Williams Sound TGS PRO 720 manuale d’uso

® HEARING HELPER ™ T our Guide System W ireless, Por table FM Listening System M ANUAL AND U SER G UIDE MAN 122C T ransmitter Model PFM T32 or T31 Receiver Model PP A R35 Model TGS PRO 720[...]

® 2 HEARING HELPER ™ FM T OUR G UIDE S YSTEM , M ODEL TGS PRO 720 I NST ALLA TION G UIDE & U SER M ANUAL Contents Page S YSTEM O VERVIEW 3 S YSTEM C OMPONENTS 4 M ICROPHONES 4 H EADPHONES & E ARPHONES 5 S AFETY I NFORMA TION 6 R ECYCLING I NSTRUCTIONS 6 O PERA TING I NSTRUCTIONS PFM T32 T RANSMITTER 7 PFM T31 T RANSMITTER 10 PPA R35 R EC[...]

® 3 S YSTEM O VER VIEW The HEARING HELPER ™ T our Guide System is a portable, high-performance, wireless system composed of the PFM T32 or T31 T ransmitter and PP A R35 Recei vers and designed for use in guided tour applications. The system allo ws one-way transmission of a tour guide’ s v oice to group members using an FM radio signal. Using [...]

® 4 S YSTEM C OMPONENTS  Body Pack T ransmitter (PFM T32 or T31) with (2) AA batteries (B A T 001)  Noise-cancelling headband microphone (MIC 086)  (10) Recei vers (PP A R35) w/batteries (BA T 001)  Instruction Manual (MAN 122)  System carry case (CCS 030 S) T HE PFM T32 OR T31 T RANSMITTER The PFM T ransmitter is a battery-powered [...]

® 5 R O PTIONAL H EADPHONES AND E ARPHONES The optional HED 021 Lightweight Headphone is the standard headset for the T our Guide System. It of fers excellent sound quality and wearing comfort. The foam earpads may be remov ed and washed in a mild detergent, rinsed thoroughly , and air dried. The headphone plugs into the “EAR” jack on top of t[...]

® 6 C A UTION! C A UTION! C A UTION! S AFETY I NFORMA TION H EARING S AFETY This product is designed to amplify sounds to a high volume le vel which could potentially cause hearing damage if used improperly . T o protect y our hearing and the hearing of others: Make sure the v olume is turned down before putting on the earphone or headphone. Then [...]

® 7 1. Install two (2) AA batteries. If you’ re using rechar geable batteries, they must be char ged before using. 2. Plug the microphone cord into the “Mic” jack on top of the transmitter . 3. Place the transmitter in the belt clip case provided. 4. Slide the Po wer Switch on top of the transmitter to “On. ” The Po wer ON LED indicator [...]

® 8 C HANGING THE PFM T32 F REQUENCY F IG . 4: PFM T32 F REQUENCY C HANGE By default, the T32’ s frequency is to set 75.7 MHz (Channel G). If you experience FM interference, or if you need to match a recei ver’ s frequenc y , it may be necessary to adjust the frequenc y on the T32. Instructions: 1. Open the battery compartment using a coin in [...]

® 9 Gain Control Adjustment If necessary , the microphone gain control on the T32 can be increased or decreased to meet the demands of specific listening applications. Instructions: 1. Open the battery compartment using a coin in the slot in the bottom of the transmitter . Remo ve the batteries. 2. Lift the battery compartment door up and pull to [...]

® 10 U SING T HE PFM T31 T RANSMITTER Note: Before you begin, make sure you ha ve AA Alkaline batteries installed in the transmitter . See Battery Information on page 15. 1. Plug the microphone into the “mic” jack on top of the transmitter . 2. T urn the po wer on: Place the FM switch to the “On” position. 3. Position the microphone as clo[...]

® 11 Switch Settings MHz 1 2 3 4 5 6 7 8 72.1 DN UP DN UP DN DN DN DN 72.3 DN UP DN UP UP DN DN DN 72.5 DN UP DN UP DN DN UP DN 72.6 DN DN UP DN DN DN DN UP 72.7 DN UP DN UP UP DN UP DN 72.8 DN UP DN DN DN DN DN UP 72.9 DN UP DN UP DN DN DN UP 74.7 UP DN DN UP UP DN DN UP 75.3 UP UP DN UP DN DN DN DN 75.4 UP UP DN DN UP DN DN DN 75.5 UP UP DN UP U[...]

® 12 U SING THE PP A R35 R ECEIVER Note: Rechargeable batteries are shipped in a dischar ged state and must be charged o vernight before using. 1. Make sure there are two char ged AA batteries in the Recei ver . If batteries are not installed, see Battery Information on page 15. NO TE: The ON indicator will illuminate RED to indicate lo w battery [...]

® 13 – or – B EL T C LIP I NST ALLA TION FOR PP A R35 T O I NST ALL : Position the belt clip on the rear of the R-35 recei ver as sho wn in Figure 9a. T urn the belt clip 180º left or right as sho wn in Figure 9b . The belt clip is now installed and ready for use. T O R EMOVE : T urn the belt clip 180º so the edge points toward the top of th[...]

® 14 PP A R35 R ECEIVER F REQUENCY C HANGE I NSTRUCTIONS Selecting a frequency for the R35 recei ver requires an adjustment to the internal tuning coil. See figure belo w to locate the coil to be adjusted. A plastic tuning wrench (PL T 005) will be needed to adjust this recei ver’ s tuning coil. Most W illiams Sound single channel Receivers are [...]

® 15 B A TTERY I NFORMA TION I NST ALLA TION Open the battery compartment using a coin in the slot in the bottom of the recei ver or transmitter . Press the batteries into place, observing proper battery polarity . Incorrect insertion of the battery is dif ficult, and if forced, may cause both mechanical and electrical damage to transmitters or re[...]

® 16 Charging Indicators Charging Pins Cord Hook P ow er Input Charging Contact Holes F IGURE 12: U SING T HE O PTIONAL CHG 200A B A TTERY C HARGER T O C HARGE THE PFM T32 OR T31 T RANSMITTER Step 1: Plug the CHG 200’ s power supply into the Po wer Input on the charger’ s side and a standard A C wall outlet. Step 2: Route the power cord around[...]

® 17 U SING T HE O PTIONAL CHG 3512 B A TTERY C HARGER TO CHARGE THE PP A R35 R ECEIVER Before inserting the PP A R35 receivers into the char ger, be sure that each recei ver has NiMH batteries installed. Also, check to make sure the switch setting in the PP A R35 battery compartment indicates the “NiMH” setting. Step 1: Plug the TFP 035 po we[...]

® 18 H INTS FOR U SING THE S YSTEM Normal operating distance between the transmitter and recei ver is about 30 meters. The operating range will v ary in different b uildings and surroundings. In some locations, the signal may momentarily disappear . This is called a “drop-out” and is due to reflection and cancellation of the radio signal. Movi[...]

® 19 I N C ASE O F D IFFICUL TY If your T our Guide System is not working, check the follo wing: 1. Read thr ough the manual and user guide car efull y to v er ify proper setup and installation of y our system . 2. Make sure the batteries are fresh or completely char ged and that the “plus” and “minus” terminals are installed correctly . 3[...]

® 20 Williams Sound products are engineered, designed, and manufactured under carefully controlled conditions to provide you with many years of reliable service. Williams Sound warrants the HEARING HELPER ™ Tour Guide System against defects in materials and workmanship for FIVE (5) years. During the first five years from the purchase date, we wi[...]

® 21 S YSTEM S PECIFICA TIONS FM T RANSMITTER , M ODEL PFM T32 Dimensions: 3-5/8" L x 2-3/8" W x 7/8" H (92.1 mm x 60.3 mm x 22.2 mm) Weight: 4.4 oz (125 g) with battery Color: Royal blue, shatter-resistant polypropylene Battery Type: Two (2) AA 1.5 V non-rechargeable Alkaline batteries (BAT 001), 70 mA nominal current drain, 30 hou[...]

® 22 R ECEIVER , M ODEL PP A R35 Dimensions: 4.1" L x 2.85" W x 1.2" H (104.1 mm x 72.4 mm x 30.4 mm) Weight: 4.5 oz (127 g) Color: Gray Battery Type: Two (2) AA non-rechargeable alkaline batteries (BAT 001), approx. 100 hours battery life or Two (2) AA rechargeable NiMH batteries (BAT 026), 1400 mAh, approx 56 hours battery life Cu[...]

[...]

© 2006, Williams Sound Corp. MAN 122C ® 10321 West 70th St., Eden Prairie, MN 55344 U.S.A. 800.843.3544 | 952.943.2252 | FAX: 952.943.2174 www.williamssound.com[...]