Haier HWM110-287S manual

User's manual This manual is for HWM1 10-287S Please read this manual carefully before using. Retain it for future reference. T win-tub Washing Machine 0030808445[...]

Contents Names of the parts - - - - - - - - - - - - - - - - - 1 Safety precautions - - - - - - - - - - - - - - - - - 2 Installation and adjustment - - - - - - - - - - - 4 Preparation before washing - - - - - - - - - - 6 The musts in washing - - - - - - - - - - - - - - - 7 Usage of the detergent - - - - - - - - - - - - - 7 Washing sequence - - - - -[...]

ºó¸Ç Ë®µÀ Major frame Base frame W ater-filling entrance W ash selector W ash timer Control panel W ater level adjusting lever Pulsator W ash tub W ash tub cover Drain hose Overflow filter V alve cover Outer cover of the spin tub Inner cover of the spin tub Spin tub Cabinet Spin timer W ater-filling translation Back cover Lint filter 1 Mean[...]

Safety precautions Please insert the power cord into special receptacle with rated vol- tage. Be sure to use single-phase three pins receptacle. The earthing terminal of the receptacle must be earthed reliably. If possible, please adopt electric leakage protector. When the machine is normally using, please put the power plug at the location easily [...]

Please don t use the washer in the environment below 0 C. If the washer is below 0 C, the washer s water inlet system and draining system will be frozen ,then result in the damaged of the whole machine. If the washer has below 0 C, please be sure to ensure the washer is placed under the room temperature for 2~4 hours and then use . It is suggested [...]

Installa tion and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. 4 Usage of the drain hose If the extra hose is too long, cut it either at point A or B. B A > 30mm <1.5m The drainage shall be smooth with the drain hose. 1.The[...]

5 How to change the direction of the drain hoses Figure 1 indicates the ex factory installation position of the drain hose. Figure 1 Figure 2 Drain h ose fixing h ook Side sectional v iew Drain h ose fixing h ook Pull outwards slightly Fixing hook installation hole Drain h ose Ta ke off the drain h ose Extend the drain hose from the side of spin tu[...]

Pr epar a tion bef or e washing 6 Preparation before washing 1.Connect the water inlet hose. 2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe. 3.Put down the drain hose . 4.Slanting or uneven ground may result in unstable wor[...]

The musts in washing 7 The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition that can be washed or spinned in one time. Laundries quantity in one washing cycle shall be lower than the rated capacity. The thickness ,size , type of the cloth will influ- ence the actual washing ca[...]

Washing sequence 8 Spin timer Wa sh timer (T o set to below 2 minute, first set to 6 minute then turn it back. it can increase the service life of the timer). (to set to below 1 minute, first set to 2 minute then turn it back. it can increase the service life of the timer). Wa ter inlet Wa sh selector (standard current, strong current) SPIN TIMER W[...]

Ï´µÓÐëÖª Midway spinning Push Push Proper Proper Outer cover of The spin tub Inner cover of The spin tub The laundries are slanting Gland No gland (1) Set the water-filling selector control rod at the "SPIN" side. Fill water for about 1 minute. If the water quantity filled is too large, the water may flow out from the wash tub sid[...]

Rinse with stored water Rinse with water-filling 1. Put the laundries into the wash tub. Select suitable current according to the laundries. 2. Fill water to preset water level. 3. Rinse Adjust the wash timer to 2-3 minutes to do rinsing. When the laundries quantity is a few , please use "Standard" current. If you use "Strong" c[...]

1. Put the laundries into the spin tub evenly and smoothly. 2. Press the gland in the tub properly. Close the inner and outer cover of the spin tub. 3. Spin Select suitable spin time according to the laundries, and do spinning. During spinning, if there's abnormal sound, it is generally owing to slanting placement of the laundries. Please stop[...]

After using, please clean the lint and foreign materials of the lint filter and overflow filter in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. Disposal after washing 12 Cleaning the overflow filter Cleaning the lint filter T oo much lint on the overflow filter wi[...]

Wipe the complete unit with soft cloth twisted dry. Wipe with neutral detergent if too dirty Do not wash it directly by water Cleaning the overflow filter 2. T ake off the corrugation pipe. Dismantle the upper part of the corrugation pipe inside the overflow filter ( as indicated in Figure 1). 3. Cleaning the overflow filter Clean the lint around t[...]

When the remained water is frozen Prevent the freezing (be sure to discharge the water completely after using) After complete draining, set the "WASH SELECTOR" at "STRONG" or "STANDARD". If it is set at "DRAIN", it will be rather difficult for the frozen water to melt. When the water is frozen Pour hot water [...]

T r ouble-shooting Ans wer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do[...]

W ater inlet hose Gland Packing list Twin-tub washing machine Name Quantity User's manual One piece One piece One piece One set 16 Speciafication W ater level/Water quantity (L) (about) Maximum/70 Medium/60 Minimum/50 Injection pressure(MPa ) Washing capacity(kg) 8.0 0.02 0.2 Spinning capacity(kg) 6.0[...]