English dropdown-ico

Frigidaire 134940700A manual

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24

Go to page of

Similar user manuals

A good user manual

The rules should oblige the seller to give the purchaser an operating instrucion of Frigidaire 134940700A, along with an item. The lack of an instruction or false information given to customer shall constitute grounds to apply for a complaint because of nonconformity of goods with the contract. In accordance with the law, a customer can receive an instruction in non-paper form; lately graphic and electronic forms of the manuals, as well as instructional videos have been majorly used. A necessary precondition for this is the unmistakable, legible character of an instruction.

What is an instruction?

The term originates from the Latin word „instructio”, which means organizing. Therefore, in an instruction of Frigidaire 134940700A one could find a process description. An instruction's purpose is to teach, to ease the start-up and an item's use or performance of certain activities. An instruction is a compilation of information about an item/a service, it is a clue.

Unfortunately, only a few customers devote their time to read an instruction of Frigidaire 134940700A. A good user manual introduces us to a number of additional functionalities of the purchased item, and also helps us to avoid the formation of most of the defects.

What should a perfect user manual contain?

First and foremost, an user manual of Frigidaire 134940700A should contain:
- informations concerning technical data of Frigidaire 134940700A
- name of the manufacturer and a year of construction of the Frigidaire 134940700A item
- rules of operation, control and maintenance of the Frigidaire 134940700A item
- safety signs and mark certificates which confirm compatibility with appropriate standards

Why don't we read the manuals?

Usually it results from the lack of time and certainty about functionalities of purchased items. Unfortunately, networking and start-up of Frigidaire 134940700A alone are not enough. An instruction contains a number of clues concerning respective functionalities, safety rules, maintenance methods (what means should be used), eventual defects of Frigidaire 134940700A, and methods of problem resolution. Eventually, when one still can't find the answer to his problems, he will be directed to the Frigidaire service. Lately animated manuals and instructional videos are quite popular among customers. These kinds of user manuals are effective; they assure that a customer will familiarize himself with the whole material, and won't skip complicated, technical information of Frigidaire 134940700A.

Why one should read the manuals?

It is mostly in the manuals where we will find the details concerning construction and possibility of the Frigidaire 134940700A item, and its use of respective accessory, as well as information concerning all the functions and facilities.

After a successful purchase of an item one should find a moment and get to know with every part of an instruction. Currently the manuals are carefully prearranged and translated, so they could be fully understood by its users. The manuals will serve as an informational aid.

Table of contents for the manual

  • Page 1

    1 Inst allation Instructions Gas & Electric Dryer www .frigidaire.com P/N 134940700A (0 804 ) Instrucciones p ara la inst alación Secadora a Gas y Eléctrica[...]

  • Page 2

    2 CONTENTS Pre-Installation Requirements..........................................................................................................................................2 Electrical Requirements..................................................................................................................................................3[...]

  • Page 3

    3 GAS Dryer CIRCUIT - Individual 15 amp. branch circuit fused with a 15 amp. maximum time delay fuse or circuit breaker . POWER SUPPL Y - 3 wire, 120 volt single phase, 60 Hz, Alternating Current. POWER SUPPL Y CORD - The dryer is equipped with a 120 volt 3-wire power cord. NEMA 10-30R NEMA 14-30R ELECTRICAL REQUIREMENTS ELECTRIC Dryer CIRCUIT - In[...]

  • Page 4

    4 SAME AS OTHER SIDE SAME AS OTHER SIDE SAME AS OTHER SIDE SAME AS OTHER SIDE SAME AS OTHER SIDE (9.5 cm) (9.5 cm) (9.5 cm) (9.5 cm) (9.5 cm) 4 3/8" 4 3/8" 4 3/8" 4 3/8" 4 3/8" 5 7/8" 5 7/8" 5 7/8" 5 7/8" 5 7/8" 13 1/2" 13 1/2" 13 1/2" 13 1/2" 13 1/2" 3 3/4" 3 3/4"[...]

  • Page 5

    5 CLOSET DOOR 60 sq. inches (387.1 sq. cm) 60 sq. inches (387.1 sq. cm) 0" (0 cm) 0" (0 cm) 0" (0 cm) 1" (2.54 cm) LOCA TION OF YOUR DRYER DO NOT INST ALL YOUR DRYER: 1. In an area exposed to dripping water or outside weather conditions. 2. In an area where it will come in contact with curtains, drapes, or anything that will obs[...]

  • Page 6

    6 28. 25” to fr on t of cabi ne t 28. 75” to cl ear kn obs 29. 5” to clear door h andle 49” to clear open doo r 13. 5” 40. 75” Cen ter lin e height for rear, right, left vents 4. 37 5” Side exha us ts 27. 0” 38” Gas su pp ly pi pe on r ear of unit 2. 375” Elect ri cal sup p ly on re ar of uni t 71. 75” 27.0” 36.0” 48.5” [...]

  • Page 7

    7 REMOVE 4 SCREWS (ONE FROM EACH HINGE FIRST) UNP UNP UNP UNP UNP ACKING ACKING ACKING ACKING ACKING 1. Using the four shipping carton corner posts (two on each side), carefully lay the dryer on its left side and remove the foam shipping base. T o prevent damage, do not use the contr ol panel as a means to pick up or move the dryer . 2. Return the [...]

  • Page 8

    Figure 1 1.Open door and rem ove four (4) plugs in the door opening opposite the hinges. Retai n all parts for uses later, unless otherwise noted. (Figure 1) Note: Use care in removing plugs in not scratching paint o n the front panel. Figure 2 2. Begin removing th e four (4) screws that attach the hinge to the front panel. (Figure 2) Fo r best res[...]

  • Page 9

    Figure 7 8. Remove lens locating screw. (Figure 7) Figure 8 9. Disengaging several of the retention tabs an d pull lens away from the trans ition ring. (Figure 8) Figure 9 Figure 10 10. Remove two (2) transition ring plugs and reinstall on previous handle side. (Figures 9 and 10) 11. Reassemble lens to transition ring wi th holes to install handle [...]

  • Page 10

    10 ELECTRICAL INST ALLA TION ELECTRIC Dryer The following are specific requirements for proper and safe electrical installation of your dryer . Failure to follow these instructions can create electrical shock and/ or a fire hazard. This appliance MUST be properly grounded. Electrical shock can result if the dryer is not properly grounded. Follow th[...]

  • Page 11

    11 4. Thread a U.L. approved 30 amp power cord, NEMA 14-30 type ST or SRDT through the strain relief. 5. Attach the green power cord ground wire to the cabinet with the green gr ound screw . 6. Attach the white (neutral) power cord conductor from the power cord and the neutral ground wire from the dryer harness to the silver-colored center terminal[...]

  • Page 12

    12 GAS CONNECTION 1. Remove the shipping cap from gas pipe at the rear of the dryer . NOTE: DO NOT connect the dryer to L.P . gas service without converting the gas valve. An L.P . conversion kit must be installed by a qualified gas technician. 2.Connect a 1/2 inch (1.27 cm) I.D. semi-rigid or approved pipe from gas supply line to the 3/8 inch (0.9[...]

  • Page 13

    13 La instalación y el servicio de la Secadora de ropa se deben realizar por un instalador calificado, la agencia de servicio o el surtidor de gas. Instale la Secadora de ropa según las instrucciones del fabricante y los códigos locales. Antes de comenzar la instalación, lea cuidadosamente estas instrucciones. Esto simplificará la instalación[...]

  • Page 14

    14 REQUERIMIENTOS ELÉCTRICOS Secadoras ELÉCTRICAS CIRCUITO : circuito independiente individual de 30 A con fusibles de acción retardada o disyuntores. Use circuitos con fusibles separados para las lavadoras y secadoras y NO haga funcionar una lavadora y una secadora en el mismo circuito. SUMINISTRO ELÉCTRICO : trifilar o tetrafilar , 240 V , 1 [...]

  • Page 15

    15 Para las instalaciones cuyo sistema de desahogo no se encuentre en el diagrama, se puede utilizar el método a continuación para determinar si el sistema de desahogo es apropiado. 1. Conecte un manómetro a tubo inclinado o digital entre la secadora y el unión de desahogo de la secadora. 2. Ponga el contador de tiempo de la secadora y la tempe[...]

  • Page 16

    16 0" (0 cm) 0" (0 cm) 0" (0 cm) 0" (0 cm) 0" (0 cm) 1" (2,54 cm) 1" (2,54 cm) 1" (2,54 cm) 1" (2,54 cm) 1" (2,54 cm) 0" (0 cm) 0" (0 cm) 0" (0 cm) 0" (0 cm) 0" (0 cm) 0" (0 cm) 0" (0 cm) 0" (0 cm) 0" (0 cm) 0" (0 cm) REQUERIMIENTOS DEL SUMINISTRO DE[...]

  • Page 17

    17 Dryer Installation Dimensions Dimensiones de la Instalación 28.25” to front of cabinet 28.75” to cle ar knobs 29.5” to clear do or handle 49” to clear open door 13.5” 40.75” Center line height for rear , right, le ft ve nts 4.375” Side exhaust s 27.0” 38” Gas supply pipe on rear of unit 2.375” Electr ical supply on rear of u[...]

  • Page 18

    18 QUITE LOS CUA TRO TORNILLOS (PRIMERO QUITE UNO DE CADA BISAGRA ) INST ALACIÓN EN CASAS MÓVILES 1. El tubo de escape de la secadora DEBE ser instalado hacia el exterior (El escape debe colocarse en la parte exterior y no debajo de la casa móvil.) Debe usarse ducto de metal que no sea combustible. El ducto de metal debe tener cuatro pulgadas (1[...]

  • Page 19

    Figure 1 1. Abra la Puerta y quite los 4 tapones de enfrente a donde se encuentra la bisagra. Conserve todas las pi ezas para utilizarlas posteriormente, a menos q ue se especifique lo contrario. (Figura 1). Nota: Tenga cuida do al quitar lo s tapones, para no dan~ar la pintura en el Panel Fro ntal. Figure 2 2. Afloje los cuatro (4) tornillos que s[...]

  • Page 20

    Figure 7 8. Quite el tornillo que fija la lente. (Figura 7). F igure 8 9. Desuniendo varias de las lengüeta s d e reten ción y retire la lente lejos del anillo de transición. (Figura 8). Figure 9 Figure 10 10. Quite dos (2) tapones del anillo de transición y reinstálese en lado anterior de la manij a . (Figuras 9 y 10) 11. Vuelva a montar la l[...]

  • Page 21

    21 INST ALACIÓN ELÉCTRICA Secadoras ELÉCTRICAS Los siguientes requerimientos son específicos para el funcionamiento correcto y seguro de su secadora. El incumplimiento de estas instrucciones puede causar prolongación excesiva del tiempo de secado y riesgos de incendio. Este artefacto DEBE ser puesto a tierra de manera correcta. Si la secadora [...]

  • Page 22

    22 4. Inserte un cordón eléctrico tetrafilar de 30 amp, NEMA 10-30 Tipo ST o SRDT , aprobado por el U.L., a través del anclaje de cable. 5. Conecte el cable verde de puesta a tierra del cordón eléctrico al gabinete mediante el tornillo verde de puesta a tierra. 6. Conecte el conductor blanco (neutro) del cordón eléctrico y el cable de puesta[...]

  • Page 23

    23 CONEXIÓN DEL GAS 1. Saque la tapa de embarque de la tubería de gas de la secadora situada en la parte trasera. NOT A: NO conecte la secadora al suministro de pr opano, sin convertìr la válvula del gas. Un juego de conversión a propano debe ser instalado por un técnico de gas calificado. 2. Conecte una tubería semirígida de 1/2" (1,2[...]

  • Page 24

    11 Notes ______________________________________________________________ ______________________________________________________________ ______________________________________________________________ ______________________________________________________________ ______________________________________________________________ __________________________[...]