Electrolux Ceramic glass hob manual

1 6310 K-m G B 949600459 INSTRUCTION BOOK Ceramic glass hob GB[...]

2 Your New Appliance Thank you for purchasing an AEG appliance. To enable you to use your new hob efficiently and safely, please read this instruction book carefully before installing or using the appliance, and retain for future reference. Should the hob be transferred to a new owner please ensure this instruction book is left with the appliance i[...]

3 Contents P a g e no F or the user Y our new appliance ...................................................................................... 2 Safety information ........................................................................................ 4 Description of the product ....................................................................[...]

4 Safety information These warnings are pro vided in the interests of your safety . Ensure you fully understand them before installing or using the appliance. Y our safety is of paramount importance. If you are unsure about the meaning of these warnings contact the Customer Care Department for assistance. Installing Do not install the hob if the ce[...]

5 Description of the pr oduct Control knobs CHEC Contr ol panel Control knobs for operations[...]

6 Ceramic glass surface The ceramic glass surface has four cooking zones. When a zone is turned on, it will illuminate at various intervals depending on the heat setting selected. Even at the highest setting the zone is disconnected occasionally to ensure that the surface is not over-heated. The glass is hard, and has been tempered to withstand hea[...]

7 Connection of child safety de vice on zones T urn the 2 control buttons to at the same time. The display will sho w: When you turn on a zone the display will sho w: T o turn on a zone, turn the 2 control buttons to at the same time. Y ou must then acti vate one of the zones within 10 seconds. The light under the symbol in the display will disappe[...]

8 Protection of the glass ceramic surface A protective film should be applied to the glass ceramic surface before use. This will make it easier to clean the surface, as well as preventing substances from being burnt onto the surface. This is what to do: 1. Pour a few drops of ceramic cleaning detergent such as vitroclen onto a piece of kitchen roll[...]

9 Switch symbols (to the left) control for regulating the small cooking zone at the rear control for regulating the double cooking zone at the front. control for regulating the lar ge cooking zone at the rear control for regulating the small cooking zone at the front. Regulating The regulation of heat is step-free for all plates on a scale from 1 t[...]

10 Residual-Heat indicator When you switch of f a zone, an "H" in the display indicates that the zone is still hot. The residual heat indicator will continue to be illuminated as long as the temperature exceeds 80 ˚ C. Cooking zones The control knobs are continuously adjustable from 1 to 9 (9 is the highest setting). There is A UTOMAX co[...]

11 CHEC control A utostop If you forget to turn a cooking zone of f after use, it will be disconnected automatically after a specific period of time. The higher the setting, the shorter the time before the zone is disconnected. Setting A UTOSTOP 1 6 hours 2 6 hours 3 5 hours 4 5 hours 5 4 hours 6 1 ½ hours 7 1 ½ hours 8 1 ½ hours 9 1 ½ hours Wh[...]

12 The use of AUTOMAX means that the maximum power is connected for a specific number of minutes, depending on the setting chosen. The table below shows the length of time for which there is full power for each setting, and the functions for which each setting is suitable. Setting F ull power time Function 1 1 minute Melting/simmering 2 3 minutes M[...]

13 Disconnection of A UTOMAX: If you do not wish to use A UTOMAX, observe the follo wing procedure: 1. T urn the control button to A OFF . 2. Then turn the control b utton to the required setting. Setting the large zone on the double zones 1. T urn the control button to The display will sho w: 2. Then turn the control b utton to the required settin[...]

14 When you turn on a zone the display will sho w: Observe the follo wing procedure to use a zone: 1. T urn the 2 buttons to at the same time. 2. Use one of the zones within 10 seconds. The light under the symbol in the display will disappear . Y ou can disconnect the child safety de vice permanently as follows: 1. T urn the 2 control buttons to an[...]

15 Advice and hints for using the cooking zones If you use the advice below you will save energy and make your cleaning tasks easier. Adjust the cooking zones correctly. Select the highest setting for the cooking zones until the food is brought to the boil. Then reduce the setting as far as possible, without the food going off the boil. Use level s[...]

16 Do not slide saucepans across the surface of the hob - alw ays lift the pan when placing it on, or removing it from the ceramic surface. W ipe the bottom surface of the pots and pans with a clean dry cloth before placing them on the ceramic surface. This helps to reduce cleaning and pre vents scratching the hob glass. W ipe off spills whilst the[...]

17 Cleaning and maintenance For reasons of hygiene and safety, the cooking zones must be kept clean. Grease stains and spilled food generate smoke when heated, and can even cause fire. The splashguard can be removed to make it easier to clean the surface. What to do: 1. Hold the splashguard as shown in the diagram. 2. Lift the splashguard straight [...]

18 Stainless steel surfaces Clean the appliance after use with a soft cloth well wrung out in warm water, use a small amount of liquid detergent for stubborn soiling. Stainless steel parts may become straw coloured with use, use a proprietary stainless steel cleaner to remove this straw discolouration. Never use metal wool, metal sponges or other a[...]

19 The decorati ve pattern on the ceramic surface can become scratched and marred with use, depending upon maintenance, but does not adv ersely af fect performance. Such blemishes are not co vered by the warranty and do not affect the operation of the hob . Spills and melts must be remov ed immediately , while the surface is still warm, using the s[...]

20 Minimum distance to side wall: 150 mm Minimum distance to rear wall (non- flammable material): 50 mm Reinforcement beams Installation Caution: In order to av oid a hazard this appliance must be installed according to these instructions for installation The appliance unit can be mounted in any type of kitchen with a w ork top whose thickness is b[...]

21 It is not necessary to attach the reinforcement beam to the work top surface, as it is held in place by a specially designed moulding, which is incorporated in the hob units flanges. The units externall y measured length 145 mm: Cooker hood 290 mm: T wo-zone ceramic-top electric hob T wo-b urner gas hob Grill Fryer Wo k 580 mm: Four -zone cerami[...]

22 The electrical connection may only be performed by a qualified electrician/ competent person. The electrical connection must be carried out in accordance with pre vailing regulations for appliances using heavy current. The connection must comply with any specific requirements specif ied by the local electricity supply authority . There must be n[...]

23 Cell V oltage 240 V Electrical connection 240V - 50Hz T otal wattage 6400W Instant heat ef fect Left front 12/18 cm 700/1700 W Left Back 14 cm 1200 W Right back 21 cm 2300 W Right front 14 cm 1200 W This unit is labelled to indicate conformity with the lo wvoltage directi ve (73/23/EEC) and the EMC directi ve (89/336/EEC). Unpacking Check that t[...]

24 Something not w orking If the hob is not working correctly, please carry out the following checks before contacting your local AEG Service Force Centre. IMPORTANT: If you call out an engineer to a fault caused by incorrect use or installation, a charge will be made even if the hob is under guarantee. Sympton The hob is not working The fuses keep[...]

25 Problems Zones will not come on, Child safety device has been activated. Zones will not come on, Autostop has been activated. Solution Turn the 2 display shows control buttons with symbol for child safety device to simultaneously. Then activate one of the zones within 10 seconds. Turn all the control display shows buttons to 0. The zones can now[...]

26 In the event of your appliance requiring service, or if you wish to purchase spare parts, contact your local AEG Service Force Centre by telephoning: 08705 929 929 Your call will automatically be routed to the Service Centre covering your post code area. In-guarantee customers should ensure that the recommended checks under the heading "Som[...]

27 AEG of fer the following guarantee to the first purchaser of this appliance: 1. The guarantee is v alid for 12 months commencing when the appliance is handed ov er to the first retail purchaser , which must be verif ied by purchase in voice or similar documentation. 2. The guarantee co vers all parts or components which fail due to faulty workma[...]

28 Before you mov e please contact your nearest Customer Care centre, listed belo w , to giv e them details of your new home. The y will then ensure that the local service organisation is a ware of your mov e and able to look after you and your appliances. France Senlis +33 (0) 44 62 29 29 Germany N ü rnberg +49 (0) 911 323 2600 Italy Pordenone +3[...]

29[...]

30[...]

31[...]

32 325 88-1710 Rev . 3-018[...]