DEVICE. These displays are classified NO APPLIED PARTS EQUIPMENT. Protection against harmful ingress of water: INGRESS IPX1 This monitor shall be classified as ORDINARY EQUIPMENT, not intended or eval[...]

vii[...]

Warnings and Cautions ................................................. iv Caution-Life Support ...................................................... v Classification .............................................................. vi Chapter 1 INTRODUCTION 1 Product Description ................................................ 1 LCD Display Performa[...]

C H A P T E R 1 I NTRODUCTION Product Description The 1928L is a medical display designed to present information to the operator and the customer. The 1928L is available in serial and USB(combo) touch interface as well as no touch. The 1928L functionally consists of a 19” LCD main display with a touchscreen. The main display element is a 19” di[...]

LCD Display Performance Features 19” TFT LCD Display Panel Display format 1280 x 1024 Display area 376.32 mm (H) x 301.056 mm (V) Pixel pitch 0.294 mm (H) x 0.294 mm (V) Contrast Ratio 1300:1( typical) Brightness LCD 300 cd/m 2 (typical) AccuTouch 246 cd/m 2 (typical) IntelliTouch 276 cd/m 2 (typical) Accutouch transmission 82% (typical) Intellit[...]

Elo QuickStar t CD Software C H A P T E R 2 I NSTALLATION A ND S ETUP This chapter discusses how to install your LCD touchmonitor and how to install Elo TouchSystems driver software. Unpacking Your Touchmonitor Check that the following items are present and in good condition: LCD monitor VGA cable USB cable Serial Cable European power cable Power c[...]

Product Overview Main Unit Back Unit Side View 2-4 Elo Touchmonitor User Guide[...]

Base Bottom View Kensington TM Lock The Kensington TM lock is a security device that prevents theft. To find out more about this secu- rity device, go to http://www.kensington.com. 2-5[...]

Touch Interface Connection Note: Before connecting the cables to your touchmonitor and PC, be sure that the computer and touchmonitor are turned off. STEP 1-Connecting the Video Cable • Tilt the screen up and back to access the connection ports. • Connect the 15-pin video cable (the ferrite bead end) or 24-pin DVI-D cable to the video port on y[...]

STEP 2-Connecting the Serial and USB Touchscreen Cable • Connect the female end of the serial (RS-232) cable to the serial port on your PC, or connect the USB touchscreen cable to the USB touchscreen connector on the back of your touchmonitor. • Connect the male end of the cable to the serial touchscreen connector on your touchmonitor, or conne[...]

STEP 3-Connecting the Speaker Cable • Connect the light blue end of the speaker cable to the light blue speaker port to the monitor (audio in). • Connect the lime (light green) end of the speaker cable to the lime speaker port on the computer (audio out). SPEAKER CABLE SPEAKER PORT CONNECTIONS ON UNDERSIDE 2-8 Elo Touchmonitor User Guide[...]

STEP 4-Connecting the Power Cable Depending on where you live, you will use either the European or US/Canadian power cable. • Connect the female end of the power cable to the medical grade power adaptor. • Connect the brick power cable into the power port on the touchmonitor. • Route the cable through the cable management channel. NOTE: To pr[...]

Optimizing the LCD Display To ensure the LCD display works well with your computer, configure the display mode of your graphic card to make it less than or equal to 1280 x 1024 resolution, and make sure the timing of the display mode is compatible with the LCD display. Refer to Appendix A for more information about resolution. Compatible video mode[...]

C H A P T E R 3 O PERATION About Touchmonitor Adjustments Your touchmonitor will unlikely require adjustment. Variations in video output and application may require adjustments to your touchmonitor to optimize the quality of the display. For best performance, your touchmonitor should be operating in native resolution, that is 1280 x 1024 at 60-75 H[...]

Front Panel Controls Control Function 1 Menu/Exit Display/Exits the OSD menus. 2 1. Enter contrast of the OSD. 2. Increase value of the adjustment item. 3. Shuffle item clockwise. 3 1. Enter audio volume adjustment. 2. Decrease value of the adjustment item. 3. Shuffle item counter-clockwise. 4 Select Select the adjustment items from the OSD menu. 5[...]

Controls and Adjustment OSD Menu Functions To Display and Select the OSD Functions: 1 Press the Menu key to activate the OSD menu. 2 Use or to move clockwise or counterclockwise through the menu. Press the select key on the monitor. The parameter will be highlighted when selected. 3 To quit the OSD screen at any time during the operation, press the[...]

OSD Control Options Control Description Contrast Increases or decreases contrast. Brightness Increases or decreases brightness. V-Position Moves the screen up or down. H-Position Moves the screen left or right. Recall Defaults Returns the monitor to its default settings. Color Balance Press or and “Select” button to select 9300, 6500, 5500, 750[...]

Power LED Display & Power Saving General Power Saving Mode When the power is on and video is present, this LED lights in green. The LED indicates the different power status with altered LED colors when monitor operates in different modes (see following table). Power Mode Consumption Indicator On 48w max. Green Sleep 7w max. Orange Off 4w NO Pow[...]

3-16 Elo Touchmonitor User Guide[...]

3-17 C H A P T E R 4 T ROUBLESHOOTING If you are experiencing trouble with your touchmonitor, refer to the following table. If the prob- lem persists, please contact your local dealer or our service center. Elo Technical Support num- bers are listed on page 31 of this manual. Solutions to Common Problems Problem Suggestion(s) The monitor does not r[...]

3-18 Elo Touchmonitor User Guide[...]

A P P E N D I X A N ATIVE R ESOLUTION The native resolution of a monitor is the resolution level at which the LCD panel is designed to perform best. 1928L native resolution is 1280 x 1024. In almost all cases, screen images look best when viewed at their native resolution. You can lower the resolution setting of a monitor but not increase it. Input[...]

As an example, a SVGA resolution LCD panel has 800 pixels horizontally by 600 pixels vertically. Input video is also represented by the same terms. XGA input video has a format of 1280 pixels horizontally by 1024 pixels vertically. When the input pixels contained in the video input format match the native resolution of the panel, there is a one to [...]

A P P E N D I X B T OUCHMONITOR S AFETY This manual contains information that is important for the proper setup and maintenance of your touchmonitor. Before setting up and powering on your new touchmonitor, read through this manual, especially Chapter 2 (Installation), and Chapter 3 (Operation). 1. To reduce the risk of electric shock, follow all s[...]

Care and Handling of Your Touchmonitor The following tips will help keep your Elo touchmonitor functioning at the optimal level. • To avoid risk of electric shock, do not disassemble the external power adaptor or display unit cabinet. The unit is not user serviceable. Remember to unplug the display unit from the power outlet before cleaning. • [...]

A P P E N D I X C T ECHNICAL S PECIFICATIONS Display Modes Your Elo touchmonitor is compatible with the following standard video modes: Item Resolution Type H.Scan(KHz) V. Scan(Hz) Polarity 1 640 x 350 VGA 31.47 70 2 720 x 400 VGA 31.47 70 3 640 x 480 VGA 31.47 60 4 640 x 480 MAC 66 35 66 -/ - 5 640 x 480 VESA 72 37.86 72 -/ - 6 640 x 480 VESA 75 3[...]

Touchmonitor Specifications Parameter Value LCD Display 19.0¨ TFT Active Matrix Panel Pixel Pitch 0.294(H) x 0.294(V) mm Display Mode VGA 640 x 350 (70 Hz) VGA 720 x 400 (70 Hz) VGA 640 x 480 (60 / 72 / 75 Hz) SVGA 800 x 600 (56 / 60 / 72 / 75 Hz) SXGA 1280 x 1024(60,70,75 Hz) Native SXGA 1280 x 1024 Contrast Ratio 1300 : 1 (typical) Brightness 30[...]

Power Supply Cord Selection North America Power Supply Cord ¡V Detachable, UL Listed, Type SJT 3 conductor, 18 AWG, configured load fittings terminating in molded on parallel blade. Grounding type hospital grade attachment plug, rated at a minimum of 3 amperes. Basic Cord Type Equivalent Types SP-2 SPE-2, SPT-2 SP-3 SPE-3, SPT-3 SV SVE, SVO, SVOO,[...]

Cord selection for other than North America For 100 V ac or 220/230/240 V ac operation, the unit is provided with IEC 320 flexible power cords properly configured for the intended country other than North America. The NOMINAL cross-sectional area (mm2 Cu) must be 0,75. For assistance in selecting the proper power cord contact the Elo distributor in[...]

C-27 HAR FLEXIBLE CORD Approval Organization Printed or Embossed Alternative Marking Harmonization Marking (May Utilizing Black-Red be Located On Jacket or Yellow Thread (Length Insulation of Internal Wiring) of color Section, mm) Comite Electrotechnique CEBEC <HAR> 10 30 10 Belge (CEBEC) Verband Deutscher Elektrotechniker (VDE) e.V. <VDE&[...]

AccuTouch (resistive) Touchscreen Specifications Mechanical Positional Accuracy Standard deviation of error is less than 0.080 in. (2.03 mm). Equates to less than ±1%. Touchpoint Density More than 100,000 touchpoints/in 2 (15,500 touchpoints/cm 2 ) Touch Activation Force Typical less than 3 ounces(85 grams) Surface Durability Surface durability is[...]

IntelliTouch Touchmonitor Specifications Mechanical Positional Accuracy Standard deviation of error is less than 0.080 in. (2.03 mm). Equates to less than ±1%. Touchpoint Density More than 100,000 touchpoints/in 2 (15,500 touchpoints/cm 2 ). Touch Activation Typically less than 3 ounces (85 grams). Force Surface Durability Surface durability is th[...]

C-30 Elo Touchmonitor User Guide[...]

P E N D I X D Contact Elo Elo TouchSystems 301 Constifution Drive Menlo Park, CA 94025 1-800-ELO-TOUCH (1-800-356-8682) www.eloinfo.elotouch.com D-31[...]

D-32 Elo Touchmonitor User Guide[...]

R EGULATORY I NFORMATION I. Electrical Safety Information: A) Compliance is required with respect to the voltage, frequency, and current requirements indicated on the manufacturer’s label. Connection to a different power source than those specified herein will likely result in improper operation, damage to the equipment or pose a fire hazard if t[...]

D) General Information to all Users: This equipment generates, uses and can radiate radio fre- quency energy. If not installed and used according to this manual the equipment may cause interference with radio and television communications. There is, however, no guarantee that interference will not occur in any particular installation due to site-sp[...]

W ARRANTY Except as otherwise stated herein or in an order acknowledgment delivered to Buyer, Seller warrants to Buyer that the Product shall be free of defects in materials and workmanship. The warranty for the touchmonitors and components of the product is 3 years. Seller makes no warranty regarding the model life of components. Seller’s suppli[...]

THESE REMEDIES SHALL BE THE BUYER’S EXCLUSIVE REMEDIES FOR BREACH OF WARRANTY. EXCEPT FOR THE EXPRESS WARRANTY SET FORTH ABOVE, SELLER GRANTS NO OTHER WARRANTIES, EXPRESS OR IMPLIED BY STATUTE OR OTHERWISE, REGARDING THE PRODUCTS, THEIR FITNESS FOR ANY PURPOSE, THEIR QUALITY, THEIR MERCHANTABILITY, THEIR NONINFRINGEMENT, OR OTHERWISE. NO EMPLOYEE[...]

Numerics ET1928L-XXWA-1-G A About touchmonitor Adjustments, 11 AccuTouch(resistive)Touchscreen Specifications, 28 Audio Volume, 14 Auto-Adjust, 14 B Back Unit, 4 Base Bottom View, 5 Brightness, 14 C Care and Handling of your Touchmonitor, 22 Caution-Life Support, v Classification, vi Clock, 14 Color Balance, 14 Connecting the Video Cable, 6 Connect[...]

I N D E X -38 R Rear View, 10 Recall Defaults, 14 Regulatory Information, 33 S Sealing, 28, 29 Sharpness, 14 Side View, 4 Solutions to Common Problems, 17 Surface Durability, 28, 29 SVGA, 19 T Technical Specifications, 23 Touch Activation Force, 28, 29 Touch Interface Connection, 6 Touch doesn’t work, 17 Touchmonitor Safety, 21 Touchmonitor Speci[...]

© 2006 Tyco Electronics Corporation . Printed in USA Check out Elo’s Web site! www.elotouch.com Get the latest... • Product information • Specifications • News on upcoming events • Press release • Software drivers Getting in Touch with Elo To find out more about Elo’s extensive range of touch solutions, visit our Web site at www.elot[...]