Wells H-2412G manuale d’uso

PRINTED IN UNITED ST A TES OF AMERICA WELLS BLOOMFIELD, LLC 2 ERIK CIRCLE, P . O. Box 280 V erdi, NV 89439 www .wellsbloomfield.com telephone: 775-689-5703 fax: 775-689-5976 IMPORTANT: DO NOT DI SCARD THIS MANUAL This manual is considered to be part of the appli ance and is to be given to the OWNER or MANAGER of the restaurant, or to the pers on re[...]

M228 306916 OpM H-2412 Instant-On Dual Pilot Gas Hotplate Unless otherwise specified, all commercial cooking equipment manufactured by WELLS BLOOMFIELD, LLC is warranted against defects in ma terials and workmanship for a period of one year from the date of original installation or 18 months from the date of shipment from our factor y, whichever co[...]

W A R R A N T Y x i S P E C I F I C A T I O N S 1 FEATURES & OPERATING CONTROLS 2 PRECAUTIONS & GENERAL INFORMATION 3 AGENCY APPROVAL INFORMATION 3 I N S T A L L A T I O N 4 I N I T I A L A D J U S T M E N T 7 O P E R A T I O N 8 TROUBLESHOOTING 10 CLEANING INSTRUCTIONS 11 ASSEMBLY DIAGRAM 12 PARTS & SERVICE 13 CUSTOMER SERVICE DATA 13 [...]

BURNERS Provide cooking heat Front and rear burners are individually controllable Removable for easy cleaning BURNER CONTROL Provide individual control of front and re ar burners KNOBS PILOT LIGHT Provides ignition source for main burners ACTUATOR Admits gas to burner when depres sed. Actuator head removable for ea sy c l e a n i n g GRATE ASSEMBLY[...]

This appliance is intended for use in commercial establishments only. This appliance is intended to prepare food for human consumpti on. No other use is recommended or autho rized by the manufacturer or its agents. This hotplate must be installed by a technician qualifie d and certifie d or licensed to install gas-fired equipme nt. A licensed techn[...]

INSTALLATION NOTE: DO NOT discard the carton or other packing materials until you have inspected the appliance for hidden damage and tested it for proper operation. Refer to SHIPPING DAMAGE CLAIM PROCEDURE on the inside front cover of this manual. DANGER: HEALTH HAZARD This appliance must be properly ventilated. Failure to provide proper ventilatio[...]

INSTALLATION (continued) GAS APPLIANCE CODE COMPLIANCE The installation of gas piping from the outlet side of the ga s meter or service regulator to the hotplate must be performed by a technician qualified and certified or licensed to install gas-fire d e quipment. A licensed and qualified technician must perform the initial startup and adjustment [...]

INSTALLATION (continued) INSTALLING THE HOTPLATE Refer to the nameplate. Verify the fuel type and pressure, which must match the nameplate specifications. Conne cting the hotplate to the wrong fuel type and/or pressure will compromise the safety and/or performance of the appliance. The hotplate must be placed in its final operational position and l[...]

INITIAL ADJUSTMENT SET GAS PRESSURE: Turn the gas shut-off valve OFF . A gas pressure test tap is provided on the gas suppl y manifold. Remove both burner control knobs and the front pan el. Remove plug in gas pressure test tap and attach a manometer. Turn the shut-off valve ON . Light the pilot light and turn both gas control valves to HI . Depres[...]

OPERATION GENERAL OPERATIONAL NOTES Carefully read the description of the hotplate operation on the specification sheet. Do NOT use this appliance if it has been subm erged in water. Call a qualified technician to examine the applia nce and to service or replace any component whi c h has been subme r ged. Burners which have been allowed to become w[...]

WARNING: FIRE HAZARD NEVER attempt to force or repair a stuck control valve. Contact your Authorized Wells Service Agency for repair s. Forced or improperly repaired valves pose the ri sk of fire and/or explosion. WARNING: FIRE AND EXPLOSION HAZARD If the pilot light should be extinguished, turn off the gas shut-off valve and remove grate and drip [...]

TROUBLESHOOTING 10 SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY Pilot will not light Gas supply off Check main / unit gas valves Air in lines Turn gas valve on. Attempt to light pilot every 15 sec. Pilot valve not on Turn pilot valve on / adjust Pilot burner holes are plug ged Clean pilot burner Front or rear burner won’t light Actuator not depressed [...]

CLEANING INSTRUCTIONS PREPARATION Turn gas shut-off valve OFF before clea ning. Allow hotplate to cool completely before cleani ng. FREQUENCY: Daily TOOLS Bristle Brush Clean Cloth or Sponge Mild Detergent Cleaner Formulated for Stainless Steel Warm Water CLEANING Turn gas shut-off valve OFF before clea ning. Allow hotplate to cool completely befor[...]

CLEANING INSTRUCTIONS (continued) 12 Fig. 7 Hotplate Assembly FRONT BURNER Slides over RIGHT nozzle; hooks into FRONT slots on pilot support REAR BURNER Slides over LEFT nozzle; hooks into REAR slots on pilot support GRA TE ASSEMBL Y Sets in place above burners DRIP TRA Y Drops in place exposing tops of burners 1. 2. 3. 4. Front actuator arm thread[...]

DESCRIPTION PART NO. CUST OMER SERVICE DA T A please have this information av ailable if calling for service RESTAURANT ___________ __________________ LOCAT ION _____________ INSTALLATION DATE _____________ ___________ TECHNICI AN ___________ SERVICE COMPAN Y ________________________________ ________________ ADDRESS _______________ ____________ STA[...]

Genuine Parts Protect - YOU - All - Ways SER VICE TRAINING - QUALITY SER VICE SER VICE TRAINING - QUALITY SERVICE CUSTOMER SA TISF ACTION CUSTOMER SA TISF ACTION Commercial Food Equipment Service Association Wells Bloomfield proudly supports CFESA Commercial Food Equipment Service Association PRINTED IN UNITED ST A TES OF AMERICA WELLS BLOOMFIELD, [...]