English dropdown-ico

Burnham Indirect - Fired Water Heater AL SL manual

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24

Go to page of

Similar user manuals

A good user manual

The rules should oblige the seller to give the purchaser an operating instrucion of Burnham Indirect - Fired Water Heater AL SL, along with an item. The lack of an instruction or false information given to customer shall constitute grounds to apply for a complaint because of nonconformity of goods with the contract. In accordance with the law, a customer can receive an instruction in non-paper form; lately graphic and electronic forms of the manuals, as well as instructional videos have been majorly used. A necessary precondition for this is the unmistakable, legible character of an instruction.

What is an instruction?

The term originates from the Latin word „instructio”, which means organizing. Therefore, in an instruction of Burnham Indirect - Fired Water Heater AL SL one could find a process description. An instruction's purpose is to teach, to ease the start-up and an item's use or performance of certain activities. An instruction is a compilation of information about an item/a service, it is a clue.

Unfortunately, only a few customers devote their time to read an instruction of Burnham Indirect - Fired Water Heater AL SL. A good user manual introduces us to a number of additional functionalities of the purchased item, and also helps us to avoid the formation of most of the defects.

What should a perfect user manual contain?

First and foremost, an user manual of Burnham Indirect - Fired Water Heater AL SL should contain:
- informations concerning technical data of Burnham Indirect - Fired Water Heater AL SL
- name of the manufacturer and a year of construction of the Burnham Indirect - Fired Water Heater AL SL item
- rules of operation, control and maintenance of the Burnham Indirect - Fired Water Heater AL SL item
- safety signs and mark certificates which confirm compatibility with appropriate standards

Why don't we read the manuals?

Usually it results from the lack of time and certainty about functionalities of purchased items. Unfortunately, networking and start-up of Burnham Indirect - Fired Water Heater AL SL alone are not enough. An instruction contains a number of clues concerning respective functionalities, safety rules, maintenance methods (what means should be used), eventual defects of Burnham Indirect - Fired Water Heater AL SL, and methods of problem resolution. Eventually, when one still can't find the answer to his problems, he will be directed to the Burnham service. Lately animated manuals and instructional videos are quite popular among customers. These kinds of user manuals are effective; they assure that a customer will familiarize himself with the whole material, and won't skip complicated, technical information of Burnham Indirect - Fired Water Heater AL SL.

Why one should read the manuals?

It is mostly in the manuals where we will find the details concerning construction and possibility of the Burnham Indirect - Fired Water Heater AL SL item, and its use of respective accessory, as well as information concerning all the functions and facilities.

After a successful purchase of an item one should find a moment and get to know with every part of an instruction. Currently the manuals are carefully prearranged and translated, so they could be fully understood by its users. The manuals will serve as an informational aid.

Table of contents for the manual

  • Page 1

    1 INST ALLA TION, OPERA TING AND SER VICE INSTRUCTIONS FOR Alliance SL ™ Indirect - Fired W ater Heater For service or repairs to the water heater , call your heating contractor . When seeking informa- tion on the water heater , provide Model Number and Serial Number as shown on Rating Label. Model Number AL SL Serial Number Installation Date Hea[...]

  • Page 2

    2 PLEASE READ INSTRUCTIONS CAREFULL Y BEFORE INST ALLING W A TER HEA TER U.S Boiler Company , Inc. – Burnham Hydronics (herein called the Company) intends that this Alliance SL™ Indirect-Fired W ater Heater be used as a separate zone to a heating system boiler . This appliance is designed to heat water by circulating water from the boiler throu[...]

  • Page 3

    3 INDEX General Information ..................................................................................................................... 2 Specications & Ratings .............................................................................................................. 2 Installation Guidelines ...................................[...]

  • Page 4

    4 A. INSPECTING AND PREP ARING THE W A TER HEA TER  q AL27SL thru AL70SL - Remove the cardboard box, which comes packaged with the heater . It should contain the following: TPI thermostat, T&P valve and a “T ee”, foamed lid and screws. q AL1 19SL - Remove the cardboard boxes, which come packaged with the heater . One box should con[...]

  • Page 5

    5 valve must be marked with maximum set pressure not to exceed the marked maximum allowable working pressure of the water heater (150psi). Install the valve into the opening provided and marked for this purpose in the water heater , and orient it or provide the tubing so that any discharge from the valve will exit only within 6 inches above, or at [...]

  • Page 6

    6  q Do not apply heat directly to the cold-water inlet as it is made of plastic and will melt. G. BOILER SUPPL Y CONNECTIONS  q W ARNING: Boiler temperature must be controlled by the boiler high limit not to exceed 200°. Failure to do so will create a hazardous installation and void the applicable limited warranties.  q All wate[...]

  • Page 7

    7  q Run all 24V AC wiring thru the square notch on bottom of TPI case. (See TPI Diagram 3)  q Incoming 24V AC power must be connected to 24V AC connectors on the bottom right corner of TPI control. (See TPI Diagram 3)  q Connect control wiring to PUMP/TT normally open relay connections (rated for both 24V and 1 10V wiring) on the[...]

  • Page 8

    8  q Do not apply heat to cold inlet.  q If there is a check valve (sometimes in water meter), backow preventer or pressure-reducing valve, install an adequate size expansion tank. G. FILLING THE HEA TER  q Completely ll heater .  q W ater connections completed and free of leaks.  q Check for proper installation [...]

  • Page 9

    9 W A TER TEMPERA TURE CONTROLS A periodic inspection of the operating controls, heat exchanger and wiring should be made by qualied ser - vice personnel. T emperature of the water should be tested periodically at the faucet to be sure thermostat is working properly . TEMPERA TURE ADJUSTMENT The TPI comes with a factory set temperature setting o[...]

  • Page 10

    10 TPI CONTROL - DIAGRAM 1 Indicating Light T emperature Adjust Differential Adjust TPI CONTROL - DIAGRAM 2 Screw A[...]

  • Page 11

    1 1 TPI CONTROL - DIAGRAM 3 Outgoing 24V wires to relay or zone valve Incoming 24V power connection Outgoing 1 10V wires to circulator Chase Nipple Conduit Incoming 24V power connections NOTE: Use proper conduit and chase nipple[...]

  • Page 12

    12 FIGURE 1 - Installation Using Zone V alves Installation Diagram Using Zone V alves FIGURE 2 - Installation Using Circulator Installation Diagram Using Separate Circulator[...]

  • Page 13

    13 FIGURE 3 - Coil Detail & T ightening Sequence Bolt Steel W asher Coil Plate Plastic O-Ring Housing T ank Flange ‘L ’ Nut Small outside O-ring Large inside O-ring Proper T ightening Sequence for T op Mount Coil CAUTION: Does not require excessive force to seal properly . 3 2 1 6 4 7 2 5 3 8 1 Incorrect Correct Note: Same as car tire lugs[...]

  • Page 14

    14 Low V oltage 120 V olts L1 Hot 120 V olts L2 Neutral Circula tor 24v T emperature Differential Pump/TT 24v LED flashing green = calling for heat solid green = at temperature red = error 20° 15° 10° 5° 160° 150° 140° 130° 120° 1 10° Probe Switched Hot ® ® T T Switching Relay T ransformer Thermostat Burner T V W T Z C1 C2 L1 L2 B1 B2 1[...]

  • Page 15

    15 Zone V alve Wiring Diagrams Wiring for 3 W ire Zone V alve L o w V oltage 120 V olts 120v 24v B oiler C onnec tions T 1 T 2 3 H ot N eutr al Z one V alv e 120v 24v T o B oiler C onnec tions /C ir cula t or H ot N eutr al 4 W ir e Z one V alv e M ot or E nd S wit ch T T T emperature Differential P ump/T T 24v LED flashing green = calling for heat[...]

  • Page 16

    16 Switching relay Wiring Diagrams Switching Relay SR-502 or SR-503 Switching Relay R8845U or SR 501[...]

  • Page 17

    17 Switching relay Wiring Diagrams (con’t) Switching Relay SR-504 with Priority Option L o w V oltage 120 V olts FUSE 1 AMP C OM / 24 V A C FOUR Z ONE SWIT CHING REL A Y WITH OPTIONAL PRIORIT Y Z ONE 1 Z ONE 2 Z ONE 3 Z ONE 4 Z ONE 4 PRIORIT Y ON OFF Z ONE 1 Z ONE 2 Z ONE 3 Z ONE 4 PO WER 120 V OL T CIR CUL A T ORS X X END SWIT CH Z C ZR INPUT SR[...]

  • Page 18

    18 HOW T O OBT AIN SER VICE ASSIST ANCE U.S. Boiler Company , Inc. – Burnham Hydronics does not have a service department or personnel to ser- vice your heater in the eld. A qualied installer or service technician must do all service work. Therefore, if you have any questions about your new water heater concerning service adjustment, repair[...]

  • Page 19

    19 Alliance SL™ Indirect-Fired W ater Heater 10/2/1 LIMITED W ARRANTY T en Y ear Limited T ank Replacement W arranty T wo Y ear Limited T ank Replacement Labor Allowance One Y ear Limited Parts W arranty U.S. Boiler Company , Inc. – Burnham Hydronics, (hereinafter called the company) offers the following Lim- ited T ank Replacement W arranty , [...]

  • Page 20

    20 ONE (1) YEAR LIMITED P ARTS W ARRANTY DURA TION: The warranty is effective for one (1) year beginning with the date of original purchase. This warranty shall begin from the date of manufacture as indicated by the serial number . COVERAGE: The warranty covers any component part of the Alliance SL™ water heater proven to be defective in workmans[...]

  • Page 21

    21 MODEL & SERIAL NUMBER INFORMA TION The following information should be noted At time of installation and retained for Future reference. Model No. Serial No. Date Installed Dealer ’s Name Address City State Zip U.S. Boiler Company , Inc., – P .O. Box 3079 – Lancaster , P A 17604 www .burnham.com[...]

  • Page 22

    22 NOTES[...]

  • Page 23

    23 NOTES[...]

  • Page 24

    24 Optional Lifetime W arranty Registration Card A vailable to Residential, Single Family Homes Only Y es, I wish to purchase the Optional Lifetime W arranty! DA TE _____________________________________________________________________ PURCHASER’S NAME _______________________________________________________ HOME ADDRESS ___________________________[...]